I am getting a grinding sound from the left front wheel while driving straight.. The sound stays the same when brakes are applied and does not change when selecting 4wd or 2wd.. I pulled the wheel off and had a look, but saw nothing unusual.. What are the steps to diagnose/repair the issue? 2004 F-150 5.4 4x4
View 6 RepliesAbout 3 months ago I started having a grinding sound from the front driver side hub area. I replaced it and it fixed the problem. I read where you should do both because he other one is soon behind it but I waited. Now I started hearing it from the passenger side too. So I replaced it today and all was good until I tested it from 4 wheel back to 2 wheel. Once I went back to 2 wheel the clicking that sounds like bearings going out to me, was back. What is it?
View 1 RepliesMy wife just bought her first truck, a 2008 F150 about a month ago. We have been driving it around since then and love the truck. The only real problem that I have seemed to encounter on the truck is a squeak coming from the front left wheel area. I can hear it when I cut the steering wheel and when I hit a big bump/pothole in the road. My dad and I have looked into it and he thinks that it is probably the axle joint where it goes into the steering knuckle/spindle. If it is this axle joint, is there a way to service/grease it and go on, or will it just simply need a new axle shaft?
View 1 RepliesRepeat Front Hub Failures -- 2WD Try this situation -- Purchased 2006 F-150 XL with 57,000 miles. Truck built on 05/24/2006.
Sept 2011 68,621 miles -- Left front hub failure -- Wheel bearing grinding -- Done by Bell Ford in Phoenix.
2013 -- Left front hub failure -- wheel bearing grinding -- done by independent shop.
Sept 2014 -- Left front hub failure -- wheel bearing grinding -- done by independent shop.
Sept 2016 -- Upper & lower control arms, struts, strut mounts, springs replaced -- Quality part used -- Complete front end alignment -- Brake job front and rear.
Nov 2016 -- New performance exhaust system due to exhaust leaks.
Dec 2016 -- Failed automatic transmission -- Remanufactured FORD transmission installed w/ 36 mo warranty. Sanderson Ford gets an A+
March 16, 2017 151,000 miles -- Left front hub failure -- wheel bearing grinding! Verified by jacking up truck and spinning left front wheel -- GRIND! This is coming from down in the hub. This is a 2 wheel drive truck. Yes, you counted correctly, this will be the 4th replacement on the Left side!
NO Towing! NO Overloading! Wheels are 2006 XLT style Aluminum rims with P235/70R17 Michelin XLT M/S (Defender LTX) tires all around.
It only hauls maybe 200 to 300 pounds of electronic equipment at the max, once in a while. This is driving me crazy! I always use FORD PARTS for the HUB ASSEMBLIES. Really loosing faith, the front right hub is OEM original - NEVER CHANGED!
MY '07 SuperCab just started making a strange rhythmic sound as I drive. It is coming from the drivers side front wheel area. It is like a short creaking sound. It stays the same if I am turning the tires. Seems to go away if I put the brakes on hard, but I slow down so much I am not sure. Front CV Joint?
View 1 RepliesI owned a 99 f250 a little while ago. Just bought a 2006 crewcab F150 xlt about 2 months ago, and for the past month there has been this unusual grinding or whirring like noise coming from the front passenger side wheel.
I took it to the mechanic and he found a bad wheel bearing on drivers side and replaced it but that wasn't the issue. He could hear the noise but wasn't able to figure out what the actual issue was.
The noise only happens when my foot is on the throttle. (not when coasting) and i also just discovered that it doesn't make any noise at all when put in 4x4.
Early this week my car started making a loud knocking/rubbing sound (Kind of in between when your brakes are ground down to the rotor and a knocking pattern).
FIRST, it started only when I turned slightly left or left.... NOW, it's doing it as I go straight and when I turn to the right as well... oddly enough it's not as bad when going left anymore...
What this could be?? And if it's an easy DIY fix..... (maybe a link on how) and how much the part(s) might be?? I've taken video (for sound as I drive)...but not sure if I can upload it (size limit).
I've got a 2008 santa fe limited 3.3 awd with about 170000 km on it. Lately when I brake I've been hearing a clicking noise coming from what sounds like the driver side front wheel area.
Had it in to my mechanic who checked the brakes and said that pads/calipers/rotors were all fine. They replaced the passenger side front bearing on the lower control arm a few weeks ago and said there is no play or noise coming from any other suspension components.
Where to look next? My mechanic isn't sure what it is so I was going to take it to the dealer and see if they can fix it. Also had new tires installed about a month ago
2004 F150 SCREW Lariat 4x4. Experiencing some odd noises. When driving down the road and turning the wheel slightly left will produce some grinding and popping from under the floorboard. I'm suspecting a CV axle as the boot is ripped on that side. Would this have anything to do with the IWE system or solenoid??
View 1 RepliesStarting at 47000 miles I noticed a rhythmic sound coming from the front right wheel area. The sound increases or decreases with speed. I waited another 6000 miles, rotated and balanced tires with no change.
