Ford F-150 - 1997-2003 :: Driver Side Brake Light And Turn Signal Doesn't Work
Jul 23, 2012
I have checked all wires for krosion and fuse's are good so confused! Just put brand new tail lights bulbs in! The top one comes on as a running light but nothing else works. I also checked under hood fuses too!
1.Only Hazard light that works is on the Right Front passenger side.
2 Drivers side Brake Light & Turn Signal Doesn't Work. But passenger works fine! Left turn signal is out and blinks really fast!
3.Passenger Side Overhead Outside Light on cab is out . Okay that's probably just a bulb!
View 13 Replies
Advertisement
I have 1999 Ford F-150 xlt and on the passenger side the brake and turn signal don't work but reverse light does. On the driver's side, everything works so I switch bulbs and outlets and it still doesn't work but two of the wires for trailer hook up and cut. I was wondering if that had anything to do with that.
View 2 Replies
My wife's 2003 sportrac has developed a problem. The left rear turn signal brake light will not work. The tail light does. When you turn on the left turn signal the front bulb and the dash light flashes real fast. I have changed both, the front and rear bulbs with no luck. I've read on here about the tilt steering column deal. I have moved the steering column while operating the turn signal with no change.
View 4 Replies
I have a 1997 F150 5.4L 2wd long bed w/ tow package.
Right (passenger) turn signal/brake light is not illuminating. The tail light on the right side does illuminate when headlights are on. (Same Bulb) All other lights are functioning properly.
When the MFS is in the right turn position the right arrow on the dash flashes and clicks faster than normal.
This happened about a month ago and it turned out to be a blown fuse. The fuse was for the trailer lighting and right turn/stop light, found in the small fuse box under the hood that only holds 2 fuses. Problem solved temporarily...
Now the issue is back, Here are some things I've tried so far:
Replaced the fuse again; Turns out the fuse didn't blow this time, but I tried a new one anyway.
Cleaned the ground for the rear light wiring harness.
Replaced the bulb.
Replaced the relay.
Checked continuity on multi-function switch, right turn position reads 2.8 ohms IIRC
Repaired pin #5 on the multi-function switch wiring connector (wire backed out, right turn related)
Replaced the bulb socket.
Inspected the wiring for broken insulation/exposed wires from that socket to under the hood, didn't find anything exposed. All wires are still in the loom.
I replaced this wiring harness and wiring looms about 6 months ago because the previous owner had done a hideous splice job for unknown reasons, so it should be ok. Should I get a new multi-function switch, or try something else? If the switch doesn't work what's the next step?
View 10 Replies
85 f150. My driver side brake light and turn signal in the back quit working. The tail light works tho which is a different filament. The bulb is good and I changed the flasher relay...the circle thing in the fuse panel. Everything else works just fine. looking for a starting point.
View 7 Replies
I have an 03 accord EX. The right turn signal doesnt work at all. I have changed the bulbs and the fuse. The left signal works just fine, while the right doesn't work front or back and the indicator light on the dash doesnt come on or click. Same happens when I put on the hazards. Its like there is no power at all to that side...
View 7 Replies
2004 F250 6.0L!!
An issue I noticed right off the bat was that whenever I had the driver side turn signal on, and the brake was applied, the turn signal freezes.
I took apart the tail light and found a concoction of wires...I posted a diagram illustrating what it looks like.
There is this pesky Red wire that is spliced into the tail light bulb socket wire (specifically the green wire).
There is a trailer brake installed...if this means anything. I've tried disconnecting that with no luck on fixing the issue.
How to further troubleshoot would be great...electrical work is not my forte!
View 14 Replies
My front left turn signal won't work, the signal on my dash board doesn't work, and the signal in the rear blinks rapidly. but the whole right side is fine. this is aggravating, I have changed the lightbulb in the front and nothing happened. It still doesn't work.
View 5 Replies
Turn signal flasher doesn't work in the heat. What gives?
All lights work. Turn signal stalk works fine. It just flashes a couple of times, then stays on. Everything works fine in cool weather, but it rarely works at all when the temperature outside is above 90 degrees. Very annoyed.
View 4 Replies
As the says I have a 1999 Yukon Denali that the Rear Brake and Turn signal on Drivers side are not working. Also brake light on trailer DOES work but not the turn signal on that side.
