Ford F-150 - 1997-2003 :: Driving And Dash Lights Won't Work
Jan 21, 2017
I have a 1997 f-150, and the other week i was driving when my driving lights went out. My Day time running lights went out in the front (DRL) and my driving lights in the rear won't come on either. The dash back light wont come on, and neither with the lights behind the A/C panel. I checked all the fuses, and none were blown, and I still replaced some anyway. And I replaced the actual headlamp switch itself. I have no clue what to do next.
View 5 Replies
Advertisement
Got in my truck this morning and noticed the service engine light, oil light and gas cause were all still on. It also had little dashes in the odometer box. The seatbelt alarm goes off as well. What is going on?
View 10 Replies
Trailer light dont work right. If the running lights are on the brakes dont work. If the running lights are off the brake lights work fine. I cant drive at night this is a huge issue for an up and coming transporter. Its not the trailer lights ive eliminated that with my plug checker. Is it the rely? Blown fuse? Or common ford electrical mess up?
View 2 Replies
My brother has this truck. Bought it new. Its crowding 200,0000 miles, hes retired and doesn't want a new truck. Problem is this. I have been thru all i know about this subject..........which is not my arena. When you open the door, the dome lights won't come on. Neither door [three door truck] front doors. It has no switch in the jamb............that I can find, that shuts these lights off and on. Least that's the way they were shut off and on; for many years. I looked at the fuse panel schematics in his owners manual. Doesn't show any fuse for these lights, one relay, is there but that's on a different schematic. I am lost everything else ,on that circuit. Push buttons...... on the light...... its self, works. It just doesn't turn those darn interior lights on.
View 6 Replies
When driving have five beeps from dash. Is this a dash fault code or abs code. and where can I find info on them. need to get rid of. Changed out complete engine a month ago. Running great beside this beeps. Almost forgot 4.6 auto 2wd extended cab long bed red and silver.
View 2 Replies
I was driving home and the dash lights went out. I checked all of the fuses and they all check good.
View 14 Replies
My dash lights and hvac lights don't work my brights indicator and check brakes lights are on so I think there's power going to it. I checked all the fuses and replaced the dimmer switch and checked all of the wires in and around the cluster. All bulbs are new and checked. I don't know what to do now and I couldn't find another post that had something i missed. 1997 5.8l F250 ....
View 7 Replies
Just got this truck, and found out i have some kind of issue. At night I can't see the dash because the dash lights don't work. I have checked all fuses and they are good. I did find this plug, and I'm wondering if it may be the cause of my dash not lighting up.
View 3 Replies
If its a fuse what else will not be working? I have not tested with a test light yet but both door panel lights don't work. All the other interior lights work. 1999 ext cab.
View 3 Replies
This has been driving nuts for 2 days.... Brake lights dont work. Either pushing pedal or turning on lights. Turn signals work just fine.
Cab/cargo/3rd brake light on back of cab doesn't work either. I have checked/done the following:
- Checked Brake pedal switch for continuity. Tested fine.
- put multi meter on wiring all the way back to brake lights. No drop in voltage.
- changed bulbs. #3157 dual filament.
- positioned steering wheel all the way up and all the way down as suggested on here. No change.
- checked multi function switch (turn signal switch) for wiring issues. None found.
- kicked rear quarter panel for caveman adjustment out of frustration. No change.
What am I missing?
View 9 Replies
Just recently now the dash warning lights stay on or come back on shortly there after when the key is removed. I replaced the ignition switch. I can even leave the wiring to it disconnected with the same result. When the positive battery cable is removed and reconnected I can hear relay or relays clicking.
I pulled all one at a time next to the master cylinder in the two boxes. same result. I pulled all relays in the fuse box in the cab one at a time. no change.
Maybe related about a month ago the hvac fan stayed on. we had to turn that to the off position to remedy that. than it "fixed" itself. Starting points to check on this 4.6 with 361k on the clock 99% original....
View 14 Replies
I am working on this 97 F150 with the EOTF. It is not doing anything. When i turn the key on, no light on the dash comes on. When i operated the 4wd switch, nothing happens, no lights on the dash, no relay clicks or transfer case noise, etc. It has a new t case motor, the switch tests out good. I have researched for a while, and either find people with different symptoms or the original poster never updated with what the fix was. I am unsure where to go at this point, i am suspect of the GEM or the t case relay, but don't want to go replacing stuff without a basis for going so. Ive tested for voltage at the switch as well and it has 5 volts at pin 3.
