Ford F-150 (2004-2008) :: ABS Light Won't Go Away After New Sensor B1230 Code
Sep 18, 2014
Problem: Initially thought replacing the rear wheel speed sensor on top of the differential would make the light go away on a 2007 F-150 XLT. What I've done already.
-Replaced the sensor
-Used the IDS ford computer to clear the code
-Test drove it for 30 minutes and the light is still on
-Reset any codes by disconnecting the battery
-I have gone as far as swapping a different ABS module thinking it was the problem, after it was re-programmed the module checked out and it wasn't at fault.
It must be a wire, all the fuses for the ABS system are fine.
Issue or traced all the wires and found a common problem such as a pinched wire or melted wire between the module and the sensor? From what I have been researching this code B1230 .
-bad sensor
-sensor grounding out somewhere
Attempted a multi-meter test today and didn't get very far.
View 1 Replies
Advertisement
I have a 2007 f150 sport. I am getting a 24 code on the airbag light and I do know that is Sensor output feed/return circuit open. What I do not know is where is this sensor located and what could it mean if I am getting the code...
View 2 Replies
"VSC OFF" light came on the other day. I took my RX350 to the dealer. The dealer said Heater Element sensor is bad. They didnot have this part in stock. I googled this part. Nothing comes up under that search. I took it to Autozone and the code came up as Mass Air flow sensor. Are both of these same thing?
View 7 Replies
I just acquired a wonderful 2005 F-150 XLT 4.6 liter truck. I need to get it passable for smog check here in AZ and the failed test revealed a P0453 error code (EVAP) which translates to a possible pressure sensor malfunction.
My question is finding the sensor and if I am looking at dropping the fuel tank to service/replace the sensor. Also, could a vacuum line be the cause?
View 7 Replies
I have a 06 F150 and I am getting the P2207 code on it. Sounds like a O2 sensor has gone bad. From reading a little about it online, it sounds like there are (3) different ones on the truck. Is there any way of knowing which one has gone bad or do you just have to replace all of them? How hard of a job is it, do you need a special tool to remove the old sensor?
View 1 Replies
So I am trying to learn how to use the forscan program. I find that it detected an open circut for th deleted intake heater, which I expected. It also found :
===ECS DTC B1230===
Code: B1230 - Driver Safety belt Retractor Low or High Resistance on Squib
Module: Electronic Crash Sensor
Diagnostic Trouble Code details
Driver Safety belt Retractor Low or High Resistance on Squib
So that answers the the question about the intermittent airbag/ seat-belt lamp. How to solve this problem? BTW- This is a E350 SD Van ....
View 1 Replies
My wife's 06 expedition 5.43v runs rough loud and dies. Not all the time just when it's to hot. I got a code it's p0022 cam sensor. I changed both started the rig up and heard loud rattling like metal maybe chain. It lasted for a the length of my video 1.4mins give or take then went fine, i turned the car off and back on everything seems fine. I know I got her oil done after driving. She had metal/plastic in her oil. I had all plugs done and actually i re did the 8th cylinder plug because it was miss firing and i pulled it by hand with only the socket no ratchet. I'm thinking the chain is going bad if not already bad. Only 113k miles my 04 f150 5.43v lasted 250k before motor swap...
View 7 Replies
2004 f-150. When I put the light switch in "auto" position and it gets dark, only the parking lights come on. The headlights do not come on. The headlights work when I put the switch in the "on" position, however. This makes no sense to me.
View 1 Replies
I have a 2008 Camry Hybrid and recently got a "Check VSC System" warning light. A diagnostic resulted in a C0210 error code. The code is for a right rear speed sensor malfunction.
I had a local shop look at it and he replaced the hub accembly including the speed sensor. It didnt work. He and I took a ride and on his diagnostic tool, the speed reading for the right rear wheel was all over the place.
The next day he replaced it thinking that the new sensor was bad. This worked, however only for a day. Now the light had come on again with the same error.
View 2 Replies
So I swapped in a new cluster fx4 to stx to get my airbag light to work. It now works but flashes code 25. Is code 25 the passenger airbag deactivation switch?
View 2 Replies
A couple of days ago my emissions light came on in my truck and the P0054 is the code I get when I scan it. Did a little research online and it looks like it could possibly be a 02 sensor issue. Truck seems to be running fine.. I have a 06 F150 with a 5.4L.....
