Ford F-150 - 1997-2003 :: No Activity With Cluster When Turning Key On / Truck Not Starting
Apr 18, 2017
I have a 2002 F150. I have an intermittent issue with truck not starting. It turns over fine but will not start. Also, when having this issue, there is also no activity with the cluster when turning the key on (other than lights lighting up); the gauges will not move as they would normally when turning key on. I have checked every fuse inside / out. I have checked the fusible link at the battery as well as any other connections I could locate around the solenoid as well as disconnecting the ECM / computer and re-plugging it back up. Typically, after letting the truck sit for a day or so, it will start back up until next time.
View 5 Replies
Advertisement
1996 f150 sometimes it starts sometimes it don't. It is cranking over the starter is in gauging as well as the fuel pump I can hear it.... It's getting spark and I replaced the starter solenoid.
View 5 Replies
I drive a 2001 ford f150 lariat 5.4L. My truck will crank but not start, i am getting complete spark, and have ran a full fuel pressure procedure, and am getting complete fuel pressure, there is no water in my gas, everything checks out how it should. I ran a test on my cluster and it showed a code that said i am not getting connection to computer to start. I removed the cluster and repaired all loose wires properly, and it still wont start! I have had many people look at it and they said it could still be a bad cluster.
View 13 Replies
The past week or 2 I have had an intermittent starting problem. Engine is turning over but wont start, but after i wait a second it will start up. I listened to see if the fuel pump was running and heard the whine. I checked the battery and the starter voltage and it was all good. i primed the fuel pump a couple of times and it started up on the first crank of the ignition. The truck runs great when driving and idling, no misses or loss of power that i have felt or heard yet. I am thinking it is either the fuel pump is starting to go or maybe the fuel filter is getting a little clogged up. Like i said up above this is an intermittent problem and that is why I am confused. Its a 2001 F150 4.6 4X4 ....
View 1 Replies
I have a 98 F150. The motor was replaced three months ago and have had no problems until now. The truck had trouble starting so i put an alternator on it. Fixed for a while and then it started blowing fuel relay fuses. I replaced fuel pump and filter. Truck has trouble starting after sitting overnight. When I am driving and floor it, once it hits about 4,000 rpms, the truck bucks like its the transmission but the rpms drop and then pick back up. Fuel pressure is right where its supposed to be.
View 1 Replies
I have a 1998 Ford F150 with 4.2.. Started off a intermittent problem of not starting acct no fuel. Now will not start at all. Checked all fuses and relays.. Am not getting voltage at fuel pump. Changed ECM thinking that was the problem.. Have checked all multi wire connectors for corrosion and tightness. Am at a lost what to try next.
Also, not sure if its related or not. The turn signals and hazard flashers do not work. When I turn on the hazard flashers, nothing happens. If I leave the flashers switch on, the turn signal work. Checked all fuses and relays and they appear good.
View 2 Replies
My 2001 4.6L F-150 has been sitting on the driveway, used once every 2 weeks or so for the last 3 yrs. I came to start it a few days ago and it kept turning over but not starting. The key security chip is working, battery is charged, all plugs are firing, fuel pump fuse and relay check good. When I turn the key to ON, sometimes I hear the fuel pump priming, other times it doesn't. The times it does prime, the truck fires right up.
The times it doesn't prime, engine won't start. When the pump does prime, and while the engine is running, the pump makes a noticeable buzzing sound, much louder than normal. When the pump primes. fuel pressure measures at 42psi in the ON position, 36psi with engine running, and 46psi with engine running and vacuum hose removed. I believe all these are within specs.
My question is this: Is it safe to assume that the pump is going bad and will eventually fail completely? My second question is (and I know this can be debated til the end of time) should I get the Motorcraft or aftermarket? I have Airtex, Spectra, Carter, and Delphi available locally.
View 4 Replies
My 2002 4.8L Silverado recently started having this intermittent starting problem.
A few days ago I got in to start it, turned the key and nothing happened. Lights, radio and power locks all were working fine but engine would not crank or turn over. Turned the key off and on a few times and then the truck started fine.
It started fine for about 3 days. Then got in to start it the next day and this happened again. Turn the key and nothing. Lights, power locks, radio all working ok. Turned the key off and on multiple times but still nothing. So I cleaned the battery cable connections and fully charged the battery, even though it checked out ok. Tried it again and same thing was happening.
This time I looked at the ignition and starting relays under the hood in the electrical box. I swapped a few of them around, tried to start it each time and still nothing.
So I had the vehicle towed to the dealership to be checked. The next day the service man calls me to tell me when they went to check it, the truck is starting fine.
I am not sure if this is a starter problem, ignition switch problem or maybe the computer. The thing is, I can't drive it like this because it is no longer reliable.
View 7 Replies
I just replaced all 5 of my instrument cluster bulbs in my 1998 f150. Everything looks nice and bright now that everything is replaced but around the top of the speedometer the light is dim. Is this normal for this instrument cluster or could there be a bad bulb or a light blockage? It's frustrating to go through effort to get to the cluster and find out after it's put back together that there's a bad bulb or something.
View 2 Replies
My dad has a 97 f150 ext cab and the gauges are dead.... What would cause this? I've checked the faq but didn't see anything.
View 3 Replies
The brake light in my instrument cluster on my 1997 F150 won't come on. I have put in 2 new bulbs.
