Ford F-150 (2004-2008) :: 2007 - Rattling While Accelerating At About 2500 RPMs
Aug 4, 2016
So I bought this 2007 used with 86K on the engine. After 2 days cats code went off and i had both replaced with brand new ones. Now my truck is making a rattling as i step on the gas at about 2500 rpms. Its sounds like metal in a can swirling around amd as i let off gas the sound stops. It happens often, also the other day in was pulling off and heard a grind for about 2 seconds then stopped never beard it again, it sounds like its coming from the rear passenger side. It sounds like a bearing. This is the noise.
IMG_4285.MOV ...
View 2 Replies
Advertisement
I recently purchased a 2013 elantra.
I have noticed that there is engine vibration and noise felt in car and pedal when accelerating at around 2500-3000 rpm's before it shifts. Is this normal behavior? It just does not seem as smooth as it should be. I have only put about 600 miles on the car.
It has been very cold, but it does not go away after warming up.
View 10 Replies
Well I am not sure if i have trans problem or not. If I put the trans in drive and go through the gears when the RPM's get to about 2000 the truck almost stops accelerating, until you give it much more gas, this happens in every gear. but If you push the button to take it out of overdrive and drive like that it doesn't do it.
View 1 Replies
I have a 2007 RX350 with about 243,000kms on it. I recently purchased this car and everything is great on it except one thing. As of late, I've begun to take notice that when I accelerate from a stand still (for example after stopping at a light/stop sign), a loud rattling/grinding starts and then as I pick up speed and change gears, it fades away. The sound is more rattling than grinding. As if there is a metal bowl with some smalls stones in it and someone is just shaking that. There is also another sub issue that I'm having. There seems to be a clicking noise every time I apply the brakes or even accelerate. The same clicking noise reoccurs every time I put the gear into drive from neutral. However, when I do that, there is only click as opposed to braking/accelerating, where there are many. I'm hoping this is all part of the same issue and not isolated issues.
View 1 Replies
i have a 2007 F150 Fx4, with 94,000 miles. When I hit the speed of around 40-45 and I step on the gas it starts to chug until I press harder down the it gets out and runs just fine. The thing that confuses me is it doesn't always do it. Id say about 3 times a week. I am replacing my fuel filter tomorrow. I purchased this truck with 85k on it, and this just started happening. The spark plugs have never been changed. And am thinking about taking it in to get those done too. I also tested all my injectors and they are all working. No codes have been thrown either.
View 6 Replies
,My '98 Honda Civic EX (manual 5-speed) is currently at 200,000 miles and makes a gargling/metallic rattling noise when I accelerate from low RPMs or whenever I'm climbing a hill. The noise sounds as if loose change is rattling around somewhere in the engine. I started noticing this a few years ago, when it was very slight and it only happened in second gear as I climbed a steep hill.
Over time, it started happening in third and fourth gear, and now it is in all gears when climbing a hill or when accelerating quickly on level ground. I also notice a lack of power when this noise is occurring. In the past, if I let off the accelerator just a little bit, or if I greatly increased on the gas, the noise would disappear. Now, increasing on the gas makes the sound worse.
View 4 Replies
Strange noise from what sounds like the suspension when I accelerate and then when I turn also. Truck was in Hawaii so that might have something to do with it. How do I get these noises to stop?
View 1 Replies
I just got this 2007 Mazda6 S Sport Value Edition for free from a family member. It has an automatic transmission.
While driving it in a parking lot I noticed that the car was make some kind of a rattling noise whenever I start accelerating slowly from around 1000ish rpms. After that the noise disappears. The first time hearing something like this was in a Prius I rented, though I don't think this affects performance at all. I am wondering if this is normal?
Also the car has being sitting unused for about a couple of months before I picked it up. I noticed immediately a burning smell after driving it, somewhere under the driver side, which makes me suspect if it has something to do with the transmission. I know very little about fixing cars of course but I also own a manual transmission car, and this smell kinda reminds me of a burning clutch.
The car drives great. The transmission seems to work fine. No slipping. Driving around those hills in San Francisco just fine.
View 2 Replies
2007 5.4 . Starts good , idles all day. As soon as you try to rev it, it stumbles rattles etc. Shut it off, wait a second, restart then Idles fine. I watched live Data and it carries on when the VVT solenoids become active (above 800 rpm).There duty cycle goes to 60-70 percent while revving. I think it Is just one side of the engine. Could be VVT solenoids sticking on? yes ? No?
View 3 Replies
I noticed the RPM's are higher than they used to be when accelerating slowly.
My car is an awd hybrid 600h with a CVT (110.000 miles) .. Do i have to check the transmission fluid? How?
Is my clutch or whatever it's called dying?
My car is still under warranty, but I'm not sure if wearable parts are included.
View 2 Replies
I have a 1998 Ford Escort which I drove about 450 miles in frigid weather over about 8 hours in mid January. After arriving at my neighborhood and getting off the expressway, I couldn't get the idle on the car (manual transmission) to go below 2500rpm's. Further, upon taking off, the car was trying to stall, and I was forced to feather the clutch through town driving and keep the throttle up so it wouldn't stall, even with the clutch in. The weather at the time was about -7 degrees (f). The next day the weather continued, and thee car would start, jump to the same idle for 10 seconds, then drop suddenly to 500rpm, then stall out. I wrote the car off, cleaned it out over the next week, and then I tried to run the radio while doing so last weekend. I got the car to start, and run normally. I think it may be a computer issue, but it may also be the temperatures. The car has 207,000 miles on it.
