I have a 2007 F150 King Ranch Super Crew 5.4 3v and it makes a ticking sound. I have read about the VCT solenoids and the phasers. My issue is that the ticking noise can be heard at Highway speeds. At it seems to be quicker as the engine speed increase. Not sure what to think. No rough idle. What could this be.
View 3 RepliesFirst, details about my truck. 2007 F150 SuperCrew, 2wd, 5.4, 203,xxx miles on it, leveled with Hell Bent Steel 2.5" kit last year, has been aligned professionally since then, tires are good and balanced.
The issue I have is a vibration, kind of the same feeling when driving on a road surface that has had the top level of asphalt removed before it's resurfaced. It's mostly noticable at highway speeds. Its not a violent type vibration, but you can feel it. There is also a sound, similar to tires with a deep off road type tread.
The sound and vibration more noticeable when making lane changes or when wheel turned towards left, at highway speeds, not as much to the right. I've checked front wheel bearings, they are good, zero play, no loose suspension parts, u-joints are good, no leaks anywhere.
Since it makes the noise and vibration a bit more when moving wheel, could it be a power steering pump? The pump is the original.
The front driver's side wheel of my 2007 Ext. Cab makes a speed-related "ticking" sound. It's usually audible but not always there. I look for rocks in the tread of my BFG All-Terrains and sometimes I find some, sometimes not. The noise seems to be independent although some of the rocks really get up in there. Sometimes its really loud and it sounds like a rock. Bearing? 4WD CV or U-Joints or whatever?
View 6 Replies06' 5.4 screw 100K... At 55mph my truck just stopped running, I pulled over to the side of the road and after two trys the truck restarted but ran rough. Auto Zone pulled a code that said replace the throttle position sensor, I did and the same thing happened again two weeks later just as before.
View 3 Replies5.4L... My truck has a momentary moan / growl / bog down issue. It happens at town and highway speeds and usually when I have cruise on OR when I lightly apply the gas peddle. It moans for a few seconds and seems to bog down then comes out of it and carry's on its way. You can hear it plainly while driving even with radio on. I have a regular muffler on the truck but when this happens, it makes it sound like I have a catback on it.
Things i have done...
- New air filter
- New oil/filter
- New fuel filter
- Ran techron injector cleaner through tank of gas
I have an '05 F150 5.4L with 110k miles on it. Bought it used about 2-3 years ago and have had on-going ignition system problems. The current problem is a significant shudder/shake/vibration that occurs when driving 50mph+ (easy to reproduce around 65-70) on the freeway, when starting up a minor, but noticeable incline. This is an incline that doesn't require much additional throttle, and this trouble occurs with cruise control on and off. the truck starts shuddering pretty rough during the incline. However, if I release the accelerator (and go up incline with slightly lower speed) or give lots of gas on accelerator the shudder usually stops. The shudder always clears after the incline when returning to flat road and just cruising.
This occurred on a recent trip a few times and I pulled the following codes (in order):
P0356 (once) : Ignition Coil F (6) Primary/Secondary Circuit Malfunction
P0302 (recurring): misfire on cylinder 2
I have since purchased and replaced the coil on #2. This did not resolve the problem. I have replaced coil on #6 in the last year...
Because I saw a suggestion somewhere on the net around this problem while searching, that this could be related to OD, I tried disabling OD and enabled OD on an incline today to test after replacing COP on #2 and it seemed to resolve the issue to turn OD off. Not sure if related...?
Other observation: Cab of truck often smells of gas just after starting the truck. Mentioned this to the shop, but they didn't find anything obvious.
Short history of codes and work that has been done:
Sometime in early 2011: Ford service dept did this work.
First failure was coil bad on #7. Tech swapped 7 & 8 to verify the problem followed the coil. Then when the problem DID follow the coil, he replaced #8 with new.
05/2011 MacKenzie Ford changed all plugs
12/2011 - swapped out COP on #7.
02/2012 - P0306 - Now, COP #6 is reported as bad.
November/December 2012
P2104 P Throttle Actuator Control (TAC) - Forced Idle
P2112 P TAC Stuck Close
P2111 TAC Stuck Open
I did throttle body clean - removed it and used TB cleaner. replaced...
