I have a 2000 F150 2WD 4.6L and been thinking of installing a tachometer to my dash. I did it to an '88 Ranger easy, It had A coil, distributor and regular spark plug wires. How would I go about this project I would like to undertake?
View 2 RepliesWhy the O/D off light on the dash is flashing??? Whats it mean? Its a 2000 ford explorer...4.0 V-6
View 9 RepliesI got a 2000 f-150. today I started getting a low beeping noise coming from under the dash. it will beep or sound a few times then stop, then start again. What warning this is for? and there is no check engine light either.
View 3 Replies2000, F-150, 35K +original miles. 4.6L V8
Some weeks ago a noise started that sounded like fan blades striking against heavy plastic fan guard. At first I thought it was coming from the transmission/Transfer case area but after a few weeks of listening to I now believe it's coming from behind the dash area, however, I can't find any reason for it be from there.
The noise usually starts around 45 MPH
I checked the heater fan and it appears to be Okay. I don't know of any other fans in that area.
Purchased 2000 F150 (224000 miles) about a year go cheap for knock around truck. Only gets driven about twice week (20 miles most). Has been running great until recently. Got in the other day went about a mile and notice really strong vibration in steering wheel and dash. First thought about something to do with alignment etc. After a little experimentation realized it was the motor. When you get to around 40 mph and try to hold the speed constant it starts shaking (I believe the motor is missing). If you mash the gas and accelerate it stops. As soon as you try to hold constant speed again it starts again. I can run it up to say 45 and let off the gas and the shaking stops. Once it was driven like this for about 5 miles or so, when I come to stop sign it idles rough. If it is put in neutral runs smoother. Could the fuel filter be clogging up? I did try some additive to see if it would clean it out, no luck. Now the check engine soon lite came on. Fuel Filter, Plugs?
View 5 RepliesI have a 2000 f150 with 198,000 miles. The lite on the dash came on, "service engine soon" , I had the codes read and they said the coils are going bad.
View 2 RepliesDad's 2000 F150 5.4 ltr will start intermittently, when it does fire it runs fine, but right after start up all the dash gauges "spike" to the max levels for a sec and then go back down to normal....
Put the Cen-Tec 98614 code reader on and it continues to say "Link error" and I can't communicate to the interface. P.S., I confirmed the Code reader is good by pulling a 420 O2 sensor code from my Toyota in just a few seconds....
I can hear the fuel pump kick in so I doubt that is the culprit. Because of the gauge spike at start up (every time) this problem screams grounding problem, but I don't know where to start. Could it be a faulty relay?
Sons 03 accent tachometer stopped working. It now reads zero..... All other gauges fine as well as lights. Question is , is there a sensor that controls it that may be bad??
View 3 RepliesF150 - 2003 ... Do some of these trucks actually not have power door locks that operate both sides? Or, is there something wrong with my newly purchased truck's door locks? If so, how hard is it to put in an aftermarket electric door lock?
All I need is for both the things to lock from one door. I haven't had to manually lock all doors in a vehicle I have owned for over 30 years, and it is hard to teach an old dog new tricks.
I bought a used bugshield for my 98. I know how to install it but it didnt come with installation materials. What screws, washers and so on do i need?
View 3 RepliesI'm doing a trans service soon on a 99 F-150 (4.2 v-6 with a 4r70w) and want to add a Wix inline filter. Is the rubber section on the cooler return line 3/8"? I'm also thinking of swapping the stock trans cooler with one from a 2003 7.3 superduty.
View 2 RepliesI am i the process of installing a F-650 dash kit. I am going to relocate my DP tuner to a location next to the power source to the right of the heat/ac control section. I am going to cut out a section for the mounting bracket. My questions are:
1: What's directly behind that section?
2: If there is something directly behind it, can I remove just the front section of the dash or do I have to remove the entire dash from the windshield?
I am going to have to remove something anyways for the lower kit to be installed.
