Ford F-150 - 1997-2003 :: 2001 - EGR Valve Location?
Apr 19, 2014
2001 5.4l Windsor... I have been reading up on some post, and I'm wondering where the EGR VALVE is located on these motors?
View 5 Replies2001 5.4l Windsor... I have been reading up on some post, and I'm wondering where the EGR VALVE is located on these motors?
View 5 RepliesI've got a 2001 f150 XLT and I've checked the Haynes manual and searched Google but I'm having no luck.
I'm trying to locate the sensor for the Automatic Head Lights.
I had a small "spill" on the dash at night and immediately the lights started to blink and click. It fixed itself but sometimes it will do a weird little "click, click noise" change thing. I would like to clean the sensor or ensure it's not partially blocked.
I have a 2001 Screw 4x4 that had a bad valve on the passenger side. I got the head rebuilt and put it all back together. Now it has a pretty bad oil leak at the rear of the engine. I thought it was the valve cover gasket but when I took it off the gasket was right where it's supposed to be. I pulled the starter and it seems to be leaking out of the new head gasket. What could I have done wrong? The thing runs perfect now but it's dripping oil like crazy so I had to have done something wrong. I used an OEM head gasket from the dealer and torqued the new head bolts to 30 ft-lbs and then went another 90 turn twice just like the book said.
View 14 RepliesI have a 2003 Lincoln aviator with the 4.6 V-8. When I was seafoaming the car today, afterwards I noticed the truck running a bit rougher, and the truck idles around 500-600 rpms instead of 900-1200 rpms. There was a hose connected to the left valve cover, I pulled it off and there was no change in power or sound or idle. Is the hose a pcv hose, if so, where is the valve on this engine in the aviator, shouldn't it be on the valve cover? Do you think its a vacuum leak cause by the pcv valve/hose or a vacuum leak somewhere else? does aviator 4,6 come with a valve or just a pcv hose?
View 14 RepliesMy 1997 Caravan 3.0 acts as if the EGR Valve needs to be cleaned. Where is the EGR Valve?
View 3 RepliesLooking for an image of pvc valve location....2003 ranger 3.0......
View 2 RepliesI have a 2004 Santa Fe with 2.4L 4 Cylinder engine. I have the inexpensive Duralast CV1139DL PCV valve but cannot figure out where to install it.
View 1 RepliesWhere the EGR Valve is located on a 2001 Chevy Venture? Pics of its location would be nice, if possible...
View 7 RepliesI cannot find the Oil Control Valve Screen location for my engine. I have also seen one post that said this engine doesn't have one, but I thought that was odd.
View 14 RepliesWhich cylinder is #3 on 2003 150 4.6. ...
View 2 RepliesI'm looking for the location of the ECM in a 97' f150 5.4.. Also need to know difficulty on replacing it and is it what controls the windshield wipers and windows?
View 1 RepliesWhere is the thermostat located on a 5.4 1999 engine.
View 1 RepliesI have a 97 F-150 that the A/C went from blowing cold to hot instantly. I have done the following;
1. Checked fuse. Was good.
2. Checked Low Pressure connection.
On this, I jumpered the connector and could not get the clutch to engage. I also checked to make sure I had 12v from that point, which I did.
3. Checked the power to the clutch assembly. Got nothing. I also put 12v directly to the clutch and it poped in just fine.
Based on all of this I think I have a bad relay between the low pressure sensor and the clutch assembly. The only problem is I cant find it. Where this relay is located
Where is cylinder six located my '99 F150 5.4? Which bank? Front or rear?
View 4 Replies1999 F150 4.2... Has at least a bad #2 cylinder valve. Very low compression. 200k on the truck. Here's the question: drop another motor or just do the heads?
View 5 RepliesSo, when I bought my truck, it leaked oil.....bad. It goes through around 2-3 quarts a week. I needed a vehicle, this one was cheap, so...I run it. Every other day, I put half a tank of gas and a couple quarts of oil in it. It leaks on the passenger side, right above the starter. I figured it was the valve cover gasket, and planned on changing it today. I saw a post about the "typical" head gasket oil leak, which sound suspiciously like what mine is doing. I have no oil in the coolant,or vice-versa.....
View 9 RepliesI'm looking for information and possible photo location for the blower motor resistor. My truck has climate control. I've looked under the dash on the passenger side and behind the glove box door and I've been unable to spot the location. Do I have to remove the plastic panel behind the glove box?
View 6 RepliesNeed location of the fuses for 12V power in dash.
View 2 Repliesi have a 2003 f150 xlt 5.4 4x4 truck i change the valve gasket cuz of a leak since it was off i paint both covers but forgot the order os bolts theirs long and short bolts can some one show me a drawing or how the order of bolts go on the both sides
View 1 RepliesOk so I have a 2002 f-150 4.2. I was replacing the PCV elbow that always crack and I figured while I'm down here, I might as well replace the PCV valve as well. I have the PCV valve that has 3 connections, 1 to the crankcase and then 2 "vacuum" type connections connected to the water pump and is full of coolant of course. What am I missing here, I though sometimes these things were connected to a vacuum line, is this some kind of heater for the PCV?
View 12 RepliesHad a question about where the battery fuse is located and it's number. I just put a brand new alternator on.my truck. Turns out I might not have needed one, switched the battery with the new alternator on and the truck still went dead after it ran for about 10-12 seconds. So some told me it may be the battery fuse but I don't know which fuse it could be.
View 2 Replies