Ford F-150 (2004-2008) :: 2005 - Clunking Around Turns In The Front And Rear End
Dec 7, 2014
My 05 f150 is lift with a 6" skyjacker lift I've only had it a week from the dealership when it stopped firing on cylinder 8 which is a lil problem easy to fix,but then it started clunking around turns in the front and rear end. So I took it the dealer and 3 days later they give it back. It's running good but its still clunking in the front they said they changed the cv joints and tie rod ends but after I got home. I inspected it they changed one damn tie rod and that was it. Is it the tie rod end that's still making the noise?
View 1 Replies
Advertisement
When going around 48mph clunking sound comes from rear end. seems like it does that when you are trying to maintain that speed. Also have had 7 window regulators to go bad on have 1 working window 4 bad now replaced the same one 3 times. Called Ford they said no complaints have come in about the window issue on 2004 trucks...
View 1 Replies
05 F150 2WD 4.6 LWB, The rear end whines when letting off the gas and makes a clunk or 2 when taking off and a clunk when I stop. It has 277.000 Miles? Or is it just time for another rear end...
View 3 Replies
I've got a clunk in the front end....replaced all the ball joints......checked the sway bar......checked the tie rods......can't find anything wrong...... Shocks go bad and clunk???
View 14 Replies
I got a horrible clunking/knocking in the front end of my pickup this morning, jerking the steering wheel like a flat tire, and after a couple miles it stopped..... bearing ???
View 7 Replies
2004 super crew. It is not the seat belt. Can I unsnap the seat to get back there?
View 4 Replies
I've got a 4.6 in a 2005, 178000. I assume the 4.6 in an E150 would be the same as the F150.
So anyways, Started and an intermediate problem where sometimes it would stalling when making turns, such as entering a driveway, making turns or going from reverse to drive. Now its turned into more of a problem with stalling, even while in just idle and not just in gear.
At idle RPM is sporadic from 300-900. Here is where I'm at New Fuel Filter. ECM is reading 38 to 41 psi fuel pressure at idle and when the throttle is pushed.
Took a chance and changed the belt since the old was a bit lose. Even ran the engine without a belt and there was no change in my problem.
I've removed the throttle body, just learned these engines don't have an IAC, they use and IAC motor instead. I don't know how to test that but I'm googling it.
Back of throttle blade is all gunked up so I'm cleaning that now. It has no codes btw.
View 7 Replies
Bought an 05 FX4 SuperCab in May - been in shop twice for a "clunking" sound when accelerating from a dead stop. Dealer says it's "operating as intended" and that no damage was being if I continue to drive. I thought it was a rear problem with the limited slip. Dealer says it's the tranny and that Ford is looking into the problem (apparently quite a few are coming back). She runs smooth and shifts fine once she gets going. Just starting from a complete stop feels painfully wrong.
View 14 Replies
I have a 2004 2WD supercab. And am hearing a 'clunking' sound when I turn almost full-lock. Below is a summary of what I have experienced so far:
- My truck used to be lowered 2" (below stock) at the front since new. Last month I lifted it (front and rear) and it now sits 2" above stock on new rancho shocks.
- I installed a camber kit and had the front aligned (toe and camber) after the above suspension work.
- The truck drove beautifully for two weeks until one day a 'clunking' sound was heard from the front-left every time I turned left. The alignment also changed as I had to now hold the steering very slightly to the left to drive straight.
- The alignment shop re-did the toe tracking (the camber did not change) and the truck drove great for about a day. Now I can hear the same clunking sound when I turn right and the tracking is again screwed up meaning I need to hold the steering very slightly to the right to drive straight.
What parts are playing up and what may need replacing?
View 2 Replies
We have a mystery: there's a clunking sound from our right front wheel when we turn, but our mechanic can't figure out why - he says the axle, struts and ball joint there all look fine. What else could be causing the sound - is he missing something important? This sound happens about 50% of the time on turns. Note that we recently (about 10 days ago) had the ball joint and struts replaced on the LEFT front wheel - could that have done something to the balance of the axle, etc. that is making this sound happen on the right front wheel? This is an old car (a 1996 Mazda Protege with 115,000 miles on it) but it's been well-maintained and is otherwise running well.
View 16 Replies
2011 ISF with clunking and rubbing noises coming from the passenger front side, especially when making right turns or hitting a pot hole. It really does sound like something is loose and bouncing around when hitting a pot hole, and its the same noise when taking a right turn at any speed. It doesn't make any sense!!! Could be engine bay or could be in the tire well, unsure. We took the tire off today and found nothing wrong and no rubbing points around. We checked the control arm, strut, sway bar, backing plate, wheel bearing for looseness. Cant find anything wrong at all...
View 12 Replies
had a leaking rear driveshaft seal at the axle and replaced it and fluid. 75W145 full synthetic as recommended. it was changed at 128000 and I've started to get an axle whine over 25 MPH up to 65-70MPH. quites down around 80 MPH. I just checked it after 2 months (whine just started) with 133000. Any TSB. does this fall under TSB 05-23-3? Noise sounds like I've got really aggressive tires on the truck. Only have Dayton HT all season. Did not add the XL3 additive. Would this work at this juncture.
