Ford F-150 (2004-2008) :: 2007 - Whirring / Bearing Type Noise On First Start Up When Cold And Truck Sits Overnight
Mar 10, 2011
Ok, so my 2007 F150 Lariat super crew cab has been at the dealership for a week now with them claiming that a part is on back order. How hard is it for them to get in a right front axle?? Granted, it was in there for other stuff too (which they can not give me a straight answer on if they fixed or not cause they are claiming the technician hasn't done the write up on it yet). My main concern is that they are screwing me around or that something happened to my truck. I am planning on stopping by there on Wed. morning after I get out of work.
Are these trucks known for bad front axles or was there some kind of a big recall on them?
Other things it went in for was the radio having the CD's cycle through when you first start up the truck, but does not happen like that all the time. Black plastic driver side front door hinge is cracked exposing the metal reinforcing part. Whirring/bearing type noise when you first start up the truck when it is cold and sits overnight (which they claim they can't hear yet waited to bring the truck inside and check it out at 3PM when they had the truck overnight from the night before when I dropped it off.) and the front driveshaft not fully disengaging when the truck is in 2wd. Almost seems like the vacuum locking hubs are still engaged.
View 8 Replies
Advertisement
I just bought 2011 Camry 2.5 6auto with 57k miles on it. The car make a rattle noise for a second or so on a cold start when sets overnight. I took it to the dealer yesterday and they replaced the timing gear assembly under warranty. This morning when I started the car in the morning it made the same rattle noise. I am going to take it back to the dealer next week.
My question is has any one had this rattle noise? if so, did the noise go away after the dealer replaced the cam gear? Also, Do you think this rattle will affect the engine in the long term?
View 11 Replies
My wife's SF with 30K miles has developed a coolant leak after it sits over night. It rest on the concrete behind the oil pan. Its only 4 to 5 drops but any coolant leak is not good. I looked around and it looks like there may be moisture down below where top oil filter is(top back of engine). Crap, I hope its not a HD gasket. Are there any coolant hoses that run on top of the engine behind the oil filter? Hopefully its just a hose. I am going to try and set up an appointment at the dealership for early next week.
View 10 Replies
I own a 2006 Chev Cobalt with 133000 kms (yes I'm Canadian). About 6 months ago after the car sat over night in the rain, it would not start that morning. It would turn over and cough and sputter for afew seconds but not stay running. I had it towed to my garage. The car sat there for a while and when the mechanic got in, it started no problem. The mechanic tried hosing down the entire area under the hood to get the car to act up, but that didn't do anything. I took the car home and we all chalked it up as a fluk. Then a week later , after an over night in the rain, it did it again. Towed to the garage and it fixed itself by the time the mechanic got to it. This happened 3 more time.
CAA sprayed all the ignition parts with something like WD40, they even got a hold of another coil pak that I could borrow to see it that would solve the problem.... it didn't. They put it on a code reader and it read " Camshaft positioning (CMP) sensor circuit". But they ( my mechanic) told me that they just didn't know what to do next. They recommend another mechanic, but I haven't gone yet because I'm afraid that they will look at my car as a "cash cow". For now, to avoid this problem, when I know it's going to rain, I plug in the block heater, and put a desk lamp with a 40 watt bulb under the hood, then bungy down a tarp over the hood after I close it. I would like to point out that if I go to work and the car gets rained on all day (9-5) it will still start. It seems like the car has to soak in the moisture first.
View 4 Replies
My 2007 Civic Hybrid is having trouble starting. This happens when it's cold out, it's been sitting outside overnight (I don't have a garage), and the IMA battery is low. I've taken it to the dealership but they were not surprisingly no luck. The car has about 65,000 miles and a new battery - the one in front - was put in not too long ago and tests fine.
View 5 Replies
I have a rear wheel bearing type of noise that appears to come from the rear. My vehicle is front wheel drive and has 135K miles.
I checked the rear wheel bearing/hub assys on both sides and they had no play but I changed them anyway. Noise did not change at all. Rear tires have normal wear, no cupping or anything. Noise gets louder with increasing speed up to a point and then remains a constant level.
My next thought is to check the front wheel bearings/cv joints.
