Ford F-150 (2004-2008) :: 2006 - Shaking And Pulsating When Braking
Jan 1, 2010
After my 2006 Ford F150 Lariet started shaking and pulsating when braking (38,000 miles) I took the truck to the Ford dealer and asked to have my brake pads checked. They came back and siad they looked fine and I had alot of wear left. Then I mentioned that is was shaking and asked them to check it again, they drove it and then said my rotors are warped and I need to replace the rotors and pads. I don't haul, tow or do anything crazy with it.
Now, here's my questions:
1. Can the rotors go bad and the brake pads be fine?
2. Should I go with a ceramic pad or stick with the OEM?
I'm just a female and don't want to be taken advantage of at the dealers. Cost is not an issue when purchasing a good product.
View 14 Replies
Advertisement
I have a 2007 Acura TSX with 117k miles. We had the rotors and pads replaced in July of 2014 at Midas (won't go back there again!). Anyway, we are getting a pulsating in the steering wheel (shaking) when braking at times. Sometimes it is much more noticeable than others. This started shortly after having the pads/rotors installed. I took it back to Midas, and of course they couldn't duplicate the issue.
So, here's my question, can we continue to drive the car until it needs new pads (then I'll change the pads and rotors)? I know that the steering vibration can be annoying at times (it's not AWFUL, but you can tell that they're warped). I really hate to have to replace both right now as money is pretty tight with buying a house.
View 4 Replies
It seems like I am going thru brakes I just replaced my brakes in May and my Rotors in July and when I brake my truck shakes like crazy. Is it the brakes again or am I missing something.
View 7 Replies
05 GX 470...no KDDS...100k miles. When I've been driving a few miles, I feel a pulsating when braking. Feels like it's coming from the front (front left if I had to guess). I put in new rotors and brakes in the front, turned the back rotors and problem still persists, no improvement.
I'm now considering the hub-bearing. However, when I do the standard-check (lift wheel and apply stress from top/bottom) there's no indication of a bad hub bearing.
The problem worsens as I drive faster. When on the highway, if I start to turn the wheel right 'then' brake...the steering wheel pulsates bad. When I turn the wheel left 'then' brake, it's not as bad...but still noticeable. When I start pressing the brake pedal 'then' start to turn the wheel right it's still there but not as bad compared to applying the brake after turning.
There's no pulsation in the break pedal, only the steering wheel and body/chassis.
View 13 Replies
I have a 2006 F-150, V6, automatic transmission, a little over 214,000 miles. When I started it up this morning, no issues, but when I dropped it into reverse, it started shaking pretty bad. Got on the road and put it in drive, and the shaking continued, then the check engine light started flashing. Haven't had any problems up to this point. Checked all the fluids including the transmission fluid a few weeks ago and all was well.
View 4 Replies
I have a 2006 F150 5.4 3v rattling and shaking excessively. I have installed two new cam phasers, two vct solinoids, two vct housings, flushed oil and installed motor craft oil and filter. This never happens if bank two vct is unplugged or in open loop. Monitioring vct's on ids only bank two is erratic. Also when I had vct housing off I blew regulated air through oil passage seems free.
View 7 Replies
Ok, I have a 2006 Ford f-150 5.4L engine. it has 88000 miles on it. Here recently it has started acting up on me. It starts shaking violently when I slightly accelerate going up hills at any speed. On level ground it doesn't do it. Going down hill it doesn't do it. When stopped it doesn't idle rough.
It does this shaking when I barely press the gas. When it starts I either let off the gas or I push the gas to the floor and it stops. What is going on? This is the first Ford I have ever known. I don't know anything about these vehicles. I have read it might be the coils and plugs but then people have told me it might be the torque converter.
View 6 Replies
I have recently been having violent shaking when I make a turn to pull into a parking spot or turn at a stop sign. I can park my truck and the truck continues to shake until I turn the motor off. When I restart the truck it runs fine. It doesn't do this all the time just sometimes. I have a 2006 Ford F-150 lariat 2 wheel drive.
View 3 Replies
I just had new rear drums put on, my front brake pads are new, my rotors are good...but there is still a pulsating when I brake. When I am just about slowed down you can definitely feel a surging coming from somewhere. The steering wheel does not shake, and I don't feel more than a vibration from the brake pedal. I have taken it to 3 mechanics and replacing the drums was given as a solution. But since I have already done that, the problem is obviously not resolved. I know I need new tires as 2 of them are really cupped and loud...could that be it?
View 19 Replies
When braking i would feel the pedal pulsating...figured the pads were finished. Checked them out and they were not in that great a shape so I changed them all around. I'm still getting a pulsating feeling in the brake pedal.... I just need to bleed them or are the discs warn or warped or something?
View 8 Replies
Ok, I changed my front brake pads and rotors last week and since then everytime I get in the truck and drive for about the first 2 or 3 miles when I push the brake pedal it feels like my ABS sytem is activating. Then it stops and the ABS light comes on but the brake pedal stops pulsating when depressed. Is my ABS going bad or did I possibly do something wrong? I have changed the rotors and pads before without problems....
View 3 Replies
Got new brakes 4 months ago - except this time put in redstuff ceramic pads.
I've had really bad vibration and grinding lately so I just had the rotors machined and cleaned up.
