Ford F-150 (2004-2008) :: Ignition Getting Hard To Turn Off
Feb 23, 2011
Have an 04 ford f-150. igntion getting hard to turn of. not all of the time but still has its moments. thinking of using some graphite to lube it up.
View 2 Replies
Feb 23, 2011
Advertisement
Honda - Odyssey :: 2004 - Hard To Get Ignition Switch To Turn
I have recently been having problems getting the ignition switch to turn. There seems to be a negative correlation to warmer weather (the warmer the weather, the more likely I will have a negative experience --- and I will get the switch to turn only with some difficulty). When I have such a failure (in which the switch does not turn), I take the key out, wipe it off with my hand, flip it over and shove it back in. Sometimes this works with one try. Sometimes it takes multiple tries. My fear, of course, is that one of these times it will never work, and I will be stranded. I should add that I do have another key, and that I have had the same experience with this key. I don't really want to spend hundreds of dollars on a new ignition switch... and I especially don't if that is really not the problem.
View 2 RepliesFord F-150 (2004-2008) :: Truck Won't Start - No Click Sound When Turn The Key In Ignition Switch?
I'm trying to get friend's 04 F150 4x4 started. I think it might be the ignition switch. Here's what I've done. Turn the Key and nothing happens. Not even a clicking sound from the battery.
-verified the battery had a good charge and that terminals were clean, connections were tight.
-checked the fuses in the passenger side kick panel, none were blown
-Determined there was power to the primary Pos wire going to the starter , but no power being sent to the smaller wire that goes to solenoid at the starter.
-Hooked a jumper wire to the starter solenoid and engine did crank (so starter is good and battery is making good connection)
This is why I'm thinking its the ignition switch.
1) Where is the ignition switch located?
2)How can I test the ignition switch?
3)Could it be the "cylinder lock and keys" that is faulty?
Ford F-150 (2004-2008) :: 2007 - Check Charging System Message When Turn Ignition To On Position
I just got a new-to-me 2007 4.0L Explorer . When I turn the ignition to the on position, I get a message that says "Check charging system"...
Once I start the engine it goes away. Is this normal?
My battery reads 12.6 with the engine off and 13.8 with it on.
Ford F-150 (2004-2008) :: Wheel Bearing - Hard To Turn One Direction
Have a wheel bearing going south can it make the car hard to turn one direction. I dont really have any humming like a wheel bearing does. But i feel a little resistance every now and then when turning the steering right. I have sprayed the steering shaft joints and i can see that they are moving free like they should. And i have a less than 2 yr old steering rack. My truck has 103k miles on the original (to my knowledge) bearings. i didn't know if sometimes a wheel bearing could cause a hard to turn in one direction feel.
View 14 RepliesSanta FE SM (2001-06) :: 2004 2.4L - Turn Ignition Key Get A Click And Engine Will Not Turn Over
We have a 2004 2.4L 4 cyl Santa Fe. Turn ignition key get a click and engine will not turn over. Push key in harder and engine may start fine. If it is the key ignition switch or something else. is there somewhere I can look to see how to remove the ignition switch?
View 4 RepliesKia - Sportage :: 2008 LX Cranks Up Automatically When Start To Turn Key In Ignition
I have a 2008 Kia Sportage LX. Lately, when I have put my key in the ignition and start to turn it, it starts automatically. On my ignition I have Off, Lock, ACC, On, and Start. When I start to turn my key to Lock position my car cranks up automatically.
View 7 RepliesFord F-150 (2004-2008) :: Ignition Stuck / Crank Sometimes Even After Let The Key Go?
The truck seems to continue to crank sometimes even after I let the key go. Kinda like it's having a difficult time starting and NEEDS to be cranked a wee bit more and takes over for me. Is this an ignition issue that I can (need) to address or is it normal. I have ZERO experience with a newer vehicle nor a Ford truck.
View 2 RepliesFord F-150 (2004-2008) :: Key Stuck In Ignition Switch
My young lad just picked up a 2004 F150 4x4. While fixing it up we have encountered a weird problem. The key goes in , starts and runs the truck but cannot be removed, unless you unhook the battery.
View 5 RepliesFord F-150 (2004-2008) :: Remove Ignition Lock Cylinder?
How do I remove ignition lock cylinder to take and get new set up?
View 4 RepliesFord F-150 (2004-2008) :: Ignition Sticks And Kills Starter
Looking at buying this used 2004 F150 and the Seller says it has a problem with the ignition switch; that it continues to run the starter even after the engine is running, which burns out the starter. He's an obvious layperson and doesn't know much about mechanical stuff (or he's pretending, IDK).
This sounds very strange to me, because if it's some kind of mechanical defect/factory defect, it's something that Ford should have identified, documented, issued a recall maybe, or something, yet when I research the issue the only thing I find is a problem with ignition switches that cause fires in model years that end in 2003 (not 2004). Other than that I find no documentation.
I wonder how accurate the Seller's description is, or maybe it's defective due to some other reason, like maybe a car thief shoved something into the ignition and damaged it, or possibly corrosion. Or maybe it's simply "sticky" and some spray lubricant would fix it.
Ford F-150 (2004-2008) :: Ignition Switch Fuse Blown?
I have a 2004 Lariat 4x4 with a no start condition. I had lights, but it wouldn't crank. I then discovered that it would not shift out of park. Turns out that it had a blown fuse. I did not have any of that type (the funky square 20a fuses) so I pulled the heated seats fuse (30a) and threw it in there, tried to start it and blew it right away. Is there a common short to look for on these? I believe that the guy that owned it before me had a satellite radio in it, and could it be a bare wire from that setup possibly blowing the fuse?Just trying to get a head start on tracking down the short.
