The passenger side power window sounds a little rough, almost like a slight grinding and it raises and lowers slower than the driver side.
This is kind of what happened when the plastic gears crumbled on the passenger side of my ranger. Does this sound like bad gears or could it be something that needs grease?
My friends truck is having a problem, and I haven't found any info on the specific issue. when you shift from P to D and accelerate, there's a slight grinding clatter in the tranny i think, bump it to 2 and the noise is completely gone! pull it to 1, and there she is again, also in reverse it does this, speed is not a factor, only the specific gears. i had read a thread which mentioned a "sun gear", and also that 1st and R are on the same bands?
I believe it was for a manual tranny that I had read about, but what this could be?! he's got a slight drag on the rear brakes, i assume it's his E-brake, could that have caused a transmission failure? We've removed the driveshaft and checked u-joints and all, nothing there, but when the truck reverses on the ground, you can watch the driveshaft bounce like it's binding. We grease the slip joint while we had it off, and we were able to spin the rear wheels by turning driveshaft w no problem while off the ground.
I have a 2001 f 350 7.3 diesel r 400 tranny 320000 miles. . Im having transmission issues. It makes a slight whine/ grinding noise only in first And reverse. And it surges. Sometimes its fine though to. Check engine light came on. Only codes i get are #4 glow plug out and a low boost pressure. Checked boost before fixin Running fine at the normal about 20 psi. ive read a bad or dirty map or iat sensor can cause transmission issues along with the low boost error code. But in my experience and some reading it sounds like a stall converter.
View 9 Replies2003 f-150 Supercrew 4x4 ... I have no power to my windows door locks, power seat, mirrors a/c, anything is the a module that controls all of that stuff? Where is it?
View 2 RepliesMy 97 f250 light duty has give me fits. The power windows do not work up or down either side, no door chime or pdl either.i think this is related to the gem module cause I have run a 12 v to the motor itself in the door and it goes up and down.checked all fuses and switched relays.I don't even hear any clicking relays.I have spliced into the orang/white wire at the 2pin connector to the motor and have hooked it to a purple wire on the back of the window switch and now have pdl,and door chime,and hear clicking under dash but still no windows.What am I missing is there another wire to splice into?
View 1 Replies1998 4X4. My rear suspension is so loud and noisy it's driving me crazy. I've soaked the thing many times with wd40 but it doesnt seem to work or work not more than a day or two.
I've tried to make a pic with my phone because I think at the rear side of the leafs they are separating way too much... I've got no more than about 150lbs and a LPG-tank on my bed...
Moreover I think my truck rides bad. I know it's no Cadillac and I'm running 33s and its a 4x4 BUT I've got quite new Rancho shocks and the whole front suspension is in good shape and it got an alignment a month ago...
So what do you think, after 181.000mls time to get new rear leafs or take the old ones apart, free them from the rust, paint & grease them and put them back together?
I have a 98 F250 Supercab XLT. 4wd with 3:73 gear ratio. twist 4wd on the dash. Truck runs great but when i switch to 4wd it makes noise and occasionally will pop out of 4wd. The noise starts at almost no speed. I can hear it at less than 5 mph. and only gets worse as i increase speed. (sounds like a bad wheel bearing) - But only in 4wd/ nice and quiet in 2wd.
I used sensors and ear phones to pinpoint the noise. It appeared to be coming from the front differential. I opened the pumpkin found clean fluid and no metal bits or any visible unusual wear. I changed the front diff. with another used unit. The noise is still there strong and unchanged. The wheel bearings and axles seem to be all right.
Been trying to isolate my noisy serpentine belt. Had the belt off and spun everything, only thing I found that made any noise was the alternator. It had a nice churp like a bearing was on its way out in it. So I replaced that figuring my squeak was going to go away. No such luck. Listening to it again while it was idling, I crawled underneath. Almost seems like the churping noise is coming from the Crank Pulley. Is there a bearing on this pulley that goes bad?
View 13 RepliesI've had this "rattle" when going over uneven roads for about the past few months and I think I narrowed it down to the rear calipers. They are both tight, but it seems as though the "floating" ability of the caliper is loose.....does that make any sense? I mean you can grab the caliper and it'll make a rattling noise, but the bolts are tight..
View 5 RepliesI haven't really gotten under it to check this out, but my truck (see signature) has a slight vibration on take off. It only does it when the wheels are turned to the right or left. They don't have to be turned very far either. It doesn't do it on straight line take offs, or on a take off from a rolling stop. ONLY when pulling off from a dead stop and the front wheels are turned any degree to the right or left. I'm running mostly bald all terrain tires, the wheels are not bent. My current wheels are new to the truck, and the problem was there with the previous rim/tire combination. The rear end doesn't seem to have any slack in it. The transmission shifts like a top. There are no other clanks or vibrations anywhere in the drivetrain and it drives good.
