Ford F-150 (2004-2008) :: 2007 - Stuttering When Press The Accelerator While Going Uphill
Aug 28, 2016
Have a problem with a stutter when I press the accelerator while going up hill. I even had this problem driving on a flat road but that was a 1 time thing and happens every time I go up hill. Had a coil replaced that came off of an '04 because one of mine went bad which caused it to shake whenever I came to a stop. Wondering if the coil has anything to do with it... 2007 5.4L ....
View 1 Replies
Advertisement
I have a 2004 F150 4.6L... There is a slight hissing sound under the dash on the drivers side when you lightly press the accelerator and then stops. No matter what speed you are going as soon as you apply the accelerator it hisses then stops. There is also the same hissing , only louder when the engine is cut off. It hisses for about 3 seconds. What could be causing this. It has been idling rough since the hissing started. The check engine light is on and showing P0420 and P0430 codes . The cats were replaced with resonators so I believe that is the reason for the codes.
View 2 Replies
2007 with 85000 miles. This noise appeaser only between 64 to 69 miles/hours, either manually pressing pedal or when crus control is on. A/C on or off. Noise goes away as soon as i let off the gas pedal. the noise is not very load it sounds like, when mechanical fuel pump stars going bad.
View 5 Replies
My wife and I have a 2004 F-150 5.4 L SCrew 2WD which is stuttering sporadically when we drive it. It will run fine and then suddenly when you increase pressure on the peddle, it will occasionally (one or twice per 30 min or more trip) hesitate. At first I was thinking it was a fuel problem, and now I am inclined to think it is a transmission problem. It causes jerking (feeling of loss of power) and then quickly goes away.
No codes show up in the computer and no lights come on in the dash. Miraculously when service drives it at the local dealer, they state that they don't find anything. We also feel the truck shifts hard since the last PCM update (the dealer states that it has the most recent PCM update). The condition has worsened and we are nearing our original MFW expiration at 36,000. We did purchase the prem extended warranty however. We recently talked the service manager into putting the in-flight computer in it, and I need to take it back today or tomorrow to have it removed.
View 14 Replies
Today my Windstar would not start, it only start if I press on the accelerator if I let go it will die, I'm thinking of gas pump?
View 2 Replies
Ford F-150, 1994 : intermittent problem. going down highway, foot on the gas. At times, will press accelerator to go faster but nothing happens, like clog somewhere. Sometimes, with foot still on gas, i will hear a popping sound coming from under the truck, (under the engine?, or drivers seat). Usually 4-5 pops, sometimes none. But after each pop, car accelerates slightly, as if it is a slight clearing, until finally, as if some clog was opened up, the car plunges forward, so i then take my foot off the gas. Sounds like either problem with fuel getting to the engine or a problem with the exhaust.
View 4 Replies
When I press slightly on the accelerator just to get the truck moving and than let off the engine stays at the higher RPM typically just over a 1000. This only happens in drive not reverse and everytime I just slightly step on the accelerator. The truck only has 1K miles on it.
View 14 Replies
Reprogram remote to unlock all the doors with 1 press? I cant stand hitting the remote twice for all the doors..
I reprogrammed my Jeep to do this but I can figure out how the sequence that works for the Truck....
View 14 Replies
I have an '04 f150 4x4 5.4L lariat new body style, I purchased it a few months ago. (I had an '03 f150 4x4 5.4L lariat that I am comparing the new one to) It seems like this 04 doesnt want to get up and go,(like the '03 did) best way to describe it is like having a potato stuck in the tail pipe. then after driving it for a few weeks I got CEL I think it was P0140, the day I was going to change bank 1&2 sensors 2, the code went away. So I didn't change them.
I instead opted to change the plugs (all plugs came out fine) now I notice a fuel smell when I let off the accelerator,(not sure if I smelled it before) its like a boat exhaust smell- not a raw fuel smell. I am wondering if all these things add up to a clogged or partially clogged cat or just a bad o2 sensor, I dont to spent $100+ for the rear two o2 sensors and still have the same problems, nor do I want to replace the cats and find out it was the o2 sensors all along. when I smell it in the cab, I do not smell it anywhere else, like: under the hood, or any where else under the truck, nor do I see a leak under the truck.
View 9 Replies
2001 f250 7.3L, 289,000 miles, changed the IPR and ICP, noticed the EBP tube was in two pieces. Would this cause the rough idle and shaking? IT started running rough and would die after a mile or two. Would have to wait 30 minutes before it would start again. That is when a buddy told me to change the IPR and ICP the ICP plug was covered in oil as well as the top of the ICP. So I changed the wiring plug as well. I originally cleaned and changed O-rings on IPR but then it wouldn't start, bought a new IPR and started but runs rough. I just started it with EBP tube removed and sensor unplugged. Idling rough when I press accelerator and RPM go above 2K it levels off pouring black smoke everywhere.
View 3 Replies
i own a 2005 f150 supercrew fx4. Today as I was attempting to go out of town I was accelerating up hill and heard a noise, sounded like air coming through a window seal or scratching, which is not the problem. The noise only came on when i increased the acceleration, there is no power loss, the truck still accelerated properly and had good power, just that the noise came on. so i returned home only to hear the problem on flat land also, when pressing the gas to accelerate. The truck seems to idle fine and have no problem with low acceleration.
