Ford F-150 - 1997-2003 :: Rebuilt Tranny Shifts Hard When Going From 2nd To 3rd And 3rd To 4th
Apr 15, 2014
I just had my tranny rebuilt it doesn't shift hard all the time but it does from time to time going from 2nd -3rd and 3rd -4th I thought being new it may need to soak up some fluid so the bands can swell so I ask the shop that rebuilt it that question he said they soaked them as they rebuilt it so they should be swollen already then he proceeded to tell me it was electrical is he telling me the truth because the ck engine light isn't showing any faults and if it was electric shouldn't that have been fixed in the shop while it was being rebuilt if it was interior electronic?
View 1 Replies
Advertisement
Have an 01 f150 super crew 4x4 with 5.4 li shifts hard from 1st to 2nd - What could be the problem?
View 1 Replies
I have an 2003 F-150 4.6L with a 4R70W transmission, the speedometer goes crazy while I drive, the truck feels like it kicks in & out of overdrive, it shifts hard, the o/d light flashes while driving and I cannot use speed control. I have already checked the transmission fluid, changed the speed sensor, & the range sensor. After changing the range sensor the truck ran perfect for 3 days then the same problems.
View 5 Replies
I am first time ford owner of a 2003 ford f150 super crew fx4 with the 5.4 Triton and lately when I accelerate hard and it down shifts. It shifts excessively hard or when your going slow and the have to accelerate it also shifts really hard i dont know if it is the diff the U-joints or if its the transmission.
View 4 Replies
I have a 2011 camry se 4cyl with 15k miles. Just wanted to know if you have to change Trans Fluid because my tranny shifts hard between gears.
View 3 Replies
I have a 2008 GC 6 speed transmission that has 55000 miles on it. When the engine and tranny is cold the transmission shifts very hard until it warms up. There are times when shifting from reverse to drive it shifts very hard. Also, the siding doors creak when driving over rough roads. Can they be adjusted?
View 2 Replies
'00 PSD w/ 291k on the clock. Starts easily, runs good, only complaint is (what I consider to be) the soft shift of the tranny. Years ago, when I bought it, it came with a Super Chips Tuner. I've never max'd it out, just usually run on the performance tow. Is there any way to clean up the shifts and make them a bit quicker with less slip. When it's time to shift, dammit, I want it to "SHIFT", not slide into gear. I don't expect it to hit the gears like a manual valve bodied drag car tranny. But, there should be something to fix this without spending a bunch of $$$..
View 4 Replies
My husband's starter went, so he took it in to be rebuilt. After my husband reinstalled it, as soon as he connects the battery up, the starter engages without the ignition on (not even a key in the ignition). Did the guy who rebuilt it screw up, or is there something my s/o might have done wrong when putting it back in?
View 11 Replies
I have 2 problems and the other is posted. I have a 99 silverado 4x4 Z71 with 149,000 miles. Just had my tranny rebuilt (all new parts including electronics). I just gave an oil change using castrol high mileage oil 10w-30. I used to use castrol 5w-30 regular oil. I just noticed an oil leak on my driveway. It seems to be coming from the tranny housing (rear main seal). I have wiped it down and am still looking for the source of the leak. I have rechecked the drain plug and the oil filter and both are tight.
View 14 Replies
I had the transmission rebuilt a year and a half ago, when I took it in it came up 4th gear incorrect ratio. The guy who rebuilt it said it wasn't the original tranny that came with the car because it was modified to fit in the car. When I got it back, after a couple hundred miles or so, the check engine light would come on for a day or two then go off. When the check engine was on it would get stuck in 3rd gear, once the light went off all was well until the next time. I took it back to the guy who rebuilt it since it was still under warranty. the P1529 code came up for TCM issue. He put some sensors and a chip in and thought it fixed it, no such luck. Finally I had the cash and had it looked at by another shop and the 4th gear incorrect ratio came up as well as the P1529 TCM code. He's suggestion to fix it was to either get a used tranny or rebuild this one again. He believes since it isn't the original tranny that the tranny in there now was for a SOHC engine, not a DOHC engine and that's why the ratio in 4th gear is off and it throws the TCM code.
View 6 Replies
My 1997 F250 Heavy duty shifts very hard and sometimes feel like it slips out of gear (i press the gas pedal to the floor and speedometer rises very slow and truck doesn't move like it should.
