Ford F-150 - 1997-2003 :: 2001 5.4L Truck Will Crank But Not Starting
Jan 31, 2017
I drive a 2001 ford f150 lariat 5.4L. My truck will crank but not start, i am getting complete spark, and have ran a full fuel pressure procedure, and am getting complete fuel pressure, there is no water in my gas, everything checks out how it should. I ran a test on my cluster and it showed a code that said i am not getting connection to computer to start. I removed the cluster and repaired all loose wires properly, and it still wont start! I have had many people look at it and they said it could still be a bad cluster.
View 13 Replies
Advertisement
I have a 2001 f150, 5.4triton, 4x4 supercrew. I'm having trouble getting the truck started. About a month ago is when I first started having trouble with it, and it's happened more frequently until now it just won't crank up at all. The engine is turning over, but it it just won't fire. When it starts, it runs and drives fine, no cut off or rough idles. I replaced the cam sensor today (figured it'd be worth a shot for 20 bucks) but that wasn't it.
View 2 Replies
I had issues with my F250 cranking last winter when the temperature dropped, so I changed out the glow plugs in the spring. I hadn't been able to truly test them yet, since it hasn't been cold, but the other morning my truck wouldn't crank up. It was 40 degrees out the night before, and it had been almost 24 hours since I cranked the truck, but it seems to me like the truck shouldn't have an issue in that mild weather.
I'm not sure what I need to do next to try and fix this problem, it's been driving me crazy and risks stranding me if I park for a while in an area where I am unable to plug by block heater in. The truck cranks fine when I have had it plugged in for a while, so I'm fairly certain it's a heating issue. I haven't done any tests since last year, but I know that the GPR was working properly last winter, which is why I changed out the glow plugs.
View 4 Replies
If I turn on my ignition switch and my gauges go to where they're supposed to be, the truck will crank. If I turn switch and , lets say gas needle for example, the needle goes to full then drops back to empty, the engine will turn over but will not crank.
View 2 Replies
I have a 97 f150 with a 4.9..... I drove it less than a half a mile and shut it off. when I got back in it to start it up it wouldn't do anything like the battery was dead but all the electrical worked but it would not turn over. after about 4 hours when I returned, it started just fine. drove it straight home and shut it off and immediately tried to start it again and had the same issue. What the culprit may be ?
View 1 Replies
1996 f150 sometimes it starts sometimes it don't. It is cranking over the starter is in gauging as well as the fuel pump I can hear it.... It's getting spark and I replaced the starter solenoid.
View 5 Replies
I am having problems with my 97 F150 6cyl. A couple of months ago, I noticed the truck after sitting for a few days without being started would not crank. After some trial and error, I found that turning the ignition switch on and off several times did the trick and the truck would crank right up. I was thinking this might be a fuel pump or fuel filter issue but, I'm not sure.
A couple of days ago I was going to drive the truck and did the ignition switch deal as usual and the truck cranked up but, there shortly after while just idling the motor died. I have tried and tried to crank it and it want start back. After thinking on it, I don't know if this is a fuel problem or not, or maybe even the ignition box.
View 2 Replies
My Truck : 1999 Ford F-150 Extended Cab 4x4 5.4L V8
So the other day I was driving the truck and it just dies on me. Tried starting but it just cranked and cranked. Got it pulled over to a parking lot and then tried to start and I got it to run again. Died a couple mins later uo the road and it will not start at all anymore. I got it towed to my driveway and I've started diagnosing some things.
I dropped the tank thinking it was a pump I replaced awhile back. The pump wasn't running but jumped to conclusions and took it back to the auto parts store. They bench tested and it works fine. I checked for voltage at the pump connector. NOTHING. So I'm not getting power to Fuel pump. Then I checked the fuse and relay for the fuel pump. Everything was okay.
I did some research and decided to check for spark. NO SPARK. Another thing I noticed the other day was that the odometer is displaying all dashes. So I'm really unsure on what to really troubleshoot. I am going back to the truck tomorrow to check a few other things. I'm not sure if the Theft light is blinking or not so I will check that tomorrow and get back to you.