View 6 Replies
Ok noticed this a few times recently. On the first start up of the day, sometimes it sounds like something "rattles" in the engine before it comes tight? This only happens when I first start the truck from sitting overnight, if I run to the store, or at lunch go out, etc, it starts normally. I did have one of the pulleys replaced this past summer, it was making a whining noise so maybe the new belt they installed is loose? I know it could be any number of things.
04 5.4 with about 87k miles...
View 14 Replies
I have a 2007 F-150 5.4l that does not crank when you turn the key to start. I have tried jumping the starter over and it does crank after that but it will not start. I am completely stumped by this and I'm not sure what the problem is?
View 2 Replies
I have a 2007 F-150 5.4L V3 Lariat with 90,000 miles on it. For about 5-6 months now I have noticed a strong sputtering when I am driving at low RPM's around the 44-50 mph range. When I lightly give it gas the sputtering begins and doesn't cease until I accelerate out of the current gear into a higher RPM/speed. This has become more pronounced over the last few weeks so my mechanic replaced the fuel flter and checked to make sure the pump was working as well. We also added some 5w-30 oil to make it full, even though 5-20 is preferred.
Truck ran smooth initially but then it got worse with the sputtering. A couple of days later I filled up my gas tank and as I pulled out of the station my truck shuttered alot and died. the CEL came on, LOP came on, and even the low tire pressure light came on. The truck will not start now, but it cranks smooth and strong until the battery loses power. I had the truck towed and then we reset the gas shut of toggle, sprayed starting fluid in the air intake, and checked all fuses, as well as the fuel pump engagement. Still no ignition. Next we replaced all spark plugs(4.5 hours later). Still no ignition. Only CEL light and low tire pressure light. I bought it used less than 18 months ago?
View 2 Replies
My 07 F-150 5.4 has a rough idle during a cold start for about 1 minute. It happens mostly when the weather is chilly or cold. Also after the first start it doesn't do it the rest of the day. Of coarse they can't find anything wrong and tell me there are no updates for anything like that.
View 3 Replies
2006 Ford Focus with an ongoing wheel bearing issue. Earlier this year I heard a repetitive whirring noise from the back right, figured it was a bearing, brought the car in for repair. The shop confirmed and replaced the bearing.
3 months later, I heard the same noise. I brought the car to a different shop (I had moved since) and they confirmed that it was the same wheel bearing that had just been replaced. They said it may have been faulty. They attempted to repair it, but the noise persisted. They actually ended up putting the new bearing on the driver's side rear and swapping out the old bearing that was on the driver's side with old one on the passenger's, which is the only way they could get the noise to stop entirely. (This confused me)
Fast forward two months and the noise is back on the same side - passenger's rear. The shop is telling me that it is unrelated since the new bearing was technically put on the other side, however, I am thinking that the same thing keeps happening whenever any bearing is put in the same spot (passenger rear). My question is as follows - what could be happening in the passenger rear that would cause bearings to continually fail?
View 1 Replies
I have a 2006 screw with the 5.4 and I get a hissing type noise from the A/C. It cycles every 7 seconds and sounds like it's coming from the far passenger vent area. It sounds like it's recharging itself or something. I've taken it into the dealer and the first time they said it was the vacuum driven system then the second time they said it was the freon recharging itself. Is every 7 seconds a little to often? It seems to get louder the longer I drive. Needless to say after a four hour trip to the beach hearing this hissing every 7 seconds drives me crazy. It will hiss then stop for seven seconds then hiss again.
View 14 Replies
I have a 2001 F350 with a 7.3 diesel and automatic trans. I purchased it about 100,000 miles ago. It is all stock as far as I know. The mileage on it was about 14-15 on the road and I decided to put a chip in it. I was somewhat leary of putting too much power to this old of a rig. I put a TS Performance chip in it. It seems to have more power. I am towing a 30 ft. Gulfstream Seahawk I think around 10,000 lbs. When I started up a hill it made a different noise like a screeching noise when I pushed it. When I back off a bit the noise goes away. When I put it back to stock setting the noise is not there just the normal downshift and increased RPM. Not sure how to describe the noise but sounds like a metal bearing type noise. I get the same rush of air or what ever that sound is when it changes back to a higher gear. Is this sound normal or what might it be. It sounds normal when not pressing it.