View 14 Replies
I have 99 f350 v10 4x4 and trans shifts great under light rpms but 2-3 shifts very hard. At wide open from about 35 mph it will shift down and take off like a bullet but wont shift until I lift my foot and then it bangs hard from 2-3. All other gears are smooth. I did some searching and have found some threads saying it could be an accumulator spring that is broken? Truck has 115,000 miles on it. love the truck but want to fix this before it does some damage.
View 1 Replies
The first has I replaced my tranny with a stock 4r100 tranny and torque that only has 75k on it. The guy was doing a 6-speed swap. After I had the tranny and torque converter and a new tranny cooler installed, the tranny shifts real hard. I think it may be from my DP Tuner. Even on my economy tune driving it very easy sometimes, it jolts into gear pretty good.
I was wondering if I could just get a shift kit to maybe correct that and if so if I would have to drop the tranny to install the shift kit. I saw a bully dog kit for like 75 bucks, however, I don't really have the money to have the truck in a shop and I would really like to not drop the tranny and not lose all my tranny fluid if possible (very expensive).
Also my other issue, the truck in warm or cold weather is very hard to start. Half of the time it takes two tries to start it. It will crank and crank and no go. Then the second try it fires right up. It has two new batteries, where do I start? Is it possible that the starter is just getting old or is it fuel or oil pressure related possibly?
View 2 Replies
2001 7.3 auto, 2wdr, 291,000, Transmission sometimes shifts hard from 1st-2nd, 2nd-3rd. Problem started after I found trans dip stick tube broken and loss of fluid. Anything I can do without going to a shop. I've replaced the Broken Tube.
View 2 Replies
I have a 03 4x4 5.4lt supcab with 154k miles. I replaced the shift motor about 40,000 ago but it has always been tempormental like I had to engage it in 4lo in N and then shift to 4hi to keep it in 4hi. Now fast forward to today. Went to shift to 4lo in N and it didn't shift. I only heard the relays click once and then it wouldn't shift into any gear even though the indicator was on PRND123. Didn't matter.
Also, Park didn't engage and the speedometer acted like it was engaged in RN and D. No movement what so ever. I think it might be the shift motor that shifted part way and is stuck in between gears. Is this possible? I drove fine to the dirt road and I haven't had problems other then the shift motor being touchy. I don't want to pay for a new tranny if it might be the shift motor.
View 5 Replies
I have an 01 4x4 Ext cab with the 5.4 auto. It just started to shudder in drive doing about 20-35 mph, it quit when I turned the OD off and has not come back yet. It also jumps in and out of OD while running highway speeds, kind of like hitting a bump or something like it. The shudder was in about 10 degree temps and not fully warmed up and the jump happens whenever I am at speeds around 60-75.
View 7 Replies
03 F150 2WD-I dropped tranny pan, changed filter, reassembled, put in 4 qts fluid. Checked dipstick, seemed to be overfilled, despite instructions to add 5 qts. Started truck, put it in reverse, went about 4 feet and then tranny wouldn't engage-ran it through all gears, just acts like in park or neutral. Over or Under filled???
View 4 Replies
How much tranny oil it will take for just a pan drain and filter change, 2000 f 150, 7700, 4x4, 5-4....
View 3 Replies
I just bought a 2002 F250 7.3 4x4 auto. It had a TS 6 position tuner installed. In stock mode, I got about 11 mpg. I wasn't too impressed. I found that when I left it in 75hp mode, my mileage went up to 21. I drive easy and try to keep shifts at or below 2,000 rpm. The problem is that, when in any position other than stock, my transmission shifts HARD.
My question is: what's going on here? Does the TS change the transmission shifts? Or is the extra bump in power enough to stress the tranny? Based on the factory gauge, the transmission is not running hot. The fluid is nice and pink with no odors or metal shavings. I'd hate to prematurely kill my transmission, but nearly doubling my fuel mileage is hard to pass up.
View 14 Replies
I have a 2000 F-150 that shifts way too early. By the time I hit 30mph it is in overdrive. Does not slip and has firm but early shifts. I am thinking the speed sensor...
View 14 Replies
Here is my issue. I have a 2000 e350 7.3 the overdrive light is flashing, the speedometer and the odometer isnt working it also shifts hard, i changed the vss, the vss plug, range sensor, and alternator. still acting up. also all the fuses are good.
View 8 Replies