View 14 RepliesFord Super Duty (1999-2016) :: 2008 F250 - How Hard Should It Be To Turn Hubs
On my 2008 f250 I can not turn the hubs without a set of pliers...does that mean I need new hubs....
What auto tranny do I have with the 5.4.. is it a six speed...
Camry :: Ignition Doesn't Turn On Toyota Hybrid 2008 - Keyless Start
I recently purchased Toyota Camry Hybrid -2008, pre-purchase inspection done by Toyota dealer. Today, my car refuses to turn ignition on (I have keyless start). After several trials, it turned on. I switched off the car and tired after 5 mins. Again it gave the trouble first time, worked second time. What could cause this issue? It's still under hybrid warranty.
View 5 RepliesFord F-150 (2004-2008) :: Transmission Or Ignition Sputtering When Accelerate Slightly?
2006 F150 FX4 5.4L, 118k miles... At highway speeds (45-50) and (55-60) as I am slightly accelerating it feels like the transmission or maybe ignition system is skipping a beat. Kind of feels like a small bump. I replaced spark plugs with motocraft about 35K miles ago and recently all transmission fluid via cooler line. Had some concerns about system flush so I just drained and refilled entire system via cooler lines. I have read that it could be my COP's ...
View 7 RepliesFord F-150 (2004-2008) :: Key Is In The Ignition Chime After Truck Turned Off And Key Removed
I guess not ALL of the time, but pretty often when I turn off my truck and remove the key from the ignition, I get the "key is in the ignition" chime, and I'm not allowed to lock my truck.
View 2 RepliesFord F-150 (2004-2008) :: 2006 - Rough Idle After Replacing Ignition Coil
completely stock 2006 4.6, 230,000 miles, I purchased and can vouch for everything after 106,000.
Two separate issues...have had a slight ticking noise growing for about the last two years. Seems to get slightly worse near an oil change but that could be my imagination. It has finally gotten loud enough that my wife (who drives with the delicacy and observational skills of a Sherman tank driver) actually mentioned it to me the other day. It is directly related to engine speed whether the truck is in gear or not. I kind of think it might be a manifold gasket going out but am not sure. Am not very worried about it but...felt like I needed to mention it because of my bigger problem....
Truck has gotten very "cranky" on startup in the last week. Has a rough time finding an idle speed but typically sorts itself out after about 5-10 seconds. This afternoon it started idling rough at a stoplight. It got steadily worse and noticeable even at speed. Four stoplights and nine miles later it threw a code and coincidentally, I was in front of an Advance Auto. They read it and said the #3 cylinder was not firing. I bought an ignition coil, drove 15 miles home and changed it. From everywhere I looked online, this is the second cylinder from the firewall on the passenger side.
Had a little trouble getting it in and am not entirely sure it is fully seated in the slot, but I can't get it to go any further. Seems as tight as a couple of the others. I disconnected the battery to clear the codes, cranked it up and it seems to run "better", but still has a rough idle. Just test drove it about 12 miles and no check engine light but the idle has not cleared up. I think coil must be working fine because I have no issues at highway speed. Earlier, when I backed off the gas you would feel the miss very badly, but not as much when under a load.
Ford F-150 (2004-2008) :: Truck Wouldn't Start Now Won't Shut Off When Pulled Key Out Of Ignition
What happened is I went to get in the truck I opened the door and the gauges and blower motor came on by itself like the ignition is in the on position. I put the key in the ignition and the truck didn't do anything. No crank or anything and I did notice the anti theft light blinking really fast. I unplugged the battery and plugged it back up then the truck started but I went to shut it off and pulled the key out the ignition and truck stayed running. But also the blower in the truck and the gauges are still staying on. People keep saying it's my key but why would the stuff cut on by itself inside the truck when I just opened the door?
View 9 RepliesFord F-150 (2004-2008) :: 2007 XLT Missing / CEL Codes Ignition Misfire 8 And Rich Fuel
My 07 xlt 4x2 4.6 (49700 miles) started missing a couple of weeks ago. Did it for 2 days, the Check Engine light came on, then it quit missing and ran normal. CE light was still on, so I had the code read and reset light. Got two codes: ignition missfire #8, and rich fuel. I assume the rich fuel was caused by raw gas in the exhaust.
Anyway, the truck ran fine for two or three days then started missing again. Checked #8 by taking the wiring connector off #8 COP - rough idle unchanged. Pulled COP off #8 and #7 and swapped. Rough idle unchanged and confirmed miss was still #8 by pulling COP connector. With #8 connected, disconnected #7 (with COP from 8) idle was significantly worse.
Replaced #8 plug. Same miss. What to check next?
Ford F-150 (2004-2008) :: Key Stuck In Ignition / When Pulled Out Chrome Bezel That Locks The Tumbler In Fell Out
When I went to pull my key out of the ignition yesterday the key got a bit stuck and when I jiggled it a little to pull it out the chrome bezel that locks the tumbler in fell out. Now the tumbler is out as well and I cant figure out how to get the tumbler in and lock the bezel in place.
I see a pin on the bottom of the ignition cylinder that I should be able to push in and pull the cylinder out but I cant seem to push the pin in at all.
Lexus RX 2004-09 :: Ignition Switch Is Locked / Would Not Turn
I put my LS 430 key in my RX330 yesterday, I realized as soon as the ignition would not turn. I put the RX key in, and ignition will not turn. I'm assuming that the pins may be locked so I tried a few options.
- I wiggled the key.
- I lubricated the lock.
- I tried rocking the car while trying to turn the ignition.
- I tapped the ignition lightly with a screw driver and hammer, but no luck.
- I turn the steering wheel while turning ignition to make sure its not locked.
I really don't want to get the car towed to the stealer/dealer.