Ford F-150 - 1997-2003 :: Electrical Malfunction - After Start Up No Gauge Moves / Temp / Oil / Battery?
Nov 11, 2015
I own a 1997 ford f150 V6 engine and I have problems with the electrics. I turn the key on and the engine starts up runs great but I then look at the gauges and not one moves at all the. No fuel when i have just filled up,no tep,no oil,no battery all read nil. I went a drive and the speedo reads 0 it does not move but the truck drives great. Could it be a fuse, does a fuse control the gauges, which one it could be. I have lifted the hood and under the hood on the drivers side there is a box with small and larger fuses.There is one that is very small and the colour is white that's blown. Would you no what that fuse is for.
View 1 Replies
Advertisement
I just bought a 97 f-150 from my dad, there are some electrical issue's but the main one seems to be battery drain.
I have noticed with the truck off key in my pocket, the a/c doors keep trying to move and the a/c head has power to it.
I know the engine has been replaced, with about 20k on it.
The temp gauge pegs w/o getting hot, and it even turned over once while we were getting in the truck. Again key in pocket.
View 1 Replies
We have a 1997 Ford Ranger, live in Minnesota. The heat doesn't work, the electric windows need to be pushed up the last 4 inches, the radio is stuck on loud, the back window latch is broken off, the dash lights only light up the speedometer to 50 mph, the driver's seat doesn't adjust for reclining, and the gas gauge doesn't work. We tend to drive our cars till they die and have been able to live with the above annoyances. However, in dealing with the lack of a gas gauge the person driving it when the odometer hits 200 miles is suppose to fill it up then reset the odometer. That was me this weekend.
Once the gas nozzle clicked off I gave it one last squirt to top it off and gasoline began flowing out under the car. Not dripping, not trickling, not squirting out back at me. Under the truck. Maybe a pint to quart of gas. After wondering if I was going to blow up that part of the county if I started my truck, I figured God wasn't done with me yet, so I started it and drove until I used up about 3 gallons. My husband thinks it is OK to keep the truck because by overfilling it I triggered a valve that actually supposed to do just what it did….release the extra gas.
View 19 Replies
I have a 94 Ford Ranger, 2WD, 5-Speed, with 2.3 engine. My temp gauge hardly moves at all... It actually appears as if it doesn't move it you don't pay close attention and were to just glance at it. I'm thinking it is most likely the temp sensor that is on the engine block as I understand there is also one that is in the line that controls the fans for the radiator. Am I approaching this in the right direction or is there something else I might need to do?
View 3 Replies
Ford crown vic, 1999, 125k miles, no engine work has been done, did flush cooling system in spring of 2013 and put in a 50/50 mix of coolant and distilled water (from a jug). No problems for the summer of 2013, have been using heater with no problems until around Tuesday of this week.
Car runs fine, no leaks, coolant checks out good. BUT now.. My temperature gauge hardly moves (up) and the heater blows warm air only. If I am driving the gauge will not move, if the car sits running for awhile it will move up some and the heat will get warmer inside of the car. My guess maybe a stuck thermostat?
View 3 Replies
I rebuilt the engine on my toyota celica. After putting everything back together there are a few bizarre symptoms I am hoping to get sorted out.
1) It only starts with starting fluid, but once it starts it will run continuously without dying.
2) The temperature gauge goes up relatively quickly, and also moves with the throttle. For example if it is as the 1/3 level and I apply throttle it will bump up. It continues to jump along with throttle play.
3) When I remove the coolant sender and/or sensor plugs, the gauge still reads the same (is this normal).
4) The fans don't turn on unless I remove the sender cable (the one with one wire and not two)
If I understand correctly the sensor with one wire is the sender and the sensor with two wires is the temp sensor. I am having a hell of a time determining the difference. The one with a single wire contact is plugged into the thermostate cover/pipe. The one with two wires is in the thermostat housing.
Did I fry the ECU somehow? What is going on?
View 14 Replies
Problem: The exterior temp. gauge is blank.
It used to fade in and out and I discovered if I pushed the button that switches from degrees F. to degrees C. it wold come on for a bit, but no more. It's just blank.
