Ford F-150 (2004-2008) :: Disable The Seat Belt Ringer?
Nov 13, 2011
Can disable seat belt ringer? Today I got in my truck put it in reverse and sat for a moment and the damn ringer came on for the belt then drove down the drive way and it came on again. There was no need for the belt seeing that I was just moving trailers around the yard. I had a few Rangers and a Bronco that I was just able to reach down and pull the ringer out but I also had a Ranger that had the speaker build on to a circuit board I ended up putting bondo in that one made it real quite.
View 6 Replies
Advertisement
How to disable the seat belt alarm on a 2008 Lexus RX 350? I tried the "reset odometer" method and that doesn't work. I also took the car to a Toyota dealer and a former Lexus technician could not disable it via computer. This alarm is annoying!
View 14 Replies
I just purchased a 2004 Excursion and I want to disable the seat belt alarm.The truck didn't come with an owners manual so I got the manual from my 2005 and followed the instructions but it wouldn't disable the alarm. It worked fine on the 2005. Need instructions for a 2004?
View 9 Replies
Any way to disable the annoying seat belt alarm. I do wear my seat belt but I can't even get out of my driveway before it goes off, also if I drive one block to the store and don't feel like putting it on. I have tried the disabling procedure in the owners manual many times and it does not work. I have also tried other procedures posted on the internet and they didn't work either. If the alarm wasn't for other things like keys left in ignition, etc I would have cut the wires by now.
View 14 Replies
Any quick and easy way to (permanently) disable the seat-belt nag warning?
I'm going to be up in the woods with my seat-belt off and don't want it driving me nuts...
View 5 Replies
Instructions on how to disable your seatbelt chime.
1. Buckle Seatbelt (1.1) go to ACC mode.
2. While depressing the brake, turn the key to the ON position. I Was thinking someone might experiment with in the ACC mode might work by pressing the start button w/o your foot on the brake pedal.
3. Press the trip reset button a few times, stop when the ODO is displayed (not trip distance - A or B). If the odometer starts at the mileage, cycle through anyway.
4. Turn the ignition to LOCK.
5. Unbuckle the driver's seat belt.
6. Turn the key to the ON position again. When the dash lights comes on, press and hold the trip reset button, and count to 20 (slowly).
7. While still holding the trip reset button, buckle the driver's side seatbelt.
8. The odometer display should read "b ON" or "b OFF". Depress the trip reset button to toggle.
9. Unbuckle and Turn OFF the car.
View 4 Replies
For a long time my 2004 regular cab truck has a quirk that both the driver (and passenger if present) must click their seat belts before starting the truck. If not, the seat belt chime and light flash, even though the seat belt light is off when the alarm is not sounding.
Even if the truck is in park, and the passenger gets out of the truck and back again with the engine running, once in drive it will start the seat belt alarm with everybody properly buckled.
A few months ago I was driving to work and the airbag light started to flash.
I took the truck in for the air bag wiring harness recall, and the airbag light did not flash since then, and for a little while the seatbelt problem went away.
1 month later the seat belt quirk was back again.
This past weekend the 5x5 air bag alert started. I checked previous posts, and confirmed that my air bag light does not ever light on my dash. I don't remember if it ever came on once the recall was "fixed".
My gut feel is that the wiring to the light is fine, and that this is a wiring problem in the harness. I saw a post that made a vague reference to the air bag sensor under the center console and the seat belt circuit and could find no more.
Looking for a wiring diagram? If the airbag light is out, does the 5x5 alert supposed to indicate that the bulb is burned out, or that the bulb is out AND there is an airbag fault?
View 9 Replies
On my 2004 F-150 (new style) the passenger seat belt will not release. What steps do I need to take to find the retractible mechanism in the back portion of the seat? Does one have to cut the fabric? I removed the head rest and the top portion where the belt rides but can't locate the retractible part.
