97 f150 4.6 4x4, no check engine light, no missing or sputtering, however when I try to get going I can't get passed 2500 rpm and when it finally does its still kind of sluggish and can't pass as easy. Changed fuel filter. It idles fine and when I put it in neutral it will go up to 5000 rpm if I want.
View 6 RepliesAnytime I run the RPM passed 2300-2500 I get this high frequency squeal. I don't seam to lose any performance, but very annoying. Is this the turbo having troubles. It's directly related to the RPM'S. Other that that, the truck runs great....
View 14 RepliesI have a 97 f150 with 4.2 4x4 auto. I have a bad miss under acceleration. if i ease on the gas no problems. stomp it and it chugs and pops back thru airbox til it gets to 2500 rpm then clears up. If I shift it manually and keep rpms up its fine till it gets below 2500. I have replaced spark plugs, plug wires, fuel filter, upper and lower intake gaskets, cleaned injectors, new air filter and cleaned o2 and mas sensors. Had vacuum system checked and was told all good.
View 12 RepliesThe problem started with a slight hesitation around 2500 under hard acceleration. Then it became more pronounced from 2 to 3.5k. The CEL would blink when it happened for more than a few seconds. Eventually the CEL stayed on. Now the car idles roughly with a periodic thump feeling, and any time a load is put on the engine, it feels very rough. I don't have VAG-COM, so I don't have any codes.
View 3 RepliesWhen I drove the car on Monday a hesitation/jerking randomly came out of no where during mild acceleration at around 2500 RPM. The next day it was doing the same thing, but one of the times it made the check engine light flash a couple times then go off. On Wednesday I put fuel injector cleaner and a new tank of gas in it to see if that worked at all, but it didn't. The problem was still occurring then the engine light came on and stayed on. So I went to see what the problem was on VCDS and here are the errors that came up. Also I should mention that on Tuesday my battery died and I had to get a jump from someone, this didn't affect the problems, but I think it has something to do with the voltage errors.
A Summary of the errors is lots of things about "low voltage b+" and "engine misfires".
01-Engine -- Status: Malfunction 0010
03-ABS Brakes -- Status: OK 0000
04-Steering Angle -- Status: OK 0000
08-Auto HVAC -- Status: OK 0000
09-Cent. Elect. -- Status: Malfunction 0010
[Code] ....
2001 F150 V8 4.6 Liter... I've been experiencing hesitation when first pressing the gas, stall at idle, RPM fluctuating between 1000 and 500 at idle and loss of acceleration. Had the truck read at autopart store and received a P0402 error and misfire is cylinder 8.
At this point, I've changed the the plug, COP, EGR valve, EGR Valve Solenoid and DPFE sensor and still have the exact same symptoms. I've also changed the plug for cylinders 5,6 & 7 as well. The check engine light is on, went off briefly after changing DPFE sensor, but back within a day.
Given the fact the error code is P0402 and some of the threads I've read, I thought the issue was centered around the EGR system, but I've replaced many of the components.
So today my 97 f150, 2wd 5.4L automatic has started giving me some troubles. The truck has 291k miles on it, i bought it with 260k miles on it. About a week ago the truck overheated due to a busted radiator side tank, it was promptly replaced the next day and i have had no problems with it since, till today. Sometimes when you start it it will stumble alive like its out of gas, give it a sec and it settles down. When you get going, its a little down on power, i know it has 291k miles on it but it pulled hard. Its OK till you get to about 35-40, when it just stops accelerating. I had my foot to the floor and it barely went above 40, if you ease into it slowly it will slowly accelerate till about 45, drop down to 40 and then go like normal.
When i changed the radiator i lost about a cup maybe a cup and a half of transmission fluid, i have gotten time to replace it but i didn't think that small amount of fluid would dramatically change performance, the fluid also looked almost new. The only other things i have done to the truck is some brake work and replace the alternator. I have no knowledge of what the previous over did or did not do. It is not throwing any code, and the OD light/button is broken, i think on newer rangers the OD light would would brink indicating transmissions problems, not sure if its the same on these trucks.
