So a week ago, I had a good load of sod in my 05 F150 4WD. After a few miles, the ABS light came on and has stayed on. Will this go back off by itself after a time, or is this a get it fixed deal? Tried unhooking the battery, but no luck.
View 14 RepliesMy dad is looking at a 2005 F150 2wd with the 4.6L V8 that a friend of his has. Its a 2wd XL, but has the cloth seats, the interior and body are excellent conditions. Its high mileage however, (210K), but the engine sounds good, but it has a miss and the check engine light is on. He took it about 6 months ago and had the oil changed, new belts and spark plugs, drove it very little and its been setting for sale for about 3 months.
When dad started it this evening, the engine was missing and the CEL light is on. His friend suggested he drive the truck for as long as he likes, (which he did today and he does like it) but I advised my dad to take it to a mechanic and have it checked out first, maybe even the dealer to have it checked out to be safe.... which he did today. He took it to a local Ford dealer today to get them to check it out they stated that it was a coil pack that is bad on the #2 cylinder.
They (dealer) also told him a bunch of other things that was "wrong" with it, but I think a lot of it was lies just to get him to get it fixed there and make money off of him. They said it needed an intake gasket (said it was leaking a little bit), they also said, battery and cables need to be cleaned, tranny service, coolant flush, etc, etc, etc.
Once outside the guy (tech) was bringing the truck out and my dad asked him the about that intake gasket and he acted like as if the dealer makes them act like things are a big deal, or saying they may not always need what they say. He told dad alot of those 4.6L's did that and it was really nothing to be concerned about, but I don't know.
I have a 95 Town Car with the 4.6L and am familiar with these cars, but I guess the 4.6L in these F150s are different beasts. I do know the plastic intakes on the 96+ models were issues.
The park brake light stays on brake fluid level is good park brake is not on park brake switch is ok will sometimes go out but always comes back on .My son and one of my buddys also have a 2005 and have the same problem....
View 6 RepliesI have a 2005 F150 XLT with a 5.4 (198,000miles) RWD. A few months back it developed a miss due to bad COP's, typical shuddering around 50-60 MPH.
I pulled off the COPs and while I was in there I pulled my old plugs as well. New Motorcraft SP515 plugs went in with a little nickle anti-seize being careful not to get any near the end of the plug and I put a set of Granatelli COPs on with a little di-electric grease on the inside of the boot. The miss went away and the truck drove like a champ.
I will also note that I replaced the front wheel hub/rotors, front calipers and new pads. I resurfaced the rear rotors, new pads and new E-brake shoes also.
The issue I am having is under light acceleration, or "normal" driving conditions the vehicle has a mild shake which eventually smooths out.
My first assumption was that I did not torque my front wheel hubs correctly or that I messed something up so I took the truck to my local front end/alignment shop for a full inspection and they said everything is great. They also said that they didn't really feel the vibrations that I mentioned. I am used to this truck driving very smooth up until the misfire situation so to me it is quit noticeable. After the front end shop I went to Discount tire cause they mentioned that my rear wheels are bouncing pretty good and that may be what I am noticing. Turns out the tires were out of balance which Discount took care of and rotated my tires while I was there.
The vibration is STILL THERE! No CELs to reference, just an obnoxious vibration. I tried to isolate the issue by accelerating in 1,2, and in D. The issue occurs regardless of the gear I start off in.
I have a 2005 f-150 with the 5.4 engine. Bought it new and now it has 107,000 miles on it. Recently,it would have a shudder at 65 or 75 mph then the passing gear would kick on and it worked perfectly. The warning check engine light came on,then,when it acted up it would flash intermittently. Took it in to the dealership and put it on the diagnosis machine. Said cylinders 2,3, and seven were not steady etc?? So,after he took it out and drove it he said those particular cylinder walls were scored. I put in a K-N air filter at about 50,000 miles,and he said that they do not seal properly and dust got by the filter into the intake and got into the engine and did this damage. One think he found was a bad coil on one cylinder and replaced it. And just as he said,when I got on the road home I romped on it and it cut out and the intermittent signal showed again! He said that that would happen and it did.
View 2 RepliesI had the oil changed in my 2009 Prius but the "change oil" light stayed lit. Rather than taking it back in to the Jiffy Lube, I found instructions on this site for resetting the light (hold down odometer button while pressing on button twice, etc.) and the display did what it was supposed to--the numbers were replaced with dashes and it seemed like the system reset. But the oil light remained on. I tried it several times to no avail.
View 11 RepliesThis morning I went out to warm my car up for a few minutes because it has been so cold and when I started it the red triangle warning light stayed on and the consumption screen said "problem" across the top with a little icon in the upper left hand corner that looked similar to a high beam headlight indicator. I turned the car off and started it again wondering if it would clear which it did not. I left it running and went inside to get my child and by the time I came out it had cleared itself.
In typing this I recall that I thought it stayed on a little longer than normal the other day and just ignored it thinking it was still in lamp test mode on initial start up.
2005 Ford F-150 FX4 5.4 V8
So my battery died the other day when I was working on the radio and I ended up having to jump start the vehicle. After the jump start the Wrench light came on the truck or the ETC light. (After doing research I have discovered you are not supposed to jump start a vehicle with ETC)
I have taken the car to the auto parts store and it does not seem the code readers they have can read codes for the ETC light.
I have also disconnected the battery cable to try and reset the light, but it still always comes on about 10 seconds after starting the car.
I have had no issues with the vehicle despite the light. No rough idle, no starting issues, or acceleration issues at any speed. What I can do to resolve this light or what part I fried when I jump started the car?