I think I've seen a thread on here about similar issues but I was unable to find it. I'm also not sure how to take the overhead console off yet. The console consists of ext. temp gauge, sun glasses compartment, and compartment for a garage door opener.
Some truck specs:
Year: 2001
Model: F150 Super-crew
Motor: 4.6L
Mileage: 250,000
Color: Silver
Original motor, second transmission.
View 9 Replies
I have a 2002 supercrew 5.4 triton. My coolant temp gauge is acting up. When it starts up its obviously in the cold range but when the truck begins to get up to temp, the gauge only goes up 1/4 full. What it can be?
View 4 Replies
I have a 97' F-150 4.6 L and I've been having some fuel gauge issues.... I filled up my tank up and I drove it 130 miles and it still said full tank... even when I had 1/2 I would start it and every time I started it it would jump up all the way to full and slowly drop down. Then randomly last night it started working... I noticed as I hit rough patches in the road and bumps it would usually fluctuate, but it would also fluctuate up... It read I have 3/4 tank last night and I go to start it today and its back up to full! I don't understand... Wouldn't a bad sending unit just stop all together?
View 1 Replies
So driving to work today I noticed my battery light came on..... Well I kept driving only cause I figured if my belt slipped off it would be to late to save it/if it was my temp gauge would start going into the red..... So as I'm still driving it kept turning off and then back on(the battery light) the whole way of a 25min ride.....
Finally got to work popped the hood and belt was in tact and seemed to have good tension... So I don't think it slipped or came off.... And then checked battery just to double check and everything is connected.... Now as we all know are alternators are right under the intake mani so front end has to come off to test it/replace it.....
Also when coming to red lights on the way to work the idle seemed fine never seemed to fluctuate crazy.... I know when my Audi had a bad alternator when I came to stops it about cut the motor off/did if I didn't keep the throttle revving it up but not sure as I haven't been able to test anything yet.
View 2 Replies
97 f250 4.6l engine pegs the temp gauge after start-up. the oil pressure light comes on then after a few miles down the road anti-freeze blows out the pressure cap (15LB) then the temp goes down ,the oil light goes off and everything is normal. no its not the thermostat, i changed that and it still does it. whats up with that?
View 14 Replies
My '97 F250 5.4L is pumping coolant on to the top of the motor which is burning off causing it to smoke like it's overheated but the temp gauge is operating in normal range. I'm losing coolant but can't see where. It's not going to the ground. It just pools up on the top of the motor. I've already replaced the water pump in the last 2 weeks because of the same issue. It stopped for a few days but now it's back again. Bad water pump from O'Reily's or is there some other issue here? I've checked while the motor's running and can't see where the coolant is coming from and there's no coolant coming out of the bleed hole in the top of the new water pump. I need this truck up and running.
View 7 Replies
My son bought his first truck, 1998 Ford F150 Supercab 4.6L Auto. (Proud of Him)
Salvage Flood Title, looks like engine been replaced. (Not so proud of him).
Anyway, vehicle seems to run and drive fine, however, failed emissions test.
P0125 Code pops up, Temp Gauge is not working, pegs all the way hot after truck is running, changed out Both ECT's in front of engine, one is right beside the other, I guess one goes to PCM and other to Gauge.
Now Gauge is reading all the way cold, let run for over 30 minutes and still shows nothing on Gauge...
View 11 Replies
I have a 2002 F-250 with a 7.3.
I have been having a no crank, no start issue off and on for a while. batteries are new, cables are new, connections are clean, and starter has been rebuilt and checked. I bought a "starter relay" which i thought was the top solenoid in this picture. I also replaced the lower solenoid in the picture. The bottom solenoid was replaced with what im sure is the correct replacement. The upper I think is wrong. It started but then shut down and will not restart. The upper solenoid also was very hot after it shut down.
Long story short what is the upper solenoid for? Im assuming its not the starter solenoid. If so where is the Starter solenoid on a 2002 7.3?
