Ford F-150 - 1997-2003 :: Ignition Key Worn Out And Will Not Easily Move
Mar 9, 2013
I have been looking around on here for an answer and I can't find exactly what I am looking for. My key is worn down and will not easily move. My spare key is like new and works great. I have a spare that doesn't have a chip in it and it will turn over the engine but not fire it up. Even with the old key and the non chip key touching together at the switch, the truck will not fire up. How does this set up work and can I remove the chip from the old key and attach it to the no chip key.
View 7 Replies
Advertisement
My speedometer has not been working for months now and it really hasn't bothered me as I go by RPMs, but I am going to make a long trip in a few weeks and I wanted to try to get this fixed.
The speedometer flips over to 100 mph and rest on the opposite side as it should. When I accelerate it does not move until I get over about 35 mph where it will then flip to 86 mph. It will slowly move to 82 mph as I accelerate up until 75, where it will then no longer change. Every once in a while it will start working when I start the truck up, or when I am driving down the road. It has before, within a 30 minute time frame, started working and stopped working 6 times. Currently my ABS light is on, but it has been on long before this started occurring. Every other gauge on my dash works.
I drive a 5 speed manual V6 2003 Ford F150.
View 6 Replies
1997 ford f150 automatic 4x4 was perfectly fine till today ,no slipping no warning nothing.pulled in the driveway and about 30 minutes later had to run out.the truck tried and pulled like it wanted to go while in drive but wouldn't.then i tried it in reverse and went fine like nothing is wrong.i put it back into drive accelerated for a minute then it went for about 15 miles.while at a red light tried to go and it wouldnt move but was able to put it in reverse to back out of the lane.so i had it tow roped back home and halfway there while accelerated about 10 miles into it it caught and ran fine till i slowed down.at home i changed the tranny filter and fluid.no foul smell,the fluid looked perfect,no metal nothing in the tranny pan,i tried to put it in 2wd and 4wd to see if it would go and still did nothing.after accelerating the gas a minute it pulled and tried to move forward but nothing.
View 9 Replies
2001 Golf with A/T. 130,000 miles. Daughter went to turn key, heard a "snap" sound, car wouldn't start...no "click" from any electrical contact, starter apparently not getting any "juice". key now turns in switch too easily...can't feel the usually resistance when turning key. Key fob works, steering wheel turnable, can move trans lever out of "Park" into all positions with foot on brake. Broken key cylinder, or some link to ignition switch? Car at repair shop, waiting it's turn.
View 3 Replies
I have a 1998 f150 4x4, the truck has not been driven in a few years and it’s been outside in my driveway up on jack stands. I just rebuilt the front end and did a four wheel break job, after getting the truck off the jack stands, I can't get it to move in drive or reverse. I also noticed that when you go from reverse to park the gears grind and I can't even get it to shift into 4H. I checked the tranny fluid and it is fine, also the tranny was just rebuilt a few years before I stopped driving the truck.
View 6 Replies
Drove to work in 6" of snow in 4H with no issues. Shifted back into 2H for drive home as roads were clear with no issues. Went to shift into 4H moments ago and floor shifter will not move!
View 1 Replies
I am noticing a snap noise that occurs only when I move forward after backing up and braking. I'm thinking it could be either a rear drum not releasing, bad U-joint, or something in the rear end. How do I isolate the cause?
View 2 Replies
Why I am getting such terrible gas mileage? The truck refuses to move off of 12 mpg. I made a 500 mile trip half of it at 70 mph running 2100 rpm. And when I filled up I calculated out 11.3 mpg. After that fill up hopped on the interstate and was running around 85 @ 2600 rpm expecting my mileage to drop even lower. Then i was on two lane hwy again constantly passing people and it only dropped to 11.1 mpg. Now no matter how easy I drive or how hard I drive it will not move over 12 mpg. Whether the tank is 100% hwy or 50/50. Its a 5 spd manual 4x4 with no modifications running the 4.6 v8. I just swapped air filters to a K&N and still no change.
View 8 Replies
I intended to purchase a 1997 F150 4x4 today and found that the manual transfer case lever will not move at all. I have read the manual and it seems simple to move from 2H to 4H (at stop of up to 55mph). No movement in the lever at all. Owner said he never uses it and has no idea what is wrong.
