Ford F-150 - 1997-2003 :: Leak Where The Coolant Leaves The Head
Jul 29, 2012
I have a 2001 F-150 5.4 engine. There is a coolant leak where the coolant leaves the head. Looks like a new gasket is in order. The part that needs to come off crosses over to the driver's side and the thermostat mounts into it. To remove this part and replace the gasket, it appears that most of the top of the engine, throtle body, fuel rails, intake, etc., will have to come off. One of the four bolts holding the part on is installed with the bolt head facing down. The only way I see to get this out is to take everything apart.
View 5 Replies
Advertisement
New truck to me. Truck was advertised with a slow coolant leak. Figured I would trace the leak down and get it repaired no issues. Anyway, working on it this evening I take a close look around the oil filler area and notice the dreaded milkshake color.
I drained the oil out of the truck and the oil actually came out nice and black. Is the headgasket the only area that would cause the oil/coolant mixture? Supposedly the truck has never been overheated.
At any rate, on to find articles on how to pull apart a 4.6L Triton head. I'll see if I'm up to this challenge.
View 3 Replies
I have a 03 5.4 F150 SCrew... The intake was leaking on the passenger side (water outlet tube meets plastic).
Putting in the Dorman replacement and noticed that the front cylinder drivers side (#5) had a decent amount of coolant in it.. None of the others did. I've drained the coolant already and was wondering should I just put this back together and see?
The water outlet crossing has a hole right next to this cylinder and I can't see any cracks and not sure if the gaskets were leaking under it.
Seems like if the head gasket was blown I would see it in more cylinders? It never smoked or run bad before I got this leak... Drove it maybe 10 miles with it leaking out onto Cyl#1. Ran fine, never missed.
I just don't want to put this back together if the head gasket is blown but I don't know what to do.
View 3 Replies
Recently bought a 2001. In the process of reading about this engine I discovered there is a some what regular breakdown of head gaskets causing water to leak into cylinders and oil pan, all of which is serious.
Given the vehicle is 12 years old and has 89K miles it appears it is in the age and range of where this leakage can occur. Any knowledgeable engine rebuilders that are familiar with this issue on the 4.2 have any comments???
1. Can this issue be avoided by replacing head gaskets now rather than waiting for future failure???
2. Are there new and improved head gaskets for this motor???
3. Does the problem occur on both heads gaskets?
4. Is that all that needs to be done or are there other seals that need replacement???
View 9 Replies
My 2003 f150 4x4 w/5.4 has 220k miles and only minor issues until a few days ago. I now have a coolant leak at the mating surface (both sides left and right) of the aluminum crossover coolant manifold (holds thermostat on one end). I have most of the bolts out to remove the crossover manifold but there is one bolt on the RH side that comes from the underside. All things equal, main question is... Can that crossover mainfold be removed independently from the intake? My thought is that in order to get to that last single bolt (there may be others I am not aware of yet) that I will need to remove the intake.
View 1 Replies
My '02 F150 180k X-cab with the 5.4L is leaking coolant when it is shut off. Its just pouring right out.It looks like it's coming from top of the trans and around the firewall area. I had to replace a drain plug already.. the one behind starter ..its not leaking.
View 4 Replies
My truck is leaking behind the engine. There is not any coolant on top of the engine. It's leaking above the transmission and running down the passage sides. Are there any hoses that could be leaking behind. Sometimes it leaks a lot other times it doesn't leak at all. The shop thinks it's a freeze plug but wouldn't it be leaking more if it was?
View 6 Replies
1998 F150 4x4 4.2 ... Small leak spraying out of a steel pipe onto the front of the motor. This isn't my truck so I'm not very familiar with it but looks like there is a pipe that come from the water pump threw a bracket and y's and one end has a hose going to heater core n the other part is where the leak is I think it has a hose connected to it that goes to the intake. Only leaks when thermostat open. I'm going to take it apart tonight n see what I find. Iv looked for a replacement part and found nothing so I am going to try n replace the steel pipe with hose.
View 4 Replies
I have a 1998 Ford f150 4.6 2x4 i have a coolant leak on the upper intake. It comes out on the back left of the intake through a metal pipe. Well where the metal pipe is (pressed in) to the intake. Now i talk to the guy at ford dealership in the parts he said it is called the (heater pipe). He also told me that the part is 21 dollars but I have to press it in and if that does stop the leak he said I would have to buy a new intake. Now here is the problem I can not find any info regarding this heater pipe. I don't know how to remove it properly, why it is leaking. I can't find it in the handbooks that i have read so far.
View 14 Replies
Only when running heat or defrost, coolant leak looks like it's coming out of the bell housing. I have a supercharger so very difficult to see behind motor, but with inspection camera, heater hose lines look dry. firewall looks dry. No coolant in cab. No steam on windows or smell. Pretty sure not casting/ freeze plugs because absolutely no leaking with heat off. Can run for days with no loss, then turn on heat and within minutes/ seconds coolant puddling in driveway. Is the hose that runs through valley pressurized only when heat is on? I saw a few older threads but as far as I could tell none specified heat on/ heat off conditions. Just started problem after doing some other work, hoses were off radiator and intercooler, replaced radiator. None of those connections are the culprit.
98 F150 Lariat 1900 TVS S/C Chiller Killer I/C 19PSI Snow performance WMI
View 6 Replies
I have an 01 supercab. 5.4 Triton 135k. I have begun to smell coolant the last couple of days. Have seen nothing leaking and truck doesn't run hot.