View 3 Replies2005 ford f150 Fx4 So last Friday I started hearing a grinding noise from the passenger side front of my truck. sounded like metal on metal. So I started rooting around and noticed that bottom ball joints were shot. so replaced bottom ball joints on both side. I aslo replaced wheel bearing hub assembly on both sides, still heard the grinding. So I noticed that both axles were slinging grease, so I replaced them on both sides.
Still heard the grinding noise. So then I removed everything from the passenger side and noticed that the locking hub actuator was grinding both axle and the wheel bearing hub. So I just got done replacing that on the passenger side, put it all back together, and still grinding noise ringtones free. Also replaced the 4wd solenoid that they said gets water in it, and I replaced the check valve. And I put new Rotors and breaks. What it could be?
I just bought 2006 f150 4wd . It make a grinding sound on both sides in the front end..it seems to be independent and when I slow and come to a stop, I makes a clanking noise like its locking something in.
View 4 RepliesI have an intermittent grinding noise coming from what sounds like both front wheels, it sounds like metal on metal almost like something metal rubbing the rotor but I just put new pads on and the noise was there before as well with nothing touching the rotors but the pads. The sound will appear out of no-where at low speeds of 35 or below and will continue until I brake and slow down, just before I come to a compete stop the noise will stop with a slight clunk.
I can then drive away with no noise. I am pretty sure it is not brake related except maybe ABS somehow but was also thinking front axle or diff, also have read posts that are bearing related, but both at the same time?. It is the slight clunk before stopping that I can not figure out is related to. It is an 05 f150 xlt 5.4 super cab 4wd with 85k miles
My 05 Supercrew 4X4 with 172k miles started making a horrible noise these last couple days. It sounds like its coming from the front passenger side area. The best I can describe is that it sounds like an electric tool motor with bad bearings. I'll be driving along at 45mph or above and every now and then I'll hear a really bad bearing squeal. It's bad enough that I can feel the extra friction caused by the squeal start to slow my truck down. It's vehicle speed related. I know what a bad wheel bearing sounds like and this is nothing like that. It's gotten bad enough I'm nervous to drive anywhere.
View 4 RepliesI gotta a roaring noise coming from my right front while turning. Planning on replacing just the wheel bearings tomorrow & not the whole hub assembly(2008 2wd). Is there a thread that lays out the steps and other parts I may need? I've seen alot different stories on the net on how to do it. Everthing from I can press new bearings to I have to do 4x4 hub conversion. Seems to be some confusion.
View 2 RepliesI've got a new issue that is happening on the front end of my truck. Whenever I try turning my wheel while driving, I get this rubbing/grinding noise coming from the front of my truck. It only happens when the wheels are in motion. It seems to happen less when I'm driving at higher speeds, but I can notice it make the sound at any speed. I tried driving it slowly in an empty parking lot while turning and it's definitely making the sound every time the tires rotate.
I took it in for an alignment because this was happening every time I drove, whether it be driving straight or making a turn. Now that my alignment has been fixed, it no longer make this noise if I am driving in a straight line, so it only seems to happen when I'm turning. I had the mechanic check to see if they could reproduce the issue. The mechanic was able to hear what I hear, but when he put it on the lift at the shop, he was not able to reproduce the sound.
I have a 2004 F150, 5.4L V8. A few years back I was in an accident when someone slammed into the front of my truck. The right front wheel & tire took the brunt of the accident. I thought the repair shop had everything back to normal until recently I occasionally have a grinding sound coming from the right front side, seems to be related to the axle. It doesn't do it all the time just at random while I'm driving. The only solution I can find is to pull over or slow my speed to a crawl. Once I slow down enough or turn my wheel one way or the other its like something SLAMS back into place. I had it looked at by a local mechanic and they couldn't find anything wrong. Could it be something in my right front axle?
View 7 RepliesAt about 20k on my 07 I started hearing a faint whup whup whup between 35 and 50 mph's on the front driver's side area. At 60+ pretty quiet. It has gotten real loud at the present 30K. I suspected the tirers as I know the Integrities are complete junk but as a test I did a rotation and exact same noise.
I thought thats not good but found it hard to believe something else was bad as I had no vibration and no pull whatsoever in steering. Long story short I bought a new set of tires Kumho KR21's at stock size and oh crap exact same noise.
2004 Sienna LE with 193,500 miles. While driving home tonight I started hearing a grinding noise from the passenger front wheel. The noise goes away on acceleration and braking. Whenever I take my foot off the gas it starts to make the noise again. It sounds almost like a brake noise but I just replaced the caliper bracket this past weekend and the brakes look great (less than 20,000 miles on caliper, rotor and pads). I suspect a bearing may be going bad and want to know if these symptoms match a bad bearing. The wheel bearings are all original.
View 4 RepliesMy 08 gx just started making this weird noise when I have I'm leaving from a stop and have the wheel towards the right. It sounds like a rubbing noise. This doesn't happen when I have the wheel turned to the left. Only the right.
View 10 RepliesHave an 08 f150 crew and love it. I have noticed though that when its in 4x4, it seems as thought the right front wheel is always engaged. Why it's not letting the 4x4 float back and forth from right to left??
View 3 Replies