Ok replaced the front brakes, tie rod ends, and all ball joints today. Also flushed old brake fluid and replaced with new. Now my cruise control does not work. Light on the dash momentarily flashes when I try to set the speed. I have checked all the fuses and the connections and everything appears normal.
2001 Ford F150 5.4L 4x4 off road pkg stock height and tire size.
I am stymied by a weird Cruise Control problem on a 2001 F150 Lariat SuperCrew with 5.4L V8 engine that I just purchased. Long story short, the cruise control does not work. That is, when I push the "On" button at any time while the engine is running (even when traveling at highway speed), the dashboard CRUISE light does not come on.
I ran the cruise control "self check" procedure. The first time I ran it, we failed with 3 flashes. So I checked the cutout switch on the brake master cylinder, and it was indeed leaking brake fluid. So I purchased a new switch and cable (Motorcraft SW-6350 Speed Sensor Switch Repair Kit) and installed them.
With the new cutout switch, we seem to pass the self test. That is, after pressing all the buttons in order , I see all the quick flashes of the CRUISE light
(1. On (flash), 2. Resume (flash) 3. Coast (flash), 4. Set/ accel (flash)). Then the accelerator pedal is pulled away from my foot.
However, unfortunately, the cruise control still does not work. That is, when I push the "On' button at any time while the engine is running (even when traveling at highway speed), the dashboard CRUISE light does not come on. What to look at next? I note that horn works, in case that's useful info.
The cruise switch on my brake master cylinder is bad and causing the cruise to not work. I have it bypassed with a jumper wire and it works fine. is there any reason not to do this?
View 11 RepliesI have a 2001 ford focus SE and l can't get the cruise control to work anymore, is the problem a fuse and if so where is it located or a problem with brake pedal?
View 6 RepliesI have an 02 f150 5.4 and since I got it it hasn't had cruse control. I went to a local ford dealership and they ran the vin and didn't find any recall on it. Under the hood on the master cylinder there is brake fluid coming out of the brake control switch. Would I have to do something with the harness too?
View 9 RepliesJust bought a 2003 5.4 6 speed 4x4 F250 .. The cruise control does not work at all. The only fuse I can find in the owners manual is a 2 amp one .. it is in good shape .. Where do I look now to solve the problem??
View 8 RepliesThe car seems to start accelerating on it own. Say cruise control is set you notice acceleration for no reason. Now cruise control does not work and acceleration at times still happens. It's not like you are flooring it just keeps going faster slowly. Don't know if this could be related I did replace the fuel pump recently and the crankshaft position sensor. I was looking to see if there is a re learn procedure for the crank sensor. I have replaced them in the past and don't remember having to do a relearn.
View 10 RepliesAirbag light flashes on dash and then stays on. Cruise control and horn wont work. I cant find a blown fuse.
View 9 RepliesMy cruise control does not work and the mechanic has diganosed the cruise control servo as the problem. The shop gave me an estimate of $700 (parts & labor) to replace it. Given the age of the car and the cost of repair, I am leaning towards doing it myself. I am handy with tools but have not done this type of repair before.
My question: Is there a downside to doing this repair myself. If I elect to do it myself, what do I need to watch for?
As a precautionary measure, I recently had the timing belt replaced on my 2003 Honda Civic. The mechanic noticed that the clutch master cylinder was leaking and I also had that replaced. After the repair, I noticed that my cruise control does not work (turns-on on the dashboard but does not work). I am taking the car back to have it fixed.
My question is where/what areas should I ask the mechanic to check to fix? I am thinking it could be as simple as a disconnected connection but I am not entirely sure.
For a while now when i would turn my fan on, from off, the lights showing the air inflow, etc. fade out and i get no air intake what so ever. The light is on when the dial is switched into the off position, but when i go from level 1 and up the power dies out. Intermittently it will turn on, but often for brief moments of time. Also when it IS on i get a permanent "cruise" light that stays on however my cruise control doesnt work when this is going on.
