Ford F-150 - 1997-2003 :: Misfiring Cylinder 3 And 8
Feb 12, 2015
Trucks throwing codes for cylinder 3 and 8 misfire. I pulled the plugs and both were covered in oil and cylinder 8s electrode was literally gone. so I replaced the plugs and within 5 miles it was missing again. so I replaced all plugs, all wires and coil packs. cylinder 8 plug had fouled out. Its a 4.6l 99. I have a mild exhaust leak where the manifold connects to the downpipe. but not bad enough I feel it should matter. it runs rough until about 3k rpm and then it kinda straightens out.
View 14 Replies
Advertisement
Ok I got this truck from my mother-in-law for free with a blown head gasket cylinder 6 driver side. I did the replacement had the heads machined put it all back together by the book. Now I can't get it to fire on all 6 cylinders only 5 I think. Thought maybe bad gas (it sat since late November) put 5 gallons (over double the gas) fresh gas and half a bottle of b-12 chem tool. Dubble checked all plugs wires connections (coils plugs wires all new). I drove for about 10 miles oil pressure and temperature stayed perfect but no change in running truck shakes a lot and no real power. Don't sputter or backfire no engine codes other than imcr bank 2 open. Engine is 4.2l v-6 170k miles.
View 2 Replies
my mechanic is stump have a 1997 Nissan pickup 2.4 liter auto tranny. number 2 cylinder misfiring.my mechanic say it have fuel, spark. and he did a compression check say compression is good. code (p. o 302) keep coming on. he change spark plug and wire and distributor cap and rotor. but light keep coming on. he say the only other thing he can think may be is. to change the whole distributor he say the cam sensor is in the distributor. tuck have 264,000 mile on it.
View 5 Replies
I am having issues with my everyday driver as of late. I developed a misfire and replaced, plugs, coils, plug wires. Misfire persisted so we replaced, injectors, fuel rail. The misfire still was there and getting worse so we checked the engine mechanically for any burnt or bent valves and it checked out fine. We completed a compression test and all cylinders tested within 5 psi of each other. We finally replaced the ECU and Cam Sensor and the problem still is here. We do not know what else to do. I have narrowed down the misfire to cylinder one. The injector is not firing on this cylinder. I know this because when you unplug it there is no change in the engines behavior. As stated earlier, injectors are new, but i switched them out just to make sure it was a bad injector. I tested the lead and the voltage was appriopiate.
View 2 Replies
I haven't started my passat for the winter and I finally did today. It was ruff start/idling and I pretty sure it was misfiring on one of the cylinders. I turned off the car and start it again...same thing, ruff idling like 3 cylinders were running. I waited five 5 mins and started it again, then it was a normal start on all cylinders. But the engine light came on, even though it started properly. I know I have to clear the code to get rid of the engine light. But I want to avoid any future misfiring. So I'm thinking new spark plug/coil overs.
View 9 Replies
I am driving a 4 cylinder 2003 Hyundai Sonata just at 130000 miles. The other day on the trip back home the car started shaking violently and the check engine light came on. I ran the code and it led me to a cylinder 1 misfire. Today I replaced my spark plugs, and wires. The number 1 plug had some deposits on it, but nothing that should cause a misfire.
Now when the car is in idle there is a spark that jumps from the boot of one of the new wires to the grounding on the corresponding coil. I have never noticed this spark before changing the plugs and wires. It does this with either set of wires. I have a picture below where the spark is jumping from. The car has a noticeable drop in idle when it sparks. Do I need to look into getting some new coils?
View 18 Replies
Where can I purchase a distributor for a 2003 Dodge Neon SE?
The engine is running rough, the gas mileage has degraded, and the Check-Engine light is ON.We went to an AutoParts Store to have them read the car's computer output to tell us why the Check-Engine light is ON.The results said that the No. 4 Cylinder was not firing consistently.We replaced all four spark plugs and the spark plug wires. It ran a little better but the Check-Engine light is still ON and the engine still runs rough. I think we should replace the distributor or maybe just the distributor cap (if possible?).
View 19 Replies
Need some input on miss firing on acceleration on a 2001 Ford SuperCrew F-150 Lariat, 5.4 engine. 200,290 miles.
Have replaced all spark plug boots covers (Sept 2012), number 1 plug (Sept 2012), 3 and 7 plugs replaced, 3 and 7 has heli-coil kits (2011) installed for blown out plugs. New in-take manifold (2010). New gas line filter, air and oil filters (Oct 2012) and oil changes every 3000 to 3500 miles. Have poured 12 oz. fuel injector cleaner in gas take two times with 6 to 7 gallons of fuel in gas tank (last 2 weeks).
Have No check engine light on for service engine but have had an diagnostic scanner analyzer plugged into driver side, in cab outlet, 4 different times to see if I have a bad coil on plug or other problems. No codes show up indicating any problems. The engine idles nicely when at stop lights but does have a slight intermittent miss at times when warmed up and stopped at lights. Engine misses when warmed up on acceleration (when it is under a load and on acceleration).
Had a mechanic tell me he could plug an analyzer into engine but couldn't guarantee he would find anything wrong. This sounded like a little snow in July to me and the mechanic didn't sound optimistic.
View 3 Replies
97 F150 4x4 XLT 5.4L... I had two cylinders misfiring, removed COP, injectors and plugs. Reinstalled all parts and reconnected all sensors. Now I am not getting fuel to the injectors. Double checked for disconnected wires and hoses, checked all fuses and relays, also the inertia switch. Fuel pump does not hum when key turned on. Tried hitting bottom of gas tank. My question is, before I pull the tank again, is there something under the hood I may be missing. It does get quite crowded at the rear of the motor.
