Ford F-150 - 1997-2003 :: On Takeoff Weird Knock Sound?
Nov 8, 2011
So for the past few months I have been hearing a knock sound when taking off from a stop. It does it every time, and its loud enough to hear distinctly. It sounds like it is coming from underneath the cab, maybe the trans or rear engine area. I thought maybe a mount. It only does it when taking off from a stop it does not do it while driving. Where to start. I hope it isn't serious, at this point it is more annoying than anything else.
View 8 Replies
Advertisement
i have a 1997 150 4.6l with 166xxx miles. when ever you go to take off there will be no power and then all off the sudden it will shoot up too 4000rpm and then you back off it will be fine. Until you stop and go again. Also when ever you come up to a stop it drops down to 500rpm. What might be going on?
View 14 Replies
So I have an issue with my 03 f150, Basically It clunks in various scenarios such as Accelerating also occurs take off and general breaking/slowing down but not really when stopping. December when it was cold and I was decelerating (not on the break just coasting) it feels like i was driving on the shoulder.
It does it much more in cold weather. Just had the truck out getting a little rough with it for 5 or so hours today and 0 issues with it.
I was thinking it was a slip yoke issue that I hear allot of trucks have the issue but I was at the dealership today and both guys and a mechanic sitting there were like "never had that issue on an 03 f150, might be your back end." They also stated the clunking would always occur and be more prominent when breaking which its not.
I am certain its not the transmission its not occurring with any shift point. Kind of hard to do it if its hard to reproduce in the heat.
View 9 Replies
I have a 2001 5.4 4x4 supercrew with 300,000 miles.. This truck is my baby. Recently when I start it up and after putting it in gear and begin taking off my engine is loud as if I am revving the engine without any indication in the rpms. I want to say it starts out on the trip a tad sluggish. Is there anything I can do to eliminate?
View 1 Replies
Last August I bought a 2002 Ford F 150 extended cab 4x4 only until the weather got really cold did I start noticing this kind of like almost vibration or like the rear end is slipping but it doesn't happen all the time it only happens when I take off but once I get driving then it goes away...
View 4 Replies
My husband bought a 1997 Ford F150 and the seller said he changed the brake lines, but the back brakes have dragged on takeoff since he bought it. Just put new shoes on it and it's still doing the same thing, but now the drums are getting hot. Is it possible that the seller got the brake line backwards and that might make the back brakes drag?
View 2 Replies
Ok so I have a 2001 f150 4.6l 4x4 I purchase it recently and have been having some issues it has a huge power loss on take off and even while driving I have changed plugs coils tested almost every sensor and am at a loss at this point. No check engine light on or codes...
View 8 Replies
I bought this truck with 60,000 miles and have had about 3 months. I don't drive it very much but when I do I have noticed that when it sets for 4-5 days or longer the transmission makes a weird noise as you take off and does does shift into gear as it does when I use it ever day. The problem goes away very quickly (not even a 1/4 mile driving) and everything is fine after that. By the way I took it to the ford dealer who did a complete 60,000 mile service on it that was suppose to include changing the transmission fluid and filters-could they have screwed something up (I did not notice this issue until after the 60,000 mile service?).
View 7 Replies
I have a M5OD that I replaced the clutch in in my '99 150 4wd in December . Manual Tranny. Now when taking off in 1st gear the transmission seems to be sliding or shifting backwards, but only in first gear. Got under my truck and looked, can't find any identifying marks to where it might be moving or what is causing this. All frame mounts are tight and the bell housing is flush with the motor. Yes, i did do the clutch change myself in shop class.
View 1 Replies
Vehicle: 01 F150 5.4 4wd
issue: snapping sound like crushing tin can at take off and now at a fast stop.
Repairs already done:
upper control arms
lower ball joints
Sway bar link and bushing
4wd cv axle shaft assembly (both side )
Slip yoke grease.
Tie rod ends replace inner and outer
I put the truck an a lift and put it on drive and there is no sound.
View 2 Replies
I've got a 2003 F150 4x4 supercrew that's got a 9.75" rear end with 3.73 gears. I just replaced clutch packs and spider gear set 2 weeks ago. The last day or two I have noticed that when I make sharp turns that it get a whining like spinning noise. It sounds to me like the spider gears are spinning. It only does it when making sharp turns. There is no noise going down the highway or normal driver. I have noticed at times I get a little shutter when I go to take off or back up. Kinda feels like a brake is hanging. I put friction modifier in when I did the clutch packs and everything. Maybe not enough?
View 5 Replies
I am having a hard time locating a mechanical knock coming from my truck. This is not an engine knock but rather a clunking noise when I come to a slightly abrupt stop and sometimes when I take off or am steering. I have recently replaced my upper and lower ball joints and all the u-joints as well. My truck has a 6" Fabtech Coil over lift and a 3" body lift. The truck is also rather squeaky when going over speed bumps.
View 8 Replies
This is on my 98 F-150 4x4 with the 5.4 and 4R100. What happens is when I put the truck in reverse and get on and off the brakes, every time I do so a relay clicks. It sounds like it's right up behind the instrument cluster.
I stuck my hand back there and can feel the click resonating in the metal brackets, but I can't figure out where it's coming from. It's never done this before and I'm worried something may fail at an inopportune time.
What this may be? It's a really loud click too and only does this in reverse. Park, drive, neutral etc. are all fine. The odd thing is when I hear the click everything still works as normal, parking lights, brake lights, reverse lights.
