Ford F-150 - 1997-2003 :: Econoline Will Not Turn Over - Steering Wheel Flopping In The Breeze
May 28, 2014
Working on my bosses 97 Econoline conversion van. The steering wheel was flopping in the breeze, gear indicator was off and some of the time it would be in reverse when you thought it was in park. Checked the torx on the shift cable plate and they are tight. Replaced the 2 bushings on the shift column. They tightened up the steering wheel flopping around. I checked the shift cable and it appears to be in good shape.
It would start sometimes if you worked the shifter in park or moved it to neutral. Now it will not turn over. Shift lock actuator does not appear to be working. Does not lock it park. No continuity between any of the three pins with the actuator pushed in or out. If you turn the key you can take it out of park without pushing on the brake. Really do not know the series of events that have to occur to make it turn over. How to trouble shoot the problem?
View 1 Replies
Advertisement
my turn signals only work with the steering wheel tilted all the way up. It works for me, but my wife drives the truck mostly because we live a mile from her work. The dealer said it was a "peanut connector." And can someone walk me through the steps to fixing it?
View 8 Replies
I took my truck to work and needed a pitman arm. So took it home put a new one on and the steering wheel was crooked which didn't bother me. but after in cranking the torsion bars I noticed how Badly I needed an alignment. So took it back in for an alignment and I cant turn the steering wheel back to center because the tie rods are maxed out. I tried to take the pitman arm back off center the wheel and everything but the key ways just line up the same way. Any chance the after market pitman arm is off or any clues?
View 11 Replies
Heard a thumping yesterday as I'm getting on the highway at rush hour. I looked in the drivers mirror and I see my rear wheel flopping around. I had sheared off 6 of the 8 studs. After towing it home I pulled the wheel and tapped out the broken studs. I've never done this before so I'm a bit unsure as to how I get the new studs in. The drum brake assembly is behind the rotor and even if I pulled all that out it still doesn't look like I have enough room. Did I just discover this job is bigger than I thought?
View 6 Replies
I noticed after the crash the steering wheel is moved forward and gear shift is up against dash. asked around and one person said they made collapsable steering wheels to impact. i have never heard of such a thing.
View 5 Replies
I want to replace my steering wheel. Will this puller work for that job?
View 5 Replies
I have a 97 F150 that I just got a few weeks ago. I was driving home Wed. night when the 4x4 low range light would come on and off intermittently I had it in 2h the whole time. I went online and couldn't really find anything on it. So I get up to go to work on Thursday and the truck wouldn't even turn over. The battery was dead. I have put in a new one but now after turning the truck off I hear a clicking sound coming from the steering wheel. What this may be?
View 3 Replies
Getting some rain here in az causing me to use my windshield wipers....which is rare. I can once and for all say I'm sick of the wipers working only with the steering wheel in the "up" position. Is it a big deal to tear into the column and replace that stinking multi-switch/harness? 378000 miles ....
View 1 Replies
I have a 2000 Ford F150 XLT 4X2 that has a "clunking/squeaking" noise in the steering wheel, intermittent happens driving straight down the road, hitting bumps, breaking. It is very annoying! changed out lower ball joints tightened wheel bearings, greased idler/pitman arm thinking that was the problem and it became worse. Had someone look at it and stated that the steering shaft was welded?!?! Why would the steering shaft be welded what am I looking at in replacing it (cost for parts and labor time) and are there any other additional parts that will have to be replaced as well?
View 1 Replies
While driving whenever we turn a curve to the right the steering wheel jerks and the whole front end jerks and will either quit when we slow down or come back straight. It seems the faster we go the worse it is also starting yesterday day we have noticed that the front end is beginning to make a popping or thumping sound while turning a curve or sometime will pop or thump randomly. It's starting to get pretty scary.
Just some info, tires are fine, no wear, all correct pressure. Had to recently use 4x4 in the snow but didn't have any problems with it. Did however hit a ditch pretty hard on the driver side and quickly came back out on the road from sliding off in the snow. Has a bad leak from the power steering reservoir to the pump (the line is bad but can't change it on my own and top off reservoir daily). Truck has 227k miles on body and 157 k on newish motor that was just put on in September.
View 2 Replies
Looking for diagrams for where the fuel filter is, the coils are in the engine compartment, and a steering wheel diagram because mine wobbles. I did attempt to look for one in a hayes when I was at Pep Boys a bit ago and didn't see one. 1998 F150 4.6L v8 w/auto trans 4wd 3dr...
View 6 Replies
I recently bought a 1998 f-250, regular cab, long bed, 4x4, 5.4l triton, automatic. The truck was involved in a wreck by the previous owner and I am trying to repair the damage. He hit some ice, slid off the road, and collided with a log cabin.
