Ford F-150 - 1997-2003 :: Cranked Fine - No Sign Of Starting
Nov 2, 2014
After the details below, the truck finally started & I let it idle over an hr. Then turned it off for the night. Just to check, immediately tried restarting. Turned over very fast. Started once almost immediately & ran for 1 - 2 sec, then died. After that it turned over fine, but no attempt to fire - just as it's done in the past.
2000 F150, 5.4 L gas. Couple weeks ago it didn't start. Cranked fine - no sign of starting. It did this once a couple mo before that - wife was shopping & didn't start at the store. By time I got there, it had started. Her "solution" was loosened / retightened the gas cap (no, don't know why).
Never found a problem - didn't do it again for months. Then it did. Figured a code scanner would show something relevant to starting problem. It didn't - as far as codes go.
Couple weeks ago, battery was NOT dead by any means, but slightly weak (hadn't driven for couple weeks). I charged the battery (< 1 yr old). Seemed to take charge OK - didn't take long. But, after charging, volts at the battery = 12.8v.
Is it possible that's too low for these trucks & cause starting problem? It turned over quite fast - still no sign of firing. Gas isn't old. New Autolite spark plugs. Clean air filter.
I decided then to use the "jump start" setting on my charger (2 weeks ago) - still didn't fire & made no difference in cranking RPMs. Jacked around that day a couple of hrs. Checked all fuses (inside & under hood).
Bought the scanner - needed one anyway. Actron 9580A. All it shows on codes is a problem ABS wheel sensor (C1230) and a non-MIL code:
P1000: "OBDII Monitor / Drive cycle test not complete."
Suggested fix: "drive vehicle until drive cycle test is complete."
I don't think that's keeping it from starting. No idea about the drive cycle test. The battery hasn't been disconnected OR dead since I replaced it. It's certainly been driven hundreds of miles since new battery. Right after reading the codes today, decided to try starting. Didn't turn over quickly - battery somewhat low after 2 weeks w/o driving.
Surprise - it started - though didn't turn over fast. I let it idle some, then started recording data w/ the scanner. Where a couple weeks ago w/ the engine turning over like mad, it wouldn't start or even fire.
Note: only real difference in today (when finally started) & 2 weeks ago, or the time several months earlier: today is much cooler - in the 60's - vs. 90's the times it didn't start.
So, right back at square one - no signs of what's keeping it from starting. Maybe need some instructions on using more advanced features of the scanner / recording live data (if it starts again).
View 14 Replies
Advertisement
2003 F150 4.2L V-6. Cranked ok but no start, no check engine light. Plenty spark and could hear fuel pump running. Thought it might be out of fuel but gauge showed over 1/4 tank . Added ~2 Gals fuel anyway, started immediately- no check engine light, no codes set. Thought- bad gauge sending unit. Dropped tank and found plenty of fuel and sending unit checks good. New pump on order but what else could cause the problem?
View 7 Replies
1999 F250 SD V10 I recently replaced the in-tank fuel pump and filter. I operated the truck briefly after and everything was normal. I parked it with about 1/4 tank of new fuel and put it on a battery tender. It was parked in a garage on level ground in temperate weather(Southern Calif.). Two months later I tried to start it and it acted like it did when the fuel pump was bad. Cranked fine but no hint of starting. Could it be the fuel lines have become full of air and need purging through Schrader valve ? I haven't begun to troubleshoot but what to check other than pushing the fuel relay reset button.
View 5 Replies
Owning a 2001 F250 Extended cab with a 7.3 I have not had a lot of questions to ask fortunately.
My truck has spent a lot more time sitting than running lately and when I went to start it the other day it cranked fine but would not fire. Quick read on this forum and the first thing I found was how if the fuel solenoid had less than 10.8 volts when cranking it would not start.
I went down and checked the battery voltage and it was at 12.1 volts no load. I put the battery charger on for about 10 hours (time to kill) and when I pulled the charger and cranked it over, started with no problem.
View 3 Replies
I have a 2001 ford F150 with a 5.4 2WD, with a starting problem. Last Friday I went to leave work the truck cranked but did not start, turned the key off and tried again same thing, on the third try it started. Drove it home 30 miles with one stop on the way, restarted just fine. At home in the driveway I restarted it 5 times without a problem so I was thinking it was just a glitch. Did not drive the truck all weekend thinking the problem was fixed.
