Ford F-150 - 1997-2003 :: 2000 - Won't Start When Put The Ignition In On Position
Jul 28, 2016
Have 2000 Ford XLT Extended Cab 4x4 with 5.4. It will not start. Put the ignition in on position and can't hear the fuel pump running. Fuse Okay, Relay OK. Does this year have A Fuel Pump Driver Module? If so, where is it located? I know where they are located on 2004 and up but not mine. If I have to change out Fuel pump, is it easier to pull the tank or the Bed?
View 6 Replies
Advertisement
97 F150 4.2 auto with Simple trans pan gasket change because it was leaking and now the ignition fuse blows every time I turn the key to the on position. Ran fine before now what? can't pull code with reader with key on or off.
View 4 Replies
I have a 97 Bravada. Recently the check engine light came on and then went off. I didn't think anything of it at the time till the other day I drove it to work and back fine without any issues, then the next morning I tried starting it and nothing happened. No cranking, no interior lights, no sounds.
I tried jumping it thinking the battery was dead but that didn't work. Now my key is stuck in the ignition in the accessory position. It will not turn all the way back to release the key.
View 11 Replies
have an issue with my 03 trailblazer. i have the problem of no start when key turned to start position. actually nothing happens when the key is turned to start position. dash comes on when key is turned to on pos tho. took battery off and had it tested and it is at full charge. took starter off and had it tested and it passed. checked ignition relay cavities per this youtube video "Chevy Trailblazer no crank testing and information" and there is no light when touching the ground request cavity and turning the key to start position.
View 3 Replies
I have a 2003 2.4L 5 speed manual Santa Fe. I was parking my vehicle and removed my key as usual and realized that the car was still running. I put it into reverse rolled back and back into 1st to roll forward just to make sure I wasn't dreaming. I ended up pulling the fuel pump fuse and disconnecting the battery to turn it off.
When I replaced the fuse and reconnected the battery I was able to bump start the vehicle without the key in the car and drive it all the way home with no problem. I took apart all the plastic pieces around the Ignition and attempted to remove the cylinder but was unable to locate any sort of small button or pin to push on to remove it. Where is the release button?
What are my options here? Do I replace the cylinder first or get a new key, or is there something else that I should check first before I take it in.
View 1 Replies
I have a 2000 f150 with 198,000 miles. The lite on the dash came on, "service engine soon" , I had the codes read and they said the coils are going bad.
View 2 Replies
Vehicle will start when put in drive and when put in reverse starter engages and also the ignition wont start vehicle sometimes and the o/d light blinks when driving down the road...
View 2 Replies
On my class C motor home, 1999 with V10 engine when I turn the ignition key to the start position I get absolute silence, when I release the key and turn it to the start position again it always starts. I have fitted a new starter motor, new solenoid and new battery but still the problem persists. I'm scared that one time it will not crank over on the second attempt.
View 10 Replies
My 2004 Accent is stuck in the "lock" position in the ignition, and the wheel is locked and barely turns in either direction. I know this is supposed to be an anti-theft feature and I've tried all of the solutions listed here...
Turning the wheel hard and soft in either direction while holding the brake all the way down and trying to turn the key. Putting the car in neutral and then park and trying the above Disconnecting the battery for a few minutes and trying the above Jacking the car up on one side to release the tension on the pin.
My question is can I remove the spring at the bottom of the locking pin by drilling a hole in the center of the plate? I've seen a few youtube videos of this done on BMW's. It will cost me $500 minimum to replace the ignition or steering column based on quotes I got.
View 10 Replies
My 2002 F150 Screw has been giving me issues when trying to start it for the last month. Sometimes it will start sometimes it won't. When I turn the ignition on the gauges all seem normal, the theft light turns solid then goes out, but engine will turn over but not start. Sometimes it will start if I leave the ignition on for 20 seconds then pull the key and try again. (this doesn't always work). I have disconnected the battery for about 2 minutes this usually works but not always.
Sometimes it will start first time with no issues. Once the the engine fires it runs fine. Another symptom is when I shut the engine off, pull the key and open the door, the chime telling me that the key is still in the ignition sounds. (but the key is in my hand)
I put a new battery in yesterday to rule that out and because the old one seemed to be getting weak. (starting issues didn't go away). I don't want to put 300+ into a fuel pump without being sure that's the problem.
View 1 Replies
I bought this truck new, then sold it to my son, now I bought it back from him. it has sat a lot the last three years. replaced egr valve 08-13, fuel filter 12-13. CEL has been on for a while 02 sensor, it had a bad miss in it so had advance auto scan it and it had miss in #3,#5 and I think he said high pressure exhaust gas? he cleard the codes, so on the way home, It started running good.
The next day it started right up and drove it a couple blocks. it sat for 30 min. then wouldn't start. I cranked it for a while. No gas smell? Hooked a timing light up and didn't get no light? I am not sure if you can check to see if its firing this way? What is the firing order? how to check the fuel pressure? when I have removed gas cap it doesn't make any sound from pressure in the tank. Also how to test coil?
