Ford F-150 (2004-2008) :: 2006 - Loud Exhaust System
Sep 8, 2011
I am almost 16 and I have a 2006 F150 FX4 with a 5.4 6 1/2 bed and i need a good sounding exahust. I dont wanna break the bank and i need to pass PA state inspection.
View 12 Replies
Sep 8, 2011
Advertisement
Camry :: 2008 SE - Loud Rattling When Accelerate - Exhaust System?
My 2008 Camry SE 2.4L rattles loudly when I accelerate. It happens all the time & I believe it's the braided portion of the exhaust system. It sounds like tin rattling.
View 1 RepliesFord Exhaust System :: 1994 Ranger - Loud Exhaust Sound In / Outside The Truck And At Idle
I have a 94 ranger 4L. I am looking for a more loud exhaust sound in/outside the truck and at idle. I have had a cherry bomb turbo on it and it was ok but not loud enough for my liking. I just picked up a flowmaster 40 2 days ago and it sounds good but again just not loud enough for my taste and kinda a lot more. I was looking for a louder muffler that is not a glasspack and would like to stay under like 80 or so.
I also thought about getting a high flow cat which i think might make some more sound but was not sure. Im running the stock pipe which is 2" and end in back of the wheel on the right. I look at the Hooker Headers Maximum Flow Muffler which i thought would be louder b/c it's more straight through the muffler so it would put off more sound better. What would u recommend for something more loud ?
Ford Exhaust System :: 2006 - Exhaust System Installation?
Want to install exhaust system on my 06 F350.Tell me,what is the best brand for my truck,I know, very good intake system is from K&N,what about exhaust?
View 10 RepliesFord Exhaust System :: Loud Pop While Cruising At 60 Mph - Muffler Blowout And Rough Engine
Yesterday, I heard a loud "pop" while cruising at 60mph. Pull into a rest stop and and discovered a hole in the muffler. The engine now idled roughly, but seem to smooth out about 2000 rpm.
Question for the experts: can the loss of a muffler cause the engine to run rough? It's a 460cid in a '77 F350.
Ford F-150 (2004-2008) :: 2006 - Major Leak From The Left Side Exhaust Manifold
I have an 06 with a 5.4 with 70k on it and I have already had to do the exhaust manifolds twice, once covered by warrantee at 19k, then again around 40k and now at 74k I have a major leak from the left side manifold again
View 1 RepliesFord F-150 (2004-2008) :: 2006 V8 - Loud Screeching Noise From Under The Hood
Everything might be a slight exaggeration. But fuse 14 covers Backup lamp and day time running lights relay coil, A/C Pressure Switch, Redundant Speed Control, Heated PCV (5.4L), Trailer Tow back-up lamps, ABS, Reverse park aid, EC Mirror.
This is a 2006. 4.6L V8, SCREW. I don't have reverse park aid. When the fuse blows there is a loud screeching noise from under the hood. Can't identify it because the fuse wont go while I am sitting idling in the driveway. The parking break i9ndicator comes on, the ABS indicator comes on, Cruise control goes away and the A/C quits cooling but still blows. I assume EC Mirror means Electronic Compass Mirror. So I need to figure out where the short is.
Prius (2004-09) :: 2006 - Loud Beeping Sound / Hybrid System Warning Light
I have had no issues with this car of 120K miles until today, although my MPG has decreased to 35 MPG. The following lights came on with a loud beeping sound : Brake warning lights, malfunction indicator light, master warning light and the hybrid system warning light. These stayed on for 25 minutes and then went off. I drove 12 miles without any issues with all the lights and sounds beeping.
View 4 RepliesFord F-150 (2004-2008) :: 2006 - Loud Noise Like A Loose Ball Bearing Spinning
Whenever I am driving 60 km/h or more a loud noise seems to come into play. The noise sounds like a really loose ball bearing spinning. Then sounds like a turbine slowing down when going 30 or under. The only issue is the noise does not go away until the truck shifts down into 1st gear. And when doing so the truck jerks enough for everyone in the vechile to feel it. This problem only seems to come when it's rainy or slushy outside and even then does not happen very often. I have had the truck to ford and another mech. Nobody can seem to pinpoint the problem. 2006 f150 5.4l ....
View 2 RepliesPrius (2001-03) :: Loud Noise Coming From Exhaust System / Catalytic Converter Replacement
After hearing some loud noise coming from my exhaust system, it was determined that there is a hole (from rust) in part of the cat. assembly. Three shops advised for replacement, there are no aftermarket products for this unit. I have NOT gotten any error codes, the only problem is the noise. What to do? The car is 10 years old with 86000 miles. I have been reading about some of you getting just the one piece and having it welded on, but I do not believe any of the shops here will do that, and indicated that it would be a very temporary fix.
View 17 RepliesFord Exhaust System :: 2004 F150 - O2 Sensor Location
So I was wondering where the O2 sensors are on the 04 f150s and if I could cut the rear set of cats out without throwing off those sensors?