Some of the vibration is gone but when I apply the brakes more than very lightly I get shaking shuddering including the steering wheel. If I apply the brakes harder it goes away.
I would estimate the pulsating/shuddering/shaking happens when I apply the brakes more than 10 percent up to say 40-50 percent. Very light pressure no problems and hard braking no issues.
This has gotten worse since the servicing. What could be causing this? I've already replaced the propshaft and am replacing the tires.
View 5 Replies
I own a Jeep Grand Cherokee 2006 V8 4.7 with 133,000 miles. This week I went to a Quick Service Oil Change , after receiving an oil change they informed me I needed a Differential Fluid Change , that I "should have " had one at my last visit and couldn't wait any longer. After receiving the two , I left and not even fifteen minutes later , I attempted to use my breaks approaching the end of the highway.
Instantly the car started making an extremely long banging / thumping sounds along with the a lot of shaking and the car proceed to dead right there. I got it towed home , the company is supposed to send some one to come do a once over. What it could be? As sad as it sounds, I have a feeling they will do a look over and claim they don't know what is wrong or that it isn't there fault in any way.
View 9 Replies
Lately my 2007 GX470's steering wheel has a shaking/vibrating problem whenever I apply the brake at speed above 50 mph or so. Without braking or with braking at slower speed, there is no problem at all -- everything is glass smooth.
1. I assume the front brake rotor is warped?
2. Will I need to change the rotor or is there a way to fix the warp (it that's the problem) without changing the rotor?
3. Approximate part & labor cost?
I plan to bring to dealer for a check up but would like to know ahead of time what to expect.
View 14 Replies
I drive a 2004 chevy Tahoe and have had this problem for about 8 months. It started out very faint and occasional, but has now escalated to loud and consistent. So it ONLY happens when turning right. I've tried to replicate it when turning left and had no success. It happens when I am turning fairly hard at a decent speed. ex. Pulling into my driveway. I've already checked the wheel bearings and Ball joints.
Another thing is that the ABS light is on sometimes when i start the car and comes on every time i turn the steering wheel all the way to the right. It also has a problem where it will shake almost uncontrollably when driving at 65+MPH after hitting a bump or sometimes just randomly on a smooth surface. We just got new tires and balanced them. It did the same with the previous set we had. I know I'm asking for a lot, but where to start?
View 14 Replies
2007 Ford F150
XLT 5.4L Supercab
55,500 miles
Only Owner
I have owned my truck since mile 1 and have not had any issues up to this point. That being said in 2011 there have been 5 occassions where I have been on interstate driving between 55-70 and had to pull over due to my truck shaking. This shaking is very extreme and truly scares me, thus the reason I pull over. I replaced my tires with Michelin 70,000 mile tires and also replace my front brakes just over a year ago.
After not being able to reproduce the shake for my mechanic, they said my upper front ball joint needed replaced and my rear shocks. They hooked the truck up to the computer and did not receive any codes and my check engine light has not come on to this point.
The research I have conducted to this point has pointed to a number of issues and I had my mechanic check all of them and they said nothing was out of the ordinary, these were: e-brake issues, front brakes, calipers, plugs/coils.
View 14 Replies
I was driving my f150 going down the highway. Cruise set at 110kmh. All of a sudden truck started shaking And sounded horrible. Shut off the cruise. Floored it.it misses fired like no tomorrow and no power, looked down check engine light was flashing. Then all of a sudden everything normal. Now its intermediate and light solid on. So I thought I will just I will hook up the code reader. And NOTHING it didn't turn On. No beep nothing. Tried 2 readers no connection. Trucks a 2005 ford f150 fx4 5.4 217600km on the clock
View 2 Replies
I have a 2007 an at about 52mph the truck has a slight but irritating bounce (up an down) an after a while sickening. It maybe felt it was coming from the rear. So I had the rear tires balanced an the guy said my right rear tire had a bend to it. Well assuming that the balancing fixed the problem it did not. So I'm going to put on the spare to see if it still bounces what else should I do?
View 14 Replies
I've done some research on the shaking that is occurring on my truck an it's a possibility that it's the e brake seizing up. I've read where everyone has taken it to the dealer to get it fixed ....
View 7 Replies
Have a 2004 Fx4. Lately its been shaking violently when i accelerate. When I turn the overdrive off it stops.
View 9 Replies
I have an '05 5.4L 3V and I was way to trusting in how it was running. BTW, I change the oil every 3 to 5 and have only driven highway miles, albeit a lot of them...155k! I bought it with 40k on it but was not aware of the plug change issue until I heard about it off-hand. I let the plug change go cuz it was running so well. Bad move.
Anyways, a few weeks ago it began to lose power and I suspected that the PCM was retarding the timing for some reason. Before I could get to the shop, the thing went nuts on me at 75mph. Started shaking and sputtering and throwing cel codes. I shut it down and after 5 minutes re-started. It seemed fine and actually was running a bit better. Took it in and the code was the 0302. #2 cyl misfire.
They also said the compression was very low on that cylinder and slightly low on 1,3 and 7 as well. I had them change the plugs and the #2 COP even though they said I needed a new engine and then I picked it up. Now the engine barely runs at all. It shakes violently, where to go from here. What should I do now? New engine?
View 14 Replies