View 3 Replies
Well, no wiring mod is required. Here is the procedure:
1. Set the LCD on the combination meter to the ODO trip.
2. Press and hold the TRIP meter reset knob for ten seconds or more within six seconds of turning the ignition switch to the ON position. Fastening the driver's seat belt while holding the knob cancels the buzzer reminder. (You may have to hit the reset meter knob to cycle through b-ON to b-OFF)
3. When this occurs, the LCD displays "b-OFF". The buzzer reminder can be switched between ON and OFF each time the TRIP meter knob is pressed. The LCD displays "b-ON" or "b-OFF" according to the buzzer reminder ON/OFF status. The display changes to the ODO or trip meter if the knob is not pressed in 10 seconds.
4) Performing steps 1) and 2) again when the buzzer reminder is off exits cancel mode.
I was able to disable the seat buzzer and took a drive. IT WORKs! I am so relieved.
View 14 Replies
I just bought my 06 Hyundai accent last night. Just today I noticed my seat belt will chime after I remove the belt, even if the car is in park. It's not a big deal but it was enough to make me look through the owners manual to see if it could be disabled. Well, I didn't find my answer so I thought maybe someone here has already done it. So, how to disable the seat belt chime?
View 7 Replies
I'm new to the board always been into old school air cooled vws but just bought a 20th anniversary GLI Jetta and need to know how to deactivate the seat belt ding ding. The car did not come with an owners manual so can't look it up.
View 8 Replies
I just got the new Avalon. Pretty nice but rear visability isn't great and front head room has been reduced to make it look sporty. My problem is with the obnoxious seat belt warning chime which seems to go on forever. How to disable it? I use my belt all the time. Don't need a reminder.
View 14 Replies
Is there a way to disable the audible portion of the seat belt warning?
View 5 Replies
I wear seatbelts and make sure passengers wear them too while driving. However, many times I keep heavy boxes on the passenger side seat...
And I am sure you all know how irritating that warning sound is (for 24 secs)
How do i disable it in 2007 Toyota Camry LE ?
View 14 Replies
Is there a way to disable the seat belt beeper in a 10 Jetta SW? I am typically driving a few blocks or less and this drives me nuts. I assume you can disable through the vag-com or does a dealer need to do this?
View 9 Replies
About 6 weeks ago my 2004 4.6 scab had a glitch in that when you got going the seat belt warning chimes came on, to clear it stop at the next junction turn off re start and away you go. Now today its moved a step further on, the airbag not working light flashes and then stops on, but no seat belt chimes?
View 2 Replies
I just sold my 2006 GS430 to pick up a 2007 LS460. So far I have no complaints.
First off: I am NOT condoning driving without a seatbelt. Merely asking a question.
In my gs430 I can go through a series of commands to disable the seat belt buzzer from beeping while i drive without a seat belt. I've browsed the forums and haven't seemed to find the same thing for the LS460.
Is it even possible it to disable it without having the dealer reprogram?
View 10 Replies
How to disable the seat belt warning sound and or the passenger side airbag warning sound?
View 7 Replies
just got a new Passat 2008, 6 MT, when I go on the freeway the passenger seat belt winding starts rattling, I have to buckle it for the rattling to stop. also, it seems like the passenger seat appears to be vibrating but the car itself is fine.
View 1 Replies
I love my Ex and I love my dobermann, but the two did not mix one day. In a matter of seconds, he almost chewed completely thru the driver's seat belt. Guess he thought I was taking too long to get out. It's basically hanging on by a quarter inch of fabric and seriously needs replacing.
I figure it can't be that hard to replace myself, but I cannot see how to remove the molding/housing that hides the mechanics of it all. I've been searching for videos, but none of them are for the Ex. :
How I can remove the housing and change the belt myself. Looking for a video or pictures.....
View 14 Replies
About to replace seat belt (dog chewed original) and had two concerns:
1) Do I have to disconnect 12v battery (to avoid triggering airbags)?
2) Care in replacement installation due to "explosive" component?
View 6 Replies