View 10 Replies
I have a 98 expedition with the 4.6l 4x4 and it has 158,000 on the dash had a new engine installed at 100,000 it started running rough and sluggish last week so I changed out the spark plugs and while changing the plug I notice oil on the threads of the two rear passenger side plugs. After the new plugs it was smoking pretty bad blueish white smoke. I figured it was the oil from around the threads that had leaked into the cyl.
The smoked cleared after 2 days and ran great for a week. Now its doing the same thing again real rough idle and and its extremely sluggish. I can put the pedal to the floor and she barely wants to move almost like the tranny is going out but the rough idle leads me to believe its and engine problem. I have the check engine light on but can't get any codes. I also tried checking for vacuum leaks by spraying either round the intake and vacuum lines and didn't notice any change in rpms so I'm guess the vacuum is fine.
View 7 Replies
1997 F150 4x4 210,000 4.6L Windsor 5 Speed. Engine totally rebuilt 15k ago (besides for timing chains and tensioners). No codes thrown.
This morning when i started my truck, it made a knocking sound (almost like metal slapping) that seemed to be coming from the bottom end of the engine. At first I thought it was a spun bearing, but then the sound went away after a minute or 2. I have Google'd the problem, and have found a few diagnoses such as: oil draining back from the filter (or something like that), or an exhaust manifold leak that stops when the metal warms up and expands, or even the starter motor not being aligned right and not disengaging properly...
This is the first time this truck has ever done this. I changed the oil and filter about 1000 miles ago with 10w-30 oil and I believe a WIX filter. Also, this is the first time using the WIX filter
The weather this morning was around 51*F, so not too cold (to me).
Also, a few weeks ago when I changed my oil, I noticed milky white stuff only on the bottom of the oil cap, and in the feed neck. The rest of my oil looked like perfect used oil. After I noticed the milky stuff, about 2-3 times a week I would clean the stuff out of the neck and off of the cap. Just recently, there hasn't been as much milky fluid. My coolant level has not changed since I marked it during the oil change. A few buddies have said it might be condensation, but it's never been like this before.
I guess my question is, is this something that could put my truck out of service if left untreated? I'm assuming it's not a spun bearing because the noise goes away, but is there a possibility coolant could be leaking into the case but stay the same level in the reservoir?
View 8 Replies
Had it before, code p1401. Changed out dpfe and it worked for 6 months. Now spark knock again. Now though I have no codes though. No vacuum leaks that I can find. New egr from before I had the problem. I applied vacuum to the green hose and it stumbled so the ports should be ok. Snytime I go above 3000 rpm i get the pinging. I replaced the dpfe again and no difference.
View 3 Replies
I have a 2000 F-150 xlt off road with a 5.4. I have owned the truck since 2001. The truck has 170K miles on it and I change the oil between 3-4K miles. The last couple oil changes I have I have noticed I haven't been draining as much out as I usually do, this past oil change was about 3 quarts low. I thought it was very odd. The truck runs great and does not smoke or leak oil.
This morning I got in and noticed a tick or slight knock, thought maybe it needed warmed up. After a minute. I shut it off and checked the oil, to my surprise there was next to no in the engine! This has me very worried now. I haven't checked my coolant since last oil change so I'm not sure if that's where it's going. Where to start looking, I'm missing like 5 quarts of oil in 3300 miles. Again the truck run great and does not smoke at all. I was getting ready to change it this weekend, always run high millage 5w-30.
View 8 Replies
1999 F150 New 5.4 ~350 miles on it. Longtube Pacesetter Headers with cometic mls gaskets. Stainless bolts.
It is making a knocking sound and I can't tell if it is internal or from the headers. I have a video that I hope you all can tell what is. I tried listening to the block with a yardstick, but I couldn't notice a significant increase in volume but my hearing isn't the best. I made sure all the header bolts were tight, but no change in sound.
YouTube...
View 6 Replies
I've got a 97 truck, broke the crank, swapped in a motor from an 07. Heads down is 07, intake up is 97. had heads planed and a valve job with new seals done. Left it alone from the rings down. Got it in this weekend, running today. Ran it in the driveway with no load for about 30 minutes, top end was noisy for about 5 minutes till the top end got good and oily (I'm assuming). Purred like a kitten, sounded real smooth. Took it for a drive around the block, heard the clatter in the video below. It's almost always there when driving. Brought it back, turned it off to check oil, it was a quart low. Added oil, startup was VERY labored with a real hard knock in the bottom end. Ran like poo till I gave it some throttle for a couple seconds, then it cleaned up and idled well. Let it run for a couple minutes, turned off and let it sit for a couple minutes then started back up, same thing. Very labored with hard knocking.
View 2 Replies
2003 Hyundai accent GL 5spd has new rings/bearings/lifters and all gaskets (when i got the vehicle it over heated to the point it shut off ) figured it was just a head gasket so replaced it found out rings were shot.. so that's the jist of it. okay so she's timed right spot on but when I go crank up the car it cranks over fast and i have to feather the throttle to get it to startup the IAC makes a weird buzzing sound and wouldn't idle right so i unplugged it and it'll idle fine. When it would finally crank up and idle she drives really well put about 20 miles on her so far just the starting issue pissing me off. I'll post a vid of it trying to start for better description...
View 1 Replies
I have just finished changing head gasket. I started up the engine works fine. But I hear a little clik sound form the converter. I put it in gear, but it can't move either forward or backward. It ran 2-3 liters of oil out of the converter when I took the engine out. I have filled new oil in the gearbox but not in the converter, dosnt it came form the gearbox into the converter?Is there air in the converter or what's wrong?
it is a F150 4x4 4.6 1997 automatic.
View 14 Replies