View 6 Replies
My alarm started going off by itself and my truck would not start so we unhooked the horn but the alarm was still trying to go off making a ticking noise when the horn should have been honking. so we also unhooked the alarm. And it started right up. I've been driving it with those things off with no problem. But today it wouldn't start again and its making a ticking noise like the horn is trying to honk.
View 6 Replies
5.4. So I have a 2004 F-150 that just passed 80,000 miles and a month ago it started making a very loud noise on startup, but only cold startup, meaning if I haven't used the truck in about three hours. Now I went on youtube to research and found a video of a truck making the exact same noise! Here is the link:
2004 f150 cold start knocking noise - YouTube ....
Need to verify what this is??? Some people are saying cam phasers and some are saying I'll need a brand new engine!
View 2 Replies
I have an '05 FX4 with 5.4 and 55,000 miles. I've noticed that once in awhile when starting the truck after it has sat for at least a day I get a type of growling noise that lasts for a second or two. It usually happens shortly after the engine starts up and gets running, but it has also happened after it has run for a minute or two and then makes the noise when I give it some gas to take off. From inside the cab the sound seems like it is coming from the driverside firewall area, but on the rare occasion that I'm able to start the truck and jump out before it makes the sound it sounds like it is coming from underneath the center of the truck. It doesn't make the sound every time on a cold start and never makes it on subsequent starts. I drive truck during the week only drive my Ford on weekends and sometimes it goes longer without being started, but I don't know if this has anything to do with it.
I thought it was a shield vibrating or something but have also heard that the VCT parts can make a rattling sound on a cold start also and this has me a little worried. This sound seems more like a fast growl than a rattle, but it happens so fast it's over before I can really register what it is. One time it made the sound twice, once after startup and again after it had idled a minute or two, thats when it seemed like it came from under the center of the truck. The engine has had a slight cam phaser knock since new, but it is so quiet that it can only be heard if you're inside a building or next to a wall and roll the window down.
Also, I change the oil every 2500-3000miles and only use Motorcraft 5w20 and a 820S filter, and generally baby the truck. What this could be. The truck runs great all the time, I just get this noise occasionally after cold start.
View 8 Replies
2002 4.6L 75K Miles ... Truck has hard time starting if it sits for a few days. Recently had the fuel filter (under driver's door) replaced for first time, and mechanic said it was clogged (?). He also checked fuel pump pressure and said it was good (about 40 lbs). Truck starts OK if used every day. Battery seems OK, as starter turn engine fine. Seems that there's a fuel problem.
View 4 Replies
I have an 08 F-150 5.4. When sitting still or moving, and turning the steering wheel to the right and only the right past center, there is a popping type noise somewhat like a screw driver down a washboard (for those who'll know what that is). I replaced the ball joints because I saw a slight amount of play, but the noise is still there.
View 12 Replies
I recently bought a 2005 f150 fx4. With about 125000 on it. It started this noise coming from the passenger side. Does it while driving only. It sounds just like the casting noise on a fishing rod. What this could be. Not sure which tire its coming from. Maybe breaks? Doesn't change when breaks are applied though.
View 11 Replies
The problem is it is hard to start after the truck has been parked overnight. It turns over ok but seems to take a long time to start. After it has ran, restart is normal, it fires right up. My ranger is a 2001(4.0 liter V6) and the problem is also with my daughter's 2006 (3.6 liter V6). I have tried a new fuel filter but no change. If I turn the key to the on position without starting it for a few seconds and then try to start it the engine starts sooner but still a little longer than normal.
View 8 Replies
2000 2WD 4.6L ... I was trouble shooting why the truck will not start after it has run for awhile then sits for about an hour. I was checking the connections on the solenoid switch on the fire wall when my wrench slipped and touched both terminals on the solenoid and the engine starter kicked in. I tightened the connection then tried to start the truck with no luck. so I tried leaving the key in the "ON" position and jumped the two terminals and the truck started. Does this tell me I have a bad solenoid switch?
View 6 Replies
