2000 ford f150 4.6 auto. Will spin over but won't start. checked coil for fire, no fire. Check fuel rail for fuel, no fuel. No theft light flashing and no check engine light on. Has new battery and plenty of fuel in tank. Started fine yesterday but not today.
View 5 RepliesMy girlfriend has a 2003 f150 4.6lt pick up its a great truck most of the time. Problem is when the temp gets in the neg double digits it becomes very hard to start it cranks fine but doesnt want to fire. When it does fire it might stall a few times before it stays running. The last cold snap we had I replaced the battery and in the summer the starter got changed. I have heard that this model of truck are known for hard cold starts. I am just wondering if this is true and any other thing besides block heater. It is strange that my 89 gm pickup will start no matter what temp and I'm having problems with the newer truck.
View 1 RepliesI have a 2003 Silverado 1500 V6 vin code x with 260000 miles, for about a week now in the morning when its damp out or when it has rained the truck won't start, it cranks fine but will not fire. once it sits for a few hours and everything drys up it fires right up with the first turn of the key.
View 3 RepliesLast night my boyfriend took a friend to the check cashing store, truck ran fine. shut it off, and when he came out the truck would not start. it cranks over but won't start. Took ignition coil off and had it tested but its fine. What else could be wrong or what can i do to try to get it to start again.
View 5 RepliesHave starting problems some times, cranks over real good but will not fire . When this happens i have no fuel pres. But after it starts then it will run good This problem usually happens first thing in the morning. Is there a fuel pump relay in this system or do i have a bad pump . I only have 85,000 miles on this truck.
View 6 RepliesI bought my 2003 F-150 XL (4.2L V6, 2WD, had 165k miles when purchased, 170k now, battery is a Napa brand manufactured in April 2012) in June 2012. A few weeks after I got it, I started having some weird issues. The check engine light came on and I went and had the codes read at Advance Auto. They were P0171 and P0174, lean bank one and lean bank two. The vacuum leak causing these codes isn't the issue I'm dealing with, it is the electrical problem.
The truck will occasionally flash every light on the dash (service engine soon, low fuel, oil, coolant temperature, seat belt, door ajar, and a couple others if I remember correctly) when I turn the key to power on the electronics. The first time I turn the key all the way to crank the truck up, it cranks fine, starts up, and dies within 3-4 seconds. The second time, it does the same thing. Third time, it just cranks and cranks, but will not start. After cranking and not starting a few times, the truck basically just clicks because the battery is run down.
This problem has happened randomly since June. It might be six weeks, one week, or only a few days between occurrences. The last two times it did it, I took the battery out of the truck, put it on a 6 amp charger overnight (about 8 hours), put it back in the truck, and it still wouldn't start, lights still flashing, etc. I gave it about 2-3 hours and both times the truck would start strongly and without incident, and the service engine soon light was off.
It rained here a LOT this summer, so I figured it might have something to do with driving through standing water at various speeds. The problem seems loosely associated with rainy weather (it rained last Saturday and I had to drive approximately 10-12 miles in it), but now it has started something new.
Yesterday afternoon, I tried to start the truck and it did the above described problem. I took the battery off and put it on a 10 amp charger for about six hours yesterday and left it disconnected overnight. Reconnected it this morning, gave it a couple of hours, still nothing. I remembered one time a while back that hitting the odometer reset button made the dash lights stop flashing. I held down the reset button and everything stayed lit up, but stopped flashing. Turned the key with the reset button held down and the truck started right up, but the dash kept flashing.
Turned it off, tried starting it without holding down the odometer reset, would crank, but not start. Tried starting it while holding down the odometer reset again, started right up. When I turned it off and tried it a third time, it just cranked for about six seconds before I gave up. This time, the oil, coolant temperature, battery, and service engine soon lights stayed lit (not flashing, they were solid) and the truck refused to start anymore.
Before it did the odometer reset BS I thought maybe I could figure it out because while it was a ghost of a problem that randomly came and went, it was always the same issue. Now I'm COMPLETELY lost.
