Ford F-150 - 1997-2003 :: 2000 Truck Will Not Start After Running For A While Then Sits For About An Hour
Jun 28, 2012
2000 2WD 4.6L ... I was trouble shooting why the truck will not start after it has run for awhile then sits for about an hour. I was checking the connections on the solenoid switch on the fire wall when my wrench slipped and touched both terminals on the solenoid and the engine starter kicked in. I tightened the connection then tried to start the truck with no luck. so I tried leaving the key in the "ON" position and jumped the two terminals and the truck started. Does this tell me I have a bad solenoid switch?
View 6 Replies
Advertisement
2002 4.6L 75K Miles ... Truck has hard time starting if it sits for a few days. Recently had the fuel filter (under driver's door) replaced for first time, and mechanic said it was clogged (?). He also checked fuel pump pressure and said it was good (about 40 lbs). Truck starts OK if used every day. Battery seems OK, as starter turn engine fine. Seems that there's a fuel problem.
View 4 Replies
I have a 2000 F150 4WD 5.4 running Extremely rich to bank one. The O2 sensors for bank 1 are reading lean(0-50 mV) Bank two is completely unaffected. New plugs in Bank one, 3 new coils in bank one, all pvc lines checked with good vacuum. Previous codes : P0171, P0301-3. The Truck will barely move. Would a small leak up stream of the O2 sensors cause this?
View 10 Replies
My emergency fuel shut off switch triggers when my truck sits. Never on the road. Why would it do this?
View 3 Replies
I have a 1997 ford f150 V-6 4.2. My son was driving the truck on the expressway and it quit running. The toe truck has delivered the truck back to my house. The engine turns over but will not start. I shot gas into the engine with a spray bottle and the engine still would not start. Was going to check the coil for spark next. What to check first. Was thinking the problem could be the modulator or coil.
View 10 Replies
I just got this truck. 1999 F250 4X4 with the 5.4L. It will start great when its cold but after you get it hot and it sits for a bit it will not start (will crank) again till it cools off. Its has new MAF coil packs and plugs, air filter tranny flush and oil change.
View 2 Replies
2000 ford f150 4.6 auto. Will spin over but won't start. checked coil for fire, no fire. Check fuel rail for fuel, no fuel. No theft light flashing and no check engine light on. Has new battery and plenty of fuel in tank. Started fine yesterday but not today.
View 5 Replies
I have a 2000 f150 with 200k miles. I have no spark and no gas at the fuel rail Schrader valve. I have replaced the shaft pos sensor, no start. I have checked the fuses and the relays. I have crawled under truck and listen for the fuel pump to turn on while someone turned the key to on and heard nothing. I have 2 keys and while turning the key to on and start, the THEFT lite flashes. I have checked the impact sensor on the passing sick panel, it hasn't been tripped.
View 5 Replies
I just bought a 00 f150 4x4 with a 5.4 auto...it wouldn't start but not because something was wrong. it kept making a clicking sound and the theft light was one blinking...took my bronco to work and when I came home it started right up...I was thinking one of the keys didn't have the chip in it but it started with both keys....it doesn't have a key fob or keyless entry. I tried locking my drivers door with the key and unlock it...
View 6 Replies
My aunt recently gave me her 02 f150 for free because it got flooded and she didnt want to fool with it. she said it ran great before it got flooded. I flushed everything. oil, gas, and tranny. I blew water out the cylinders and replaced the spark plugs. I took the fuel injectors out and cleaned and cycled some b12 threw them. The truck starts and gets spark to every cylinder and is only running on 3. I can pull 3 plug wires off and the idle does not change. Idk what it could be but dead cylinders. I am afraid I am going to have to find a new engine. I am going to do a compression check later this week when I have time. I am new to fords so if there is anything I should check...
View 2 Replies
I have a 1998 F150 4.6 2wd regular cab with 255,000 miles on it. Lately it has had some problems. The first is that it will run really rough when under a load, meaning when I step on the gas. It runs smooth at idle and at cruise but when I step on the accelerator it bogs way down and almost shuts off. I have changed the spark plugs, spark plug wires, coil packs and fuel filter. Now I'm thinking maybe fuel pump?
The other issue is that when the truck is having to work a little harder (i.e. pulling a trailer or running in the summer with the AC on) it will start to run hot. I have changed the thermostat, flushed the coolant, cleaned out the radiator, etc. and it still does it. Could both of my issues be related to a fuel problem??
