Ford F-150 - 1997-2003 :: 2000 - Gas Gauge Not Working?
Feb 24, 2014
How to diagnose my gas gauge not working? How to find out if it's the sending unit, pump, or gauge?
View 3 Replies
Feb 24, 2014
Advertisement
Ford F-150 - 1997-2003 :: 1998 V6 - High Beams And Coolant Gauge Not Working
I just bought a 98 F150 V6 Manual transmission 2wd truck. Its a clean truck and I'm liking it so far but its got a couple minor issues. Whats the point of buying a truck if you don't get to work on it??
The High Beams don't work at all. Low beams are fine. I've put new bulbs in, and fuse 16 in the passenger compartment has continuity. I'm suspecting the multiple function switch, because when I pull out to engage the high beams, nothing happens. The indicator on the dash doesn't come on, and the low beams don't turn off either.
The second issue is the coolant gauge doesn't read. When I turn the key to the on position, the needle on the gauge moves up just a bit, but it never moves after that. Anything to check?
There are a couple other minor things like the e-brake light on the dash doesn't always turn on, but I can deal with that.
Ford F-150 - 1997-2003 :: 2000 F250 - Cruise Control Not Working
I did the diagnosis,on my non working cruise control on my 2000 f250. The cruise light came on when, I, depressed the off switch and turned key on. I depressed on switch,cruise light came on.
I then depressed the resume, coast, and set switch, as described in the diagnostic procedure,suggested,and no light came on. Do the switches for the cruise control are bad.
I have checked the fuses at the power distribution box under the hood and checked the fuses under dash,all are fine. I just replaced the switch at master cylinder, as it was leaking and it had the recall switch replacement, too.
Ford F-150 - 1997-2003 :: 2000 - A/C Pump Stopped Working After 15 Minutes?
Ok this is actually on my girls car, a 2000 Altima. But i know all newer AC systems work the same. Cus its the same set up as my 98 f150. But the AC will work great for the first 15 mins or so then i notice the pump stops working(not cycling on/off) So i turn it off for 5 mins and then it starts working again and i hear the pump engaging, but it will only work for like 5 mins now. Could it be a bad pressure cycling switch or clogged condenser and gettn the AC too hot and it shuts down.
View 3 RepliesFord A/C :: 1997 - Temperature Gauge Quit Working After Changing The Thermostat And Coolant?
Temperature gauge quit working after changing the thermostat and coolant.
With the engine off, I disconnected the single wire from the temperature sending unit and switched on the ignition without starting engine. The gauge pointer stayed in at the Cold mark. Using a Jumper wire, I grounded the sending unit wire and the needle on the gauge went to the Hot mark.
I quickly turned off the ignition, and replaced the sending unit with a SW-2328 (F1SZ-10884-A) Temp Sender. Warmed up the engine, but still no reading on the dash gauge.
Ford Fuel System :: 2000 - Gas Gauge Not Working - Rattle In Brake Fluid Junction?
My gas gauge is not working on my 2000 F-150. We have already replaced the sending unit and still nothing.... The Fuel pump is working....
Second, When reading the computer what is Lean Bank 1?? Is it dirty fuel injection??
Thirdly, When I start the vehicle....WHY would I get a rattle in the brake fluid junction box????
Ford F-150 - 1997-2003 :: Cannot Get The Oil Gauge To Read Pressure
I changed the sending unit and replace the oil filter with a motorcraft unit and still can't get the oil gauge to read pressure. Since it is a gear oil pump I don't believe it is the pump.
View 2 RepliesFord F-150 - 1997-2003 :: Oil Pressure Gauge Drops To Zero
I have an 01 F150 Lariat Supercrew 4x4 with the 5.4 Triton. The truck has 222,000 miles on it. Recently, I have noticed that when I am stopped at a stop light/stop sign while in gear, the oil pressure gauge drops to zero and the light comes on. As soon as I let off the brake and give it gas, it pops back up to normal. While driving, the needle never moves and stays consistent until I stop again, and back down to zero it goes.
If I put the truck in Park, the pressure goes back to normal. Same with neutral. It seems it is hit or miss and does not do this all the time, but I just wanted to see what your thoughts are. After doing some research I am leaning towards an oil pressure sensor/sending unit.... The truck runs perfectly fine, I just want to make sure it is not something more serious.
