Ford F-150 (2004-2008) :: 2005 - Rattle And Vibration At Idle Only Occurs With The Truck In Gear And Stopped
Mar 27, 2017
My F-150 has developed a rattle and vibration at idle that only occurs with the truck in gear and stopped (with the brake depressed.) The noise appears to be coming from the front of the truck, perhaps from the driver's side (though it's difficult to tell while sitting in the cab).
Before I go crawling around underneath with my son holding the brake while the truck is in drive--I would sure like to know where it might be best to point the flashlight.
View 6 Replies
Advertisement
I'm having an issue with my 2005 f150 xlt. Its been happening for almost near a month and still cant locate the issue .
It has a vibration at 75km throughout the whole truck. Ive tried multiple things done to it by a mechanic, such as having the tires balanced and the ujoints replaced. The problem still persisted and after attempting to test out to see if press/releasing the parking break (my mechani suggested trying that out), my driveshaft fell off.
Apparently the center bearing snapped and cant simply be replaced on the 05's. So i had to get a new driveshaft installed (used, both the 3 mechanics I've gone to say its in good condition).
Even after replacing the driveshaft the issue persists - however it seems a bit softer than it was (I am guessing the old driveshaft was worn from the vibration causing it to be worse). After that I took it to another shop to see if they could locate the issue. They did a driveline inspection and engine inspection too see if a misfire could be the cause.
Again, nothing was found. The only thing they were able to find was that the issue only happens under load and slightly occurs at 40 and 100km as well (although alot softer then the one at 75) and they say they cant find anything physically and it was a mystery to them.
View 2 Replies
I have a 2004 F150 with 195,000mi. For the last several moths the truck has had a rattle on startup, some days it is barely noticable and only on cold starts, other days it is loud and occurs on every startup. The truck was most recently serviced at the Ford dealer and is filled with Motorcraft 5w-20 syn blend and Motorcraft filter Every change before was either Motorcraft syn blend or Penzoil Platinum (I have always used Motorcraft filters on it) and the noise continued after oil changes so I don't think the drain back valve is the issue. I replaced the cam phasers, timing chains, chain tensioners, and guides about 15,000 miles (2 years) ago and the vct solenoids shortly after that. Here is an audio clip of the noise (I know the truck also has an exhaust manifold leak, I plan on replacing the manifold while im working on it
Is this noise the lash adjusters or have the cam phasers failed again (they were dorman parts)? If it is the lash adjusters, can they be replaced without removing the cams? will failed adjusters be obviously damaged? Should I also replace the cam followers? do i need to replace all 24 at once or can i safely replace only damaged ones or maybe just 1 bank (noise seems to only be coming from the pass side)?
View 11 Replies
My friend just bought a 2008 F150 5.4 110k, it ran great all day during all of the test drives, after he gets it home it has started acting up. Most of the time it runs great, but sometimes when you stop the truck the idle will drop down and the truck sounds like it is going to die but so far it hasn't actually died, it starts knocking really badly and runs very rough. If you let it keep running like that it sets P0340. If you rev the truck up it cleans up and sounds fine again and it will even drop back down to a clean idle most of the time. I swapped the cam sensors because it was easy and just to see and it didn't make a difference, I was hoping after switching the sensors the code would switch to the other head but it didn't.
View 14 Replies
A week and a half ago I went out to my truck to go somewhere and I got about 2 blocks away and the truck started running really rough and had a big lack of power, so I turned around and scanned it with my code reader and the codes I got were p2271, p2196, p0303, p0012, p2197, and p2272. since then I've changed all the spark plugs, boots, swapped all the coils and injectors from a great running truck, fuel filter, and the bank 1 upstream O2 sensor.
the other thing that came to mind that could of caused the problem is that a few days before the problem started. I jump started a co-workers car and he hooked the cables up backwards on his car. Could this be the cause of the problems I'm having.
The truck is an 05 F150 FX4 5.4 with 180,000 miles on it.
