Ford F-150 - 1997-2003 :: Horn Blowing / Lights On But No Startup
Dec 1, 2014
I have a 97' F150, 4x4, Auto trans, 5.4L Lariat. Power locks and windows. Auto locking hubs. It doesn't appear to have any theft deterrent system installed.
It has been sitting for some time. When I hook up the battery the headlights, dash lights, and wipers turn on and the horn starts blowing continuously.
Cycling the key in the ignition or door has no effect. Cycling the key to the start position does not engage the starter.
View 14 Replies
Advertisement
On the way home yesterday I was caught in a deluge. I ended up having to go through one spot where the water was pooled, but not really that deep. Anyways, 45 minutes later I arrive home, park the car, and 15 minutes later the car horn starts blowing constantly. This went on for several minutes, stopped and started a few times, then eventually stopped. Nothing I tried would make it stop, it just eventually stopped on its own. So as not to wake the neighbors last night I pulled the fuse to the horn. With the fuse back in, the horn still works, what caused the problem?
View 5 Replies
I have a 2002 f150 super crew, 5.4l and 4wd. The low tone horn is not working and I am having trouble locating it. Where do you suppose Ford has hid it?
View 2 Replies
Is there a fuse or some thing? Can I rig it?
View 6 Replies
The one on my truck sounds pretty wimpy. I don't use it a lot but it's supposed to get your attention... Mine., Not so good.
View 13 Replies
I have a 2003 F150. My horn and cruise both stopped working. All fuses are OK. Cruise controls are on steering wheel (as is horn). Why both would stop working???
View 2 Replies
My truck horn sounds wimpy and how I can look into for a deeper sound. I am looking for a simple replacement that doesn't need any extra wiring or modification.
View 1 Replies
Every time that I hit the brakes, the headlights flash and the horn blows for about 30 seconds. I am guessing that it has something to do with the factory alarm? I do not have a key pad. It is a 1997 F-150.
View 3 Replies
I have an '02 F150 Lariat CC 5.4L. The truck is new to me and neither the cruise control nor the horn works. i have checked all (known) fuses and relays. I have tried the cc diagnostic, and the dash light DOES NOT illuminate. Should I assume that the dash light is not burned out? Is there a way to test the clock spring connections for continuity? and how do I access the connection
i checked the cc brake pressure switch and have continuity there.
View 2 Replies
I have a 2002 f150 with about 165,XXX miles on it. drove to work one morning and got out and locked the truck and the horn went off and wouldn't stop. after a few minutes of pushing the horn button down and applying pressure it finally stopped. well this went on for few days, and then it stopped so i figured it was done. Well few days ago i tried to push the horn down at another driver and it wouldn't work. then i realized that my controls on my steering wheel did not work either.
View 3 Replies
I am having trouble with all sorts of functions on my 2002 F150 4x4, 4wd not working, cluster module illumination not working, horn not working, reving up and down at idle and sometimes dyin, cruise control quit working. I have been reading it is the GEM module that causes these issues. My question is I ordered a new one from Ford, when it arrives I was told I can just install it and It should be pre programmed. but one ford house tells me that they have to install it and program it. Which it right? I have seen several sites on u tube where people replace the module and then start their truck right up without any issue.
View 2 Replies
My '01 F-150 2WD, XLT has a foghorn sound coming from the left front side at idle after the 4.6L is warmed up. It goes away with an increase in engine RPM and is unnoticeable at hwy speeds. I have no codes (I have checked w/ my code reader). The service desk guy at the stealer said it is my abs pump going bad (I figured it was a pump of some sort, my 55 packard PS makes the same noise when almost empty-the system leaks). It also appears this is a stealer only part, and going to cost 6 or 7 benjamins to buy and probably another 5 benjamins too fix.
View 4 Replies
1997 F150 4x4 210,000 4.6L Windsor 5 Speed. Engine totally rebuilt 15k ago (besides for timing chains and tensioners). No codes thrown.
This morning when i started my truck, it made a knocking sound (almost like metal slapping) that seemed to be coming from the bottom end of the engine. At first I thought it was a spun bearing, but then the sound went away after a minute or 2. I have Google'd the problem, and have found a few diagnoses such as: oil draining back from the filter (or something like that), or an exhaust manifold leak that stops when the metal warms up and expands, or even the starter motor not being aligned right and not disengaging properly...
This is the first time this truck has ever done this. I changed the oil and filter about 1000 miles ago with 10w-30 oil and I believe a WIX filter. Also, this is the first time using the WIX filter
The weather this morning was around 51*F, so not too cold (to me).
Also, a few weeks ago when I changed my oil, I noticed milky white stuff only on the bottom of the oil cap, and in the feed neck. The rest of my oil looked like perfect used oil. After I noticed the milky stuff, about 2-3 times a week I would clean the stuff out of the neck and off of the cap. Just recently, there hasn't been as much milky fluid. My coolant level has not changed since I marked it during the oil change. A few buddies have said it might be condensation, but it's never been like this before.
I guess my question is, is this something that could put my truck out of service if left untreated? I'm assuming it's not a spun bearing because the noise goes away, but is there a possibility coolant could be leaking into the case but stay the same level in the reservoir?
View 8 Replies
My F150 at startup is reving real high, almost max rpm's, like the pedal is on the floor. What could be going on?
View 6 Replies
I've got a 2003 ford f-150 with a 4.6l 150000 miles. when it is started the rpms are at 2000 for about a min. and a half then it drops to normal when its started cold. when started at operating temp. The rpms are at 2000 for about 30 to 45 sec then drop to normal. The iac, upper and lower intake gaskets, intake run controller valve, dfbe, low intake and shield, coolant temp. sensor, intake air temp. sensor, egr, egr regulator valve, maf, ecm have all been swapped out no vacuum leaks all line in good condition tps voltage reading of 0.84v...
View 2 Replies
So on a cold start I keep hearing this ticking noise. Not every time, but more often than not.
I have two thoughts:
1) Low oil pressure causing timing chain tensioners to allow slack in the timing chain. Oil pressure builds up after about 1 minute of driving.
2) Oil Restricter in the valve cover starving one side of the valve cover?
View 7 Replies
I am going to start from the beginning because oftens times we don't provide all of the information that may be pertinent to the correct diagnosis or repair. It'll be kind of lengthy! It all started about 3 days ago when my wife told me that my truck was "shaking." I said, "ok, just drive the car til' I can look at it" The next morning, the I was able to look at the truck. I had a cylinder 8 misfire detected. I drove it for about 1 hour that day to and from work. I did this so I could see what what the "shaking" was. It was actually what I describe as a "shudder."
Anyways, I done a fuel pressure check and all was well. I took of the coil, tested it, it was fine. So, I took out the plug to inspect it. It was wet! Not drinched, just mildly damp. I dried it off, cleaned it off with carb cleaner and it fired right up no hesitation no nothing. No CEL light, no shaking, no shuddering. It ran perfectly normal. I let it warm up to speed and took it for a test drive around about 6 city blocks. All was well. So I took it on the highway for about a 2 mile stretch. I was givin' her some juice pretty hard to see if it would misfire. Upon acceleration I heard a screech. Now this is where it get's interesting.
The screech that I hear, I just related it to the belt because it's done it ALL the time. When I first bought the truck it squalled like a whipped puppy cause of a cheap belt. The good ol' bar of soap trick fixed that! But, ever since then, it upon shifting, or under acceleration it would screech then stop. So anyways, on the highway run, it screeched while I was accelerating. It did this from about 60mph-80mph. I then, turned around and came back home. By the time I got to the stoplight to turn off towards my house my oil light was on and the engine was knocking. Not a tap, a knock.
I slowly coasted home not going over 20mph and pulling it out of drive as much as I could. I get home, and I check the oil and there is nothing on the dipstick! WTF!? I always run Mobil1 Full synthetic and put it 6qts. It doesn't smoke, doesn't leak or nothing! So I freaked out and went and bought 2 qts of Valvoline Hi-Mi and poured it in. It brought up the hash marks and quieted the deep knock. Later that night after work, I done a full oil change and flush and put back in my Mobil1 Fully synthetic 5w20. It now knocks at startup, and smooths out to a tic. Then at idle, it sounds like a light knock. It appears that it goes away upon acceleration.
View 14 Replies
I've got an '02 F150 with a 5.4L Triton. Despite being 10 yrs. old it's just passed the dealer warranty mileage about 80,000 miles. Due to a family situation it's been sitting idle for upwards of 2 or 3 weeks between startups.
When I do startup there's a puff of blue/geyish smoke, the engine idles rough for about 30 secs. and then everything smooths out and she runs normal.
I haven't noticed this issue before, I would add the temps here have been extremely cold the last few weeks. What direction do I point a mechanic in so he doesn't waste time or money on a diagnostic.
View 5 Replies
97 f250 4.6l engine pegs the temp gauge after start-up. the oil pressure light comes on then after a few miles down the road anti-freeze blows out the pressure cap (15LB) then the temp goes down ,the oil light goes off and everything is normal. no its not the thermostat, i changed that and it still does it. whats up with that?
View 14 Replies
I've recently begun experiencing a problem with my truck dying immediately upon start up. It's a 99 5.4 and it will act like it's starting normally but then will idle down and die. If I gas it to 4000-5000 rpm it will eventually return to normal idle and run fine. At first it was once a week and then every day, usually upon the second start of the day but today it happened twice and I suspect it will become more frequent. What to check that doesn't involve a Ford Dealer?
View 3 Replies
We have a 2002 F-150 4.6L 4x4. The engine went bad and we bought a new engine (remanned ATK). Had this engine installed and a year later it was bad and was determined it was a manufacturer defect so they sent a replacement engine under warranty.
We had this new engine installed. The mechanic fired it up and it backfired through the intake. They claim that the compression is good, the fuel pressure is good, and the timing is correct. Can they check these things when the truck is not running? The mechanic is completely frustrated with the situation...
Everything I read leads to a timing issue but they say they checked it so before I go in there screaming I want to make sure it couldn't possibly be anything else...
View 14 Replies