2003 F150 5.4 72852 miles
I have a Rough Idle & sometimes a hesitation or stumble on acceleration. I cleaned the MAF & IAC motor & Air & Fuel Filters are new. I got a 20890 scanner & ran test 6 53 as suggested in many posts by BlueGrass. Here are My results & what They Convert to.
1 00F5 .3675
2 0051 .1215
3 0000
4 0000
5 00A3 .2445
6 0000
7 0000
8 0000
I'm guessing the cop's are ok & probably need plugs? I was hoping to just swap a coil. Too cold to do plugs & truck won't fit in my garage.
I bought a 99 f150 lariat 4x4 with the 5.4 from a guy who said that it needed an oil pump. He said it lost pressure coming into work, he turned it off and coasted in. I towed it home and replaced the battery and bought a new oil pressure sending unit just to be sure it wasn't that.
Those things are so hard to get to. Finally I got an oxygen sensor tool on it and it was only hand tight. Rather than take it off I just tightened it up and started the truck. The dash guage read normal but the truck was idling so badly. Steady at about 1000 rpm and tooth rattling. 1500 with the foot on the pedal it evens out but still rough. Not sure if this was a good idea but I took it around the block. No power under 2500 rpm. Barely moving even. Just felt like there was no throttle response at all and again very rough.
Got it home and parked it. Now I'm wondering what to do to fix the Idle and power problem. Where to start would be great. And input on the oil pressure sending unit too. I suppose I'll have to get under there and replace it at some point anyways.
I have an 03 Camry LE with 80,000 miles I do all the maintenance myself it has had the alternator replaced once at around 40,000 miles. The problem that just started is a whistling sound that ONLY is audible after 2500 rpm at acceleration. When the car is in park no matter how much I revive the engine I can not get it to make the whistle sound it ONLY can be heard at acceleration after 2500 rpms.
Also once I cease to accelerate it goes away while I'm driving there is NO Whistling. I've read that it could be the alternator so I had it checked twice on the car and it checked out good it passed all tests. I've removed the belt and spun the pulley to listen for bad bearing but to me sounded fine. I've removed the throttle body boot and checked for cracks an found nothing also cleaned throttle body (not that it needed it) while I had it off.
Also checked air box and nothing. The only thing I've done recently was take out cabin air filter to clean and replaced it but there was no problem with that. What's puzzling is that it ONLY occurs at acceleration after 2500 rpms then stops after acceleration.
-My pickup was parked and hit in the rear axle in January. I had to have the whole axle replaced as well as the leaf spring to frame mounts.
-I finally received the pickup back and now when the trans is in Drive it will not up-shift until the rpms reach 2500 and it is a hard shift.
-Also the speedo does not work now.
-Check engine light also came on with code P0500- vehicle speed sensor.
-I replaced the VSS at the transfercase and the ABS sensor in the rear differential with no change.
So my 98 f150 xlt 4.6 is having a issue where the truck is jumping from 1500 rpm to about 2500 - 2600 rpm. You know sitting there trying to get up to speed. then all the sudden i look down and its at 1500 rpm. but still not really going anywhere. So i give it a little more throttle or gas and it jumps from 1500 to about 2500. Its been like this for a month but i thought it was crap fuel. What is the cause or maybe a solution?
View 4 RepliesMy F150 with 175,000 miles on gave me a the ol' P0305 code indicating misfiring in cylinder #5. I changed the plugs and wires using Motorcraft wires and Motorcraft AGS34FM plugs.
Now the truck idles fine, does not give a OBD code but runs rough at 2,000-2,500 rpm. Tried it out on the highway and it started "bucking" a bit. Not sure what to try next.
Automatic with about 75k mils.
Car hesitates when pressing on the gas. I have to reach high speeds at a slow rate. If I want to push the car a bit, it will hesitate a lot around 2-2500 rpm.
Changed coil packs with new plugs. Dealer changed pcv valve changed by dealer, recall.
Car is stage 2 apr, full apr tbe, neuspeed intake, forge DV.
Could it be the MAF sensor, the DV, or cam follower failure?
Let me add, car is having horrible gas mileage.