View 9 Replies
My truck gear shift is stuck in Park (console type). I have been reading threads that discuss potential causes such as blown fuses, bad brake switch, bad brake shift interlock actuator, and even ignition switch. All fuses are okay. Before I try to get into all the other possibilities, I have a question around what the local auto parts worker suggested. He said that there is a small plastic piece that may have slipped down interfering with gear movement. This could make sense, especially since the white manual release lever doesn't seem to be moving.
View 14 Replies
Just got 2005 screw fx4. Seemed to run ok 115000 mi.Had exhaust leak,I put on 3" cat back on. Then I noticed tapping at front of the engine.Turns out tim. chain guides are broken. looks like very common prob after reading many forum/threads. Anyway got timing chain kit, phasers, selinoids. Truck runs and sounds great.But so far had truck back 2weeks stalled 2x at idle.What next??
View 14 Replies
I recently purchased a used 2006 Ford F-150 (5.4l RWD). I was fully aware of a problem with the brake rotors when I bought the truck from a dealership. They supposedly changed the rotors and the rotors appear to be new...But every time I brake the truck almost flutters in the front end. I haven't noticed vibration while on the highway, only when braking. I am worried because I can fix it I just cant seem to figure out what the problem is.
View 4 Replies
I took it to the dealer and they blamed the trailer. I told them that I have pulled two different trailers and it did it with both. Then he said that the trailer was not heavy enough to weigh down the springs. So now I not suppose to tow an empty trailer? Also my father in law has pulled the trailer with his Z71 with no shake and the other belongs to a neighbor with a 98 F150 with no shake. The vibration only starts above 45mph. Any clue as to what could be causing this?
View 14 Replies
I've got a 2005 F-150 (5.4 triton) with about 35k miles that I rarely use in 4x4 mode. The other day, after stopping to fill up with gas, the truck 4x4 Lo light was on after starting it. The dashboard switch was still in 2H mode as I never switched it. I first thought that the dashboard light might be in error, but when I began to pull out of the gas station. the truck was in fact in 4x4 Lo. I had forgotten how to cycle it back to 2H so I slowly drove about 3 miles home at 20 mph.
Once home, I re-read the tranny sync sequence and managed to get back to 4x2. I called the dealer who never heard of a truck getting into that Lo mode w/o activating the switch and suggested that I just monitor it. I read a number of forum threads discussing the IWE and solenoid problems, but all of those threads dealt with issues of not being able to get too 4x4 mode. My biggest concern is that I leave in a month for a 2000 mile trip, towing a cargo trailer and I'd hate to inadvertently switch into 4/4 when traveling 60 mpg on a highway.
View 1 Replies
I have 2008 f150 with 5.4 and 54000 miles. It has a bad vibration or rough idle only when AC is on. When AC is off it runs very smooth. Runs great while driving with AC on. Tensioner pulley was moving a lot more than normal when engine started vibrating so i replaced it and the belt but it didn't work. I also checked the other pulleys and they are good.
View 1 Replies
I am trying to solve a mystery on my mom's truck. It's an '06 4.2L F-150 STX with about 133k miles. It had a check engine light on until today- I cleaned the TB and changed air filter yesterday, and both were filthy. Code vanished later on while driving.
I want to check the PCV because the truck idles high and rough in any setting from park to OD, stopped or moving. Worse when stopped though. Entire coil pack has already been changed due to previous misfire problems. This feels similar to a misfire but without the acceleration hesitation. It has also had a recent oil change, and fuel/oil filter change as well.
There is only one hose connecting to the intake on this truck, and it appears to be a vapor line of some sort to the valve cover, but isn't a PCV cause it's just a hollow tube. There is nothing else coming out of the TB at all, except for the throttle control cable. I don't even seen any nipples or connections or holes where a PCV hose or valve should go. I thought it was on the passenger side, under the TB... but there is nothing here at all. I'm stumped.
