Ford F-150 - 1997-2003 :: 4X4 Doesn't Stay Locked In
Oct 29, 2014
So, I know this question has been asked probably a million times. But I can't seem to find the exact information I need. I have a 2003 fx4 f-150 and just like everyone else. My 4x4 doesn't work. But, the deal with mine is that sometimes it works, sometimes it doesn't. It's a toss up. When it does go in however, it doesn't stay locked in. Sometimes it stays in for 10 seconds, sometimes 30 minutes. When the switch is turned to 4hi or 4low it doesn't always engage, only sometimes. Light on dash comes on every single time I matter what. Solenoids click as they should. Also, the a/c and heater was stuck in the vent only, recently went to defrost only.
View 5 Replies
Advertisement
I bought a '98 F150. 4.2 powered, 2WD, automatic. About 140k on it. The truck runs well and is in remarkable shape other than a few dings.
The fuel filler does have the "collar" with the little flapper door on it. So the gas cap doesn't latch and fuel nozzles won't stay put. How would this be repaired?
View 2 Replies
Just got done with a ball joint replacement on my 2003 F550, everything went together great, just as it should. Until I got to the drivers side hub lock.
I have Mile Marker 449s/s manual hubs. Turn from free to lock and theres this loud clicking sound about halfway to LOCK (passenger side doesn't do this). Hub will stay locked for about 2 rotations, then it unlocks and makes a clicking sound. You cannot turn the hub back to FREE, it gets halfway and stops. I tried forcing it and broke the spring fingers inside. Have a new set on order.
Is this a locking hub issue or an assembly error? I was going to take these steps.
- Take passenger side hub lock off and see if it operates normally or same on drivers side.
- If same, remove axle and re-seat/re-assemble everything again
Anything to specifically check? All the parts went back in, washers were in correct order, outer snap ring is in groove.
View 11 Replies
My son locked my keys in the cab of the truck. To complicate things, I have the Ford upgraded alarm which disables the keypad. And the real kick in the $^%, is that I only have 1 set of keys. I'm definitely going to have a couple of more sets of keys made when I get inside, how to get inside the cab. I live way out in the boonies and really would like to avoid calling a locksmith.
View 14 Replies
I know it will wear out the tires but will it hurt the front end? Also the drive shafts to the front end is not turning.
View 1 Replies
My aunt has a 1998 F150 with the 4.6 V8. with only 40,000 miles.
Two years ago when she tried to leave work the truck would not start, it would crank over, but it would not start. She had the truck towed home and we figured out it was her fuel pump went bad. She did not have the money at the time to fix it, so she let it set and drover her nissan around.
I know after sitting for a few years the piston rings will stake (rust) to the cylinder walls. Usually take the plugs out, and pour in some oil, PB blaster,etc....and let it sit for a day or so, then turn the motor by hand to free it up.
Well She decided to get it fixed finally, and had it towed to the local ford dealer after sitting in her driveway for two years. Ford calls her later in the day and tells her the battery is dead and wont hold a charge, and the engine is siezed/locked up. They tell her it needs a brand new engine and could cost $5000. + after all is said and done.
She calls me asking what she should do. I told her BS! it only has 40,000 miles, and it does not need a new engine. It just needs to be broke free from sitting. I told her to have it towed to my house and I will fix it.
So today she had the tow truck bring it out to me. Tow truck driver tells me that ford said it has a bad fuel pump ( we knew) and that the motor has a spun main bearing in the motor..and asks me if I was going to rebuild the engine.
I tell him the story on the truck and he shook his head..and said yea..Ford is Full of it! I call my aunt and tell her what the tow truck driver told me, so she calls Ford..and asks what they did to the truck? Ford said, the truck has a dead battery, bad fuel pump and a spun bearing. She asked them how do they know it was a bearing?
Ford said they got the truck to run but the engine made a horrible noise like a bad /spun bearing inside.
I asked her, how did they get the truck to run with no gas/no fuel pressure if the fuel pump is out? The only way they could is with spraying Starting fluid ( ETHER) into the motor and fuel injection motors HATE that..they will run like total crap...
Bang, etc. because none of the sensors are working correctly..and makes the computer go OH CRAP. It's the end of the world!
If they (ford service) broke the motor free..I wonder how bad they did it. Did they FORCE it and break something internal ( bent a rod, wrist pin..)? I can't prove it, if they did.
So the truck is at my house and I am going to check it out. I am still going to pull the plugs and put oil inside, turn the motor by hand to make sure it is not locked up or messed up internally from them "working" on it.
I have never heard of a bearing going bad by just sitting. I have never worked on a 4.6 mod motor..and I know nothing about how good or bad they are... but I am soon to find out!
View 14 Replies
I'm having a problem with my passenger door always staying locked. Even when I press the unlock button it won't unlock, but it will unlock if i use the key and keep it turned but if i turn the key back after I unlock it it locks automatically. The other way I can open the door is from the inside door handle only. How can I fix this so people can enter in the passenger side normally???
View 4 Replies
97 F150 4x4 5.4L ... Just put this truck back on the road after being parked since 2008. While driving at 45 mph, transfer case engaged and is locked in 4wd lo. I did notice a pop about a minute after I started the truck. Drove approx. 5 miles. Transfer case engaged and chirped the back tires, slowed speed to about 5mph. Having it towed home. I'm thinking shift motor???
View 14 Replies
I have a 97 f150 5.4 4x4 a/c compressor and clutch. It won't let my motor turn over because the ac compressor is locked up bc the bearings are shot is there any way to by fix this until i get a new compressor and clutch....
View 6 Replies
I have a 02' f150 v6 67,000 miles. When I come to a stop, the trans shudders abit like the converter is still locked up. It then goes to stall in a few seconds. this does not happen all the time, fluid is clean. I understand there is a simple fix for this, or is this normal?
