Ford F-150 (2004-2008) :: 2005 - Adding 3-4" Lift - Adjustment For Snowplow?
Jun 30, 2013
I just got this truck with the plow installed so I'm not sure what kind of adjustments are available for the plow itself. If I add a 3-4" lift, will the plow still reach the ground and work OK? What kind of adjustments would need to be made?
View 2 Replies
Advertisement
I wanted to put bigger tires on my truck, something more agressive. Is there a torsion bar? Can it be adjusted? How? If not what is the biggest tire i can put on with my stock 17" rims? 2wd 2005 f150...
View 2 Replies
I'm trying to figure out how / if cruise control can be added to a 2005 F150 with the 4.2L V6. I bought an aftermarket kit, popped the hood, and then learned all about electronic throttles . What (aside from adding the cruise control switches) do you have to do?
View 14 Replies
I am looking to add a new exhaust to my 05 F150 SuperCrew and am stuck between an MBRP and Magnaflow. I think I want to go with a S.I/D.O setup. Any opinions on either brand or are they basically the same?
View 9 Replies
I have a 02 f250 powerstroke and I wanna put a suspension lift kit on it I wanna go with a 6 inch lift but I'm afraid if I go any higher than a 4 inch I'll have to change to much. What I would have to change and if I would have to extend any of my brake lines also the truck is a cab and a half with an 8 foot bed so I do have a carrier baring on the drive shaft would I have to change anything with that?
View 14 Replies
I have a 2004 fx4 supercrew 4x4 , 170k miles. I bought it a few months ago and installed a 6" rough country lift and 35" tires. I noticed a little shake in the steering wheel but not too bad, just annoying. I just put on a fabtech dual steering stabilizer to remedy the problem and its much worse. What could be at fault that dual stabilizer would make it worse? I hate to just take them off, I would rather find the problem. Oh, the tires are all balanced and I had an alignment done also.
View 14 Replies
What are the largest size tires that will fit to give my truck a tougher look without rubbing or causing any other issues? Again I have a 2008 FX4 SuperCrew.
View 14 Replies
I'm not too familiar with the difference between lift kits and leveling kits. I want to lift my truck 2" but in doing research do i need get a lift kit and a leveling kit? For the front and the back? I have a 2006 F150 4.6 V8 RWD I also haven't been able to find any good places to but the kits (also because I don't know what all i may need) It would be ideal to get a kit i can bolt on myself.
View 1 Replies
I have noticed a lot of things on the web on modules that promise increased MPG and power by adding a resistor on the IAT sensor. As much as I like the idea of increased MPG and power for cheap, if it doesn't work, I don't want to waste my time. So, what is the consensus on this type of modification? Will this mod be effective or only be a waste of time?
View 3 Replies
How hard are they to put on, and who makes the best one? I was told about hell bent steel, but I am not sure? I got an 04 Ford F150 looking to level it out...
View 7 Replies
I would like to add the stereo controls to my steering wheel. From what I gathered it can be done by just buying the buttons and the taking it to the stealership to flash the computer to get them to work? BTW This is on my 06 XLT Scab.
View 1 Replies
I have a F-150 5.4 automattic 07 model and I need to add some tranny oil,I can't see on dipstick or in book what oil I need,(4) (5)??? I still can't see any markings on dipstick, where would I see a 4 or 5 on dipstick??
View 2 Replies
For our new pontoon with surge brakes I need to add reverse lights to the wiring harness to deactivate the surge brakes while backing up. What is the proper way of doing this? BTW this is on an 06 F150 XLT with factory 7 pin harness.
View 4 Replies
Is there any mechanical adjustment on the manual shift hydraulic clutch? My clutch is not slipping but is just about all the way up on the pedal.
View 3 Replies
2006 4.2L The pedal is good and the fluid is full but the clutch engages and releases about 2 inches from the floorboard. Is there possibly a rod that can be adjusted at the slave cylinder that moves the engage/release point along the pedal travel? Any thoughts before I get out the creeper?
View 1 Replies
I have a 1994 Black Ford F150 and i was wondering if i could lift the truck 6 inches only using lift blocks (or any other cheap way to get my truck off the ground)....
View 2 Replies
How many have had luck and results adjusting there steering box.I ajusted mine and it corrected the bad wandering proplem. I just hope this will last.
View 7 Replies
I have a fabtech 4 link 6" lift on a 2008 6.4. The lift kit used to sit level but the front is sitting lower now. How can I fix this?
View 10 Replies
I got to replace mine because the hood won't stay up on it's own and is heavy to lift. I was wondering if these things fail often. Mine is an '08.
View 5 Replies
I've searched and can only find instructions/details on 6.4L and older Super Duty trucks. The process is the same to adjust the gear box for a 6.7L?
View 5 Replies
My 05 has an incredibly annoying door squeak that is right behind my ear on the drivers door. If I pull in on the door handle just a little it stops. I tried to adjust the door to close a little quieter, but I don't seem to have any adjustment on the latch in the door or on the door pillar. Am I missing something? The hinges are tight so the door is not really moving up and down that much, but It is making me crazy.
View 4 Replies