View 9 Replies
Sometimes the truck is hard to get started and to keep running, Once it warms up it will run fine. The next time it is started it will start fine but when you are going down the road if I try to accelerate it will start backfiring and not pick up any speed. I am getting a lean code on both banks. I have changed the IAC, the throttle position sensor and mass air flow sensor. 2002 F150 with 6 cyl
View 1 Replies
I have a 2001 F150 4.6L auto. This truck suddenly started running rough. Cleared all codes and re-scanned after starting truck. The codes are as follows; P0135, P0155, P0443, P0740, P0743, P0758, P1451, P1460, P1747, and P1760.
My question is; is it normal to have this many DTCs come up at once? Could my PCM be faulty causing this problem? Can you swap a pcm from the same year truck with the same options without reprogramming?
View 2 Replies
I have an 01 F150 SuperCrew with factory keyless entry fobs. I would like to be able to leave my truck running, take the keyless entry fob with me, and then lock the doors. Currently, the keyless entry fobs are disabled when the truck is running and I'd be locked out of the truck. I've had newer Fords that would allow the fobs to stay active with the vehicle running. Do this can be programmed into the truck?
View 5 Replies
2001 F150 4.6. Just replaced all 4 oxygen sensors and spark plugs. Replaced rubber grommet on brake booster as it was leaking vacuum.
Truck is still running rough hesitating.
Pulled codes came up as PO141 oxygen sensor heater circuit. PO171 passenger side cylinders running lean. Fuel trim outside limits.
View 9 Replies
I have been having some issues with my 97 ford f150 4.6 liter, started out running rough, then hydrolocked with no serious damage, blown intake manifold gasket, fixed that, alternator over charging do to bad voltage regulator, fixed that. and airbag code 52, still working on that, as well as failure to connect when trying to do diagnostic scan. now I am wondering if the engine diagnostic is still even working. still running good just a very slight vibration when warms up. I am not getting any code. or my check engine light is not showing any codes. What I want to do is force a code. What would be the safest way to force a code or force engine light to give a code?
View 6 Replies
2001 F350 with 5.4 ... No leaking brake lines. The bad calipers have been replaced. Brake system doesnt seem to build pressure when the truck is running. The pedal gets stiff when the truck is shut off but when its started the pedal goes to the floor. Just put in a new booster and master cylinder. Flushed and blead all the lines several times now and got all the air out and am now getting a nice solid stream of fluid.
View 3 Replies
Ok, so my 2007 F150 Lariat super crew cab has been at the dealership for a week now with them claiming that a part is on back order. How hard is it for them to get in a right front axle?? Granted, it was in there for other stuff too (which they can not give me a straight answer on if they fixed or not cause they are claiming the technician hasn't done the write up on it yet). My main concern is that they are screwing me around or that something happened to my truck. I am planning on stopping by there on Wed. morning after I get out of work.
Are these trucks known for bad front axles or was there some kind of a big recall on them?
Other things it went in for was the radio having the CD's cycle through when you first start up the truck, but does not happen like that all the time. Black plastic driver side front door hinge is cracked exposing the metal reinforcing part. Whirring/bearing type noise when you first start up the truck when it is cold and sits overnight (which they claim they can't hear yet waited to bring the truck inside and check it out at 3PM when they had the truck overnight from the night before when I dropped it off.) and the front driveshaft not fully disengaging when the truck is in 2wd. Almost seems like the vacuum locking hubs are still engaged.
View 8 Replies
I'm trying to figure out why my truck sits about an 1 1/4" lower on the driver's side. I went around with a tape measure and checked and both the front and back of the truck sit lower than the passenger side. I actually can feel it when driving, feels like it wants to tip over when I'm turning right. Could it just be worn shocks? What else should I look for? All four tires have the same pressure in them also.
View 13 Replies
Every time i run 50 miles per hour i feel shaking on my steering wheel..i did balance on my tire and alignment..still the same..
View 6 Replies
I own a 2000 f150, 7700 with 199,000 miles, 5.4 eng. In drive with foot on brake, it idles at 600 rps, fairly smooth. When I accelerate from a stop the engine shudders. Ten months ago I had the plugs replaced, last week I bought 8 new coils and I installed them, no change. I removed the down stream o2 sensor from the exhaust, it was as clean as blued gun metal. Can these 2 sensors be cleaned or tested? The service engine lite is not on. List of things to check?
View 12 Replies