The light is just on. When it does decide to work and i turn my cruise control on it works up until my fan dies out again (they are on and off at the same times) and thus, the cruise control dies again. I took apart my heater circuit board in hopes that it would solve the problem, and for about a week it did. However it ceased to work yet again. I went and pulled one from a scrapped car to see if replacing the unit would solve the problem, but this one is not having any better luck.
2000 F 150, 4.2 v6, M5OD-2 Manual Transmission, LX, reg cab .. Cruise Control passed all static and dynamic self test. All fuses inside and under hood checked good and still cruse control will not engage. All other functions work: brake lights, turn signals, etc. Green cruise light is operational, checked pin #10 on wiring harness at servo,amplifier unit under hood and have good ground. The Cruise ON button will not turn on cruise control system and will not light green cruse light.
View 4 RepliesA few years ago I had the clutch changed on my 1997 F150. Afterwards the cruise control wasn't working. When I brought the truck back to the repair shop I heard the manager tell the mechanic to "attach the clip by the pedal" and that fixed it.
I just had some work done, had to replace the oil pan, and the mechanic had to remove the transmission. Now the cruise control doesn't work. I changed the Pressure switch but it didn't fix the cruise control. What that clip might be that fixed the cruise control last time?
I have an '02 F150 Lariat CC 5.4L. The truck is new to me and neither the cruise control nor the horn works. i have checked all (known) fuses and relays. I have tried the cc diagnostic, and the dash light DOES NOT illuminate. Should I assume that the dash light is not burned out? Is there a way to test the clock spring connections for continuity? and how do I access the connection
i checked the cc brake pressure switch and have continuity there.
I did the diagnosis,on my non working cruise control on my 2000 f250. The cruise light came on when, I, depressed the off switch and turned key on. I depressed on switch,cruise light came on.
I then depressed the resume, coast, and set switch, as described in the diagnostic procedure,suggested,and no light came on. Do the switches for the cruise control are bad.
I have checked the fuses at the power distribution box under the hood and checked the fuses under dash,all are fine. I just replaced the switch at master cylinder, as it was leaking and it had the recall switch replacement, too.
All, i have an issue ( or at least i think its an issue) with my 99 f150 5.4. When i use my cruise control, i notice when i put on the brakes slightly to slow down, it feels like its not coasting because you can feel the engine still engaged and wont coast. I think this happens even without the cruise on. What this could be? I have the latest update on the cruise control harness. I believe that was for power always to it even in off, causing fires.
View 3 RepliesI have a Ford F150, 2003. I replaced the switch above the master brake cylinder just a few months ago soon after I bought the truck. I put 17" rims and new tires on my truck and now my cruise control works intermittently. It worked fine before then.
Can there be a connection between the intermittent failure of the Cruise and the larger rims and tires? I know my speedometer is off by about 4 MPH at 55 but I expected that.
I'm at my wit's end trying to install cruise control in my 2009 Corolla. I thought it was a relatively easy install, but then after putting the airbag in place, I find that the horn no longer works. I test out the cruise control, and the green "Cruise" lights up on the dashboard..but it doesn't actually work.
View 9 RepliesI am having trouble with all sorts of functions on my 2002 F150 4x4, 4wd not working, cluster module illumination not working, horn not working, reving up and down at idle and sometimes dyin, cruise control quit working. I have been reading it is the GEM module that causes these issues. My question is I ordered a new one from Ford, when it arrives I was told I can just install it and It should be pre programmed. but one ford house tells me that they have to install it and program it. Which it right? I have seen several sites on u tube where people replace the module and then start their truck right up without any issue.
View 2 RepliesI have a 2001 f350 7.3 powerstroke electric shift 4x4 auto trans, truck cruise control just quit, no illumination at dash, when switched on, checked all fuses they are good, owners manual doesn't say much...
View 7 RepliesJust got my first X(and Ford) a couple days ago. Anyways, the cruise control doesn't work. I checked the CC switch on the master and it tested fine and I installed new switches on the steering wheel.
When I do the self diagnostic test with the steering wheel switches they all test fine, and on the last button(set) it lights up, but no other flashes. What does that mean? In 1 thread it stats that 0 flashes is the speed control servo.