View 6 Replies
I recently picked up a 2wd 2002 F-150 with a 4.2l V6 that has just over 300k miles. The CEL is on and I'm getting P1131, P1151, P0316, P0305 and an occasional P0301. It has a very distinct misfire from around 1,000 rpm and smooths out between 1,500 & 2,000 rpm, the idle rpm occasionally bounces (sometimes enough to stall), and the idle is sometimes rough.
I have replaced the plugs, wires, fuelfilter, and replaced a leaking PCV hose. As I have changed things the symptoms have improved some but they are still there. While capturing some livedata it kept going out of CL and into OL Fault. When it would the idle quality was crap and the miss was much more significant. I would have to put it into D hold the brake and run the RPM's up to just over 1k to get it back into CL.
After I got done with the data stream at idle, I set the parking brake held the foot brake and put the truck in D then ran the rpm's up to around 1,200 & held it there. The truck stayed in CL but it would cycle between misfiring for 5 - 10 seconds then clear up and run smooth for 20 ' 30 seconds, every time it cycled there was an audible click that could be heard. Also, the AC was off the whole time.
Live DataStream @ Idle: CL
CalculatedLoad Value - 12.9- 14.1%
EngineCoolant Temp - 103degrees C
Short TermFuel Trim B1 - 32.8%
Long TermFuel Trim B1 - 0.0%
Short TermFuel Trim B2 - 32.8%
Long TermFuel Trim B2 - 0.0%
Engine RPM - 816 . 846
[Code] .....
View 14 Replies
I have a 1997 f150 lariat 4.6, at some point i started losing power, so of course I had my friend come by and check all the mechanics under neath the hood and besides needing caps and rotors all seemed well under there, so twice I've put it on a computer and it needs and o2 sensor, I've already checked my Cadillac coverter , and dropped and replaced my gas tank twice, I ended up having to replace a shock, it does run better when i put heat through it for a short time.
I've been checking my antifreeze and I am not losing none, I also did regular maintenance to it to figuring it was a fowled plug but still no good , so whats next ? coils ? I didn't replace my plug wires but I checked them all and they looked to be in good condition and I have a transmission filter kit to change that out I don't believe its been done ever ..
View 5 Replies
I have a '99 F150 w/ the 5.4 and 4R70W, with 226K miles. I am experiencing what I believe is a TC shudder after the tranny shifts into OD between approximately 40-50mph. This sounds like a pretty common problem with this particular tranny, but some of what I've read describes the shudder as feeling akin to driving over rumblestrips, but what I'm experiencing is a very sharp, bucking. Is this how the TC shudder feels, or am I actually dealing with a misfire. Btw, I did completely change the tranny fluid with Mercon V, and added a friction modifier, but no change. I also read that the TC unlocks when the brake lights come on, so I tried lightly hitting the brakes when the bucking was occuring, but it continued.
View 14 Replies
I have a 99 f150 with 171xxx miles and the other day it suck in second gear and start shaking and misfiring and would stall out. I took the truck and got the codes read and it threw codes for the tcc solenoid and shift solenoid. I put both in the transmission and it kepy doing the same thing. I check fuse 24 under the hood and it was blown, I replaced it and everything worked fine for a day then it blew the fuse 2 more times and i cant figure out why it is blowing that fuse. I cant find any shorts maybe pcm??
View 5 Replies
2002 f150 4.6l v8... Truck is misfiring and the exhaust is smelling very rich, I have new coils and plugs, it also idles rough and stalls if i let it idle for more than a couple minutes. Could it be something with fuel delivery system?
View 1 Replies
Changed the spark plugs now I have misfire in cylinders 3 and 6. Do I change the spark plug wires or the coil pack?
View 5 Replies
Had a misfire in cylinder 1 so I put new plugs and wires. Still misfired. Changed fuel injector. Still misfired. Changed ignition coil and misfire on cylinder 1 is gone now cylinder 2 and 3 are misfiring. I double checked wires and they are properly installed.
View 11 Replies
I had a misfire and my CEL came on had it read and it said cylinder 4 was misfiring and that there was a misfire in the first 1,000 RPM's. I replaced the COP and plug and now I'm getting terrible MPG. I tried to reset the PCM by removing the Neg. battery connection and it seemed to work for 4 days now my MPG has gone bad again. It seems to run smooth/good.
View 1 Replies
I have changed the COP and the injector as well as the spark plug. I am still having a misfire on #7 cylinder....
View 8 Replies
Which cylinder is #3 on 2003 150 4.6. ...
View 2 Replies
I've got a 2000 Ford Ranger, manual 4 cyl. When cold, she's been stalling out. It happens very reliably when I come to a stop and put it in neutral (or put the clutch in). Only when she gets warmed up does it stop. Check engine light has been on (for a long time) saying the TPS sensor is out and the 4 cyl. is misfiring. I replaced the TPS sensor and it had no effect on the problem. A friend recommended changing the oxygen sensor.
View 5 Replies
Had a miss in the #5 cylinder on a 2005 F-150 5.4 Triton. Had it hooked up to see which code was given and the tech said that #5 was the culprit. Taking no chances, I purchased a new plug and coil pack. I installed them and it ran great until I got up to around 70mph and then it started dong the same thing it was doing earlier. I took it back to the place that checked the codes and it came back as the #5 cylinder misfiring again. I am not sure how this is possible after replacing the plug and coil pack. Is there some way that the plug that fires just ahead of #5 is fouled out and causing the #5 cylinder to get too much fuel transferred to that cylinder? Or is there a possible short somewhere causing that cylinder to misfire and ruin the coil pack? I am stumped on this for the moment anyway.
View 8 Replies