Here's the deal. Ive got a 2000 f150 4.6 4x4xlt 170000 miles, About 2 ears ago or so the truck would not start on the first try or two. now this only occurred every once and a while. Last winter it became more of a problem. All i had to do was cycle the key a couple times listen for the pump to prime and was good to go. Summer rolls around no problem at all. Fall rolls around and here we go again no prime. cycle the key a couple times good to go. As it gets colder the problem gets worse. No we fast forward to couple a weeks ago, was out in the woods cutting firewood i go to move the truck and it wont start. I have to cycle the key like 30-40 times. Now its doing it like every time i go to mov the truck until yesterday. Now it wont prime at all. Now every time it primed in the past it runs perfect after it starts . the filter has been changed every 12-15000 or every fall, Ive replaces the fuel pump relay to try it no change, tryed the other key no difference. Im leaning towards a pump but ive never heard of one doing this before.
View 6 Replies2000 7.3 Excursion. Truck ran fine on a 5 hour trip for family vacation. Pulled and to where we were going turn the truck off then what I had to do I came outside try to restart the truck for the next three days it would take 2 to 3 cranks before it was would start. Then on day number three tried six times and didn't start went to bed woke up the next morning and it took three cranks to start. drove it down to mechanic shop near me they have been troubleshooting and think it's an electrical issue the code is P1280; he said there were a couple other codes too and he would tell me what they were later but he never has. I took him a new CPS a new ICM and a new PCM, none of that fixed it. I am at my wits end here and really have to have my truck for work every day.
View 1 RepliesI am having trouble getting my 2000 7.3 (200k) to start on the colder mornings. It will crank over fast, but won't start without a lot of tries. Today it took 6 pre-heats and cranks, but on others (and colder days) it has started easier. It does seem to be getting worse though.
I have replaced the glow plug relay recently so it *shouldn't* be that unless the replacement is fried. Starts fine the rest of the day and drives fine, but not in the cooler am (it was about 34 this morning). I also tested the batteries yesterday and while they aren't new, they tested okay.
Also, I read (briefly) about the CPS, but forgot to watch the tach this morning, but did notice it is pushing smoke out when turning over.
2000 F150 4.6L Romeo 2WD. Engine cranks great. Fuel pump working. Changed fuel filter. Will not start. No codes. Fixed A/C day before yesterday, only had air coming out defroster, disintegrated vacuum hose at firewall. Ran errands yesterday, no problems whatsoever. Get in truck today to go to work and no start at all, engine turns over fine. What next?
View 7 RepliesI have a 2003 Ford Ranger 4X4 4L AUTO. About once every 6 months it will not start. It cranks just fine but doesn't fire. After about 45 min. it start and runs great for an other 6 Months. I have replace the plugs, wires, distributor cap but it hasn't solved the problem. It has had this problem when it is cold and warmed up.
View 4 RepliesI have a problem with my Durango whenever i drive my car it is fine and normal. When i get to where I am at and i try to start my car again it will just turn over like it wants to start but doesnt. I just recently started driving the car for about 4 days ago and it drove fine. Until yesterday i got to my shop and tried to start it.. it will just crank. I scanned it and it turned out i had a bad crankshaft sensor. I gone ahead and replace that and the car starts up fine. I drove it around town and then this morning drove it to work and when i tried to leave for lunch it did the same thing. It cranks but does not fire up. I scanned it.. and no codes. My dad was saying something like sometimes it has sparks going to the crank and sometimes it doesn't.
View 2 RepliesA couple of weeks ago my truck wouldn't start. I replaced the crankshaft position sensor and when that didn't work I took it to a mechanic. At first it wouldn't start for him either. After move the truck inside he tried to crank it again and it fired right up. He said he didn't want to replace something if he wasn't sure what it was. Today it wouldn't start again. I bought some noid lights as suggested on line and tested one of the injector connectors and it did not light up. I realize that the injectors are not getting the needed "pulse". Whole thinking about what to do next I noticed that there was a broken wire. The wire is going to a really small looking box of some sort that is attached to the engine close to the injector at the front of the engine. What the wire is for and I am really not sure what to do next. I will try to upload a picture...