The visible damage was done to the driver side front. The bumper, grill/surround, header panel, headlight, turn signal, fender, and hood all need to be replaced. When you drive the truck there is a shimmy coming from the front that can be felt in the steering wheel. When going straight and releasing the steering wheel it pulls to the passenger side. The driver side front rim might be bent? Which might prove interesting if I have to replace it (7x150mm).
This is my first Ford truck. I was willing to take the gamble on fixing it up. I hope that it works out and I am able to do so. What years/models can I source these parts from?
View 8 Replies
I have a 2001 ford f150 lariat 5.4 L Trition it shuts off while driving the steering wheel locks up when the truck shuts off I tried everything and it doesn't seem to help the problem. I changed the Iacv idle air control valve,I had a bad o2 sensor changed that, changed the crank sensor, cleaned the throttle body and changed the Tps sensor, got a new battery, changed the vacuum lines.i really don't know what else to do this truck is becoming a nightmare and is dangerous to drive I never know when it's going to shut off and when it does shut off sometimes it starts right up and other times it doesn't.
View 2 Replies
I've got 2003f150 4x4 and had a fender bender front end out of line so had it lined up but steering wheel 180 degrees out..well watched a video about just adjusting drag link..so i crawled under ready to adjust but cant find an adjustment collar. Mine the only one without it?
View 10 Replies
Purchased 2000 F150 (224000 miles) about a year go cheap for knock around truck. Only gets driven about twice week (20 miles most). Has been running great until recently. Got in the other day went about a mile and notice really strong vibration in steering wheel and dash. First thought about something to do with alignment etc. After a little experimentation realized it was the motor. When you get to around 40 mph and try to hold the speed constant it starts shaking (I believe the motor is missing). If you mash the gas and accelerate it stops. As soon as you try to hold constant speed again it starts again. I can run it up to say 45 and let off the gas and the shaking stops. Once it was driven like this for about 5 miles or so, when I come to stop sign it idles rough. If it is put in neutral runs smoother. Could the fuel filter be clogging up? I did try some additive to see if it would clean it out, no luck. Now the check engine soon lite came on. Fuel Filter, Plugs?
View 5 Replies
I have a 1997 Ford Econoline conversion campervan that I don't use very often. I need to open the hood to jump start the battery. Last time I opened the hood I did not notice anything wrong with the hood or the hood release latch inside the cab. Now when I pulled the hood release latch inside the cab, nothing happens to the hood at all (the hood does not open at all). Is there a way I can open the hood or do I need to tow it to my mechanic?
View 4 Replies
I may, or may not have had to jump a curb at 40 mph to avoid rear ending another car. Truck is a 2003 F-150, single cab stx package, 4.2ltr. Long story short, no damage to my passenger side front tire or rim that I can see, but I do have a horrible grinding noise when I turn the wheel either direction. The truck still turns properly, power steering fluid is level. What should I start replacing first?! She's got about 90k miles on it, I'm sure a lot of the suspension parts are due, just need to know where to start!
View 3 Replies
Here's a little more info on the truck I'll be working on:
-2001 Ford F-150 XLT Supercrew Cab 5.4L Triton.
-Has been used as a work truck so it has some miles on it 200,000+ and it shows. He showed me the lower control arm and the upper control arms bushings are a worn. Some coming apart and others with cracks in the (the bushings).
-So might need some more things replace but need to learn more about the truck to figure out exactly what?
Anyway, I'm probably just scratching the surface of the work needing to be done on this truck but for now I'll focus on the more important issues since without a functioning steering wheel he cant drive the beast. Might end up doing some customizing to the truck in the future such as changing the headlights to give the truck a more meaner look, along with the grill.
View 14 Replies
I just bought a 99 f150. Its in great shape only 65000 on it but there is a hissing swooshing sound when turning the wheel... not really any brake sounds. The truck has been maintained and I dont see any leeks in the ps system hoses. I didn't know anything about the atf fluid in the truck... and I haven't added either ps or atf fluid to it. I'm wondering if that is maybe something the dealer i bought it from did. or maybe one of the shops the previous owner did. Would ps fluid cause these kinds of sounds? Do I need a flush of the system.. How to do that.
View 14 Replies
I have a 2003 F150 manual 4WD with 4.6L engine and 165000 miles. When i am driving i feel a vibration in the steering wheel and on floor board that intensifies when i press the accelerator. I do hear an irregular humming that sounds like it is coming from the driver side front. I checked the wheel for any play but it was very tight. i check tie rod ends, ball joints no play. i recently changed both u-joints on the rear shaft and the bearing hub on the passenger side front. Also, the steering feels a little 'wobbly' when i make sharp turns. it almost feels like it is giving. What else should i check?
View 1 Replies
I have a 03 1.8t jetta if i turn the steering wheel all the way to either side a epc light comes on and cuts power a lot what could this be....
View 2 Replies