Monday morning leave for work and everything was fine, went to start the truck in the afternoon and the same problem as listed above (3 or 4 tries and it started). It home again in the driveway restarts every time. I do not have any check engine light on but I thought I would still plug in my code reader NO CODE. Where to start troubling shooting this problem?
View 11 Replies
1997 Ford F-150 4.2L V6... I got into my truck yesterday and went to turn it on. The motor cranked half way then quit. Now everyone time I attempt to turn it on all I hear is a click and nothing else. A friend of mine who is pretty good with cars took a look at it with me. He tested my starter with a volt meter and said everything seems fine. We proceeded and checked all fuses, non of which we found are blown.
We then focused on the starter solenoid. We were able to get the truck running by arcing the 2 lower big terminals. I purchased a new solenoid thinking that was the problem, however replacing it solved nothing. Same problem is still present.
I have now arc the terminals to get the truck started 2-3 times in order to get to a shop. They spent all day looking things over and are pointing the problem to a bad starter relay. (i thought the starter relay was actually the same thing as the starter solenoid) Anyways they told us they have looked over all the diagrams they have access to and cannot locate the location of the starter relay. (maybe becasue its the solenoid?..)
View 14 Replies
My 1992 buick regal 3.8l initially cranked fine but did not start. I went to crank again and starter turned very slowly and finally just clicked got new battery and still same slow finally jumped it and got it to somehow start took it to shop they went to replace starter and told me that a weight had fallen off my flywheel/flexplate and lodged in starter so i agreed to let them replace flywheel starter 2 days later still in shop does this sound reasonable?
View 12 Replies
2000 f150 4x4 5.4 7700 series. Problem I am having is taking off from a stop sign the engine feels like its not getting any fuel especially when out side temp gets above 90 or some higher, truck runs great other then that ,expected fuel mileage is good,no codes at all, doesn't miss or jump..
View 9 Replies
I have a 1995 f-250 7.3 liter diesel engine. Truck starts fine and runs good for a while and then it will stall. I pull over and after a couple of attempts it will start and run fine for a while. I have changed the fuel filter and put fresh fuel in but it still stalls.
View 7 Replies
I just bought a 2002 Jetta 2.0L with automatic trans and about 98000 miles on the odometer.It drove fine on a short test drive. It drove fine on a 45 min drive home after which I parked it for a short while (about an 60-90 mins.) Then I tried to restart it . It cranked fine but would not start. After 3 or 4 attempts I let it rest for a min and then it started. And the CEL came on.
This was a few days ago. Today I finally got a chance to scan it with these results:
VCDS Version: Release 15.7.3 Running on Windows 7 x86
[URL] .....
Address 01: Engine Labels: 06A-906-032-AVH.lbl
Control Module Part Number: 06A 906 032 FR
Component and/or Version: 2.0l R4/2V G 4070
Software Coding: 00003
[Code] ....
I'm new to MK4's and I'm at a bit of a loss as to where to start. It looks to me like there's a problem with both the fuel pump relay and the crank sensor. But what to make of all the short to ground codes. Could they be caused by a bad fuel pump relay?
View 4 Replies
My 2002 F-150 with the 5.4 has an issue with a high rev (1000 RPM for a few seconds) while at a stop sign, along with a clunking/banging sound coming from under the truck. This is when I have the brake mashed all the way, and this all happens at the same time, almost every time I come to a stop at a stop sign or light. I do have an intake manifold leak, which i have recently determined, but I do not know if the high rev at a stop sign has to do with the manifold leak or to do with the transmission sounding thump I hear. Could this be a torque converter not unlocking, and then suddenly unlocking? Because after the thump sound, the RPM's go down to around 650 from 1000 every time.
View 4 Replies
I have a 99 7.3 F250. It dies when I slow down for a turn or for a stop sign. At highway speed, it 'surges' sometimes, and makes he whole truck jump. Also, there is a small leak in the tube connected to the turbo. Has 250k miles ......
