Woke up this morning and was going to work. Went to unlock my truck and noticed the lights didn't come on inside when I used the remote door unlock. Then I started truck and the tranny lever on the steering column wouldn't go into gear plus the sterring wheel will not lock when the truck is off!
View 1 RepliesI have a '97 F150 4x4 with the 5.4L engine and automatic transmission. The tranny's been slipping on and off for a couple of years. It started when it was hot outside, I had been driving a long ways, and I was trompin' on the gas to pass someone. Still, the slips were rare. As it got worse during the hot summer months, I just minimized my long-distance travels.
I recently took it to a transmission mechanic. Like some of the feedback to posts in here, he felt it was a problem with the engine - because we had a bad EGR valve signal on the computer. (We still flushed the fluid. I later replaced the EGR and the DPFE. Another mechanic went through everything, replaced some valves that had something to do with the EGR, and feels the engine is 100% (and it runs very, very smooth). For those that will bring it up - I have replaced all of the coils (though it's been a few years). Having actually replaced some numerous times over the years, I can feel when one is bad (of course, the 'check engine' light as well). Lastly, we've replaced all bulbs in the dash so they are all working as well. Also, the transmission is not leaking. The computer system is giving us no errors/throwing codes.
After a couple of weeks, I happened to drive the truck a long distance one day and it started slipping. It got bad enough that it was slipping every time going from first to second gear. It would usually engage as I took my foot off the gas. Since then, because I haven't driven long distances, I have not had a problem.
The transmission mechanic thinks it's still an engine issue. He also mentioned a mechanical/electrical switch system on the side of the transmission (?). Give me a list of things to look at.
I have just put in another transmission and the truck will not shift out of first gear, it will go in reverse and first and reverse. The guy who had it before me had the same problem when he put in a transmission with only about 40-60,000 miles he assumed it was a bad transmission. And that's how I ended up with the truck. We have so far installed yet another transmission and it is doing the same not shifting out of first that it did for him. There is no cel or blinking overdrive lights, checked fluid levels, checked selinoids, gonna purchase a used computer for diagnostics, I am stumped with limited knowledge. The dealership said the transmission should be the e40d I'm reading it should have the 4r100 is that correct? The truck is the 5.4L v8 with 74,000 original miles. Truck sounds amazing. I really want to fix it.
View 2 RepliesI have a 2002 f150 lariat super crew 4x2 with a 5.4L engine with 145,000 miles. My tranny is shot, and i was told it happened because the tranny cooler went bad. A few people have told me it sounds strange that the cooler went bad on its own. The truck is still at the shop that diagnosed it and i cant seem to figure out if it has the 4R70w or the 4r100 tranny in it. Is this something that's standard or something i will have to look at on the truck itself to figure out.
View 11 RepliesI have a 2002 f150 2wd 4.2l engine. With 135,000 miles I just replaced the battery about 300 miles ago and I usually tow a trailer almost always. Also I replaced the Plugs and Plug wires about 15,000 miles ago When I am towing I turn the OD off. Now the problem. I noticed that when I am not towing now that when approaching highway speeds it seems to shift back and forth from overdrive while accelerating only.
But when pulling a trailer with OD off it shifts fine. No engine codes appear. I am due to service the transmission fluid I think I have about 35,000 on the fluid now but before I do I just want to pass this that while I have the pan out. Is there anything else I should check or could this just be a issue with dirty fluid Or Possibly the drivetrain controller because I hardly ever drive without towing..
It started with not being able to pull the shifter into gear...when started and no wipers, interior light, found a blown fuse, repaced it, all ok, blew fuse again, bigger fuse. It still works, now I have no high beams and cruise. 170,00kms....
View 1 RepliesThe problem started with a front seal leak a few months ago which I had no choice but to continue driving with because of low funds. I don't drive much so a couple of quarts of ATF was usually enough to get me out and about for what little driving I had to do. I know.. a front seal is cheap, but I'm partially disabled and unable to work on anything that is not under the hood.
I finally scraped up enough money to hire a friend to replace the seal, but he had a life crisis before completing the work, so I had to get another friend to reinstall the trany... still had the leak, but I could get around by adding ATF as before.
So we tried again... dropped everything and put another new seal on. This stopped the leak, but we got some grinding/squealing noises and could not get the trany to engage any gear.
From reading forum posts and other sources, we decided to replace the TC which we just completed this evening. We got some more of the grinding / squealing noise like before, except that it only occurred the first time we tried cranking the engine, the 2nd time we got no noises, but again no gears engaging.
What to check/replace next assuming there is something we can look at other than a total trany rebuild or replacement. I personally find it hard to believe we could have gone from a tolerably functional trany to scrap metal just replacing a seal and the TC. Its gotta be something simple we overlooked !!
I have a 1997 F-150, 2 wheel drive, 4.6L truck. Recently the transmission got to where it didn't shift properly. Then it got to where, after driving it about 10 to 15 miles the transmission would drop out of gear with the transmission selector in drive.
I have replaced the transmission sensor, the rear end sensor and it still does the same thing. Drive about 10 to 15 miles and, with the transmission selector in drive the truck will not pull. The motor can be rev'ed but the truck won't move just like it was in neutral.
What is wrong. The transmission shifts fine, the truck runs fine, but after 10 to 15 miles the transmission quits working.
So my aunt has a 2002 ford f150 king ranch 5.4l and a night ago it started this problem which when you put it in drive which she has to put it in 2nd for it when she pushs on the pedal it will rev up to 2500rpms than jerks and goes and its usely fine till she stops than goes and it does it again...