I have a 2000 F150 with 4.6l triton 125k miles. i have a bad miss ONLY between 1500 and 2000 rpm. This will happen in any gear and in neutral, but only between those rpm's. seems to happen more constant in warm weather. This miss is so bad it feels like the transmission is going to fall out. but since it does it in neutral i doubt tranny problems. things I've replaced: fuel filter, tranny fluid and filter, crankshaft pos. camshaft pos, TPI, MAF, spark plugs, Ignition coils ( all 8) cleaned throttle body ( found 1 EGR port clogged completely )..
I had a couple codes but nothing constant. Been working on this for about 1 year. Codes p0320 (ignition speed input error) p0262 (injector circuit high cylinder #1). my only question here is...... What would only make this dang engine miss between 1500 and 2000 rpm. motor runs perfect thru all other ranges. idle... high speed.. and even throttling through this bad range is ok.. but when stabilizing between 1500 and 2000 starts jerking and missing like no fuel and no fire. i have put in superchip program couple years ago and it ran fine for about 1 year, then this trouble started... I have put back to stock program but still trouble.
Just had a question about my 00 F250 7.3. I recently have noticed that my tachometer needle will not always move the way its supposed to. Sometimes it will sit at zero until I drive it for a min then all of a sudden pops up to where its supposed to be. I also noticed today that while i was driving it just dropped to zero for a second or two then back up to where it was supposed to be again.
When it does this there is no drivability issues with it or idle issues what so ever. Which is strange to me and I cannot seem to put my finger on what could be causing the issue. As I have searched online for a while to no avail as most of the other issues include drivability and idle issues. Also not that it matters but I have recently replace the cps sensor with a new one OEM of course but i don't think that has anything to do with this problem.
Got in my truck this morning and noticed the service engine light, oil light and gas cause were all still on. It also had little dashes in the odometer box. The seatbelt alarm goes off as well. What is going on?
View 10 RepliesI had a small pin fall out from under the dash today in my 2000 F150 today, I was shifting the truck into park when it came out and hit me in the foot. It is turned down on one end and knurled on the other end. Now the shifter feels sloppy front to back and when at rest in park the shifter is almost against the dash, where I should start to look for this? Or do I just start taking it apart until I find a hole with no pin in it? So far it is still shifting and tight as far as what gear its in but goes way too close to the dash.
View 2 RepliesWhen driving have five beeps from dash. Is this a dash fault code or abs code. and where can I find info on them. need to get rid of. Changed out complete engine a month ago. Running great beside this beeps. Almost forgot 4.6 auto 2wd extended cab long bed red and silver.
View 2 RepliesI was driving home and the dash lights went out. I checked all of the fuses and they all check good.
View 14 RepliesThis ID10T light came on last weekend, and I just started trying to fix this. I found this post [URL] ....., but this isn't my problem.
The alt is old, but tested good four times at Napa. Battery is three years old, and it's holding good charge. My scan gauge 2 is showing 11.4-11.6, and I'm guessing this is what's throwing the code, although there isn't an actual code.
I don't have the money to go just start replacing parts, and I need this truck for next weekend, 10/3/15, so I hope to find something by then.
At 2000rpm the SC2 is still showing 11.6 volts, so would it be the charging system? Volt reg? Something in there is clamping the voltage down. At 18 years old, and 250k miles I'm not afraid to put new parts into.
I have a darn gurgling noise behind the dash! Now I have read different things on this, it has been doing this for awhile, like as in about 4 months or more. Any way I've read head gasket, air in the system and heater core! Now I did have a t-stat problem. But I fixed that, it was about a week ago. But the noise was there before that! It doesn't overheat and the heat works good! Also I see no water in the oil or anything. By the way it is a 97 F150 4.6 extended cab. It runs fine it's just when I step on the gas it does this. It has me baffled right now....
View 12 RepliesMy dash lights and hvac lights don't work my brights indicator and check brakes lights are on so I think there's power going to it. I checked all the fuses and replaced the dimmer switch and checked all of the wires in and around the cluster. All bulbs are new and checked. I don't know what to do now and I couldn't find another post that had something i missed. 1997 5.8l F250 ....
View 7 Replies