I just installed a set of HID conversion kit on my 2005 F-150 STX. It is only one beam bulb so therefor I have no high beams. Also, to remind you I have fog lights on the truck. My question is, when I turn my head lights on, and pull the switch to turn on the fog lights, a "blue light" indicator lights up on the dash. It is the high beam indicator and why that is lit. As far as I remember, that light never came on before the install. You have to excuse me since this is my first truck ever and I just got it back after having it repaired at the body shop the last two months. So technically, I only had the truck for 2 months....Just curious whether the blue light is suppose to be on when the fogs are on the dash.
View 14 RepliesI have a 2005 F-150 and the tail lights and turn signals stopped working. Only the park light seems to work and it very dim. I replaced the bulbs and that did not fix the problem, so I checked with a volt meter and I'm only getting 6 volts to the socket. Fuses appear to be good.
View 1 RepliesI have a 2005 f150 with 96,000 miles. Long story short, last August I was headed to the mountains going up a steep long hill and the engine light come on. once i was over the pass the light went off. During my 4 wheelin' trip it never came back on until I was headed home and going over another pass and then it stayed on for a couple of days. I had it checked and it was a cylinder 5 misfire. I did some research and found that replacing the coil cover might fix the problem and if not the spark plugs would need to be changed.
I changed the coil cover, problems solved... until I headed to the mountains. light came on and then eventually went off later that day. I didnt think much of it. then a few months later i was headed to the mountains again and the light came on in the same place on the steep incline hill. I. took it back to the shop, same reading. I decided it was time to replace the spark plugs anyways so I would invest. I have new plugs and everything is good however, I had no plans to go to the mountains in the near future. Now, a few months later I headed to the mountains and crossed my fingers it would not come on but it did.
I've done the research again and it seemed like the coil cover and spark plugs are usually the cause of the problem...however I have changed mine. The light is now off again. I don't understand what is triggering the problem and what is really happening and if it is safe to keep taking to the mountains with this happening. I did notice that everything was fine at 60MPH but once i hit the hill and steeped on the gas to go 65 and hit 4-5RMP that is when the check engine light came on...
My dad has a 2005 Ford F150 and his airbag light buzzes and flashes. We counted and it flashes 5 times then short pause then 1 flash then long pause and restarts. Also I dont know if it is related but his cruise control doesnt work either.
View 9 RepliesOk, I changed my front brake pads and rotors last week and since then everytime I get in the truck and drive for about the first 2 or 3 miles when I push the brake pedal it feels like my ABS sytem is activating. Then it stops and the ABS light comes on but the brake pedal stops pulsating when depressed. Is my ABS going bad or did I possibly do something wrong? I have changed the rotors and pads before without problems....
View 3 RepliesMy transfer case will only pull vacuum to the hubs when floor shifter is in between 4 low and 4 high. as soon as the dash light comes on for low or high it looses vacuum. Is there a switch that tells it to pull vacuum? Any good breakdown of the transfer case?
View 6 RepliesI am having a minor problem with my 05 F150 Lariat. Under light acceleration going up a slight grade the truck sometimes shudders (vibrates?). If I let off the gas or accelerate slightly it stops. At first I thought it was a feedback loop with the electronic throttle so I had the dealer reflash the computer but that didn't fix it. I've noticed that it happens right about the time the torque converter locks (looking at the tach) and I'm sure it has something to do with torque converter locking up and then disengaging continuously. Funny thing, it seems to happen frequently on the same hill at the same speed. What was done to fix it?
View 14 RepliesHad the check engine light in the 2005 F150 (90,000 miles) come on. Got the code checked and its P0420. I know that has to do with the cat threshold levels etc. so I believe I am looking to replace the o2 sensor, if I am not mistaken.
How hard of a job is this? Ive done a decent amount of engine work and worked in a shop in high school. Just looking to see if that is the right thing to try first, replacing the sensor, before replacing the cat.
Also I know its the right bank, but if I am not mistaken there is a before and after the cat o2 sensor, which do i replace? Both?
I have an 05 F-150 Lariat 5.4 and it has been going haywire today. While driving if I hit a hard bump the power will cut off (radio, a/c) and even sometimes the truck. Check engine light came on and I pulled codes P2160 & P0506. Also, when it completely cuts off and I start it back up it says "engine in failsafe mode".
View 1 RepliesMy cat converter is rattling on driver's side and check engine light is on. Rattle is the inside of the converter, not the heat shield. How much $ and what kind of converter replacement is recommended?
View 10 RepliesLast night I changed out my alternator and charged the batteries on my Excursion. When I went to start it up the ABS light stayed on. I scanned for codes but no luck there.
View 2 Replies97 Ford F150 4.6 V8 230+ thousand miles. Driving this morning, the ABS light came on and started blinking then the blinking stoped for a minute but the light stayed on. It did this several times untill reaching the destination. The brakes worked properly the whole time. Started the truck after shutting it down and the ABS light stayed on and the shifter would not come out of Park. What could be causing the light to blink and is the shifter not moving related to the light?
View 3 RepliesSo I get in my X today and she fires right up as usual... Then the battery light started blinking then stayed on... Then I hear a click and all my stock gauges go out my window and lock switches don't work and my radio doesn't work... Battery light stays on and all signals work as do the mirrors and everything else... I turn the truck off then back on it all comes back on.. 15-20 seconds later I hear the click and all the same stuff is off again.... No seemingly applicable fuses are blown... And the behavior is repeatable...
View 14 Replies