View 9 RepliesWhite 1997 Explorer XLT 4 door 4x4 4.0 sohc 220,000 miles. The power windows and locks don't work. I've tried all of them in the whole car and nothing. Replaced all fuses at the inside panel and replaced all fuses and relays under the hood. Replaced master control switch on the drivers side and still nothing.
View 1 RepliesGot some road noise going on always noisy while driving straight or turning to the right. If I take a turn at speed on the highway to the left the noise stops. Sounds normal, once I straighten out the noise returns. So my thoughts are clearly drivers side, but not 100% sure where to start my search. Wheel hub is my first thought, is there anything i can do to check if the hub is good since they are sealed?
View 4 RepliesI have a 2000 F-150 xlt off road with a 5.4. I have owned the truck since 2001. The truck has 170K miles on it and I change the oil between 3-4K miles. The last couple oil changes I have I have noticed I haven't been draining as much out as I usually do, this past oil change was about 3 quarts low. I thought it was very odd. The truck runs great and does not smoke or leak oil.
This morning I got in and noticed a tick or slight knock, thought maybe it needed warmed up. After a minute. I shut it off and checked the oil, to my surprise there was next to no in the engine! This has me very worried now. I haven't checked my coolant since last oil change so I'm not sure if that's where it's going. Where to start looking, I'm missing like 5 quarts of oil in 3300 miles. Again the truck run great and does not smoke at all. I was getting ready to change it this weekend, always run high millage 5w-30.
Recently noticed when driving, I'll hear and feel a slight clicking noise coming from my steering column. I can be going straight or turning. it is intermittent. I've look underneath and nothing seems obvious. when the truck is in park, I've tried to manhandle the steering wheel, the steering wheel is solid. the truck is a 1998 f150xl v6.
View 1 RepliesI have 2002 f150, fx4, ext cab, 110000miles 5.4 automatic truck, i just replaced my spark plugs, it still have a little miss, thought spark plugs will resolve but its the same, im wondering if i should change O2 sensors? clean EGR Valve? IAC valve? i am not getting good gas mileage and maybe its this missfire or something, its runs good without any problems, just this slight miss makes me think if its the cause to bad MPG.
I tried to find threads with pictures of how to change O2, how to clean EGR, and IAC, i remember seeing these threads but cant find em. And you think these three things will resolve my MPG and the slight miss?
I have a 2001 f150 5.4 with 200,900 miles. Just bought the truck about six months ago off my dad when he got a new one. I am now experiencing what seems to be a slight misfire. With the hood up pulling the throttle around 2200 rpm starts making a loud knock. Above that rpm nothing and below that nothing. Standing by the tailpipe it sounds like a small backfire. It Idles really rough and when you get that sound out of the tailpipe it jumps like its hiccuping. And tailpipe is vibrating quite a bit.
Things I have done in the past month include replacing the pcv valve, changing spark plugs, cleaning throttle body, cleaning MAF, took down exhaust to check cats because i was experiencing a power loss and bogging. When the exhaust was off i punched the two rear cats. I ran a bottle of iso heat in the gas. Everything seems to have supported the power problem but now less than a week later i am starting to experience the knock and backfire type sounds.
I have a 97 F150 4.6. The truck has developed a slight stumble/misfire when under acceleration. Once at speed it runs fine. It has not given any codes. I've checked for them several times. The plugs and wires have been changed. Is it possible that a coil pack could be bad without throwing a code?
View 3 Replies99 f150 xlt power windows. My friends always like to roll my windows down to try and smoke cigarettes. I was wondering if there is any way to install a window lock maybe a switch that turns on or off but still allows me to control the windows from the drivers side.
View 2 RepliesWe initially had problems with the functioning of the power window. Changed the motor and the relay. All seemed well. Now when the car is initially turned on the dome light has no power, the wipers or the power windows. After a few minutes the power may return on not at all......
View 1 RepliesI have a '13 6.2 with 11k on it and it's started making a weird noise since the temp has turned cold. At first I noticed a slight whistle at certain rpm's but the temps were around 0 so I didn't think too much of it since stuff gets noisy the colder it gets. Today the temps were in the upper teens and I'm noticing a new sound. From around 1000-1500rpm I'm getting a whining sound that is noticeable in the cab. It's coming form the engine since it does it while sitting and I can make the sound appear by getting the engine at the correct speed. It's louder when the engine is cold but I can still notice it a bit after the engine is at operating temps. Below 1000 and above 1500 rpm there is no noise. I never really noticed it before, but since I heard the slight whining last week I've been listening more and I know that's when you start hearing noises that you normally wouldn't pay attention to.
View 1 RepliesI have a 2000 F-150 4x4 with a 5.4 engine. On two different occasions, I have been driving down the highway about 70 miles an hour down a slight grade in OD. When I let off the gas to coast a little the truck will downshift. press on the gas again, the truck goes back into OD. I do this a couple of times and then it wont do it again. What might be happening. Truck has 82,000 miles on it. I am the only owner. Transmission fluid changed a year ago.
View 6 Replies