Ford F-150 (2004-2008) :: Engine Noise - Knock Or Tick At 1000 RPM


May 14, 2011

Knock or tick at 1000 rpm. Truck has 20000 miles on it. Dealer replaced cam phasers. What next?

View 1 Replies

Advertisement

Lexus RX 2004-09 :: RX330 - Faint Tap / Knock / Tick Noise Coming From Engine

Lexus 3.3L RX-330 Engine Noise - Part 3 - YouTube

I am concerned with an engine noise.

5 months ago we bought a 2005 Lexus RX-330. It had 109k miles on it (now has 113k). There is a faint but noticeable engine tap/ knock/ tick coming from the engine. I think it has the 3.3l, 3gr-fe engine.

I have listed some observations:

The sound does not occur on startup, when the car is completely cold.
The sound starts after 5-10 minutes of driving or idling.
The sound diminishes and is almost imperceptible after another 10 minutes of driving.
The sound is only noticeable at idle.
The sound/tap seems to occur about 5 times a second at 600 rpm (idle)
The sound increases frequency with rising of rpm.
At approximately 2k rpm the sound cannot be heard.
If the vehicle is stopped after driving, allowed to sit for 5-10 minutes and then restarted, the sound will be loudest even though the engine is still hot.
The engine is quiet overall with exception of this sound. The fuel injector sound is the next loudest sound.
The sound doesn't seem to have gotten louder in the last 5 months but it may have gotten just slightly louder by my estimation.
I can hear the sound inside the vehicle and outside as well.

No other symptoms are present. I had the timing belt, water pump, idler and tensioner replaced as maintenance and as a possible solution to this problem right after buying the vehicle.

The mechanic heard the sound but told me he wasn't sure of the cause. He and I agree that it sounds like an internal engine noise. It is not a pulley, idler or exhaust sound. The mechanic told me not to worry about it and it was a normal sound. He also said to start troubleshooting would get expensive. I am still concerned.

View 14 Replies

Ford F-150 (2004-2008) :: Engine Knock / Clunking Noise When Come To A Stop Or Takeoff Or Steering

I am having a hard time locating a mechanical knock coming from my truck. This is not an engine knock but rather a clunking noise when I come to a slightly abrupt stop and sometimes when I take off or am steering. I have recently replaced my upper and lower ball joints and all the u-joints as well. My truck has a 6" Fabtech Coil over lift and a 3" body lift. The truck is also rather squeaky when going over speed bumps.

View 8 Replies

Ford F-150 (2004-2008) :: Humming / Rubbing Noise Under The Hood When Come Across 1000 RPMs

I put a link below on the video that I made. But when I come across 1,000 RPMs weather I turn, go straight, left or right it makes this noise like a humming or rubbing noise. I took it to the dealership and they fed me crap saying when it gets worse or when it happens every time brig it back.

[URL] ....

I don't think this link is working I'm trying to figure out this iPhone. Search my YouTube channel Kill3rcr3w that's the channel I just uploaded it

View 2 Replies

Ford F-150 (2004-2008) :: 5.4L Engine Has A Knock

A 2004 and up f150. I found one in great shape for 5,000 dollars with 120,000. Drives good but it has a knock I'n the 5.4 engine. It gets quieter when the engine is warm. Should I avoid this truck or will I be okay with purchasing? Only thing holding me back from buying truck is the knock...

View 9 Replies

Ford F-150 - 1997-2003 :: Tick Or Slight Knock - Coolant Low?

I have a 2000 F-150 xlt off road with a 5.4. I have owned the truck since 2001. The truck has 170K miles on it and I change the oil between 3-4K miles. The last couple oil changes I have I have noticed I haven't been draining as much out as I usually do, this past oil change was about 3 quarts low. I thought it was very odd. The truck runs great and does not smoke or leak oil.

This morning I got in and noticed a tick or slight knock, thought maybe it needed warmed up. After a minute. I shut it off and checked the oil, to my surprise there was next to no in the engine! This has me very worried now. I haven't checked my coolant since last oil change so I'm not sure if that's where it's going. Where to start looking, I'm missing like 5 quarts of oil in 3300 miles. Again the truck run great and does not smoke at all. I was getting ready to change it this weekend, always run high millage 5w-30.

