I busted the cable end by not removing it properly. My question is what is the proper method of remove the cable from the throttle body? Are the cable ends replaceable? If so who has them as a google search didn't find any? I've tried to find written information but haven't any luck. bl2009
View 1 RepliesSo, instead of pushing the throttle cable back and then off, I tried to pop it off and broke the little tab. I've been trying to look for a replacement, but all I'm coming up with is an entire throttle body. Not too bad, but would still like to fix it for much cheaper. It's a 2002 F150 with a 5.4L.
View 2 RepliesRead about and want to clean my throttle body. Why have to remove it from the truck ? 2009 f-250 5.4 .....
View 5 RepliesI need to clean my throttle body on my '97 F-150 and it has a label saying not to clean directly. Is it still safe to use TB cleaner and to go ahead and clean it? It needs done but how would I go about it.
View 6 RepliesThe Throttle Body on my 2001, 4.6 L is making a strange whirring noise, when you puy your hand on the intake pipe, you can feel a slight vibration. The Truck idles and runs okay, with no codes. Giving it a little gas and the noise goes away. The last thing I did was clean the IAC with Gum Out Carb cleaner, the second or third time I've done this over many years, with no problems. I'm a little perplexed at the cause.
View 6 RepliesI'm usually over in the EX forum but today was working on my brothers 1998 F150 - V8 4.6L. Had the EGR code P0401 and due to FTE I found the problem took the throttle body off and found it was definitely plugged. One of the bolts was really loose and came off way to easily. Didn't realize until cleaning why... Now I drilled 8 studs out of my aluminum EX heads but this one has me pondering how I'm going to clamp this thing down and center a bit..
1st pic - ports WOW - guessing this was the problem ...
2nd pic - bigger issue ...
3rd pic - the ports cleaned up ...
I have a throttle body noise that sounds like a warble,It is sporadic and I think it should not be their. But I have heard some other f-150s make the same noise. Is it normal or is something not right.
View 3 RepliesI accidentally broke the control lever where the cruize control attaches. I've looked all over but I can't find the lever. Where I could buy just the lever? New throttle body is more than I want to spend.
View 1 RepliesHigh mileage 1999 4.6 4wd 5 spd: Needed to replace the rear ABS sensor and decided to clean the throttle body too while the battery was unplugged. Cleaned it around the butterfly and not much else. Truck idled at 750 BEFORE cleaning the TB. Now it fluctuates between 820 and 950 rpms. Also tends to stay at a higher rpm after pushing in the clutch and taking it out of gear.
Did a thorough check for vacuum leaks, nothing. After research, I cleaned the IAC and re installed (battery was disconnected then too). No improvement. Unplugged the IAC while running- ZERO change in idle. Installed new IAC, no change whatsoever. Unplugged NEW IAC, no change whatsoever. Is there an issue with the PCM needing time to fully re learn? Am I missing something.
Obviously its not a good thing, but this seems a little severe for a truck that hasnt had any issues prior. The truck is a 1998 F150 4.6 and was running just fine until POP!! A puff of grey smoke coming from the throttle body and followed by (obviously) a rough idle. So basically, I know that any metal fragments were directly sucked into the intake and based on the size of the chipped area (roughly 1.5cm). I am wondering what type of internal damage this would (or already has) caused.
View 3 RepliesI have 2011 f150 5.0 with 38,000 miles and the throttle body seized up tight.
View 10 RepliesMy 1997 ford explorer has this problem that when you start the engine it runs fine then it's makes a choking sound in the throttle body area I have a video of it on YouTube here's the link :
1997 Ford Explorer Engine Trouble !!! - YouTube....
And the truck doesn't give any ob11 codes.....
I bought a 2009 f150 5.4 with 150000 miles on it. I have a slight hesitation from idle so I want to clean the throttle body. I found several for the older f150"s with the horizontal throttle body but this 2009 has a vertical mounted one. I change the air filter and cleaned the MAF but didn't change anything. My wife's ford 500 had this problem and cleaning the throttle body completely cured it.
View 3 RepliesMy 97 Suburban died and will not start. Things I have done:
1 Changed fuel filter
2 Changed fuel pump twice
3 Checked fuel pressure 60psi
4 Changed plugs and wires
5 Changed rotor and cap
6 jumped switch to make sure pump runs
The Suburban will start only if I pour gas in the throttle body and will idle as long as I continue to pour gas in but will die when I quit.
Having problems with a ECM and throttle body for 2010 Corolla S? My corolla will idle rough and the throttle body will shut the car down to where it is inoperable. It throws codes and shuts the VVT down. The car currently has 56k miles on it and has been to Toyota 3 times in 3 months.
The first time they say they replaced the ECM, I really don't think so. 24 hours after we picked the car up it shut down again. The second time we brought it back in they said the brake light bulb caused the throttle body to shut down.
It had to go back again this week after it shut down again in traffic when it was idling. Toyota said the throttle body had to re-learn the idle again from when the ECM was supposedly replaced.
I have a 2009 Camry which has the well known very bad vibration at idle when in drive at a light. My Ultragauge shows the RPM are very low when it vibrates. Sometimes it drops to around 425-450 rpm when at a stop light in drive (automatic car). Then it sometimes moves up to around 625-675 rpm and that is when the vibration completely disappears and it is nice and smooth. This issue is intermittent but happens everyday.
Most people think it is due to a bad engine mount and spend money doing that and get no results.
I have done a lot of research and feel it is due to a dirty throttle body and IAC valve and want to test my theory. I will post results once I do the job. What is the easiest and most thorough way to clean both?
97 Sierra K1500, 5.7 liter. High pitched whistling sound underhood in the vicinity of the throttle body. Starts after truck warms up and quiets down when accelerating. I've wiggled hoses, disconnected what I could without stalling engine, checked air lines into throttle body, checked air filter, etc. Sound does not change when I apply brakes so I don't think it's related to master cylinder. The only time it changes is when I accelerate, then only gets quiet until I come back to steady speed.
Truck has 85,000, runs great. No codes.
So i recently bought a used 2003 camry le 4cyl with 72k miles on it. So it's still in good condition. Previously I had a 92 camry 4cyl which is run with throttle cable. The new generation camry's now are drive by wire or driven electronically. So I decided to check out the whole car and looked into the throttle body, the out side of the butterfly plate, and notice some thick black substance. It seems like grease or oil. I don't know if its there to lubricate the motor to run the plate or just oil.
View 8 RepliesI had to swap in a new battery the other day, and I noticed that the positive terminal connector is broken. I don't really want to pay >$100 for a new cable right now, so any success story about splicing in just a new terminal ring or using one of the generic battery cables?
View 4 RepliesMy wifes 01 Supercrew had the tailgate cable pop off the other day- it came unscrewed from the tailgate. I went to screw it back in, but there is nothing to screw it into. Whatever was there to accept the bolt is gone. There seems to be an access panel on the tailgate (appx. 48 x 8) that I cant seem to get off- it like its being held in place from inside but I cant see how. I slightly bent up the panel trying to remove it, then lightly tapped it back in place- now I have a ding on the outside finish. So, what was in there to hold the bolt, can I just use a regular nut with a washer if I can get my fingers in there, and whats with the access door ?
View 2 Replies2006 Honda CRV, throttle by wire. How can you get the throttle plate open to clean the throttle body etc.
View 4 Replies