Late December 2012 - while driving on freeway at speeds 50+, but easily reproduced around 60 after starting up a slight incline. symptom is heavy shudder/shake. Possibly resolved by turning OD off.
P0356 (once) : Ignition Coil F (6) Primary/Secondary Circuit Malfunction
P0302 (recurring) : Misfire on cylinder 2
2006' screw, 5.4L, 116K miles ... The truck looses power at highway speeds to the point that I need to pull off of the road. When this happens the check engine light is on and the truck is still running but will not accelerate, is it possible the computer is going into limp mode and if so what would cause this?
View 1 RepliesSo my 07 with 125k miles has had new rotors for about 50k miles or so, but for a while now when the brakes get hot it gets a violent shudder on braking at highway speeds....the odd part to me is nothing at lower speeds, and not always at higher speeds....do I just have warped rotors again? The rest of the front end I good and tight....
View 9 RepliesI am 98% sure my 17" chrome clad wheels are making a clicking or ticking sound as I drive. I took off the plastic center cap and the noise changed.. it's less than constant now.
View 3 RepliesI have a 04 f150 fx4 with the 5.4 v8. My truck has a tick to it. It does it all the time, hot, cold, at idle, and while driving. I thought it was a cam phaser but I've been hearing people say bad cam phasers make the engine sound like a diesel engine. My does not sound like a diesel it just makes a ticking sound, my dad says it sounds like a 350 with a rod knocking, however now that it doesn't sound like a diesel I am wondering if it could be the vct.
View 2 RepliesStarted my truck (2007 EB 4x4, 5.4) this morning with my daughter in her car seat behind me, we get about 1/4 mile down the street and all of a sudden I notice myself moving!
My daughter starts freaking out, I pull over and my seat is still moving. I end up COMPLETELY reclined, all the way down and all the way back. The seat pinned my daughter in her seat, she's flipping out...I had to unbuckle her car seat while she's screaming because her legs are pinned and have to slide her car seat out sideways with her in it.
Seat does NOT move at all.
Now, before all of this I had heard a "ticking" sound coming from inside my seat, been doing it for months but since everything worked and not dummy lights came on I just ignored it. Apparently, this was not a good idea because now it is not ticking and the seat is not working....
I just bought this truck yesterday. During the test drive and everything it seemed all fine. After all the paperwork and the truck was actually mine. I noticed once it is all warmed up it seems to have a slight knock/tick? and a slight miss to it. I shot a couple videos, one up underneath where it sounds like most of the noise is coming from. Could it be an exhaust leak? Or is it something internal? Like the Cam Phasers, or a rod or something!
Here is a video around the exhaust area.
Here is up underneath the truck.
Ok, So, Im 40 miles from home stuck in ice and snow in a hotel.. (my wife works close by- thought it would be safer than driving in the 10 inches of snow we got 3 days in a row) so, I go to pick her up tonight and I engage 4hi.. I hear the click and the light comes on.. but no clunk of the hubs locking.. I drop it in 4 lo.. it shifts in low.. but the hubs are not locking..
I hear a ticking sound as I drive and when I put it in 2wd it goes away. I turn off the truck, turn the wheel hard both ways .. get out and I can physically turn the drive shaft and I hear the ticking in the hubs. If I read correctly when the truck is off these should be locked?
is it possible the vacuum is not releasing? I also get the groaning when I start up of the air diverter.. that im told is operated by vacuum.. so I am guessing I have a vacuum problem??
07 f150 screw 5.4 104+ miles, loss of power and ticking noise (sounds like no oil)on passengers side, no engine light, no codes, ford dealer changed coil packs and plugs, inspected valve gear on passengers side and nothing seemed out of spec, no broken springs, followers, lifters, manifolds on both sides have been replaced very recently.
The ticking noise began about a week after an oil change, truck runs fine but no power/sluggish. exhaust is magnaflow side exit and seems to be louder inside the cab than usual or could be just me.
Truck had a miss that i was trying to find prior to oil change and ticking noise. it ran well for a week with the tick before (and miss) the loss of power which started after a 30 min drive under load up hill. it almost felt and sounded as if the muffler was dragging on the road for about 100 feet, ran fine for two miles until it was shutdown. restarted fine but flat when you get into it.