View 14 Replies
Here's the deal. Ive got a 2000 f150 4.6 4x4xlt 170000 miles, About 2 ears ago or so the truck would not start on the first try or two. now this only occurred every once and a while. Last winter it became more of a problem. All i had to do was cycle the key a couple times listen for the pump to prime and was good to go. Summer rolls around no problem at all. Fall rolls around and here we go again no prime. cycle the key a couple times good to go. As it gets colder the problem gets worse. No we fast forward to couple a weeks ago, was out in the woods cutting firewood i go to move the truck and it wont start. I have to cycle the key like 30-40 times. Now its doing it like every time i go to mov the truck until yesterday. Now it wont prime at all. Now every time it primed in the past it runs perfect after it starts . the filter has been changed every 12-15000 or every fall, Ive replaces the fuel pump relay to try it no change, tryed the other key no difference. Im leaning towards a pump but ive never heard of one doing this before.
View 6 Replies
My truck is trying to start its self the lights flash and one of the relays makes a loud buzzing sound. I can take the relay out the sound stops but they truck still tries to start/lights flash.
My wife has been saying she's been hearing a clicking as she drives it coming from the drivers side somewhere she thinks under the dash. But at this point nothing happen. And it had not been raining any when this was happening not for a long time.
The first time anything mechanical happen was only the lights came on and stayed on and drained my battery about a week after wife heard the clicking noise. I recharged the battery and chalked it up to my wife maybe bumping the light switch slightly causing them to stay on and not auto on and off. truck ran fine for a couple of weeks then wife drove it again the other day and after she got home she called me at work saying it was making a bad buzzing sound lights were on and its trying to crank, while it was sitting in my driveway with no one in it (sacred her to death).
That day it was raining. Now I had a small drip coming from driverside window inside so I thought maybe went down on my fuse box. So today I tried to get it out but having a hard time getting cables to disconnect so i left it and inspected really well and it does not appear to have been wet at all. Dust on top no water trails or marks same from side bottom and in the fuse holder. So i really don't know whats going on. Maybe still is fuse box?
2000 f150 5.4l 4x4 ......
View 1 Replies
I have a 2000 f150 4wd 4.6. It wouldn't start this morning. A few years ago I had to change the inertia switch so my first move was to bypass that, which didn't work.
After that I gave it a shot of ether to see if it would hiccup and tell me if I had spark or not. It started up, ran rough while the air cleaner was off, then cleared up and ran fine, and is now starting/running fine again.
The problem is that I have to take the truck on a trip Saturday, and I can't figure out what the problem was if the truck is starting. What it could have been? No check engine light or anything either.
View 5 Replies
2000 F150 4.6L Romeo 2WD. Engine cranks great. Fuel pump working. Changed fuel filter. Will not start. No codes. Fixed A/C day before yesterday, only had air coming out defroster, disintegrated vacuum hose at firewall. Ran errands yesterday, no problems whatsoever. Get in truck today to go to work and no start at all, engine turns over fine. What next?
View 7 Replies
2000 ford f150 4.6 auto. Will spin over but won't start. checked coil for fire, no fire. Check fuel rail for fuel, no fuel. No theft light flashing and no check engine light on. Has new battery and plenty of fuel in tank. Started fine yesterday but not today.
View 5 Replies
2000 2WD 4.6L ... I was trouble shooting why the truck will not start after it has run for awhile then sits for about an hour. I was checking the connections on the solenoid switch on the fire wall when my wrench slipped and touched both terminals on the solenoid and the engine starter kicked in. I tightened the connection then tried to start the truck with no luck. so I tried leaving the key in the "ON" position and jumped the two terminals and the truck started. Does this tell me I have a bad solenoid switch?
View 6 Replies
Have a problem with starting. Truck had an alarm system that I took off. Reconnected the wires back to factory. Installed a new battery-starter cable. Checked and had no radio and no power windows. Found two relays missing and one fuse under the hood missing. Installed new. Tried again and have all accessories but will do nothing when turning key to start. With key on I can jump across solenoid by starter and it will start. Once started it will not allow me to shift out of park. If I shut truck off and turn key to on position I can shift out of park and into neutral and jump across solenoid and it runs. Once I shift back into park it kills the truck and we start all over again. I've traced wires and fuses and can't find anything. 2000 f150 xlt 4x4 5.4l....
View 3 Replies
I have a 2000 f150 with 200k miles. I have no spark and no gas at the fuel rail Schrader valve. I have replaced the shaft pos sensor, no start. I have checked the fuses and the relays. I have crawled under truck and listen for the fuel pump to turn on while someone turned the key to on and heard nothing. I have 2 keys and while turning the key to on and start, the THEFT lite flashes. I have checked the impact sensor on the passing sick panel, it hasn't been tripped.
View 5 Replies
I have a 2000 E350 boxtruck with a 5.4 auto. The motor is a new rebuilt with about 4000 mile, coils were replaced with motor, injectors were rebuilt with motor.Today (500 miles from home) the truck died. I was going up a slight hill on an interstate. It will still start, but runs very rough and when I put it in gear and step on the gas it dies.
So I had it towed to a garage. While pushing it into the garage I noticed my gas cap was missing. I know it was on 45 min earlier because I got gas. Did I forget to put in back on? probably.. But I wondering if the missing gas cap could cause the truck to run bad,vary bad?
View 14 Replies
I just bought a 00 f150 4x4 with a 5.4 auto...it wouldn't start but not because something was wrong. it kept making a clicking sound and the theft light was one blinking...took my bronco to work and when I came home it started right up...I was thinking one of the keys didn't have the chip in it but it started with both keys....it doesn't have a key fob or keyless entry. I tried locking my drivers door with the key and unlock it...
View 6 Replies