I tested the Tail light circuit by plugging it into the passenger side and it works so that rules out that. What wires to test under the dash to test the combo / multi switch?
Also the tail lights or park light do work (both top and middle bulb lights up when the vehicle is running) its just brighter filament does not light up when breaks are pressed or turn signal is on.
View 6 Replies
It all began on my 1997 Camry when the driver's front turn signal began the rapid flashing thing, indicating to me that the bulb in the front was out. I replaced the bulb. The running light part works, but the flasher still does not. On the front passenger side of the car, the turn signal works, but the running light does not. I replaced the passenger side bulb at the same time I replaced the driver's side bulb. The flashing turn signal works as it did before, but the running light still does not go on.
The problem shouldn't be the bulbs - they are new. The flasher unit behind the fuse box should affect both lights flashing, so it probably is not that.
What thing or things can cause one light to flash for the turn signal but not be on constantly for the running light (passenger front side) and to work as a running light being constantly on, but not flashing as a turn signal (driver's front side)?
View 3 Replies
On the final stages of prepping my truck for sale. I noticed today that occasionally while making a right hand turn the signal light will not work when you put the lever in the locked position (no dashboard arrow to the right and no front/rear light). I can pull the stalk upward, but not lock it, and it always works correctly. I am thinking a bit of corrosion on a switch, but I thought I would check and see if others have run into this.
View 1 Replies
My trailer left turn signal and brake light stopped working. The running lights work on the trailer. The lights all work on the truck. I am hooked up to a 2007 F150 and it all worked 'yesterday.' not sure where to start.
View 6 Replies
This has been driving nuts for 2 days.... Brake lights dont work. Either pushing pedal or turning on lights. Turn signals work just fine.
Cab/cargo/3rd brake light on back of cab doesn't work either. I have checked/done the following:
- Checked Brake pedal switch for continuity. Tested fine.
- put multi meter on wiring all the way back to brake lights. No drop in voltage.
- changed bulbs. #3157 dual filament.
- positioned steering wheel all the way up and all the way down as suggested on here. No change.
- checked multi function switch (turn signal switch) for wiring issues. None found.
- kicked rear quarter panel for caveman adjustment out of frustration. No change.
What am I missing?
View 9 Replies
2003 X limited, 2wd 6.0L
Last week wife's right rear turn signal/brake light stopped working. The left one flashes normally. The right tail light works fine which is a different bulb. I tried changing bulbs (didn't work).....tried a new socket with new and old bulb (didn't work). Could it be a relay? Or not relay as they would be both out (left and right)?
I looked at my trailering wiring plug down by bumper and the white wire with green stripe looks split a little towards the end. Could it be a bad ground or short in that wire? Would the trailering wiring have anything to do with it? I was going to try to replace the relay if I could find it, what is the part number for it.
View 3 Replies
Drivers side turn signal does not work, and blinks fast when turned on. The brake light on that side and hazards do not work. when I unlock the car with the remote, it lights up fine.
View 5 Replies
I have a 2003 V10 Excursion with an electrical problem. The right turn, right brake and right hazard light do not work but the flasher makes the clicking noise. When the right turn signal is on, the right front turn signal light works but is at double speed. The right rear light does not work. Same when brake and hazard are applied.
I checked the bulb socket with a multi meter and have no current. I also checked my trailer plug and have all functions work. Fuses were checked also for the brake circuit and were all ok.
View 4 Replies
I've got a 2001 f150 supercrew 4x4 with the 4.6. I plugged in trailer lights and now I have no brake, turn signal, or hazard lights. I've checked fuses and none are blown.
View 8 Replies
I have a 2000 Sierra and my driver's side brake light won't work but the light bulb is not bad. The Passenger side light, however works. What should I check on the truck to solve this problem. Would it be between where the bulb snaps in and where the plug for the lights plug into the truck under the bed or should I check something else?
View 5 Replies
1994 Econoline E350. All the other lights work but on the front right the turn signal light flashes but the Hazard lite will not flash. I check for power at the wire at the light and there is none.
View 6 Replies
I just bought an 05 F250 XLT. I noticed tonight that the rear turn signals and brake lights don't work.
The front turn signals work fine, although they flash fast. I know that usually means a light on its way out. neither taillight flashes though, which puzzles me.
My second issue is that, of the 3 brake lights, only the high mounted light illuminates when I hit the brakes.
View 1 Replies