Than today it wouldn't even go in anything but reverse... So than we herd about the Range Sensor on the side of the transmission and it seems like it was it so I unplug it when it was running and when i push on the pedal and it revs up to 2500rpms it will go forward and have power. So we went to get a new range sensor after like 4 hours trying to get the dam thing off and another 2 to get it back on.. I started it up and only reverse works again... So I unplug the harness to it again and we got the gears but 1st and 2nd will just rev and go.
We at a lost right now i even tighten the shift screws under the dash cause our expedition was loose at one time and the gear shifter was loose like hers. But even tighten the bolts it still don't fix the looseness or even the gears.. Is this a transmission problem? OR even the torq covertor?
Was looking for some advice on what my problem may be. I just replaced the slave cylinder on my 02 f150 4.2 and two days after I changed it on my way home from work my truck jerked when I was about to turn into my driveway. Then when I stopped I put it in neutral snd it started rattling really bad it stopped when I pushed the clutch in And when i let out it started again. It sounds really bad and im hoping its something I can fix my self and not terminal.
View 4 RepliesAnything else that could cause reverse to go out of an automatic tranny other than the tranny being shot? I don't know of anything but any way to keep me from replacing a tranny.
View 2 RepliesI have a M5OD that I replaced the clutch in in my '99 150 4wd in December . Manual Tranny. Now when taking off in 1st gear the transmission seems to be sliding or shifting backwards, but only in first gear. Got under my truck and looked, can't find any identifying marks to where it might be moving or what is causing this. All frame mounts are tight and the bell housing is flush with the motor. Yes, i did do the clutch change myself in shop class.
View 1 RepliesI have a 2002 f150 4.6L triton. I've been having problems with it making a clicking noise. It only does it when its in gear. I put it in park or natural I hear nothing. But as soon as I put it in drive or reverse and put a little pressure on throttle it starts to tick pretty loudly.
View 4 RepliesI have a 99 F150 4x4 with the 4.6 Motor approx 150000miles. Transmission went out so I decided to try and replace it...
New/rebuilt tranny went in with no problem but something is not right. It will drive but seems like it is stuck in high gear and bogs the motor down. It is giving me error codes P1747, P0750, P0755, P0743, P0102. All the wiring harness is in good shape with no burns or other noticeable problems. Somehow the transmission isn't reading right?
When I bought this rebuilt transmission I was told it was set up for 2wd but he would convert it for 4wd. The only difference i noticed with the new tranny is the shaft coming out of the tranny, where the safety neutral switch is, has a diamond shape instead of the oval shape that connects the shifter cable. No big deal i think, just had to buy a new link for the shifter cable with the diamond.
Also on the passenger side of the tranny there is a nine pin plug. My wire harness from the truck has one pin hole that is opposite of the tranny. Not sure why. Do I need a new harness or wrong tranny?
I just bought a 98 f150 about a month ago from someone. The guy i bought it from said the tranny had been rebuilt about 4 months prior and i have the invoice proving it. I have lately noticed a hard shift from first to second gear, all other gears shift perfectly, but on my way from work toady the tranny seemed to slightly slip out of gear(in other words the rpms didn't shoot up, just loss of power) when accelerating from a stop light, and then it seemed to catch and started shifting ok. my question is given these symptoms is it possible that i can make this tranny last a little while longer or is it about to quit? any possible causes?
View 4 RepliesThe Speed Needle works fine. But...the Odometer part quit some time ago. I can't tell what my fuel Mileage is now. How to troubleshoot this problem?
Things that might affect this problem; Transmission skids loudly when going in and out of 4-OD. It could be the Torque converter clutch?
The Gear shift lever is sloppy. Doesn't fill me with Confidence.
Brake fluid warning light is on most of the time. Fluid level is up hi though. Driver door mirror control switch don't work in one direction Who on this Forum has a Switch for me?
I just bought a 1997 f350 460 with 84,000 miles. When I put it in drive it wont shift out of first gear. If I shift manually I can get first and then second and they both work fine, if I go back to drive to hit third it goes into neutral and doesn't re-engage until the speed drops and then it goes back into first. atf looks fine and doesn't smell. Perhaps sight unseen internet auctions are not the right way to get a good deal...
View 2 RepliesOur 2002 Explorer E.B., V6 4wd 153,000 miles, when cold only in winter months the transmission is slow to go into gear, forward or reverse, takes 10 or 15 seconds to catch into gear. If you warm the car up for 5 minutes or so it is ok no problem. In warm weather it does not do this. Transmission shifts normally and runs great other than this. I changed tranny fluid and filter with Mercon V about 12 months ago. Could it be the solenoid pack or something else.
View 3 RepliesMy transmission is manual, front wheel drive, 4 cylinder motor, plunger has come disconnected from shifting forks, car is stuck in 3rd or 4th gear. Would it be easier to change transmission or is replacing the plunger mechanism a viable option?
View 3 RepliesMy 97 AWD Aerostar bumps in and out of gear on very hot days. I've had the transmission fluid and filter changed. That repair worked, but it still shifts hard when very hot. I tow a boat. I always push the shifter button in to deactivate the OD when towing. I talked to friends who recommended an auxiliary transmission cooler. I looked on the van where one might be installed. I have a factory transmission cooler (oem factory installed).
The cooler is in front of the radiator. I don't see any room to add an additional cooler. The van has 145,000 miles. The van runs and shifts fine most of the time. The problem has happened only on very hot days. What I can do to prevent transmission problems. I've read that the AWD 1997s use a five speed transmission. 1997 was the first and last year the five speed automatic was installed in the AWD Aerostar.
I just had a 97 Ford Ranger with a 3 speed overdrive transmission in my garage that we replaced the transmission because it was not shifting down into first gear, not even manually!. The new transmission is doing the exact same thing as the original.
View 5 Replies