View 8 Replies

Jeep - Grandcherokee :: 2004 - Making Click / Tick Noise From Right Side Of Engine At Start Up

2004 Jeep Grand Cherokee V8 4.7 L. Clock from right side of engine immediately after starting engine. Seems to be in rhythm with engine and increases in frequency as I rev. Gradually subsides over first 5 minutes and not audible after that. Recent small leak of transmission fluid, but I'm thinking that has nothing to do with this.

View 12 Replies

Ford F-150 (2004-2008) :: Engine Will Run Really Rough And Knock Loudly In Reverse Or Park

I have a 2008 fx4 with 75000 km it runs great but when I go on a long ride up hills or tow my trailer it acts up only when I get to my destination. the engine will run really rough and knock loudly seems only when I use reverse or sometimes park (and oil pressure in dash looks good),and if I shut ignition off and restart it no problems till I make engine work hard again.

View 14 Replies

Accent MC (2006-11) :: Tick Tick Noise In Front Of Driver Seat While Waiting At Traffic Light

I just recently started driving... with a second hand hyundai accent. Whenever i stop at traffic light with engine on, i hear tick tick noise (probs from engine?). it seems to be coming from front of the driver seat. When I start at the beginning, I do not hear any noise and also when i am driving i do not hear any noise or lets say nothing audible like this. Its only when i stop my car and while i am waiting, i hear this tick tick noise(very clear and audible).

Is it engine metallic part making sound when cooling down? When I start my car I see symbol for low oil pressure, batter life, check engine, but as soon the engine starts these symbol disappear which I think is normal behaviour.

View 3 Replies

Ram / SRT10 :: 1996 / V10 - Truck Has A Tick / Knock But Can't Seem To Locate?

I have a 1996 Ram with the V10 that only has 10,000 miles since it was replaced by Dodge. 7 years has passed since that shortblock warranty job. It now has a tick/knock that I cant seem to locate? I changed the lifters and one push rod since is was a little bent and put it all back together. Still getting the same thing - nothing has changed ...

View 13 Replies

Ford F-150 (2004-2008) :: Spark Knock Under Load?

I have a 04 5.4 w/ a whipple supercharger. truck has 104k miles. Has a misfire in cyl 4 (p0304, p0316) And spark knock.. I've changed the plugs, coil on cyl 4, fuel filter, and today the o2 sensor(pass side upper, bank 2??). I've ran tecron injector cleaner threw it, and always used Chevron 90 octane. (highest in Alaska)

The noise only happens when under load, or accelerating with more then half the throttle. doesn't happen when i slowly get up to speed. What I could do next? About to take it to the dealer to run a full diagnostic test on it.. Also, does not hesitate or bog. drives normal just with that noise

View 5 Replies

Ford F-150 (2004-2008) :: Knock Sensors Replaced Now Won't Idle

I replaced my knock sensors on 2004 5.4L and now it will not idle without me keeping foot on gas. Idles down to +- 450-500 rpms. If I hold down gas pedla seems to run smooth. What to check to fix this problem?

View 10 Replies

Ford F-150 (2004-2008) :: Slight Knock / Ticking Sound When Warmed Up

I just bought this truck yesterday. During the test drive and everything it seemed all fine. After all the paperwork and the truck was actually mine. I noticed once it is all warmed up it seems to have a slight knock/tick? and a slight miss to it. I shot a couple videos, one up underneath where it sounds like most of the noise is coming from. Could it be an exhaust leak? Or is it something internal? Like the Cam Phasers, or a rod or something!

Here is a video around the exhaust area.

Here is up underneath the truck.

View 5 Replies

Elantra HD (2006-10) :: 2008 - Engine Shudder / Vibration Whenever RPMs Are Between 1000 And1500

I drive a 2008 Elantra automatic,and have a constant engine shudder/vibration whenever the rpms are between 1000 and1500. The engine shudder stops as soon as I accelerate above 1500 rpms,or take my foot off the gas completely.

The dealer recommended cleaning of the fuel injector system,not sure if thats the course to take.I do know my model has had fuel pump issues,but the dealer has told me all recalls on the car have been processed.