View 5 Replies
this is my brothers truck 05 f-150 4x4, i put brakes front and back and flushed the system about six months ago now. the other day when he was coming home from college the front passenger tire locked up. he drove it home and i went over took it apart nothing was sticking put it back together and it was fine. now today he call it stuck again so i just pulled it apart, pads are now purple from the heat, pins are free, caliper moves i put a small piece of wood in it and had him press the brakes the caliper moved out and i pused it back in, reinstalled everything and its not stuck no more. what do you think is causing this? my uncle says it could be the abs box acting up, when he bought the truck my dad made him buy the extended warrenty but he wont pay the 100 dollar deductible because this past winter we all went out in the two foot of snow and he got stuck so i pulled him out and our dad says thats what f$ucked his brakes up so now his is pissed. so how can i fix this for him? oh it only has 42k on it
View 7 Replies
2005 FX4 truck. Doesn't click when going straight, but if turning wheel like turning into or out of a parking spot, it makes a clicking noise that gets faster as you get faster. It sounds almost like a baseball card in a bicycle spoke honestly. Don't know if its related, but about 3 months before i noticed the sound I had the Rancho quick lift struts installed on the truck. Somebody told me it could be wheel bearings but in my experience a wheel bearing will make a roaring noise, and it would roar while going straight down the road. This is only when turning the wheels. Also, it doesn't matter if you turn left or right, you can hear it both directions.
View 6 Replies
I have a 2005 f150 and it will not engage the front hubs. It is a manual shift on the fly not electric. I have done some checking and this is what i have found so far. Pull the lever into 4H, dash light comes on, IWE's do not lock onto axle. Same for 4L. The transfer case does come in when lever is pulled into either 4H or 4L. Front end up on jack stands, engine off. Turn either wheel and axle turns with it as it should. Start engine, turn either wheel and it is free from axle, as it should be. so there is vacuum going to IWE when engine is on. Not sure what to check next. Is the vacuum solenoid on the firewall bad?? Is there something not getting activated when i pull the floor lever back?
View 4 Replies
I have a 2005 Supercrew 4X2 with 110,000 miles on it. Lately I've noticed at 30 mph and up if I steer to the left I get a growling noise from the left front. When I straighten up or steer right it goes away. I don't feel anything in the steering wheel or seat of the pants...just this growling noise during a left steer. Tires are about half wore out...I went ahead and rotated them to see if the growl moved. It didn't, stays in the left front.
Does that sound like the bearings in the rotor are on the way out? It won't stop raining so I haven't had a chance to jack it up and see if I have I have play in that tire/wheel. I thumbed through my Haynes manual and it seems pretty straight forward to replace the rotor. New rotors/bearings, one time use nut, might as well do pads while I'm in there, torque nut to 275 ft. lbs. Am I on the right track? Any other way to diagnose this growl? Is the R&R of the rotor as easy as it sounds? Tips or trick, things I should know that Haynes isn't telling...
View 1 Replies
My 2005 F150 is making a thumping noise in the front end. It increases as speed increases and is more pronounced when turning wheel left and almost goes away when turning to the right. Sometimes at higher speeds I can feel it in the gas pedal. Seems to be coming more from the driver side but I could be wrong On that.
View 3 Replies
My uncle has an 05 F150 extended cab. When he bought it he put his license plate in the rear window until he could get some bolts for it. When it was there it fell between the back of the rear seat and the back of the cab. Currently he has one plate on the rear, but is worried he will get stopped for not having a front plate installed. So he knew I am an FTE member and I could find out how to remove the seat back. I have not tried to remove it nor seen if I could reach it.
View 4 Replies
I wanted to put bigger tires on my truck, something more agressive. Is there a torsion bar? Can it be adjusted? How? If not what is the biggest tire i can put on with my stock 17" rims? 2wd 2005 f150...
View 2 Replies
My 2005 f150 extended cab / supercab front doors wont close fully. The light on the dash goes off, but you can see the door is still open in the mirror. It also sounds open. The rear doors are fine.
View 6 Replies
I have a 2005 F150 4x4, with just over 75K, and I have owned it from new. I am having left front brake issues. The left front brake seems to drag, but of course does not do it consistentally or after a given type of braking event. It just does it very randomly. I originally replaced the caplier pins thinking one may have been hanging up. It seemed to fix the issue for a couple months then it happened again. So doing more inquiry it seems some have had issues with the front rubber lines.
I just had both front lines replaced with OEM Ford parts and the system flushed out at a dealer. The brakes again seemed to work fine driving home from the dealer anto work today. Then on the way home it did it again, started dragging. The truck starts to feel sluggish while accelerating and slows very quickly just lifting off the gas. then when you get out you feel the wheel and it is very HOT and you can hear a heat popping sound. (First time it happened it was smoking it got so hot.) Right side seemsfine.
Since it does it so randomly I am at a loss. I can not just drop it off at the dealer and say drive it until it. I am considering having the caliper replaced, which I really considered when it was at the dealer for the hoses since I had the IWE's done at the same time, so they were off.
View 14 Replies