Ford F-150 - 1997-2003 :: Gauge Cluster Dead?
My dad has a 97 f150 ext cab and the gauges are dead.... What would cause this? I've checked the faq but didn't see anything.
View 3 RepliesFord F-150 - 1997-2003 :: Headlights Sometimes Working And Turn Signals Not Working - Multi Function Switch Replacement?
Well now I have to replace the multi function switch due to moving my steering wheel and the headlights sometimes working and turning signals not working. I saw a great video on youtube about changing a Multi Function Switch and it shows where the air bag needs to be removed. I was hoping that since my truck is an older 1997 F250 LD I wouldn't have to remove the airbag. Is there a way to do this w/out messing with the airbag on the 1997?
View 1 RepliesFord F-150 - 1997-2003 :: 2002 - Oil Pressure Light On / Gauge Went To Zero?
2002 F150, 4.6 V8, 140k miles. Oil level good, oil was changed 2 months ago.
Driving along one day, out of the blue oil pressure light comes on, oil pressure gauge went to zero.
Engine did not run hot, no bad engines noises that I can hear.
Upon restart, oil pressure will be up on the gauge for minute or so, then goes to zero and oil light comes on.
Asked around, some say oil pump, some say oil filter or pickup tube.
Ford F-150 - 1997-2003 :: Exterior Temp Gauge Blackout
Problem: The exterior temp. gauge is blank.
It used to fade in and out and I discovered if I pushed the button that switches from degrees F. to degrees C. it wold come on for a bit, but no more. It's just blank.
I think I've seen a thread on here about similar issues but I was unable to find it. I'm also not sure how to take the overhead console off yet. The console consists of ext. temp gauge, sun glasses compartment, and compartment for a garage door opener.
Some truck specs:
Year: 2001
Model: F150 Super-crew
Motor: 4.6L
Mileage: 250,000
Color: Silver
Original motor, second transmission.
Ford F-150 - 1997-2003 :: 4.2L V6 Won't Start / Gauge Needles Peg Out On Max Then Back To Zero
I have a 1999 F-150 with a 4.2L V6. I went out to start the truck this morning and when I powered on the ignition the needles on all the gauges and lights were normal. When the chiming stopped, I turned the key to crank the engine. I heard one click and nothing. Then I noticed all the gauge needles peg out on max, then back to zero. No power at all and nothing. Engine will not do anything. I turn the key to the off position and hear a faint beep coming from under the dash. Not a chime, but a beeping sound. The battery is about 4 months old and the starter is about 2 months old. The engine was bad in the truck when I bought it and I replaced the engine about 2 months ago. It has been running just fine up until this morning. Could the battery be bad? I also have installed new battery cable ends and checked all the connections at the starter.
View 11 RepliesFord F-150 - 1997-2003 :: Coolant Temp Gauge Only Goes Up 1/4 Full
I have a 2002 supercrew 5.4 triton. My coolant temp gauge is acting up. When it starts up its obviously in the cold range but when the truck begins to get up to temp, the gauge only goes up 1/4 full. What it can be?
View 4 RepliesFord F-150 - 1997-2003 :: 1998 - Battery Gauge Size?
Finish a job yesterday and go to start my 98 F-150...4.6 and get the dreaded click. All has been fine. Firewall relay clicking, so crawl underneath in the slop and snow and the main battery wire corroded off the starter solenoid. Go back up top and turn the key to run position, crawl back underneath and short that wire to the other main terminal that feeds the 12 volts into the starter. Truck starts right up. That gets me home, I found a 4 gauge lug in my electrical stuff, clean up the wire and crimp it on ( actually a smoosh with a vice-grip cause my crimper won't get in there and trying to solder in that position wasn't gonna' work). Replacing that cable and how hard was it to pull it out of that loom that it shares with other wires? I was thinking just run a separate cable in a new loom and zip tie it to the other loom? I was guessing it is 2 gauge? Looks like about 4' would be enough to go from the battery to the starter.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Coolant Temperature Gauge Not Working
Basically my coolant temperature gauge either reads as the hottest it can be, or the coldest. It doesn't jump around a whole bunch, but it's always all the way to one end or the other. From what I've read there seems to be a lot of different temperature sensors, so I get a little confused with all of the abbreviations, but I'm fairly certain I checked the correct one, next to the thermostat housing.