View 1 Replies
This 2005 LeSabre with a 3.8 v-6 ran fine but had a marginal battery. Then the key got left on overnight leaving the battery totally dead. After jumping the battery and letting it charge, the engine cranked fine but refused to start. Haven't had a chance to check for fuel or spark. Why would a dead battery trigger this no start condition?
View 2 Replies
So after work tonight I went to start truck it turned over fine but wouldn't start, when it finally did it barely ran and then it was fine, I had it b4 when I start it would turn over for a little bit b4 starting, would that be fuel pump?
View 1 Replies
I recently had a problem with my car stalling when warm and not starting at all until cooler. This was the crank position sensor.
Now the car will not start without starting fluid. When starting fluid is used, the car will start and then run fine. Once you shut it off then try to start it, same thing. The fuel pump turns on when key is in on position. Holding pedal down to try and clear flood does nothing. Car just cranks and cranks but doesn't start until starting fluid is used.
So there is either not quite enough pressure at fuel rail, pump is not getting enough draw from battery, several other things could be suspect. Car is a 2003 Hyundai Accent. Battery tested borderline ok. It does the same thing with donor battery attached. I have a fuel gage but need an adaptor for it that I don't currently have to fit on this fuel rail. Stumped because the car runs beautifully once starting fluid gets it going.
View 19 Replies
We have a 2003 Ford F250 Super Duty, gas engine. This will start fine, then a day later, it won't. Wait 30 minutes, then it starts.
Starter and battery are fine. It acts like it isn't getting fuel. Fuel pump? Filter? What else might cause this?
View 2 Replies
The Engine cranks over fine, but won't start. When it does start everything is okay and it runs good with no codes. I noticed that by taking the key out of the ignition, I was checking under the hood, and put it back in the truck fired right up. Also it has never done this to the second driver who has a different key. The truck runs fine at all speeds and loads, even when hauling twenty bags of wet mulch. It's a 2001, 4.6 L, RWD. Could the PATS Chip be failing?
View 9 Replies
2002 f150 7700 with 5.4 triton and 4r100 tranny started chugging under acceleration and now stalls when put in D, 2 or 1. park and neutral are fine and reverse works perfectly.
Now when I put it in drive it chugs and stalls immediately... 1/10 times it will keep running but chug violently like its running out of gas. will get worse and stall if you press the gas. i can light the tires up for a block in reverse however.
Changed coils 1 2 and 3, IAC, bank 1 knock sensor, camshaft position sensor
View 5 Replies
So my aunt has a 2002 ford f150 king ranch 5.4l and a night ago it started this problem which when you put it in drive which she has to put it in 2nd for it when she pushs on the pedal it will rev up to 2500rpms than jerks and goes and its usely fine till she stops than goes and it does it again...
Than today it wouldn't even go in anything but reverse... So than we herd about the Range Sensor on the side of the transmission and it seems like it was it so I unplug it when it was running and when i push on the pedal and it revs up to 2500rpms it will go forward and have power. So we went to get a new range sensor after like 4 hours trying to get the dam thing off and another 2 to get it back on.. I started it up and only reverse works again... So I unplug the harness to it again and we got the gears but 1st and 2nd will just rev and go.
We at a lost right now i even tighten the shift screws under the dash cause our expedition was loose at one time and the gear shifter was loose like hers. But even tighten the bolts it still don't fix the looseness or even the gears.. Is this a transmission problem? OR even the torq covertor?
View 4 Replies
My girlfriend has a 2003 f150 4.6lt pick up its a great truck most of the time. Problem is when the temp gets in the neg double digits it becomes very hard to start it cranks fine but doesnt want to fire. When it does fire it might stall a few times before it stays running. The last cold snap we had I replaced the battery and in the summer the starter got changed. I have heard that this model of truck are known for hard cold starts. I am just wondering if this is true and any other thing besides block heater. It is strange that my 89 gm pickup will start no matter what temp and I'm having problems with the newer truck.
View 1 Replies
I've got a 2001 4.6 F150, starter spins just fine, but it won't start. Checked all the basics, but it has no spark, and no pulses at the injectors. Is the PCM dead? Wore out the Haynes manual on this one....
View 12 Replies
