Ford F-150 - 1997-2003 :: A/C Works For 12 - 15 Miles Then Shuts Off?
Sep 7, 2012
2003 F 150. 5.4 motor. 4x4. 270,000 miles. Climate control.
The A/C is ice cold.. For the first 12-15 miles, and then it shuts off and is warm.
I had it recharged at the shop just to be sure. When it works, it blows out the vent at approx. 42 degrees.. nice and cold.
This problem happens every time. Turning the climate control off and then back on doesn't work.
Shutting the truck off and then back on doesn't work. Wait a while.. Not quite sure how long, but the next time I drive it, it will work again. For about 12-15 miles and then blows warm again.
A bit of funky , moist smell to it when it blows warm.. Typical A/C smell I think.. The box could prob use a cleaning.
View 8 Replies
Advertisement
The AC works, but just not well enough on a really hot day. On a day in the 90s I have to put it on Max AC and even then it does not cool down for a while and the air out of the vents is not ice cold.
So, it works, but I cannot tell if there is something wrong or not. I recently put in a can of AC Pro and it did not change anything.
View 6 Replies
My digital odometer is funky! Sometimes time it works sometimes it doesn't. Sometimes it works on start up than after a lil while it fades out.
View 7 Replies
I was driving my f150 with the AC on, it has a 4 position fan switch. Lo, 1 , 2, and Hi. The fan only works on Hi. I don't think its a fuse, so what are the possibilities ?
View 3 Replies
So my a/c works some times. I'll get in it in the morning, turn the a/c on. It works great, ice cold blowing hard. Then I'll turn the fan down from high and in a minute or so the cold air stops and it blows warm. Then for the rest of the day it wont blow cold air(i get in and out of my truck a dozen or so times through out the day turning the truck off each time). my dad has a freon pressure gauge. We checked it and it had good pressure. the blue gauge was at 50 and the red was a hundred and some i forget, but dad said "that's where it should be" so i guess that's not the problem. I am wondering if there is switch bad or a sensor. Its an '02 fx4 f150 4x4 140,000
View 1 Replies
Having problems with the truck - either a no crank situation and now a complete shut down while driving at any speed.
Dash is blank with no power when truck shuts down, here is the hitch with the no crank, I pulled and replaced the PCM module and the truck fired up without hesitation. I had to do this a few times over the course of today to get home. I can live with having to do that for a while but it is unnerving to have the truck shut down with 0 notice.
Throttle body was just cleaned, and all starter/battery connections cleaned and protected. Brand new PCM relay. What does this relay have to do with reset, for clean start up after removing it and then just putting it back in it's place? Would there be any solutions for the dies completely while driving, or fails to crank?
View 7 Replies
My dads f150 shuts off intermittently while driving it. He has to pull over and wait about 5 minutes until it restarts again. We have tried replacing the fuel filter, still shuts off! Some one pointed out the coil!? I am thinking that it might be the switch. It might be bad, shorting out and shutting down the truck?
View 6 Replies
Got an 01 f150 excab with the 5.4 as of lately sometimes when i turn the 1-4 blower control know it wont do anything on heat or ac than other times it will work like it supposes to?
View 2 Replies
98 f150 4.2l imrc quits working after 30 secs or so. Valves are good,linkage is good, vacuum lines good, electric vacuum switch/valve on r/h side of intake good, power to that switch/valve is there, loosing ground from computer??? What tells the computer to operate these valves?
View 9 Replies
I got a 2000 F250 XLT that the AC fan only works on high. Same thing in heat mode. Is there a relay for the other speeds that I need to check out?
View 2 Replies
2002 f150 7700 with 5.4 triton and 4r100 tranny started chugging under acceleration and now stalls when put in D, 2 or 1. park and neutral are fine and reverse works perfectly.
Now when I put it in drive it chugs and stalls immediately... 1/10 times it will keep running but chug violently like its running out of gas. will get worse and stall if you press the gas. i can light the tires up for a block in reverse however.
Changed coils 1 2 and 3, IAC, bank 1 knock sensor, camshaft position sensor
View 5 Replies
My 2001 f150 super crew, the heat only works on speeds 1-3. All 4 speeds blow air fine, I'm talking about the temperature. not the blower. Could it be the heat resistor?
