Ford F-150 - 1997-2003 :: Location Of ECM - Replacement?
Jan 6, 2016
I'm looking for the location of the ECM in a 97' f150 5.4.. Also need to know difficulty on replacing it and is it what controls the windshield wipers and windows?
View 1 RepliesI'm looking for the location of the ECM in a 97' f150 5.4.. Also need to know difficulty on replacing it and is it what controls the windshield wipers and windows?
View 1 RepliesWhich cylinder is #3 on 2003 150 4.6. ...
View 2 RepliesWhere is the thermostat located on a 5.4 1999 engine.
View 1 RepliesI have a 97 F-150 that the A/C went from blowing cold to hot instantly. I have done the following;
1. Checked fuse. Was good.
2. Checked Low Pressure connection.
On this, I jumpered the connector and could not get the clutch to engage. I also checked to make sure I had 12v from that point, which I did.
3. Checked the power to the clutch assembly. Got nothing. I also put 12v directly to the clutch and it poped in just fine.
Based on all of this I think I have a bad relay between the low pressure sensor and the clutch assembly. The only problem is I cant find it. Where this relay is located
2001 5.4l Windsor... I have been reading up on some post, and I'm wondering where the EGR VALVE is located on these motors?
View 5 RepliesWhere is cylinder six located my '99 F150 5.4? Which bank? Front or rear?
View 4 RepliesI'm looking for information and possible photo location for the blower motor resistor. My truck has climate control. I've looked under the dash on the passenger side and behind the glove box door and I've been unable to spot the location. Do I have to remove the plastic panel behind the glove box?
View 6 RepliesNeed location of the fuses for 12V power in dash.
View 2 RepliesHad a question about where the battery fuse is located and it's number. I just put a brand new alternator on.my truck. Turns out I might not have needed one, switched the battery with the new alternator on and the truck still went dead after it ran for about 10-12 seconds. So some told me it may be the battery fuse but I don't know which fuse it could be.
View 2 RepliesI've got a 2001 f150 XLT and I've checked the Haynes manual and searched Google but I'm having no luck.
I'm trying to locate the sensor for the Automatic Head Lights.
I had a small "spill" on the dash at night and immediately the lights started to blink and click. It fixed itself but sometimes it will do a weird little "click, click noise" change thing. I would like to clean the sensor or ensure it's not partially blocked.
Locating subject relay on my F-150 XLT Extended Cab, 4.6Ltruck. All my research thus far indicates it is somewhere on the truck. An electrical diagram I've come up with shows it in the "Blower/Flasher Relay Block". So my question is exactly where is the Blower/Flasher Relay Block?
View 4 RepliesF250 LD 99. Battery light flashing from time to time. When it happen voltage gauge in dash go up (but not in red zone so far). All other light are blinking too but not on and of like battery warning light then like stronger - weaker. So far at Internet is said should be ground. I saw one ground at firewall close to negative post of battery but where is other ground? Can it be voltage regulator (alternator)? Did clean battery posts, didn’t work. 4,6 engine. Voltage at battery posts with engine on is 14,7 - 15,1 V. With engine off 12,3 V.
Didn't managed to check voltage when is battery light flashing as it only happen when I drive not at idle.
I am in the process of re-assembling a 97 F-150 that was disassembled by someone else. Looking for photos or reference as to where the bracket for the parking brake should be located and how? It looks as if the bracket connects to the front leaf spring hanger, but I'd like to see a photo of it in position as well as routing of the cable around the spring and axle. I'm concerned with re-installing it and having it in a position where it will bind or get pinched.
View 1 RepliesI have a 99 f150 XL 4.6, 5 speed. I spent some time tracing the leads around the ignition system to find the EDIS module. The purpose of this is to install a aftermarket tach coming off the EDIS. This seems to be a simple approach and I have a pin diagram handy for it. I am initially shying away from tapping into the EEC. Maybe better yet, what wire color to splice behind the gauge cluster that would be useful too.
View 1 RepliesWhere exactly is the coolant temp sensor located on a 2000 F-150 4.6 V-8.
View 5 RepliesI've got 2003f150 4x4 and had a fender bender front end out of line so had it lined up but steering wheel 180 degrees out..well watched a video about just adjusting drag link..so i crawled under ready to adjust but cant find an adjustment collar. Mine the only one without it?
View 10 RepliesI own a 2003 F-150 4.2 engine 2 wheel drive extended cab. I need finding an easier way to get at the O2 sensor connector on bank #2. I am having a trouble code of P0171 and want to check the sensor to see if it is working...
View 6 RepliesLast week I broke the pinion and spider gears in in rear end. Well Im getting a used rear end rather than rebuidling mine. What is the gear ratio on the 97 F150 xlt 4.6l 4x4. I figured they would all be the same but my tag is missing on my diff and I was told by an auto parts store that there were a couple different ones.
View 14 RepliesI am needing to replace the selector switch for my 4x4 on my 2003 F150 Lariat FX4... I already have the new switch. Whats the best way to get in there to remove and replace the switch?
View 7 RepliesI had to swap in a new battery the other day, and I noticed that the positive terminal connector is broken. I don't really want to pay >$100 for a new cable right now, so any success story about splicing in just a new terminal ring or using one of the generic battery cables?
View 4 RepliesSo the story goes like this, my teacher was trying to scrap a truck that he had sitting on his farm so i got it. I've been using it for a DD for the past year and a half and not I'm starting to do rust repair starting with rocker panels. But, what i was really wondering is how involved would it be to replace the radiator core support? Main reason being last time i was under the hood replacing the pass side valve cover gasket i hit it and knocked a hole right through it so yeah I'm thinking is about time to replace it.
View 1 Replies