View 1 Replies
I have engine light on and the code is PO446. just changed fuel filter on my 2006 5.4L f150. What the code means ?
View 1 Replies
So the check engine light came up on my truck and I scanned it to find P0021 which is Intake camshaft over advance or VCT solenoid stuck open. I really doubt my truck skipped timing and all the research I've found had it linked with other codes requiring cam phasers. The truck is a 2008 F150XL with the 5.4 Triton with 90k on it
View 1 Replies
Well, truck did it again last night. Shut down to idle, wrench light came on. My Edge Insight showed P2104, Throttle Actuator Control System-Forced Idle. This is the third time it's done it over several months. Took it to Ford again, they didn't find anything. First time they replaced the throttle control unit. He's talking about RF interference but ignition & alternator checked ok. Each time it's done it has been in the same place, Sacramento Raceway. This is getting ridiculous, can't just drive it & show them because it's only done it over several months period.
View 14 Replies
Intermittently, the parking brake/ABS light comes on with no pattern I can put my finger on. Some times its on when I start it and stays on the entire time I drive it. Some times its off when I start it and then comes on while I'm driving it. This morning I took it by Advance auto and had them check for codes while the light was on: C1342 - ABS control module. I can't find a lot of information about this code or what can be done to fix it other than taking it to a dealer. Any alternative solution, perhaps re-seating the connectors to the module - and where the heck is the module and what does it look like?
View 1 Replies
I have a 2006 F-150 with the 5.4L. I got the check engine light and the computer says catalyst deficiency bank 2. So I assume the passenger side converter is blocked. Is there anyway to either take out the cat and replace with a piece of straight pipe and bypass the o2 sensors or take the cat out of the housing and put the housing in and then bypass the o2 sensors.
View 14 Replies
I just started to have this problem yesterday. Engine light comes on and stays on. Engine shakes and truck won't go over 50 MPH. Autozone code checker came up with P0171.
Truck has about 95K miles and I had the spark plugs replaced at 75K miles.
Transmission was rebuilt at around that time also.
I only drove it to Autozone and back today to post the code and see what everyone's opinion is as to what's wrong.
Here's what the printout says : P0171 "Fuel Trim Bank One Condition"
View 6 Replies
I just got an Egde Evo which I installed and everything looked great. After a few runs, I noticed the ABS light coming on an soon after that my transmission goes to limp mode (the wrench lights up).
I receive the DTC error: P2106 on the Edge Evo.
I have gone back to Factory default, but it keeps coming back, ie. the ABS light lights up and the Trans goes to Forced Limited Power (according to the Evo).
View 6 Replies
Had the check engine light in the 2005 F150 (90,000 miles) come on. Got the code checked and its P0420. I know that has to do with the cat threshold levels etc. so I believe I am looking to replace the o2 sensor, if I am not mistaken.
How hard of a job is this? Ive done a decent amount of engine work and worked in a shop in high school. Just looking to see if that is the right thing to try first, replacing the sensor, before replacing the cat.
Also I know its the right bank, but if I am not mistaken there is a before and after the cat o2 sensor, which do i replace? Both?
View 3 Replies
I keep getting a lean bank code. I have cleaned tb and replaced one of the rubber lines. It only comes on when I take a good ride with the truck. Not sure what else it could be. I'm thinking O2 sensor maybe.
2008 F-350 5.4 3V. 65k miles
View 9 Replies
I am running a 2008 Ford F-250 with the DPF Delete and the Mini Maxx Tunner. I have replaced the ECT (Engine Coolant Temp Sensor) as well as the EGR Valve and housing troubleshooting this issue. Both the Engine light and the coolant icon come on when I turn on the vehicle. I am getting a P0117 Engine Coolant Temperature Circuit Low code on the Mini Maxx.
From a cold start with codes cleared if I turn the engine to ON even without starting the engine the Engine codes will come on and the the Mini Maxx will read engine coolant temp 302 and will go into Defueling Mode. I have repeatedly tried removing and reattaching the connector to the ECT thinking it could be loose connection. I can't drive the truck because there is no power and i know the engine is not hot because I have let it sit all night before doing these tests. I do not have a scanner to test other than the Mini Maxx. Other notes: I have checked Coolant I have checked Oil
View 3 Replies