View 7 Replies
My old F150 died, so I recently bought a 2000 F150 in great shape, but it doesn't have the automatic light setting on the headlight cluster. Possible to switch out the headlight cluster to one that has the fourth automatic setting? After having automatic headlights for years, I've gotten so used to that luxury.
View 1 Replies
So I noticed this is a common problem in several scenarios. Some are electric failures and key failures and computer failures....And other times they happen when you switch the cluster.
I had a blacked out cluster with a couple broken gauges and after spending an hour swapping the cluster I get a crank but no start. I tried switching the 301 and 304 fuses (fuel pump and PCM) as that was mentioned somewhere online but it did nothing. Any quick fixes or do I need to tow it to a dealership?
2001 Supercrew with 4.6L and 4x4
View 14 Replies
I have a 97 f150 4x4 4.6 the airbag light in the cluster is constantly staying on it does not flash at all. The only threads I can find are for the airbag light flashing which mine does not do. The passenger airbag light is not burnt out so that's not the problem. Where to start looking.
View 2 Replies
I have a 1997 Ford Expedition, 5.4. My research indicates that fuses 2. 19. 29 are associated with the instrument cluster (IC), could you identify their specific function in relation to the IC? My IC gauge lights are not showing and my alternator is not consistently charging. The blinkers, battery, oil, brake, and ABS indicator lights are showing in start. Regarding the alternator, my research indicates that a failing alt light on the IC may cause the no charging condition? As a note, I have a brand new battery, brand new alternator, brand new 3 pin wiring harness. Also, when the alternator is not charging and I connect the a jumper from the exciter wire directly to the pos battery terminal, the charging starts.
View 9 Replies
I am having trouble with all sorts of functions on my 2002 F150 4x4, 4wd not working, cluster module illumination not working, horn not working, reving up and down at idle and sometimes dyin, cruise control quit working. I have been reading it is the GEM module that causes these issues. My question is I ordered a new one from Ford, when it arrives I was told I can just install it and It should be pre programmed. but one ford house tells me that they have to install it and program it. Which it right? I have seen several sites on u tube where people replace the module and then start their truck right up without any issue.
View 2 Replies
Have a 7.3 powerstroke won't start.. I have went through tons of parts check everything I can think of. I have put icp, our, fuel pump, fuel pump, injector, glow plugs and relay, fuel and air filter. new starter, new valve cover harness. HPOP is good and compression is good?
View 14 Replies
I had issues with my F250 cranking last winter when the temperature dropped, so I changed out the glow plugs in the spring. I hadn't been able to truly test them yet, since it hasn't been cold, but the other morning my truck wouldn't crank up. It was 40 degrees out the night before, and it had been almost 24 hours since I cranked the truck, but it seems to me like the truck shouldn't have an issue in that mild weather.
I'm not sure what I need to do next to try and fix this problem, it's been driving me crazy and risks stranding me if I park for a while in an area where I am unable to plug by block heater in. The truck cranks fine when I have had it plugged in for a while, so I'm fairly certain it's a heating issue. I haven't done any tests since last year, but I know that the GPR was working properly last winter, which is why I changed out the glow plugs.
View 4 Replies
I have a 2000 F450 with a 7.3. I am having problems starting it. Batteries are good, engine turns over strong. It has started a few times after a extremely long crank (so long I am sure I am burning out the starter). I have replaced the CPS since it was cheap enough but that didn't make a difference. I have unplugged the ICP and it is very oily inside the connection. Does this mean the ICP should definitely be replaced? The truck will not start with the ICP unplugged. Should it be able to start with the ICP unplugged? Other items I plan on looking at at the IPR and possible the IDM box. Am I on the right track?
View 11 Replies
The other day, I started having problems with the truck not starting when at operating temp. Went for a drive and stopped a a scenic overlook, and spent about 30 minutes taking pictures. Went back to the truck, and it wouldn't start. Outside temp was about 95 degrees.
I tried for about half an hour to start it, but all it would do is turn over. There was a work crew there with their heavy machinery, and I was able to borrow their starting fluid. One quick squirt into the intake, and it fired right up.
Although I do have an oil leak from the right valve cover, when I checked the oil, it was just off the full mark. The truck was parked on a slight angle with the driver side being about a foot higher than the passenger side.
2003 F350 w/6.0, 180,000 miles
View 14 Replies
Okay a little update on my truck not starting, and for those who have not read my earlier post. My water in fuel light has been on in my truck for probably a month of use. I drained the water sep under the truck nonstop and added several bottles of water remover and the light would not go out so I assumed the sensor was just bad. (im new to owning a powerstroke btw) I broke down coming home from work, got it towed home, and still cant get it started. It will crank fine just wont fire up. I tried unplugging the ICP, i replaced the CPS, and ordered a new water sep/ fuel filter for under the truck. And the fuel filter on top was just replaced a month before breaking down. Every single time i drain the separator tons of clear water diluted fuel comes out before it turns greenish.
Not sure if this could be a cause of getting water in my fuel but one time i filled the truck up completely and it was like the water overfilled and probably a quart or two of fuel spewed out onto the ground. Not sure where it came from. Also I have just over a quarter tank so i was thinking maybe the float broke and I just needed to add fuel but today before i went to add fuel i drained the sep and tons of water came out... Im so worried about hydrolocking my engine or ruining my injectors. But I dont know if my issue even is water related if the sensor just went bad...
View 14 Replies