Will investigate more this weekend. Where to start looking for this. It has to be leaking somewhere. Windows don't fog and the smell is there all the time. I live in florida so don't use much heat.
Not the heater core. Heat works fine and no smell from the vents.
View 12 Replies
I have a leak on the right side of the cross over pipe. I removed one long bolt from the right side and two long bolts from the left side that go through the thermostat housing, and three bolts from the back of the alternator, but the pipe doesn't seem to want to move. I don't want to break anything.
View 2 Replies
I have a 1990 F-150 w/351 that I knew had a coolant leak at the back of the engine when I bought. It's a tinker around truck, something for me to play with.
I've traced the leak back to a metal tube/pipe that sticks out of the engine compartment just below the AC housing. I cannot find anything in the Haynes manual or a diagram on the intertron that shows what this is and if it should have a hose on it or...?
View 3 Replies
I'm trying to figure where the coolant leak is. Appears to originate on the driver's side front, right near the thermostat housing. Since the engine tilts back the entire drivers side is wet. The thermostat gasket appears to be OK, but it does have a lot of miles on it.
If it's not the thermostat then can coolant leak from the cross over tube. And is the cross over removable without taking off the intake. There appears to be a bolt coming up from underneath on the passenger side.
Also, does coolant flow through this plastic intake. If it does, then the leak could be some where else, if not, then it's probably the thermostat.
View 9 Replies
I have a 2006 f250 6.0l diesel. I just replaced the egr valve plus egr cooler and I was going to flush the coolant. I was filling the truck with distilled water to do the flush when I noticed a leak under the truck. When looked to see where it was coming from it looks like it's coming from where the cylinder head meets the block on both sides in the back by the transmission. Is this a sign that the head gaskets are shot or did I forgot to tighten a hose or something stupid like that?
View 2 Replies
I have 2012 R with 33,000.00 miles on it. During regular service they detected that I have a coolant leak. They replaced a flange and determined that there was actually a head gasket leak. This is very unusual for such a low mileage. The car is still under extended warranty and they are in the process of replacing the head gasket. They told me today that they have to machine the head since there was some residue due to the coolant leak. This is all done at a VW dealer service.
View 1 Replies
I found during an oil change that there is coolant in my oil, I had suspicions of this because of having to add coolant more than I should of had to. There is probably either a crack in my block, head gasket or intake manifold, my question is how can I tell which. I figure that if I preform a compression check it will tell me that I have a cracked block and or a cracked head gasket, what will tell me if I breeched my intake manifold.
View 19 Replies
Quick question, my 2007 Santa Fe with 3.3 has developed a small coolant leak. Every so often, I see a few drops on the garage floor and every 6 months or so I need to fill the reservoir with new coolant. So I took it in last Friday at a Hyundai dealership and he said that I need a new head gasket.
So my question is, is that correct? I did a search and most say that if you need a new head gasket, coolant would have leaked into the engine and oil.
When I changed the oil back in June, I don't recall seeing any foam or-or any indication that something is wrong with the oil. Even yesterday, I open up the oil cap and pull the dipstick, every looks normal. I assumed that not all head gasket problems lead to coolant in the oil?
View 22 Replies
2007 Pilot leaks coolant but, mechanic can not find the leak anywhere including the head gasket. He was a certified Honda mechanic.
View 16 Replies
I just bought my 2006 Toyota Prius about a year ago in 2009. It has been treating me LIKE GOLD !!! up to this point. About a month or two ago, the check engine light came on and stayed on along with a big red triangular warning light. I let it go for about a week hoping that it would just go away.
I brought the vehicle into my local Toyota dealership so they can diagnose it.They told me that they had 3 or 4 different "codes" coming from the machine when getting the signals from the check engine light. All the codes were related to the cooling system. They said that they felt that there was "debris" clogging the pathway for the coolant flow throughout the engine. They had recommended a "coolant flush" for the hybrid side as well as the mechanical side. So I took their advice and I had them perform the coolant flushes.
After leaving the dealership that 1st time, the check engine light came back on the next day. I called the same dealership and explained it to them. They asked me to bring it in again. SO I brought it to them a 2nd time. They diagnosed it again. They told me they came up with 2 of the SAME "codes" and 1 that was different, but ALL the codes were STILL related to the cooling system. They explained to me that something was preventing the clear flow of coolant throughout the engine. And since the thermostat was the only major obstacle, they recommended that I replace it. Well, I did. And after I left the dealership that 2nd time, I was praying that this was the last of my Prius issues! The check engine light came back on the next day.
View 1 Replies
I have the 2.4l engine and the car has 177K on it. Bought it from a friend at 60K and never had a problem with it. I started getting the coolant puddle from the rear of the engine. We took the intake manifold off and saw that the head was leaking in the rear. Real small drop forming and then falling. No codes at the time either. Seems this car has problems with the Engine bolts and was wondering how many people out there had a blown head gasket and there was no bolt issue?
Also I know this is not the right thing to do but use Engine Block Sealant? This is the kind that you drain your antifreeze,flush twice and then run this stuff in it for little while and then replace with antifreeze.
I am upside down on the car because I put 50K a year on so don't think I will get anything for trade. I am hoping my brother in law and I can fix it but am wondering what the odds are there is a problem with the bolts.
View 8 Replies