What to check? Any other relays or fuses besides the fuel pump? What about any modules to check like PCM, GEM, etc. Or I've heard the crankshaft sensor could be an issue.
View 14 Replies
I have a 2002 F150. I have an intermittent issue with truck not starting. It turns over fine but will not start. Also, when having this issue, there is also no activity with the cluster when turning the key on (other than lights lighting up); the gauges will not move as they would normally when turning key on. I have checked every fuse inside / out. I have checked the fusible link at the battery as well as any other connections I could locate around the solenoid as well as disconnecting the ECM / computer and re-plugging it back up. Typically, after letting the truck sit for a day or so, it will start back up until next time.
View 5 Replies
I have a 98 F150. The motor was replaced three months ago and have had no problems until now. The truck had trouble starting so i put an alternator on it. Fixed for a while and then it started blowing fuel relay fuses. I replaced fuel pump and filter. Truck has trouble starting after sitting overnight. When I am driving and floor it, once it hits about 4,000 rpms, the truck bucks like its the transmission but the rpms drop and then pick back up. Fuel pressure is right where its supposed to be.
View 1 Replies
I have a 2001 E-350 w/7.3. When I start the truck first thing or when engine is cooled down it starts fine. I checked the high pressure pump pressure and it is 500 - 600 psi start up great. But when engine warms and try to start it it has long crank before starting. I checked pressure and it is between 425 to0 450 and takes awhile for it to get to 500 or better. Is this a cause of the high pressure oil pump ? I changed the oil and still does same thing. Also I noticed that after engine is hot and I try to start it, while cranking the engine the oil gauge does not move. I don't know if it supposed to when you crank it or not. I thought on other 7.3's I've worked on that the gauge builds up pressure....
View 14 Replies
I have a 1998 Ford F150 with 4.2.. Started off a intermittent problem of not starting acct no fuel. Now will not start at all. Checked all fuses and relays.. Am not getting voltage at fuel pump. Changed ECM thinking that was the problem.. Have checked all multi wire connectors for corrosion and tightness. Am at a lost what to try next.
Also, not sure if its related or not. The turn signals and hazard flashers do not work. When I turn on the hazard flashers, nothing happens. If I leave the flashers switch on, the turn signal work. Checked all fuses and relays and they appear good.
View 2 Replies
2001 F250 7.3l 294k miles
Ok so truck has always had difficulty starting cold since I got it about 12k miles ago. Replaced glow plugs, that made things slightly better but still no start unless temp gauge was in that first line above the C. Changed to Rotella, immediately after oil change starts better and at slightly colder temps.
Since getting the truck when you turn the ignition on you can hear a 'whistling' type noise which I believe is the fuel system pressurising. That used to last as long as the chimes did when you first turn the ignition on. More recently it lasts a lot longer.
Towed recently and had intermittent check engine light - believe this could be HPOP related, haven't checked codes yet as we're on vacation. No oil in the valley. But I do have a little oil carry over in the turbo intercooler pipes.
Truck slightly sluggish at setting off initially and then picks up reasonably well when not towing but my Dyno says I'm putting a bit more pedal to get the same performance from say two months ago
Pretty sure injectors haven't been changed since truck was new but can't be absolutely certain as there is no history. I was surmising this is probably both a HPOP and injector age issue but only from what I've found searching...
View 14 Replies
I looked under my truck and noticed a Antifreeze Leak I looked under the truck and noticed the antifreeze leaking around the crank shaft. I have never seen a leak from that area. I haven't pulled anything just want a good direction before I start pulling parts off.
I looked up top didn't see any hoses leaking. looked all around the block. the only place I can see it coming from is behind the crank shaft pulley somewhere.
2001 F150 XLT 4X4 ....
View 6 Replies
I got an 2001 f150 4.2l v6, 5speed. It started running real rough almost like it was hitting on only 3 cylinders I replaced the crank sensor and did a tune up on it along with a new coil pack and now it won't hit a lick the plugs are getting fire, it's getting fuel but, will not start it's not throwing any engine codes. Which leads me to believe it may have a bad ecm.