Using a multimeter I checked the resistance of the sensor, and it was around 600 ohms about 30 minutes after it had been driven. I'm not sure if this is where it should be or not, but it was rising as the truck cooled off.
Anyway, I'm not sure if I just tested the sensor incorrectly or if there could be another issue. A friend of mine suggested that the thermostat may have gotten stuck or something, but it doesn't seem like the gauge would switch at all if that were the case. What I should check to try and fix this.
Ford F-150 - 1997-2003 :: Electrical Malfunctions - Temp Gauge Pegs Without Getting Hot?
I just bought a 97 f-150 from my dad, there are some electrical issue's but the main one seems to be battery drain.
I have noticed with the truck off key in my pocket, the a/c doors keep trying to move and the a/c head has power to it.
I know the engine has been replaced, with about 20k on it.
The temp gauge pegs w/o getting hot, and it even turned over once while we were getting in the truck. Again key in pocket.
Ford F-150 - 1997-2003 :: 2001 - Oil Pressure Gauge Dropping To Zero Intermittently?
Just recently got a sweet deal on an 01 Lariat with a very low mileage 5.4L. I almost didn't purchase it because the oil pressure gauge will not read when you start the engine. Sometimes it will sometimes not.
When it does read, it is just past half which is the normal reading. When it doesn't read, it shows zero and the light is on. The engine runs fine either way, and the previous owner said it has been that way for years. The engine has been well cared for, and has been running Mobile 1 full synthetic for most of the 80k miles. The oil was not overly dirty at purchase, so I figured it to be a loose connection. I suffer from the cold solder joints that these trucks are plaqued with, as evident by the intermittent odometer reading. Do you think the oil gauge issue is the same thing? A cold solder joint? Or should i just start with a new sender?
Ford F-150 - 1997-2003 :: Engine Pegs The Temp Gauge After Startup
97 f250 4.6l engine pegs the temp gauge after start-up. the oil pressure light comes on then after a few miles down the road anti-freeze blows out the pressure cap (15LB) then the temp goes down ,the oil light goes off and everything is normal. no its not the thermostat, i changed that and it still does it. whats up with that?
View 14 RepliesFord F-150 - 1997-2003 :: 2000 4.6L - Missing Only Between 1500 And 2000 RPM
I have a 2000 F150 with 4.6l triton 125k miles. i have a bad miss ONLY between 1500 and 2000 rpm. This will happen in any gear and in neutral, but only between those rpm's. seems to happen more constant in warm weather. This miss is so bad it feels like the transmission is going to fall out. but since it does it in neutral i doubt tranny problems. things I've replaced: fuel filter, tranny fluid and filter, crankshaft pos. camshaft pos, TPI, MAF, spark plugs, Ignition coils ( all 8) cleaned throttle body ( found 1 EGR port clogged completely )..
I had a couple codes but nothing constant. Been working on this for about 1 year. Codes p0320 (ignition speed input error) p0262 (injector circuit high cylinder #1). my only question here is...... What would only make this dang engine miss between 1500 and 2000 rpm. motor runs perfect thru all other ranges. idle... high speed.. and even throttling through this bad range is ok.. but when stabilizing between 1500 and 2000 starts jerking and missing like no fuel and no fire. i have put in superchip program couple years ago and it ran fine for about 1 year, then this trouble started... I have put back to stock program but still trouble.
Monte Carlo :: 2000 - Temp Gauge Not Working / Fan Running After Shutting Car Off
I have a 2000 monte carlo ss. A few months ago the check engine light came on, the temp gauge stopped working, and after shutting the car off you can hear the fan running for about 10-15mins after i shut it off. I assumed it was the thermostat, so that was the first thing i changed. For the first few weeks everything seemed fine. No check engine light, temp gauge worked...then today suddenly it all started happening again. What could be causing it if the thermostat has already been changed? what should i try next?
View 2 Replies