View 9 Replies
My launch scanner reported a bad oil pressure switch, but I've replaced that, and when I did the oil pressure light went away, but my gauge still didn't work. Could it be a faulty switch? Or is it common for gauges to stop working on these fords seeing how there's a resistor to trick the gauge from the factory anyway? If I smack my dash the gauge will raise and lower. But I think that's normal.
View 7 Replies
I have a 2000 F150 4WD 5.4 running Extremely rich to bank one. The O2 sensors for bank 1 are reading lean(0-50 mV) Bank two is completely unaffected. New plugs in Bank one, 3 new coils in bank one, all pvc lines checked with good vacuum. Previous codes : P0171, P0301-3. The Truck will barely move. Would a small leak up stream of the O2 sensors cause this?
View 10 Replies
99 F 250LD 240k miles. I think I know the answer but hope I'm wrong. Started noticing the blower fan staying on when left in the panel position, even with key out. This morning I walked by my truck and noticed the radio on. Opened the door and the door chime started beeping. Is this a case of a leaky windshield and water running down the a-pillar and getting the GEM wet? Hope not but I think that's it. I haven't seen any water leaks yet. Could it be a stuck ignition relay? I've never heard of a relay staying open. Could it be a corroded fuse panel. i also heard a clicking coming from the area of the PCM recently but it stopped.
View 7 Replies
I recently purchased my 1998 F150 Lariat, and it came with a small silver key (I haven't figured out what it's for yet), and a key for the ignition, plus the remote door lock control on the key chain.
Naturally, for the first several weeks I had been locking and unlocking the doors with the remote. I had assumed that the ignition key would also lock/unlock the doors and tailgate. Well, it fits into the locks, but doesn't turn.
Could it be that a different key is required for doors, or, maybe the door lock cylinders are seized?
View 11 Replies
I'm having a problem with my ignition switch. It won't turn and I have to turn the steering wheel for it to finally work.
View 4 Replies
2000 F150 5.4 engine. The truck was running great, but it's time to sale it. The ignition cylinder periodically will stick. So, my son the genius , took a pair of pliers to force it to turn. I get home from work to move it the front yard and the PATS theft is blinking fast as I try to start it. It cranks just not start. I hear the fuel pump come on. I removed the cover on the steering column and there is no damage to the ring around the key cylinder or anything I can see, just the cylinder itself . I tried disconnecting the battery, switching relays,etc.
View 9 Replies
When I turn off the ignition and try to rotate the ignition switch/key to the steering column lock position it will not go all the way. It stops just before locking the steering column and I cannot remove the key. This is an automatic with a gearshift on the column. I have to reach up with my left hand to pull the gearshift lever up as if to pass the PARK position. While holding the gearshift like that the ignition switch can be rotated to lock and key removed.
I had the dealership attempt to fix this twice while under warranty with no success. After 10 years I am sick of it and would like to fix it. 2002 Ford F150 4x4 5.4L automatic on column.
View 11 Replies
So yesterday i got my windshield tinted at a shop and now im having issues. My ac stays on when the key is out of the ignition i can use all settings from low to high. My windshield wipers only work in neutral and park. Im calling them when they open but i think the water they spray on the tint got down in the dash and fried something.
View 6 Replies
Have 2000 Ford XLT Extended Cab 4x4 with 5.4. It will not start. Put the ignition in on position and can't hear the fuel pump running. Fuse Okay, Relay OK. Does this year have A Fuel Pump Driver Module? If so, where is it located? I know where they are located on 2004 and up but not mine. If I have to change out Fuel pump, is it easier to pull the tank or the Bed?
View 6 Replies
Vehicle will start when put in drive and when put in reverse starter engages and also the ignition wont start vehicle sometimes and the o/d light blinks when driving down the road...
View 2 Replies
My boss gave me a 2002 f150 if i can get it started. No key and no paper work in order to get locksmith to replace key. The only way i have noticed to get it started is to drill through cylinder to get it out. Need to know how to get it going?
View 4 Replies
1997 Ford F-150 4X4 ignition Actuator Rod. Looking for instructions on how to replace a broken Actuator Rod? I know the rod is broken because the upper part moves and the lower part connected to the switch does not move.
View 4 Replies