View 14 Replies
I am looking at a 1997 F150 with a 5.4 in it, guy who owns it says if you drive it down the street the temp gauge climbs and then the truck goes into limp mode but if you check the engine temp under hood it is nowhere near overheating. Where I should start to look for a problem here? If this is too complicated I will pass on the truck, its not worth it to me to get this truck if it is going to be a nightmare. I have a 2000 with a 4.6 that runs great so this would just be a spare for me, but would like to have it because its in such nice shape.
View 1 Replies
1998 f150 4.6 4x4 auto 180k .... Runs 100% other than a strange and inconsistent overheating issue.
On cold startup truck will warm up. Then the temp gauge drops to practically 0. After 15-20 seconds gauge shoots up to max and then falls back to normal after 15-20 seconds. Then it'll go back to driving normally. At some point it pukes.
View 6 Replies
Was driving my truck I have a 97 f150 4x4 4.6L, btw. The heater started blowing cold air and I looked at the temp gauge but it was showing lower than it normally does and then, after a couple of miles or so I looked at the temp gauge again. By this time I was in my driveway. And it was overheating it might have been that way before I looked at the temp gauge again. But any way I opened the hood didn't see any leaks, all my hoses were hot except the top heater hose. Also checked the oil it was full and coolant was too, what this could be? Sounds like a t-stat to me? But could be worse. Also forgot to mention that the oil had no signs of water in there nor the expansion tank cap !
View 3 Replies
Finish a job yesterday and go to start my 98 F-150...4.6 and get the dreaded click. All has been fine. Firewall relay clicking, so crawl underneath in the slop and snow and the main battery wire corroded off the starter solenoid. Go back up top and turn the key to run position, crawl back underneath and short that wire to the other main terminal that feeds the 12 volts into the starter. Truck starts right up. That gets me home, I found a 4 gauge lug in my electrical stuff, clean up the wire and crimp it on ( actually a smoosh with a vice-grip cause my crimper won't get in there and trying to solder in that position wasn't gonna' work). Replacing that cable and how hard was it to pull it out of that loom that it shares with other wires? I was thinking just run a separate cable in a new loom and zip tie it to the other loom? I was guessing it is 2 gauge? Looks like about 4' would be enough to go from the battery to the starter.
View 3 Replies
I have a 2000 7.3 f450 having some electrical issues. When you turn the key on sometimes the dash will start ticking and left side light flashing...engine will turn over but it won't start. The ticking is coming from under the hood relay 32 (you can hear and feel it clicking). Book says its injector driver module power relay. A lot of the times it will start fine other times it will be running and just die (prob because of this issue) happened once when I was driving.
What to check here already replaced the relay still have the problem.
View 6 Replies
Over the past weekend i noticed all the electronics having a slight "flicker", so I figured my alternator was on its way out. After replacing the alt with a reman, I still had the issue. Then, replaced it with a new new one and the issue still persists. I will be getting a meter to test later when my buddy gets off work. The gauge on the dash is running high and battery light is flickering. Is there something I am missing? I ran another ground to frame also.
2001 SCAB 5.4 144,000mi 4x4 ....
View 3 Replies
My car has the original battery and it hasn't given me issue. Even a few weeks back when most of the country was really frozen and the car was parked outside, it started fine.
Last week after a work day in the parking lot, she was dead-dead. No dome light, no cluster, no lock LED. After 5 minutes tethered to a friend's battery via jumpers, it quickly showed interior electricity but the starter strained. 5 minutes more and the car started like nothing happened. Last weekend after a movie, the car was dead-dead again. I opened the door to see if I could hear the starter to determine how dead it was and the dome/cluster lights came back and it started fast.
The car sat for 36 hours or so and started fine, even after pretty substantial temp drops. Got around town for the past 2 days, no issue.
Today the car was dead again. Jumped it off my Mk2 and went on my way. It started fine and got me to Advanced Auto where their battery tester read 400 CCA and their info showed spec was 430 CCA. They didn't want to sell me a battery yet and suggested an overnight trickle charge and to monitor the issue.
If it was just a dead battery requiring a jump, I'd replace it. But the other oddities + the seemingly good test #'s makes me wonder what else I'm seeing.
View 10 Replies