View 4 Replies
I bought a 99 f350, that already had HID's in it, i found out i was running the wrong batters (weren't 800 cold crank) I just had to replace the alternator. Ever since the new alternator when i turn on my headlights my truck shuts off. IT fried my IDM and i just put a new IDM and 2 new batteries in it today. Thinking i had fixed the problem i drove around no issues, finally i was leaving someones house and turned on my lights, and truck shuts off!!! It restarts but now im trowing a code!!!! im guessing the HIDs are wired wrong and that's why its shutting down the truck but OEM IDM from ford is 1300$!!!!! brand new one installed today,
View 5 Replies
I have a 2001 ford f150 lariat 5.4 L Trition it shuts off while driving the steering wheel locks up when the truck shuts off I tried everything and it doesn't seem to help the problem. I changed the Iacv idle air control valve,I had a bad o2 sensor changed that, changed the crank sensor, cleaned the throttle body and changed the Tps sensor, got a new battery, changed the vacuum lines.i really don't know what else to do this truck is becoming a nightmare and is dangerous to drive I never know when it's going to shut off and when it does shut off sometimes it starts right up and other times it doesn't.
View 2 Replies
PCV hose/grommet was rotted out with 1 inch hole but supposedly he spent a long time tracking down the problem. It was located way in the back middle (like underneath the wiper blades area).
2002 F150 XLT Crew Cab 4.6L 4x4 170K
What known issues would do this but not turn engine light on? Motor sounds excellent and runs excellent. Previously it was missing and engine code come up as random misfire, misfire cylinder #2 and #4. I replaced the coil packs on 2 and 4 and erased the code and there was a 1000% difference. Ran excellent (still does).
However, a week later I noticed a subtle shake in the motor, and at idle it would stay at 1...maybe slowly chirp just above 1, and then sputter a little down to 1/2 rpm. It will do this and stay running, but sometimes it will cut off.
What are the possible things that you think it could be considering no check engine codes? (Bad motor?)
View 4 Replies
my turn signals only work with the steering wheel tilted all the way up. It works for me, but my wife drives the truck mostly because we live a mile from her work. The dealer said it was a "peanut connector." And can someone walk me through the steps to fixing it?
View 8 Replies
Tranny just started slipping a couple of weeks ago, only occasionally. Seems to be between 2nd and 3rd. any chance a fluid change will work? I don't have have the money right now for a new or rebuilt and I am far from mechanically inclined to do the work myself. 2000 F150 62K org Miles....
View 1 Replies
I am having a huge issue with my 1999 ford f-250 super duty 7.3 diesel. I am goin thru 1-2 gallons of oil every 150-200 miles I drive. I can can smell oil thru the exhaust when its running. There is a layer of oil "residue" on the engine. A buddy of mine suggested that I might have a broken O-ring on a fuel injector.....is there ANY way of testing that before tearing everything apart to get to the valve covers??
There is NO oil on the ground when left parked for a few days. I can NOT see any significant area in the engine compartment where it is leaking....
View 4 Replies
I recently removed my timing cover due to a coolant leak and found the cover was cracked. I had it welded and reinstalled but i did not remove the crank sensor from the cover while it was being welded. Now the engine starts but shuts right back down. Do the welding may have damaged the sensor and giving me this condition? 1997 4.2 ....
View 1 Replies
I have a 1997 F150 4 x 4 with the 5.4 overdrive transmission. When I accelerate from a stop I can feel the slip of the transmission until I reach exactly 35 miles an hour. Above 35 seems to be normal and have plenty of torque.
The funny thing about this is I have had a 2001 Windstar same 35 miles an hour. I have also owned a 1997 Ford Explorer with this exact same issue. Three different motor and trans combination that will not lock up until you reach 35 miles an hour.
The truck has 213,000 I have replaced all coils fuel filters catalytic converter and torque converter. Have exterior tranny cooler. engine runs good and strong. And no code I have a reader.
View 6 Replies
I have a 2001 f150 7700 edition. The truck has 118,000 miles and i've owned it for the past three years, the trucks great and really reliable. I drive the truck every day 50 miles to my college and about two weeks ago my truck started shaking . I had just got off the highway and made it to a stop sign. I then took off and when I hit about 30 miles an hour the truck started shaking but when I hit 40 it stopped.
I said whatever and ignored it. now it does it pretty much anytime I go past 30 miles in hour. My tranny shifts good. I checked the fluid and it was normal. smelt it and it didn't smell burnt or anything still pretty red. Some days its worse then others. Also, no engine lights, tranny lights, no obvious lose parts, tires are good. It only shakes when I give it gas. I let off the gas at 80mph and it doesn't shake at all. Which is why I'm confused.
View 3 Replies