View 13 RepliesMy 2001 Accent GS (1.6L DOHC) wouldn't restart after a short 2 mile trip to a local store. The engine cranks fine but doesn't fire.
It has had a CEL issue for awhile and after it wouldn't start I checked the codes and got:
303
335
722
I replaced the Crank Position Sensor and Fuel Filter but it still just turns over.
I hear the fuel pump run when I turn the key on and I broke the fuel line and it is Pressurized, so I doubt it is a fuel issue.
The 722 code indicates the output speed sensor has an issue. Need to know definitively if that sensor is completely shot could this prevent the ECU from firing the engine?
I have had this car since it was brand new and I'd like to keep it going a little longer.
I have a 2001 f150, 5.4triton, 4x4 supercrew. I'm having trouble getting the truck started. About a month ago is when I first started having trouble with it, and it's happened more frequently until now it just won't crank up at all. The engine is turning over, but it it just won't fire. When it starts, it runs and drives fine, no cut off or rough idles. I replaced the cam sensor today (figured it'd be worth a shot for 20 bucks) but that wasn't it.
View 2 RepliesMy dad has a 99 F250 with a no start issue. Everything was starting and running fine one day. The next he gets a no start. Cranks fast and fine but wont fire up and start. He has a scangaugeII hooked up to it and his oil pressures and volts look fine. His tach moves when he is trying to start it. He checked the icp sensor and it had oil through it so he replaced it with a Ford part. Unplugged it and the scangauge pressure goes up but no start. He also replaced the ipr with a new Ford one just in case. He checked and is getting low pressure and high pressure oil.
I am having him check the fuel heater fuse #22 to make sure it is not blown. He had the block heater plugged in all night along with a battery charger to make sure they are topped off as well. We have gone through a couple of the checklists on this site for a no start condition but nothing has solved it yet. I think he is sitting at about 200k on the motor. No major issues or problems until now. He is currently also pulling the ICM to check it out as well. No codes are being thrown.
I have a 03 xc90 t6 came out of work the other day and it wouldn't start replaced spark plugs, both cam sensors, crank sensor. After doing all that it sounds like it wants to fire now but doesnt.
View 1 Replies2000 2WD 4.6L ... I was trouble shooting why the truck will not start after it has run for awhile then sits for about an hour. I was checking the connections on the solenoid switch on the fire wall when my wrench slipped and touched both terminals on the solenoid and the engine starter kicked in. I tightened the connection then tried to start the truck with no luck. so I tried leaving the key in the "ON" position and jumped the two terminals and the truck started. Does this tell me I have a bad solenoid switch?
View 6 RepliesI have a 2000 f150 with 200k miles. I have no spark and no gas at the fuel rail Schrader valve. I have replaced the shaft pos sensor, no start. I have checked the fuses and the relays. I have crawled under truck and listen for the fuel pump to turn on while someone turned the key to on and heard nothing. I have 2 keys and while turning the key to on and start, the THEFT lite flashes. I have checked the impact sensor on the passing sick panel, it hasn't been tripped.
View 5 RepliesFriends truck, 06 with 135k. Problem he's having is, truck cranks over fine but doesn't fire, if he kick starts it, it fires right up. Haven't had the chance to put my AE on it, figured I throw it out there.
View 7 RepliesI just bought a 00 f150 4x4 with a 5.4 auto...it wouldn't start but not because something was wrong. it kept making a clicking sound and the theft light was one blinking...took my bronco to work and when I came home it started right up...I was thinking one of the keys didn't have the chip in it but it started with both keys....it doesn't have a key fob or keyless entry. I tried locking my drivers door with the key and unlock it...
View 6 Replies