View 13 RepliesAzera TG (2006-11) :: Exhaust Growl Loud
Haven't had my Azera Limited 3.8L very long. Got it because I wanted a comfortable cruiser.
Because today, I was on a fairly short acceleration lane trying to merge onto a busy Interstate. As I was getting ready to slip into the only large opening between 2 vehicles, the rear one, a black Escalade, started to speed up. With the end of the short on-ramp coming up fast, I stomped on the throttle.
Didn't expect to hear the engine/exhaust growl so loud when the full 260 hp kicked in. Surprised me and my passengers. I know it's fuel injected, but the sound reminded me of the huge secondaries opening on a Holley four barrel carburetor. Wouldn't be surprised if the Escalade driver also heard it as my Azera jumped ahead an easily merged.
Ford Exhaust System :: Exhaust Leak - No Gasket Or Donut Ring In The Flange?
I tore it apart and there was no gasket or donut ring in the flange. Is there supposed to be a gasket or donut ring? I can feel the leak with my hand. I have retightened & it still "tick-ticks" real bad.
View 7 RepliesFord Exhaust System :: 351w Exhaust Collector Stud Nut Size
I have a 90 bronco with a efi 351w and im missing one nut for the manifold to exhaust pipe flange. I have looked all over the net and can't find the size I know its a 1/2in socket but I need the thread pitch and size, had the parts guy try to sell me the stud and nut kit seem really expensive for just a nut and to install the full kit I have to pull skid plates and the trany supports just to start to get room to do the job, seems like a lot of work to replace 1 nut...
View 1 RepliesFord Exhaust System :: 2003 V10 - Running Little Bit Rough / Exhaust Leak?
I just purchased a 2003 V10 with 270 000kms. The truck had had regular maintenance. It has an exhaust leak and runs a little bit rough. Could the exhaust leak cause the truck to run a little rough or am I dealing with another issue?
View 2 RepliesFord Exhaust System :: Exhaust Quieter When Cold / Much Louder When Warmed Up
My F150 exhaust seems rather quiet when I first start it up, but after it gets warmed up good, the exhaust is much louder (which I like). I started wondering if I had a crack up front that widened out when it got hot, so looked under it when I got home today with it hot and still idling, but didn't see any cracks. Also I did not hear any noise like a leak. All sound was coming from the side exit pipe. So... what is the phenomenon that would cause this?
View 5 RepliesFord Exhaust :: 2000 - Can Remove Catalytic Converter From The Exhaust System?
Long story, I'll try to make this short, 2000 E250 5.4L What would or could happen if the catalytic converter was removed from the exhaust system?
View 5 RepliesFord Exhaust System :: 1996 F150 - Exhaust Making Strange Howling Noise
Ok, probably about 1/3 times i start my 96 f150 4.9 with true duals, the left pipe has a higher pitched howling noise, its a steady tone whether I rev the truck up or not it just gets louder. It will do it for about 6 seconds and then stop. The truck doesn't run badly because of it, but i took her to autozone to get her scanned and they said that the oxygen sensor on the first manifold bank has a slow response on startup. Is that what causes this strange noise, I don't even know how it would make it, it sounds much different from the engine. The right pipe doesn't do anything.
View 9 RepliesFord Exhaust System :: Exhaust Manifold Leaking / Louder Than Normal Knock When Accelerating
Leaking exhaust manifold? The truck has a much louder than normal "knock" when accelerating. At first I thought and had some bad fuel in the tank. I eliminated that with a full take of good fuel and some STP but the "knocking" continued. Then I thought that perhaps it wasn't firing on all cylinders but it felt like it had full power. I took it to my mechanic and he said it as a exhaust manifold leak. He said that he has never replaced the exhaust manifold but that it was a "nightmare" and expensive. He also said that it's not a safety issue but on the long run the leak would cause the truck not to pass its emission test. He said the problem was with rusted bolts that would be difficult to remove.
View 12 RepliesIS F (2008-2014) :: Code P0420 After New X Force Exhaust System Install
just recently installed the new X force exhaust system on my 2008 ISF with 72,000 miles on it. I've had the exhaust on the car for about 300 miles it when I was driving home from work today the vsc and check engine light pops up. I turn the car off when I got home and then turned it back on the check engine light was off but the stored Code was still there when I read it with the scanner P0420. I'm thinking maybe there's an exhaust leak even though it sounds fine.
View 14 RepliesFord Exhaust System :: Exhaust Leak At Manifold Where Donut Gasket Meets The Catalytic Converters
My truck just started running really loud when it's cold and the leak goes away when it warms up to operating temperature.I did a little bit of investigating and I have found where the leak is coming from at the end of the exhaust manifold where the donut gasket meets the catalytic converters. It appears that the bolts rotted that hold the system together at the gasket. What should I do to repair this? I don't really want to replace the whole manifold because I know I'll break a stud off in the engine because everything is pretty rusty down there. I even took some pictures of the problem....
View 3 Replies