View 2 Replies
I've been noticing over the past couple years that sometimes when I accelerate, there's a slight delay between the time I press my foot down on the pedal and when acceleration actually happens. From reading other threads it would seem that the most common fix is to re-flash the ECU. I bought a DiabloSport Predator tuner along with a CAI a while back to improve performance/gas mileage and I was wondering if there's a way I can use the tuner to re-flash.
If not, do most ford repair shops already carry these? I don't want to buy a flash programmer. Also, if the shop does carry this type of an item, what is the average cost to get it re-flashed?
I own an '04 F150 XLT 5.4l.
View 1 Replies
When I'm on the highway around 60 mph I get a whistling whining vibration sound. if I accelerate or ease off the accelerator it stops, but when I get back to around that speed it comes back. What this could be?
View 9 Replies
I have a 2001 Ford Excursion Limited 7.3l with 199,980 miles on it.
It has a TS-6. My first problem is that when I come to a stop or slow down to a crawl then press the accelerator the engine stalls and dies. I have looked and looked at threads and can not find this example anywhere. There is no pressing the pedal and it remains at idle. It dies, shuts off, quiets. I have thought icp, tps, ivs
Second problem is that a/c is blowing hot. Other than being out of Freon, what could be other things to check. It does sometime go to default, but has done so in awhile. It does not blow cold in rear and hot in front. They both blow hot. I have replaced the pvh sensor.
View 1 Replies
My 2005 Santa fe has a single knock when you press the accelerator, then between 60 and 70mph there is now a shake in the steering wheel. I have been told it is probably the CV joint and just wanted more input.
View 2 Replies
I'm having an issue with my transmission. When driving it shifts just fine, but I have to let it accelerate slowly. If I press to hard on the accelerator pedal the engine ron races. So I ease up and it catches and slowly accelerates. For example going up hill, I press the accelerator and the car doesn't speed up, the engine races, so I have to just let the car slowly increase in speed by lightly pressing the gas pedal, no get up and go! Only occurs in 4th and 5th gears. What could be causing this. I have already flushed the gear oil as I had to replace the output shaft seal as it was leaking.
2000 Hyundai Accent 5 Speed Manual Transmission....
View 3 Replies
I have a 2008 XL 4.2 auto trans with 60,000 miles on it. We purchased a new travel trailer with a total weight just under 5000 lbs that we pulled for about 2000 miles this summer. On the last trip we noticed the truck was missing pretty bad going up hills or under load. After we got home I started to notice the miss at times even not towing. Did a tune up with Motocraft plus and wires and seems to still have a miss at an idle and very low RPM. What would be best to check next?? Would Coil be logical?
View 10 Replies
I have a 2006 Rav4 and every time I drive my car after it's been sitting for a while there is a very loud noise coming from the rear of the car, the noise usually lasts about 10 to 20 seconds and only happens when I press on the accelerator, and is always when I go forward, never in reverse. The noise is usually louder when it is humid or it is raining.
View 1 Replies
Had my .:R for 2 years now and just noticed other day. When you cruise in 2/3/4/5 gears about 3000 RPM and suddenly press accelerator 1/3 down RPM jump UP for a split second on tachometer. They go up by one segment (which is 200RPM) and then drop back down.
Now, DSG should not do that to my understanding as clutch pack is engaged! There should be no slip. Also, it is not a drive train shunt, as I kept the car in very slight acceleration.
View 5 Replies
2005 Ford F150 lariat 5.4
I had a misfire under a bit of a load (acceleration) and up hills. I changed spark plus with OEM Motor craft ones, truck ran super nice for a couple week.
Had the engine light flash, slow down and the RPM go up a tiny bit then back down and the light goes off
Now I'm back to miss fire different location, and a rough idle. I've swapped coil packs around and the miss fire stayed on cylinder 4.
Spark plug screwed or injector or ?????
View 14 Replies
Took it to the dealer today to have the seatbelt replaced, which they did. As I was leaving the lot I noticed the airbag light was still blinking so I went back. Tech brought out the OBDII and ran a scan. No errors. Went through all menus and cleared everything only to realize his OBDII had the wrong 'code card' in it. So he went and got the right card and came back, ran it again, still no errors. Went through all menus again and cleared everything including what he called an old error but not one related to the airbag. As he was walking away to go get his manager the light... just went off on it's own. (Think it was mad at the tech, NOW I know why.. then I didn't.)
On the way home, on the highway, in Texas, going uphill... the accelerator suddenly becomes unresponsive. The car starts slowing down, 65, 60, in a 70 where everyone passing me is doing 80... So, I goosed the gas, revved it over 4k and ... the gear shifted and the car sped up... WTF?! Now this car ONLY has 83k miles on it. It was mint. No problems AT all, ran smooth as butter until I let the dealer touch it. NOW, it drives like gramma's jalopy and I can't for the life of me figure out what the heck the seatbelt has to do with the other issue but THAT drastic of a change is NOT coincidence.
View 1 Replies