View 3 Replies
I have a 1996 Explorer XL 2 dr. It has the 4.0L OHV V6 and the 4R55E Transmission. I bought it used with 152,000 miles on the odometer. About a month after I bought it I noticed it sounded different. I looked down at the tach and the RPMs are up around 2500 with the overdrive engaged. I turned the overdrive off and nothing changed. I turned it back on and nothing changed.
That weekend I pulled the tranny pan and filter and replaced the filter and fluid. There was the normal amount of debris in the bottom of the pan but nothing major. Now when I drive it it tries to shift into overdrive but when it does the engine bogs down and the O/D off light starts flashing. I know how to do the overhaul but I wanted to get a few opinions before I start tearing into it. What could be wrong .
View 1 Replies
I have an 04 celica gt with around 168 k miles on it. Recently I have noticed a distinct metal on metal rattling noise whenever I accelerate at low speeds. It seems to be my exhaust as when I rev it up in park it makes the noise. But it doesn't ever make the noise when I'm on the expressway or cruising at back roads speeds. When I got under and looked at my exhaust everything looked normal?
View 3 Replies
I got an old 1989 F-150, manual, in-line 6 engine, with an 8-foot bed. I use it for hauling landscaping equipment, as i am starting a business. i will likely start hauling trailers with it this summer, but I also just want the engine to give me more power.
What are some things I could do to up the HP, or a better truck in general. I'm not looking to make it into a 350Hp monster, just get a little more out of it. What can I replace or add that would do this?
First, the idle dies on me when i put it in neutral, or gets stuck at 2500rpms. is this a vacuum leak, or the idle-air control valve?
View 9 Replies
-My pickup was parked and hit in the rear axle in January. I had to have the whole axle replaced as well as the leaf spring to frame mounts.
-I finally received the pickup back and now when the trans is in Drive it will not up-shift until the rpms reach 2500 and it is a hard shift.
-Also the speedo does not work now.
-Check engine light also came on with code P0500- vehicle speed sensor.
-I replaced the VSS at the transfercase and the ABS sensor in the rear differential with no change.
View 8 Replies
I bought a 2006 F-350 4WD Lariat SRW with a little over 200,000 miles on it. The truck seems to run perfectly, except when pulling a load (9,000-10,000 lbs) down the interstate/highway. Sometimes, when pulling above 65-70 mph for an extended period of time (45 minutes to an hour) the truck will all of a sudden idle down and won't get above 2300-2500 RPMs (even if you put it in neutral and floor it). It's not enough to shut it down, but it won't let the truck accelerate as fast as normal. Killing the truck and cranking it back makes it go back to running normal for a little while, but the periods of it acting up get shorter after each killing and restarting. I took it to the Ford place while it was acting up, and they thought it was a turbo problem. They cleaned the turbo and said everything looked fine, but the same problem arose after leaving the shop. They've been stumped at 3 different Ford shops, but one said there's a 95% chance a new turbo would fix the problem. What might be wrong?
View 8 Replies
I have a 2003 excursion... it is a v 10and just yesterday there was a whistling noise. I parked the vehicle and idle it slowly but no noise. I drove it again n the noise was there again. So the noise is there at 2000-2500 rpm. I'm wondering if its my exhaust manifold?? Also I'm starting to loose power. When running and in parked it shut off.
View 10 Replies
My mother has a '04 Santa Fe 3.5. Her automobile makes a rattling/grinding sound when around 1000rpms/idle. However, the sound disappears when accelerating and drives like a charm. The sound returns once again around 1000rmps at idle or stop. I have changed the oil pan, replaced oil and filter and even put in a new battery. I'm not an aficionado when it comes to Hyundais (Subaru driver here).Car also has 180k miles.
View 6 Replies
Truck: Ranger
Year: 1990
Engine: 2.3 Lima
Trans: 5 Speed Manual
Miles: 83,445
Recently Replaced:Oil Pressure Switch
Oil Pan Gasket
Crank Position Sensor
Spark Plugs
Plug Wireset
Ignition Control Module
Driver Side Coilpack
After I got done with all of this crap on my Ranger, I noticed that it was driving great! But...today I was on my way to school and BAM! My engine idle started hitting (presumably because I do not have a tachometer) about 3000RPM and lowering down to about 2500RPM and from there, every time I am not in gear it decided to fluctuate between 2500RPM and 3000RPM. Crazy style too.
Now, I got to school, and getting closer to it at a stop light the truck basically died. It was almost at 100'ish RPM. I gave it gas, and BAM. I hear a continuous hissing noise from under my hood. Haven't diagnosed it fully yet because I just got home and its 12AM.
Now, every time I stop at a light or in traffic or whatever it may be, I have to give it gas every other second, like a small push on the pedal, to make sure the truck doesn't die. Also, every time I am out of gear and my RPM's are at an 'idle' state, I get continuous hissing from somewhere, I get no power loss or anything, just really weird idle RPM's and hissing when my foot is not on the gas basically. It is strange. I think It is some sort of Vacuum leak but I am not sure.
To get a better picture of the 'hissing' noise, it is the same hissing as you would hear when letting the air out of a tire. That is the best way I could describe it.
View 3 Replies
So my 98 f150 xlt 4.6 is having a issue where the truck is jumping from 1500 rpm to about 2500 - 2600 rpm. You know sitting there trying to get up to speed. then all the sudden i look down and its at 1500 rpm. but still not really going anywhere. So i give it a little more throttle or gas and it jumps from 1500 to about 2500. Its been like this for a month but i thought it was crap fuel. What is the cause or maybe a solution?
View 4 Replies
Is rattling under acceleration normal on the tig? Sounds like a heatshield to me or something, usually around 2500 rpm or so, pretty disappointing on a 35k dollar vehicle.
Imagine a drawer of silverware being shaken around, that's kind of what it sounds like, mostly noticeable with the windows down.
View 19 Replies