Clogged cat/cats; internal damage to muffler, oil issue even tho the gauge reads fine.
I have a question about my 2007 F150 4x4 with the 5.4L. It has a ticking noise sound coming from somewhere around the motor, but it's not there till the motor has warmed up. It almost sounds like a exhaust leak, but I'm not sure. What it might be, or what to look for?
View 11 RepliesI have a 2007 F150 (2wd) with 80k. My truck recently was vibrating under braking so i took it to my mechanic to have the brakes fixed. All the rotors needed to be replaced. In doing so, the front rotors were changed out with the kit that converts the front rotor/bearing assembly into two separate pieces to cut down on maintenance costs in the future. With this being said, after getting this work done, the truck didn't vibrate anymore... that is until i got it out on the highway. Now the truck vibrates from about 45-50 and 70-80 pretty bad. The steering wheel shakes back and forth too. I have gotten the tires balanced in hopes to fix this problem which it didnt. What could this problem be?
View 4 RepliesOn my 07' I bought it home mid AUG. It has been getting much worse to a point there is a rear driveline vibration at all speeds above 40 and up to 70. I used to change intensity whether you are on or off the gas, and would almost vanish if in neutral. However now it is all the time.
I cannot feel any play on the u-joints, the yoke has a little play in the xfer case but is is normal like on most other trucks I have owned, and the pinion flange is nice and tight. Could this be **tight** ujoints or the driveshaft itself? It looks rusty, but there are no dents on it.
We have 3 company work trucks. They are F150's 2WD V6 - one is a 2008 and two are 2007s. They have all had thrust bearing problems. We just had the #9 thrust bearing replaced in the 2008 for the third time. The trans hasn't failed but starts making a whining sound at all speeds which varies in pitch relative to speed. The 2008 has had it replaced at: 40K, 60K, and now 70K. One 2007 had it replaced at 60K and 90K. The other 2007 had it replaced at 50K.
Our dealership says they've never seen anything like it & that our trucks are the only ones they've seen this on. They are suggesting it's happening due to driving behaviors. All 3 trucks have a single driver and aren't switched or shared. The 2008 doesn't carry or tow. The 2007s both carry hundreds of pounds of tools daily. This just seems like too much of a coincidence to be driver induced and that we're the only ones with these issues.
My 2008 Ford Focus SE hesitates at highway speeds, seems to decelerate and accelerate, sometimes more, sometime less and sometime not at all. dosn't seem to affect the acceleration.
View 1 RepliesStill showing the same codes (per repairman) and still having the intermittent rough idle at low speeds when the engine is warm. It has been so intermittent that I could almost live with it.
So repair guys first replaces the VCT's and runs fine until warmed up and the problem reoccurs with the same codes. He replaces both cam phasers and tensioners today and still same problem and same codes which point to the VCT and cam phasers.
Truck has 80k, city driven, oil changed every 3k or so. Burns ethanol and still runs great at speeds over 10 mph even when this problem appears.
2007 Ford Fx4 with 6 inch suspension lift. Just rebuilt front suspension. I Had bad upper ball joints and one of the hubs was bad. Also had a bad tie rod end on one side. The tires began to wear excessively on the inside and quickly degraded.
I figured since I was in there, I would just change everything. I replaced upper control arms, lower ball joints, stabilizer bar links, strut assemblies, and inner and outer tie rods on both sides. Obviously everything is much better. But...
On test driving and running short errands near the house, it seems like I can still sense a slight thumping/clunking or bounce from the right side at slow speeds at times. It is hard to describe because there isn't really a sound associated with it. It is not constant; it feels a bit like a ball joint just starting to go. I cannot identify it with any of the new parts, they all check out and nuts are tight, etc.
I have not gotten an alignment yet. Getting new tires and alignment Saturday. Tires are in pretty bad shape. But, alignment isn't too badly off and at slow speeds around the neighborhood its more of a bouncing after a road seam or when accelerating from a stop, etc.
when I was doing the work, one of the half shafts had more play than the other. It was easier to move out of the way to install the shocks and lower ball joints. I could easily bend it over past the stabilizer bar link and use the link to hold it out of the way. Is this normal? I have never owned a vehicle with IFS and CVs before. Could the bouncing/clunking be caused by a worn CV joint, even in 2wd?