View 3 Replies

Ford F-150 (2009-2014) :: Ticking Noise At 800 To 1000 RPMs / Rough Idle Leads To Engine Fail

2010 F150 ... So I have the tick noise at rpm's 800-1000 at drive through, stops, etc. So I did research on it a few months ago and saw that it might be VCT's but should be able to drive. so I drove it waiting to save money and have it go to a shop. well this past weekend while coming home from work my oil light came on the pressure dropped to zero, I was on the highway so I drove about another mile to get off highway and once I got off my truck died. I had it towed to my house and I thought I blew my motor. So I started doing research here and found that the VCT's AND cam Phaser could be bad. so I replaced my VCT on driver side put it all back together it started and loud knock was gone. then after 5 mins it was back very loud knock!

So I shut it down and took apart the passenger side once I got the valve cover off I found the problem.... The bolt that holds the cam phaser in place snapped off and was riding along the camshaft. So I took that out and extracted remaining part of bolt. inspected my camshaft and it was really messed up. so I bought new Phaser and Camshaft. the camshaft just came in today and I am trying to put it back in. but the hole for the pin in the phaser doesn't line up and I cant spin the shaft to make it line up. should I spin the cam phaser? I marked the chain and the phaser is where it should be on chain, but with that bolt snapping off could that have thrown the timing off so my mark is no good? when I lay the camshaft in place it sits perfect and if I just move the phase over 2-3 links it will all fit together. Should I do that?

View 5 Replies

Ford F-150 (2004-2008) :: Intermittent Rattle / Knock / Running Rough And Dying At Stops

I am working on a customers 08 F-350 5.4l has 135k on it. came in with a severe rattle/knock, running poorly, and dying at stops. ECM gave up 8 codes relating to the timing... Found the phaser replacement steps here on FTE and followed them and replaced the VCT solenoids since i was in there. Customer reported that he replaced the cam sensors already. Ran great for a day, and the next day when I pulled into the shop it gave me a rattle. Not as violent as before but noticeable. I special ordered the wedge and followed the replacement to a 'T'. I have no performance issues and no codes.

View 5 Replies

Ford F-150 (2004-2008) :: Stalling Every Time Came To A Stop And Eventually Lost Oil Pressure / Knock In Bottom End

I recently bought a 2005 F150 King Ranch. I had a 900km drive to get it home but only mad it half way and am now stuck. I was stalling every time I came to a stop and eventually lost oil pressure. This is when I stopped driving and took it in. The shop said it had a knock in the lower end and stopped diagnosing it there. I can now sell it for parts and take a big hit or I can try and patch it myself.

I am assuming based on my symptoms it is a spun rod/main/thrust bearing. The mechanic was not very supportive to narrow it down to anything other than replace the motor.

How many km might I get out of this engine if I pull the motor and replace only the crank and rod/main/thrust bearings. This will not be my daily driver so if I can get another 50000-100000 km off of that, then it will last me at least 5 years.

This is of course assuming that when pull it apart I do not find an other major problems such as bent or broken pistons and rods or scoured cylinder walls. I am not that experienced of a mechanic, so I am not that confident about pulling the heads off and rebuilding the whole thing.

View 4 Replies

Lexus LS 2007+ :: Transmission / Engine Noise When Accelerating Decelerating Between 1000 And 3000 Rpm

Have owned a 2014 LS460 since April. Ever since then, when accelerating decelerating between 1000 and 3000 rpm, we hear a whining and grinding noise.

View 9 Replies

Ford F-150 (2004-2008) :: Engine Noise During Acceleration

I noticed the problem today when I was driving to the store. I was going around 60 and went to pass a car. As soon as I hit the gas there is a popping noise coming from the engine compartment and it had no power. It only does it between 50-65 mph.

View 1 Replies

Ford F-150 (2004-2008) :: 5.4L Engine Noise When Idling

5.4 sound like a diesel when idling?

View 14 Replies

Passat (B5) :: Engine Knock Noise When Engine Fully Warmed Up And In Drive Or Reverse

OK--2001.5 1.8t Tip, 85k, nothing but Mobil1 since day one religiously. At around 81k miles the t/belt tensioner seized & let the belt jump and bend a few valves. Had VW do the repair under the p.t. warranty. Engine now runs very well again except there is a knock noise that sounds an awful lot like a crank or rod bearing. The noise is worse with the engine fully warmed up and in drive or reverse. Took it back to VW, they said it's a bearing in the a/c compressor. Sounded like B.S. to me, since the noise is no different with or without the a/c on. I picked up the car & removed the a/c belt at home & found the noise was exactly the same. I've about had it with VW on this issue. Been back 3 times with the noise complaint, & the noise is getting worse!!

View 1 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved