Ford F-150 - 1997-2003 :: Engine Just Revved When Shifting Into 3rd Gear
Jun 4, 2012
My daughter bought this truck about 6 months ago. This morning a driver cut her off, then hit his breaks. She had to make a panic stop. When she went to take off again, 1st and 2nd was no problem. When she shifted into 3rd, the engine just revved.
She tried to shift back into 2nd, but it wouldn't go into 2nd. She pulled over and now it won't go into any gear. The shifter lever won't even go over far enough to go into 4th, 5th, or reverse. I doubt the panic stop had anything to with it, but thought I'd throw it out there, just because.
Okay here's the truck: 1997 F150, 4x4, base model, short bed, 4.6L, 5 speed manual, manual transfer case, 190k miles. Truck has been beaten and abused badly, but is basically mechanically sound.
Here's what I've done so far. Checked the fluid, it was fine. Pulled the top cover and shifter lever out. I don't have a clue what I was looking for in there, but I hoped to see something obvious. I didn't.
View 13 Replies
Advertisement
In my 1998 f150 4.6L 5 speed manual. When I go to put it in reverse I get 1st instead, but if I do a second shift to reverse I get reverse. This happens on an average of once a week.
I know this can happen in FWD cars where you put it in one gear and get a different gear instead. Something to do with the shifting cable. But the f150 is RWD, the shifting problem only happens in reverse. Is this problem someone without ASE certificates can do, or without dropping the transmission?
I'll add to this so I don't start yet another post. Ive thought of the problem and if it was really going into 1st instead of reverse the problem likely would be bad enough it would just stay in 1st. Its possible that I am getting 4th gear when I go into reverse which tells me the clutch grabs really well, and its a problem I really need to fix, I don't know that much about transmissions but I do know if it keeps getting 4th instead of reverse, the clutch wont be so good pretty fast.
View 1 Replies
A few weeks ago I bot this truck to have some fun with. 98 F150 4.2l with a lift and some beefy tires. Well something to get me into trouble. On the test drive i never herd anything, mostly because I wasn't ripping it around. I know very little about transmissions, mostly because I never had a problem before.
I have a grinding noise when down shifting into 3rd for either 4 or 5th. It doesn't happen when I am going from 2-3. It also wont happen if i keep the clutch disengaged for a few seconds. It almost like the transmission need time to slow down for a second before shifting.
It also does this going into reverse.
View 1 Replies
I have a 2000 F150 with the 4.6L engine and I have a question about the transmission. When shifting from 1st to 2nd gear there is sometimes a little hard jump when shifting. All the other shifting through out the range is buttery smooth. The issue has been around for a long time and has never gotten worse. Is there anything simple I can do to fix this. Do those tranny additives work at all? Otherwise, I will just continue to live with it.
View 2 Replies
I have a M5OD that I replaced the clutch in in my '99 150 4wd in December . Manual Tranny. Now when taking off in 1st gear the transmission seems to be sliding or shifting backwards, but only in first gear. Got under my truck and looked, can't find any identifying marks to where it might be moving or what is causing this. All frame mounts are tight and the bell housing is flush with the motor. Yes, i did do the clutch change myself in shop class.
View 1 Replies
97 f150 4.2 ... Got a pickup awhile back and was smoking excessive mostly blue. Pulled the motor and had exhaust valve with hole in it and intake valve not seating on separate cylinders. All new gaskets and put back in truck. Deleted catalytic since they were both destroyed and cleaned muffler as best I could. Now it smokes but mostly white when revved up and maybe slight blue at idle. It's not using coolant or oil but went through five gallons of gas in short time.
Tests I have done : Checked fuel pressure and holds 38 psi all day. Tested maf o2 sensors, one is bad and tested vacuum and compression all good. It seems to be over fueling to the extreme. idles a little rough and will backfire on occasion. No check engine light but had all the o2 sensor issue codes. I'm leaning toward bad PCM... Would that cause the smoke rough idle and super rich condition??
View 14 Replies
2001 F150 5.4 v8 ... In the past few months my truck has been a bit strange, but in the past few weeks it's gotten to the point I'm nervous to drive it. Usually when shifting around 30-35, the engine revs up and stops accelerating and I have to take my foot off the pedal to make it return to normal. It doesn't do this after I do that, but the past time I tried to drive I couldn't get above 35 and the rpm was in the upper 2000s going at a constant 35. When I stop for any reason such as making a turn, when it shifts it lurches forward and I hear a loud clunk.
Naturally, I've checked all the fluids and fuses and they're all fine. The mechanic I regularly visit insists that nothing is wrong with it.
View 2 Replies
I just got my truck back from the tranny shop 3 days ago,was driving down the hiway looked down and my speedo went from 65 to 0 instantly. it was driving fine till i exited then started reving and not shifting till about 3000 rpms. So i changed the sensor on the rear end and the vss on the transfer case but no results.
View 7 Replies
1991, F-250, automatic, 150,000 miles, two tanks. Used mostly for towing an RV plus some pleasure. Not in daily use. A month ago I parked it and a few days later cranked it up and found it wouldn't run over thirty MPH. There was some high pitched backfire in the engine compartment and the trans. wouldn't shift. I parked it and the next day it wouldn't start. When I turned the key on the fuel pumps (either tank) ran continuously. Towed to a garage (I am not a Mechanic). They have replaced the fuel pressure control, checked all pressures and it still won't run right. The problem is intermittent. My tranny man said the trans was good. My mechanics don't know what to do. I bought it in 1998.
View 3 Replies
My truck is a 2000 model 2wd with the 5.4 engine. It has about 234000 miles on it. It suddenly started surging last night rpm jumping around approximately 4-600rpms each time. I noticed that once I got up around 50mph it would smooth out...
View 4 Replies
I have a 2003 T&C 3.6L with tow package, purchased used (privately) with 25K miles in 2006. Since I have owned it, it will occasionally not go into any gear when first started after sitting at least overnight- basically stays in neutral until engine is revved to about 2500 RPM. You can rev it in neutral or while it's in gear. This always works, and the transmission will then work fine until another overnight stay. I have had the transmission serviced 3-4 times (once when it first happened, and then at recommended intervals. The car now has 96K on it, and it has been happening less frequently (in fact, it hasn't occurred in about two weeks). I have discussed this with two Chrysler dealers, and have left it overnight twice, but of course it didn't repeat at the dealer. I haven't been able to correlate when it happens with anything except: it seems to occur more frequently when garaged in Pittsburgh than when sitting outside in Myrtle Beach (I spend time in both places).
View 3 Replies
I just had a 97 Ford Ranger with a 3 speed overdrive transmission in my garage that we replaced the transmission because it was not shifting down into first gear, not even manually!. The new transmission is doing the exact same thing as the original.
View 5 Replies
Our red line is at 6k rpm, but I accidentally revved it to about 6500 in second gear today, and nothing kicked in to stop me. I'm surprised that this car doesn't have a rev limiter at red line. Looking for about rev limits on these engines (2.5)?
View 7 Replies
I really liked my 97 f150 4x4. It was a very very good truck... until last night. It randomly shifted into 4hi. Okay, shorted wires, right? Eh... well this morning i was gonna take it into the school's shop, and now its switching between 4hi and 4lo... on its own... so i disconnected the switch in hopes that that was borked and it still keeps doing it. Also, disconnected axle actuator and it didn't unlock so its sitting in the parking lot currently...
View 3 Replies
I have 1999, F150 5.4L with electric 4wd shift. I put it in 4high just fine and smooth. Now 4lo on other hand rough shift if it goes in 4lo, sometimes won't engage but 4 high works fine. What's the cause
View 2 Replies
I had recently purchased a 2003 golf gti AUTOMATIC (with optional shifter) with a 1.8 turbo 4 cylinder engine. The vehicle has 139,000 miles on it. Before purchasing, I had a mechanic come out and look at the vehicle for a pre-purchase inspection, and ran the code P0303 (cylinder 3 misfire) which without test driving, told me that is what caused the shift shudder I noticed when I had test driven it a previous day. He told me the coil packs were in good condition by looking at the top of them, and told me if I replace the spark plugs, the issue should go away.
I feel it is important to mention that he had also run codes on the transmission and nothing came up. Taking it home, this morning I had replaced the spark plugs and driven it for about an hour both regularly and aggressively to test it. The problem is still there, and I was really hoping that there is a solution to this problem, because everything else on the car is beautiful, while being my dream car, I just want it to work as well as I know it can. To be more descriptive, when shifting to 3rd the whole car feels basically like it is tripping over itself before successfully shifting.
View 10 Replies
I have a 1997 Chevy Blazer. I have had issues where I could not start my truck and determined it could be the battery. After checking alternator, battery, and starter I was told that all were good. Cleaning terminals did not fix problem. I got a new battery. So I have determined that a power drain is going on somewhere. I have now found that when I shift the transmission from drive to reverse or vice versa that the rear hatch window comes open. As I shift the gear I hear the latch popping behind me. Now I have determined that there is a short somewhere and this could be the cause of my power drain. What I need to know is where to start looking for the default and how to fix my problem.
View 3 Replies
I have a 1999 Ford F-150 XLT, with the 5.4 and a 4spd auto. 172,XXX miles on the clock and i have owned it starting on April of 2014.
Tonight driving home from work, it took some time on the highway (4 miles) to shift into top gear. When you lift off the gas pedal after reaching the speed limit, normally the truck will shift from 3rd to 4th no problem. When I let off the pedal, there was no gear change.
It took sometime for it to shift up. When downshifting on the exit ramp, there was nothing abnormal. Where I live it is 19 Degrees Fahrenheit and this is the beginning of the cold snap that will last well into mid-January of next year.
View 14 Replies
I have a 1998 F-150 XLT, 2WD, 4.2L, V6, just over 103,000 miles. My transmission shifts fine into reverse but when I put it into drive it is very slow to engage, sometimes it doesn't. I have to put it in drive, hold down the brakes, give it some gas and then it will engage and lurch forward. I have check the fluid level and quality. Both are fine. This just started to happen two days ago with no fore warning. No previous problems with transmission.
View 4 Replies
Just got a 98 f150 yesterday and I noticed last night when I went to shift into reverse, with the clutch all the way to the floor as I tried pulling the shifter back, it sounded like the clutch wasn't engaged at all. Shifting from all the other gears works just fine. Ive found that If the truck is off and I start it in reverse it works just fine.
View 3 Replies
My friend has just brought a truck and has lost 3-4 gear in the auto trans. We have the PO782 code coming up. Is there something in particular we should look at first.
View 2 Replies
