Ford F-150 - 1997-2003 :: New Starter Won't Turn / Motor Is Seized?
Sep 9, 2012
I have 98 f150 with 4.6 starter went so I put a new one on wich was a hassle and it tries to turn but just wont as if the motor is seized. I had been hear a loud howling sound from what I think is the ac unit and the ac line burst after trying to start. Would a bearing or something with the AC be enough to stop the engine from turning over? Or could it maybe be a wire connection problem? To me it sounds like a starter trying to start a seized motor but I cant see that my motor would be out it only has 190 000km and the oil looks good. but we couldn't turn the motor over with a ratchet? The truck had been getting gutless. I am stuck...
View 4 Replies
Advertisement
Yr 2000 F-150 with V6 . Only 68K miles. 3 weeks ago went into fast food for lunch and then truck would not start. The starter would spin it over real well and plenty of gas etc etc. I came back the next day with a tow truck to take it to the dealer and it cranked and ran perfectly for 3 weeks till yesterday. Same thing. Will not start in parking lot of grocery store.
I only have one key and someone suggested that it could be the chip in the key or the theft system acting up. I only have one key from when I bought the truck 7 years ago used. Someone else said when the anti theft system is screwing up, the motor will be totally dead and starter will not work.
This time I am again planning to tow to the dealer and I fear a huge bill for something that is actually very tiny at fault since the truck runs perfectly well and then mysteriously will not start. This is the 2nd time in 3 weeks I have been stranded. I pulled all the fuses and reinserted. I checked all spark wires and they are in good shape and tight. What could it be that all of a sudden causes the engine to not start up and run intermittently ?
It is something I can do myself and I am pretty capable. I replaced in the last year water pump, power steering pump, ball joints and alternator. So what is not getting..... fuel or spark? The only two things we need for to run ... right ?
View 9 Replies
I have an 02 f150 5.4 4x4, drowned it a while back, thought i had hydro lock, crank can be turned by hand though as far as i can with a wrench, so internals seem to be fine, no bent or broken rods that i could tell, ripped everything apart cleaned it up put it back together, new fuses, new ignition relay, new starter, alternator and battery as well, turned the key to on and got all my electronic stuff back up, turned to start and it all goes dark, which i assume is because at that point its sending power to the starter, but the starter didn't turn or crank the engine...
So question being when i put my new starter on is it possible that i might have crossed a wire or something that would cause it to not crank? and due to the fact that I had water in it, and had hydro locked it, all my plugs are out, now I know that spark is needed for the engine to run, but shouldn't be needed just for the crank to turn right? question being is that once i fix the wires on my starter, I am looking for initial crank before start up, so do i need to put a plug or two back in and hook them up to make it crank? or will it crank without them? and yes I did replace all my fluids as well.
View 8 Replies
After getting the oil changed in my 1997 Ford F-150 4.6L with 150K miles at a local quick lube, I made one stop and my truck wouldn't start. I could hear the starter engage the flywheel, but couldn't turn it over at all. Oil was clean and full. I bench tested the starter and it tests good. I put a breaker bar on the crankcase nut and I could barely move it. Oil level was about 2 quarts low before oil change.
View 10 Replies
I'm having some strange electrical issues b where to start fixing the problems. Here is whats happening:
- Put the key into the ignition and turn to the "on" position, full power to everything no issues at this point
- Turn the key to the start position, get 1 click out of the starter and then lose all power to everything
- Turn the key off and back to "on" position, sometimes I get power at this point and sometimes the power stays dead for a while
- Check the battery, which is good (12.3 volts)
- At one point someone noticed some sparks coming from a connector near the back of the firewall on the passenger side (sits on top of a metal cover with a large positive terminal right behind it). I've disconnected this terminal, cleaned it and put on some dielectric grease all of which hasn't done anything.
- Basically I mess around with few things, check some connectors, let it sit for a few minutes and then it will start.
View 5 Replies
I have a 2001 supercab 4x4 with a 4.6 in it, it has 186k on it and the only issues I've had was a misfire not to long ago. I replaced the plugs and coil packs and fixed that issue. 2 days ago she ran fine with no issues and this morning I went out to go to the store and she wouldn't start. All the dash lights come on and all of that normal stuff when you turn the key. When I turn the key I hear what sounds kind of like a clunking noise towards the bottom of the windshield and the middle of the dash. The starter does not engage, no nothing, really confused here. I thought maybe the battery was bad so I put my jumper on it and tried but again nothing happened.
View 14 Replies
Ford F150 truck, when starting, the starter will turn over strongly for half a second then just abruptly makes a loud noise and stops. It won't ever fully crank. Is this just a bad starter?
View 2 Replies
I have a 97 f150 5.4 4x4 a/c compressor and clutch. It won't let my motor turn over because the ac compressor is locked up bc the bearings are shot is there any way to by fix this until i get a new compressor and clutch....
View 6 Replies
This 97 F150 4.2 is new to me, originally a very base 2wd white fleet vehicle, with 189,000 miles, runs smoothly and quietly, idles well, transmission shifts smoothly. Gets reasonable gas mileage.