View 13 Replies
I recently aquired an f150 from a tenant, it's an 2003 with 219k, v6. When you first start it all the dash lights and needles go berserk and it will only run for a second, if you press the trip button over and over until eventually the lights are solid it starts and runs fine. If you disconnect the battery for a while it will also start and run fine. What this is? Guy also said the intake runner control valve is stuck open, where is that at?
View 2 Replies
1997 Expedition ... I've looked through quite a few 4X4 issue threads and haven't seen my issue described yet ..
When in 4X4 high most times all is well but every once in a while the lights on the dash will flash from 4X4 to 4Lo then 4AWD then settle right back where it should be at 4X4. I don't think that the front axle is being affected as the truck doesn't seem to fall out of and then back into front axle lock.
My guess is that this is an electrical issue but will get to the bottom of it and report back.
View 2 Replies
Brake lights do not work. The turn signals work, the flashers work, and the running lights (head lights) work. I checked the bulbs and both filaments light up during the above processes.
I removed the brake switch at the pedal. When I was removing it, I heard some clicking under the dash. I connected the 2 pins with a wire (bypassing the switch), and got a spark a few times along with the clicking sound like a relay,and the brake lights would come on, but now nothing. No sparks, no clicking. The flashers and turn signals and running lights still work.
There are no blown fuses in the fuse box to the left of the steering column. Is there a relay somewhere under the dash just for the brake lights?
View 7 Replies
I'm trying to get an F150/1997 started that's been sitting for about 2 years. After installing the battery, turning the key, nothing happens. No click, no turnover, nothing. The dash lights come on along with open door chime.
What to check first or troubleshoot this? The vehicle was running fine when parked, battery removed. I was thinking the brake pedal switch might be corroded, or maybe someone unplugged something under the hood or tampered with something.
View 7 Replies
Just bought this as a daily driver. This being my first truck and USED with over 100k in miles, I got it at a deal, but I am worried it might be a lemon. The engine is giving off 8 codes (listed below) that I pulled off my obd2 wifi scanner. This morning was a failure to start with all lights appearing on the dash. There is allot of accumulation around the terminals on the battery as well but the scanner read nothing about a faulty charge. I am trying to have my truck working soon so I can stop asking for rides ... broke down (5.4L triton straight piped )...
ERROR CODES:
P1131
P0171
P0174
P0316
P1151
P0401
View 4 Replies
I have a 98 f150 4x4, 4.6L 150k miles, during start up the blinker indicator lights on the dash illuminated and stayed on, when trying the blinkers they did not work, but if I shut the head lights off the blinkers do work and indicators respond normally. This is the same if I turn the fan blower on, blinkers don't work and indicators stay illuminated. Also I have found that the power windows, and 4wd no longer work. Other functions work such as power mirror, radio etc. all fuses under the dash and under the hood are good, I tried switching some of the relays to see if that changed anything but with no success . took the kick panel off and inspected the grounds and all seem tight. It looks like the main battery ground is just to the body and there is one solid ground from the frame to the body under the cab. all seem tight and don't appear to be corroded. Truck starts and runs great.
View 8 Replies
I have a 2000 F-150 5.4. The lights will dim very momentarily and brighten right back up when driving under 2000 rpm. It is barely noticeable except on the small back roads at night. It is actual the most noticeable on the dome light. I replaced a failing alternator probably a month or so ago and I don't remember it before I replaced the alternator. What could be involved with the new part to cause the flicker. Could it be bad ground connection or what? I don't have any voltage readouts or anything. I can get those tomorrow.
View 5 Replies
At 130,000 I replaced the transmission. Now, randomly the car has flickering lights on the dash while I am driving. The radio flickers, and the tach/speedometers drop to zero. After this happens and I turn off the car, the car will not restart. It is completely dead. If I wait 2.5 minutes, there is much clicking in the dash, then everything comes back to life. No one can figure it out. I will add that in the 9 years I've owned this thing, I have replaced 5-6 batteries. The transmission guy says something is pulling on the battery, but he nor Honda can figure out what it is.
View 3 Replies
I have an 05 Freestar with no instrumentation and no error codes. None of the gauges work and most of the warning lights are lit when the truck is running. No A/C and no ABS while driving and turn signals work, but do not display on the dash. It appears that two separate code readers are not acknowledging the computer. The battery and alternator check out good and there is no drain on the battery when ign switch is off.
View 5 Replies