View 3 Replies
I have a 2001 F150 XL, 2WD, 4.2L, Auto at work. It will intermittently crank but not start, also, my scan tool will sometimes not connect to the truck. The only code I ever get is 1 about not being able to connect to self diagnostics. I have narrowed it down to the PCM relay in the underhood power distribution module not turning on because it SOMETIMES only sees a 2 volt turn on signal instead of 12 volts. I have replaced the ignition switch on the steering column- initially I thought that took care of it.
But as I was about to put the meter away it did it again. If I remove and reinstall the diode that is in the PDM, sometimes more than once, I can get it to turn on. Are these diodes available from any one besides Ford? The wiring diagram in my Haynes manual is very generic and does not show the circuit from the ignition switch to the fuse box. Where can I find a GOOD and complete wiring diagram for free on the net so I can print it out and take it with me to work?
View 1 Replies
2001 F150 4.6 V8 Triton
Automatic
Battery Tests Good
Starter Tests Good - I saw it spin and come out at the testing station at Autozone
Ignition Relay (the one in the fusebox)- New (8mo.)
Switch on the firewall on passenger side of truck - New (8mo.)
Battery terminals/connectors - Tight, no movement, Cleaned within the last week.
Starter connections - cleaned within the last week.
I am having trouble with my truck not starting. The issue has been occurring on and off for over a year. Usually, it happens about once a month, regardless of weather.
I turn the key, and there is one click. Usually at this point, I can use one hand to gently pull the shifter "up" towards park and turn the key again and it will start. Recently it is not starting when I do this. I have tried many times, and have tried to start it in Neutral (is that even possible with an Automatic?).
With the key in the "ON" position, I go under the truck and jump the starter cellinoid. I am jumping the small post to the big post where th wire comes from the battery. I do not touch the post that the wire goes into the starter.
I am very confused because it starts just fine without fail and almost instantly when I jump the posts. It is drive-able this way, but I would like to resolve this issue, and resume using my key to start it since the issue doesn't seem to be resolving itself as it usually does.
A friend told me about the Ignition Starter Switch inside the Column. If I have time I will attempt to start the truck with a screw driver on the switch tonight to narrow down the issue.
View 9 Replies
My 2001 5.4 makes a grinding noise when starting. Not all the time but some of the time. it will always start but it is annoying. Need to know if this would be starter or solenoid?
View 4 Replies
Having some problems with my truck.... First off I bought a 2002 excursion and drove it for one day. Then I was at the car wash cleaning up the truck. Then I saw the window fogging up so I turned the car off. Now it won't start.
I had previously installed a new stereo, but had some problems, so I ran the remote wire to the fuse box, because the wire in the harness wasn't getting power.. So after a little trouble shooting we found out that the fuel pump wasn't working or was bad.
We replaced it, now it has pressure but will not start, will start with starting fluid but will not crank on its own. someone told me it may be a bad PCM? and a dealer can only replace it... I don't have tons of cash, as i bought this truck on 8/30/12 and this happened the day after i bought it.
The previous owner has paid or the fuel pump replacing but I don't think its right on my part to have him pay more money as this may be a mess up on my part with hooking the radio up to the fuse box... we have tried the fuses,realys, crank sensors...
View 6 Replies
Yesterday the truck run Perfect. Got home and shut it off. This morning I get I. Turn key and the truck will crank but not start. After it tries to start the oil light comes on. I Che ked the oil and it was 2.5 its low. Added oil and it still isn't starting! 2010 f150 5.4l ....
View 3 Replies
The past week or 2 I have had an intermittent starting problem. Engine is turning over but wont start, but after i wait a second it will start up. I listened to see if the fuel pump was running and heard the whine. I checked the battery and the starter voltage and it was all good. i primed the fuel pump a couple of times and it started up on the first crank of the ignition. The truck runs great when driving and idling, no misses or loss of power that i have felt or heard yet. I am thinking it is either the fuel pump is starting to go or maybe the fuel filter is getting a little clogged up. Like i said up above this is an intermittent problem and that is why I am confused. Its a 2001 F150 4.6 4X4 ....
View 1 Replies