Problem statement: the truck has an intermittent starting problem. The failure to start happens about 5-10% of the time. The motor will turn over fine, but but immediately stumbles while trying to start. Turn key off and then re-start attempt will be again followed by a bucking stumble. Some times the motor might try and run for 2-3 seconds bucking and stumbling. It is possible the problem happens more often when the truck is warm and has been shut off for 15 minutes or so. Once the problem happens it is very repeatable. It won't start again unless I wait about 30 minutes to an hour. Once it starts it seems to run very nicely. I have noticed some times when I go to successfully start the truck it might run roughly for the first 3-4 seconds bucking and sputtering a bit and then smooth out and not have an issue until the next re-start attempt.
The truck runs so nicely when it is running I doubt it is an issue with the plugs, air filter general tune up. Could it be an intermittent fuel pump issue? The next time it occurs I will check fuel pressure. Could it be fuel pressure regulator? Also tested by fuel pressure. ECU? The truck runs very nicely most of time that seems like a long shot. Crank sensor? Bad fuel? I did add some dry gas.
View 14 Replies
I have a 2009 Jeep Liberty with 43,000 miles which many times in the morning, the car won't start. I hear for just a brief moment the starter motor turn on for less than half a second then turn off. I take the key out and try again. It takes a few times for it to run. I have tried different keys and once it has been started for the day, it usually is not an issue until the next morning.
View 2 Replies
I have a 2001 ford f150 with a 4.6 liter v8, my ac compressor is completely seized up, I can't afford to replace the ac right now. So I would like to just get a shorter serpentine belt to bypass the ac for now, need to get a measurement on the shorter belt for my engine? and the proper way to re route the belt without the ac?
View 7 Replies
1998 F250 ld 5.4 4X4 4wabs. The front rotor was seized on THOROUGHLY bearing split apart (outer bearing and bearing "core" still attached to rotor, outer race inner bearing and sleeve still in steering knuckle), the bearing was fine fine until i tried to remove the rotor, any chance it can be pressed back together and saved?
View 3 Replies
I have a Toyota 87 pickup that have been working great for the longest time. Now there is a problem and I need to fix it. It is a problem with the ignition switch I think but I am not sure. When I put the key in and turn it to 1st position I can hear the electrical system turn on, as in the little hums and noises that the electrical system does on a car this age. The next position where the starter motor would engage is however silent and non working. If I where to have a bad battery this is where the relay would go tic-tic-tic but there is no sound what so ever. So Im thinking maybe bad switch, or bad relay? How do I test this the easiest. Toyota got a r22 in it.
View 9 Replies
I have a 2010 Yaris 1.3 motor. Sometimes when I turn the ignition on it seems to keep wanting to start?
meaning it sounds like the starter motor isn't disengaging when the motor turns over, its been back to teh dealer twice now, someone suggested a relay?
I am taking it back again tonight for the auto sparkie to look at. The last time it did this I had to manually turn the car off to stop it turning over.
View 1 Replies
Trying to track down an issue (annoyance) I'm having with my 02 7.3 4x4 excursion. When I get in the truck and turn the key (after waiting for glow plugs) the starter doesn't actually turn over for 1-3 seconds and sometimes up to 5. When the truck does turn over everything works perfect it's just an annoying delay.
View 13 Replies
Have a 97 Ford explorer. Over 270,000 miles on it. Recently had Crank sensor, Crank case vent tube, plugs wires replaced along with intake manifold gaskets. Also had fuel injectors cleaned out. Now i cant get it to turn over. Went to store, truck started fine, came out and click. Thought it might be the battery even though its also brand new but no, had the starter checked, it is also good. Put test light on all electrical having to do with starter and found all hot wires and good grounds. Finally bypassed the solenoid for starter and still nothing but a click. I also checked NSS to see if that might be it but after putting it in reverse, the reverse lights came on, and even jiggled shifter in park and neutral to see if that might work but still just a click. Not sure where to go from here short of buying all new parts but doesn't make much sense to do that if they all appear to be working properly. Don't have a volt meter to check voltage.
View 5 Replies
Starter Removal, The top bolt is a bugger.
View 5 Replies
The starter on my kid's truck doesn't disengage and continues to turn over after the ignition is off. I have seen a few posts on this but have yet to find a clear troubleshooting path and it seems a lot of money wasted on new starters, solenoids and new ignitions.
View 4 Replies
I have a '99 F-150 SC, 4x4, 4.6L, with 48,000 miles. I drove approximately 15 miles, then parked for 20 minutes. When I returned, the truck wouldn't do anything when the key was switched to start. It's as though there was no power going to the starter. Could it be a problem with the immobizer system, or just a freak incident with how I handled the key? The truck ended up starting after another 15 minutes and has consistantly started for the remainder of the day.
View 4 Replies
Starter problem with my 1999 Ford 5.4 f150. Last few days I’ve had to cross the solenoid terminals in order to start up. After replacing the solenoid the starter would not disengage. Put the old solenoid back on, crossed term and the starter did the same thing. Bought new starter (what a job finding the upper bolt) replaced old one, and I’m still hearing the starter running along with the motor. What else?
View 11 Replies
1998 f250 4.6 4x4. In park the starter engages with key on . Ounce running the starter is still engaged in park and neutral. No engagement in the drive gears. Changed the ignition switch and neutral safety switch on the trans. When key is off instrument cluster is still on.
View 3 Replies