2003 Ford F150 XLT - Truck hesitates (or bucks) as the throttle is pressed. Not from a stop though. It starts / runs fine, but no matter how how fast, what gear, hot or cold, it feels like the fuel cuts out for 1/2 second. Also it is not a specific point in the throttle motion. It does it when it is halfway, 3/4 or fully depressed, but is not consistent. It does happen more frequently now than two weeks ago. I am not getting a check engine light.
4.6L V8, 5 Speed Manual 4x4, 74000 mi
I have a 2001 f150 5.4 with 200,900 miles. Just bought the truck about six months ago off my dad when he got a new one. I am now experiencing what seems to be a slight misfire. With the hood up pulling the throttle around 2200 rpm starts making a loud knock. Above that rpm nothing and below that nothing. Standing by the tailpipe it sounds like a small backfire. It Idles really rough and when you get that sound out of the tailpipe it jumps like its hiccuping. And tailpipe is vibrating quite a bit.
Things I have done in the past month include replacing the pcv valve, changing spark plugs, cleaning throttle body, cleaning MAF, took down exhaust to check cats because i was experiencing a power loss and bogging. When the exhaust was off i punched the two rear cats. I ran a bottle of iso heat in the gas. Everything seems to have supported the power problem but now less than a week later i am starting to experience the knock and backfire type sounds.
Recently purchased a 2000 ford f150 4.2l. started hesitating when i would try to accelerated stressed or when a.c on. if i drive it like a grandpa wont do it. filled up the gas tank and it completely went away. the second it went down to the 3/4 line, started hesitating again. mind you when it was full even with the a.c on and going 80mph on expressway it would not hesitate.
View 2 RepliesI have a 1998 f150 w/ the 4.6L V8
For months I have had a hesitation in this truck when i go to accelerate, and at times you can even feel a little buck with the cruise set at 70MPH. It has gotten worse and worse. When i start pulling a trailer good luck, it will do it but its terrible, hesitations and misfiring,
There is always a misfire/hesitation. Will Idle nice After its warmed up. Sat for 2 weeks fired it up and it had a HORRIBLE idle for at least 1-2 min. This is new now it wont idle when cold. Now I had one code Cylinder 4 misfire, cleared the code never came back 2-3k miles later still not back on -
replaced coil packs
New plugs
New wires
Fuel pressure test good
Checked the Heater hose - not leaking and nothing in the hole.
Just bought a 1998 5.4l F-150 Lariat. 136,000 miles.
Question about the overdrive button on trans handle. When I push the button, I don't see any light turn on (or off) and I don't feel any change in the gear ratio or increase/decrease in rpm's. I assume since the button in there marked "overdrive" that the vehicle in fact was equipped with it. Could it be a bad button, fuse, or ?
Also, it just started the shudder/hesitation at certain speeds that I see a lot on these threads. Seems like that is a coil issue as the description in many threads is exactly what I am experiencing to incl the rotten egg/fuel odor. However, it started the same day (not same time, later same day) I decided to push the overdrive button while checking out all the things on the truck.
My 2003 Elantra has multi spark (quad) electrodes? I have a hesitation on acceleration problem. Also feel resistance when pressing the gas pedal. I am going to change the plugs and wires. Just wondering if the type of plugs may contribute to the problem.
View 9 RepliesI have a 2003 screw 4x2 with the 4.6, 148,000 miles, and I'm not sure what kind of transmission. Recently when the truck would shift into second it would hesitate and I would feel a slight grind, but it only did it when it would shift at 2000 rpm, if it shifted at 2500 rpm it would shift fine. I checked the fluid level, it was full, it smelled okay, looked *fine.
After pulling a boat (19 foot bass boat...nothing too heavy) it started to shake violently when I'd take off from a red light. So I dropped the pan and changed the filter, The fluid was dark red and smelled a little burnt. I put 4qts of fluid in it along with some Lucas transmission fix. The shake during take off is gone, and the grinding while shifting into second got a lot better but didn't go away completely.
However, now the grinding into second has has gotten worse again, and if I make a right turn from a red light it grinds and feels like its slipping until it shifts. I am not sure why making a right turn would affect it but its definitely worse when i turn right, left turns are fine. I'm guessing my transmission is going out and I just need to get it rebuilt...