Ford F-150 - 1997-2003 :: Older 5.4 Engine Swap To Newer From E-series?
Jun 5, 2015
Having older 5.4 truck tried to swap in a newer 5.4 2v from a E- series? The vans never got the 3v engine. I have a 2001 5.4 w/150000 miles, and I have a line on a 2008 5.4 2v from a E-350 with only 30,000 miles. Any issues/problems with the swap?
View 2 Replies
Advertisement
I have a 2000 f150 5.4 4x4 auto with a bad engine, and have 1997 f150 4.6 4x4 auto rolled but with a strong engine. What would need to be done to replace the 5.4 with the older 4.6 engine?
View 1 Replies
2001 5.4L 4x4...Engine bought from reputable junkyard with 140K has new manifold studs, motorcraft spark plugs, and 8 coils (bought on Amazon).
No check engine codes...checked for vacuum leaks...And has rough idle.
Is there a reason it might have rough idle aside from blown motor? The mechanic was going to take it to get computer reflashed but not trying to throw money down the drain...
View 6 Replies
I have acquired a 4.6l DOHC out of a mid year 85 mustang cobra, would like to install in my 2000 F150 that has a 4.6l sohc, what is available for ECM with the swap?
View 2 Replies
I have a 2001 ford ranger 2.5 and a standard 5 speed. Its been knocking for a while now and recently its made a much lower tone knock, I am thinking I may have thrown a bearing. Also I am wondering what other engines I can use, besides the 2.5.....
View 3 Replies
My names brad. I have the old model 97 . Is it possible to swap the cab to a 4 door. Its got a 8ft bed
View 1 Replies
I have A 1986 ranger with a 2.9 v6. I am thinking of doing a diesel swap and I am wondering what engine and trans combos would work best for this. I was thinking 4bt but there are may other options that could work.
View 14 Replies
Ok so I've done a lot of searching but can't find any info on how to repin the harness to use the 2000 4r70w in my 2002. Both are 4x4 and came behind a 5.4.
View 4 Replies
Is it possible to put a 7.3 ltr from a 1997 van in my 2004 f250.....6.0 has cost me my fair share and would like to swap, 7.3 was giving to me because body is smashed i know engine is good , runs and drives
View 3 Replies
I replaced my 7AFE engine in my Celica 1997 1.8 with another 7AFE engine. The replacement engine had a different wiring harness, so I kept my original wiring harness.
After the swap, I started the engine and it stopped by itself after about 30-60 seconds.
Now it wont start. I have fuel, but no spark. I have tried three different distributors.
I have tried to read the fault codes, with connecting TE1 and E1, but no engine light lights up in the dash.
View 12 Replies
Did the swap and all works good except the boost is often at 3psI then sometimes it works good. Used the 03 harness. So did I need to change a wire or sensor or use 03 pcm?? I was told maf sensor might cause issues but no codes for it.
View 10 Replies
We put in a used engine (2003 Accord 3.0L V6) from a Junkyard over the weekend, and now it won't start. It'll turn over and fire on a couple cylinders, but not enough to start. Doesn't seem to matter if spray a little starting fluid in the Throttle body while trying to start it. It sounds normal while turning over, put in a new timing belt while it was out, and turned it over by hand 6 times to verify correct install before reassembling.
View 3 Replies
Can I swap my 2 piece out for a one piece in my 88 ranger supercab? It is a 4x4 5 speed.
View 8 Replies
Will the transmission from a 2000 fit a 96? They're both 3.0's.
View 3 Replies
1991 Ranger 4.0L A4LD... Its a 4x4. ext cab
What else will bolt up to this 4.0L? Could i put a 4R44E/4R55E tranny? Is there a good stick that bolts up?
View 5 Replies
Will a driver door from a 92 ford ranger fit a 93 ford ranger?
View 5 Replies
I have a 1987 ford ranger, it has a 2.0L carborated motor and I also have a 1994 ford ranger fuel injected motor I believe it's a 2.3L, I am wondering if the swap will work to put the 94 motor in the 87....
View 3 Replies
Im wanting to get more power out of my 94 auto supercab but I don't wanna kill mpg it has 3.08 gears I was thinking swap to 3.55 to keep mpg would there be noticeable power difference?
View 6 Replies
So I want to add a backup camera to my truck. Ive got a headunit that will do it but I dont like how any of the aftermarket one really look and I dont like most of the locations to mount or the angle they mount at. So my question is will a tailgate handle from say a 2010 that has the factory hole for a backup camera fit in the spot of my 2001 tailgate handle? I have to replace the handle anyways since it broke this past weekend, thought Id add the camera while I was at it if I can get it to work like I want.
View 7 Replies
I have found a 97 explorer 4x4 with a v6 and auto trans priced really cheap. It has something called control track on it. Everything is in real good shape except the trans. It only works in reverse. Is there a common failure on these trans that might cause this ? from what Ive read this is a awd set up. that's is 4wd -all the time. If the trans is a major repair I would rather do away with the awd and convert to a simpler 2wd. Would such a swap be advisable ? I m wondering about wiring harnesses, sensors, cars computer, etc.
View 1 Replies
I am Hearing a series of 5 one second tones about 1 minute after starting. There is no indication on the dash that anything is wrong. There are five tones about one second long. They repeat five times and then stop. The truck appears to be running fine. What is this?
View 1 Replies