View 1 Replies
ran fine the day before, fuelled up that night, next morning it did this. cleaned the IAC, tried a different TPS, cleaned mass air flow sensor. check vacuum lines. put couple bottles of gas line anti freeze in.
[URL]
View 9 Replies
I have a 03 4x4 5.4lt supcab with 154k miles. I replaced the shift motor about 40,000 ago but it has always been tempormental like I had to engage it in 4lo in N and then shift to 4hi to keep it in 4hi. Now fast forward to today. Went to shift to 4lo in N and it didn't shift. I only heard the relays click once and then it wouldn't shift into any gear even though the indicator was on PRND123. Didn't matter.
Also, Park didn't engage and the speedometer acted like it was engaged in RN and D. No movement what so ever. I think it might be the shift motor that shifted part way and is stuck in between gears. Is this possible? I drove fine to the dirt road and I haven't had problems other then the shift motor being touchy. I don't want to pay for a new tranny if it might be the shift motor.
View 5 Replies
Going down a steep loose gravel drive way, going maybe 5 miles per hour. About 50 feet before the stop sign we lightly applied the brakes and the front right wheel completely locked up. If we didn't turn into the grass we would of stopped in the middle of the busy street. We picked up speed when we applied the brakes, like we were on ice. When I got out, I could see the one long brake mark in the driveway. This happened on a paved road about 6 months ago, it had some loose gravel at the stop sign. I couldn't tell which wheel locked up at the time. This happened on snow in December to, twice. Since the ABS light never came on. Brake pads and rotors needed replacing about 9 months ago. Tires have been rotated, no change. Not sure what it could be. I disconnected the Abs fuse for now.
View 5 Replies
91 F-150 4x4 with AOD. OD,D,1st gear. The truck will idle fine, but when I put it into gear it seems like it is locked in in either drive or reverse. Its hard to stop at lights or stop signs and boggs the engine down and has no low end power. When in neutral it is fine. I have replaced the torque converter with a new one, no change. I replaced the valve body with a constant pressure body as well and still no change. Is there anything else that could keep the thing locked up? The smaller inside overdrive shaft looked good and slid in and out easily. Is there any kind of solenoid in the AOD that would cause this or if vacuum has any role in this problem...
View 1 Replies
Got a buddy with a 98 white f150 with the 5.4 motor. It will start up and idle fine but if you try to drive it it has no power what so ever. What it could be?
View 2 Replies
I have a 2000 Regular Cab Work Truck with non power split bench seat. The passenger side back will not hook in the up position.
Before diving into it. Is the mechanism broken or is it something I can fix if I tear it apart? There is nothing stuck under or behind that I can tell.
View 4 Replies
Have a 2001 F-150 with 4.6L. when i turn the key and pull it out the accessories stay on. What could be wrong and what can i do to fix so I don't have to keep disconnecting the battery?
View 9 Replies
Just recently now the dash warning lights stay on or come back on shortly there after when the key is removed. I replaced the ignition switch. I can even leave the wiring to it disconnected with the same result. When the positive battery cable is removed and reconnected I can hear relay or relays clicking.
I pulled all one at a time next to the master cylinder in the two boxes. same result. I pulled all relays in the fuse box in the cab one at a time. no change.
Maybe related about a month ago the hvac fan stayed on. we had to turn that to the off position to remedy that. than it "fixed" itself. Starting points to check on this 4.6 with 361k on the clock 99% original....
View 14 Replies
Yesterday I changed two burned out light-bulbs in the a/c control panel. When I tested them after dark they worked as designed. An hour or so later my brother-in-law called me to tell me my interior lights were on. When I walked out to check the lights were off. This morning my wife drove the truck to the store and called me to tell me the interior lights were staying on. Didn't have this problem before replacing those burned out bulbs.
View 2 Replies
I am having a major issue with my truck. I replaced all of my brakes about 8 months ago. Replaced everything. Rotors, calipers, pads etc. About 3 weeks ago I pushed on the brakes and they locked up and I heard a loud pop and then grinding. I pulled my wheel and my brake on the right rear had broke the 2 mounting bolts and fell off. So I put the brake back on thinking I hadn't tightened the bolts.
Drove about 7 miles and around the 10th time I stepped on my brakes it did the same thing. So I replaced the brakes again. Calipers caliper mount and pads. I have been driving it 2 weeks and all of a sudden same thing happened. I push on the brakes the right rear locked up and snapped the bolts again. So now I replaced everything rotor calipers etc. Greased everything up and no problems for a day. Do I need to replace the brake mount and where do I get that?
View 1 Replies
I have an F 150 2002 Trition V-8. I always thought I knew how to read an instrument panel on a vehicle but after being put down by my Ford, I have to rethink this knowledge.
I have noticed over the past 4 years that my volt meter guage on the instrument panel always stayed in the same place whether the motor was running or just the key in the on position. I noticed that a little battery icon kept coming on and going out yesterday. I read the owner's manual and it said something like this indicates your battery is not taking a charge correctly. Well why has the guage not told me anything. Well the alternator has quit but yet and still the guage is still showing me all is well.
I ask a Ford dealer service dept. about this and they do not have a clue. All they tell me is people do not pay attention to the guage but when the light comes on they need. They also said the gauge would work when everything shuts down, but man! I don't need it to work then. I know it's broken when that happens. It quits running.
What is the purpose of the gauge sitting there all shiny and pretty if it is not going to say anything other than "HEY MAN! I am just here looking pretty and taking up space".
I have looked at other trucks and they do the same thing. Nothing .. What is going on with this gauge which undoubtedly does nothing?
View 10 Replies