I am beginning to think the truck just does not have one at all, which I know for a fact is impossible. I have traced every line on this motor from top to bottom, and I do not see it. Should have a heater on it I assume? What else can make the truck so rough? I don't buy it that "it's just that way". That is complete, lazy, BS. I have had/driven many trucks; 4x4s, supercrew, diesels, jeeps, dump trucks... I have NEVER had a truck run as badly and roughly as this one does. Heck, a twin-turbo 700HP diesel doesn't run this roughly.
View 3 Replies
I have a 07 f150 getting 17 mpg in town, I would like to get 20 MPG in town, this is a 5 speed, i do not shift into 5th gear. Max in town in 40 MPH. I have 3.55... I was wondering would 3.27 getting me to that 20 MPG?
View 14 Replies
I bought the truck last November with a bunch of issues. My most recent problem is a hard vibration at idle. No it is not the infamous misfire and stall. All timing components (chains, tensioners, guides and vct solenoids) have been replaced.
I've replaced the ignition coils, spark plugs, air filter, and fuel filter. When I'm at a stop light or just idling in the driveway I can feel the vibration in the cab through the seats and the steering wheel. I can see the drivers side mirror vibrate but not the passenger side.
I've seen posts that are saying that this vibration is normal, but it seems a but harder of a shake than normal. Would there be anything that would only affect the driver side bank and not the passenger side?
View 7 Replies
When the truck is idling it has a weird vibration and their is a hum that comes from the engine. It then clicks like my clutch fan disengages or engages and both go away. I have only noticed at stop signs and sitting in a parking lot. 2004 5.4L....
View 2 Replies
I have a 2008 F150 that the battery drains after sitting 4 days or longer. This has happened about a dozen times since I bought the truck and the dealer could never figure out why. Warranty is up now and it is STILL happening! I had corporate office insult me by telling me everything "checks out" and it is just like a cell phone. If you don't periodically charge it up, the battery dies. I asked her where I was supposed to plug my truck in at night and there was silence on the other end. I am 62 and have never had a car or truck do this from just sitting. The dealer insists everything checks out.
View 14 Replies
Let me describe this perplexing issue. I have a speratic rough idle problem. When it happens it's almost like the truck wants to stall. Once going the truck is fine. There has never been any acceleration issues, but for a short time the truck would kind of lunge off idle. It hasn't done that for quite some time. I've replaced the fuel filter. There are no vacuum leaks that I know of. I've tried higher octane fuel. I've tried injector cleaner for a month. What should the fuel pressure be and what is the test port located? Is the fuel pump in the tank? If so, whats that big log looking thing behind the gas tank that the fuel lines run to? Also, there are no MIL codes...
View 14 Replies
This morning I drove down to unlock my gate and got out of the truck while it was idling. When I got to the gate the truck just stopped running it did not sputter or anything it was like a light switch and just shut off. I got back in the truck and tried to start it but nothing happened starter did not engage at all or even try to run. I put a new battery in it knowing that is not the problem but it will just not start or even turn over.
View 1 Replies
I have an 07 F150 xl 2wd 5speed. It has a vibration/shake at about 30-45 mph no matter if its in gear or neutral, or if its under throttle or not. It also gets a little worse when breaking coming down from about 45-30mph.
I was thinking at first it was the wheels out of balance since it was only at a certain mph range but the braking thing has me thinking rotors. The truck has about 51000 miles on it.
View 4 Replies
I have a 2005 F250 5.4 3V Triton work truck that the tail lights will not work on. When I turn my lights on, the front running lights come on but no tail lights. I have brake lights, turn signals, emergency flashers, but no tail lights. I have checked all my fuses, checked the wiring and even replaced the bulbs, but still no tail lights. I turned my lights on and pulled the fuse that powered them and the parking lamps on the front went off, I replaced the fuse and they came back on but still no tail lights. I got pulled over by a state trooper because of it so I would really like to get to the bottom of this.
View 1 Replies
Over the last couple months when I started driving, I noticed that the cruise control wasn't working at all. The next time I would start it was working again. It "stopped" working a few times.
The last time it stopped working was about a week ago, and hasn't worked since. I have read about horn relay fuses, tail light fuses, some sort of module on the engine. Where should I start?
View 8 Replies
