Ford F-150 - 1997-2003 :: 2000 F250 Cab Heater Blowing / No Warm Air
Oct 7, 2012
This problem is on my son's 2000 F-250 5.4. It's into October and my son tells me he has no heat coming out of his vents. I figure it has to be the control valve that should be in the heater hose lines. Could be jammed closed or a vacuum line has come off the pot that controls the open close cycle. We open the hood and nowhere can we see a coolant control flow valve. It is so tight and dark under all that mess of wires, intake, air conditioner lines and whatever.
Just where should we be looking for the valve. Also it could be the vacuum line is unplugged on the dash, behind the warm/cool selector. And even there is a possibility that some doofus has removed something. He bought the truck this summer. So to get us on the right path, where we start looking for the flow control valve?
View 3 Replies
Advertisement
We got our first taste of fall weather in Houston this weekend, and with it I've discovered a new problem with my truck. After the engine was up to temp, I noticed that the heater would blow cold air any time I sat at idle. If you rev up the rpm's to 1500-2000, you can feel the air start to get warm again. I'm guessing this means my heater core needs to be backflushed.
View 4 Replies
My 00 f-150 is not blowing air through the heater I replaced heater core and the temp door I had same problem before work done I did not see an issue when apart but no vacuum or electric to test when apart. The only thing that changes when I move selector for vent floor and defrost I do get a little better flow when on vent. My feet get cold and defrost is not working well if I put hand on defrost I feel warm air but 3-4" away when on floor; I feel nothing anything at all fan seems fine.
View 3 Replies
I just bought a 2000 f250 diesel truck and am having problems with the ac. When I first turn on the ac it blows very cold and works perfectly but after about 5 or 10 minutes it will start blowing warm and slightly humid air for probably around 5 or 10 minutes and then suddenly the very cold air will come back. This cycle repeats over and over again and I'm not sure what is wrong.
View 5 Replies
98 F150 2wd 5.4 -even though VIN says its "W" 4.6; it has a 5.4 with 4.6 timing setup-found. But that's a whole other story...
So, Replaced heater core. did the blend door too.
A week later it overheated and blew a heater hose off the core at the firewall (several times). Temp was up and down, forced me into cylinder head protect mode, so i called my mechanic.
Mechanic used a sniffer (blue liquid turns yellow) in my overflow tank and there was exhaust gas in it... so we replaced head gaskets, intake, timing, water pump, radiator and the rotted out rad support.
Got it done and back on the road, but a few weeks later and the heater hose quick disconnect blew off again, spewing coolant all over (again). This was what we thought was part of the original problem- head gasket allowing cylinder compression into the coolant passages. the little rubber hose that comes from the back of the intake and goes up into the heater core builds enough pressure to pop the disconnect right off and I dont know why. Like I said- I thought it was the head gasket blowing pressure into it but that's all been replaced. Why the pressure would be so high at that point, and how do I correct this?
This is my daily driver, so for now I've bypassed the heater core, but I'm afraid that pressure is gonna burst a hose and/or fitting again.
View 4 Replies
I'm driving a 2000 F150 with the Triton V8 5.4L.
My check engine light came on the other night while heading home. I went to Auto Zone and had them scan it and it came back with the P0125 error code.
My guess is that the thermostat is faulty because my heater is blowing lukewarm air after about 20-30 minutes of normal driving and I would expect the air to be much warmer so I'm thinking that the engine is not getting up to normal operating temperature.
I understand that this can be bad for fuel economy and such, but my question is it safe to drive?
I had planned on hunting up in the hills tomorrow all day and just want to know if this could cause any damage?
Here's a picture of what my cluster looks like after running for about 30 minutes.
Cluster after 30 minutes of driving.
View 2 Replies
I can't seem to get the engine temp to middle range on the marker, but yet my heater blows "to me" hot air. Even while sitting in idle for extended amounts of time I cannot get it to "operating" temperature. I would think if my thermostat was stuck open my heater would blow either cold or slightly warm air. I have the 5.4L engine with knn air filter and no cats.
View 14 Replies
My Ford Explorer blows warm air instead of hot air and it's getting colder and my windows get fogged up. I fixed my clicking sound behind the dash.
View 1 Replies
My hubby is working on a 2000 F150. The heater does not get hot. He has checked the blend door and it is functioning correctly. Is there a valve on the back of the engine that shuts the water off going to the heater core?
View 5 Replies
2000 supercab 4x4 166k miles. Starts right up in morning no probs. Drive to work shut it off and turn key it does NOTHING. Gauges light up, etc but wil not crank. Let it sit all day and it will fire right up. Battery, starter solenoid? Looking for place to start. Won't crank in neutral either.
View 2 Replies
I have a friend that wants me to replace his heater core on his 1998 f250 with a triton 5.4. I told him I would and I've done the one in my 1995 f150 5.8. is it the same process or where to find the step by step instructions.
View 1 Replies
I have a SF 2009 Limited. Since I bought it 2 years ago, I noticed the heater blows luke warm air. Not hot. It takes 20min for the cabin to reach 22degC when it's only 0 outside.
It was like that when brand new.
It has the auto temp control, so it might be playing tricks on me but I don't think so.
I am tempted to find the pipe feeding the heater radiator and insulate the pipes. Maybe the heater only gets warm liquid.
What else can I do?
View 4 Replies
I bought a white 2015 Sonata GLS with 55000 kms on it. Car works fine but really great on gas in city with AC ( 11-12 liters/100 kms ).
And my main problem is my AC/heater vents. Its nice cool day out and I wanna roll my windows up and use outdoor air (with AC off and heating knob on cool - Blue side) but still blow warmer air (the more I turn the temp knob to less cool side more warm air comes out). I went to dealership and complaint about it but they said can't duplicate problem. And I replaced cabin air filter too, but still same problem.
I don't have automatic temperature climate control option, so its all manual, red and blue setting for heat and cold. I complaint them may be my heater stuck on heating but no action taken from them..
View 15 Replies
I cant find my original post but I am reporting back on a low heat output issue. Not the climate door. It was the heater core clogging up. Instead of replacing, this is what I did. Purchased a "drill pump" and some clear hose and some CLR. Cut both the heater hoses,taking consideration of where best to install "T" connectors.
While hoses disconnected,filled heater core with CLR(as much as I could get in it). Hooked clear hose,drill pump configuration,on to the heater hoses. Ran drill pump in both directions for several minutes and stopping and letting it sit for a few minutes.
About 1 hour all together. Pieces of debris came out of the heater core and I could see it through the clear hose. Flushed the heater core out. Installed "T" connectors and it is heating very well now.
View 1 Replies
My 52 Mercury Heater fan is working now, but the air blowing out of it is not warm and this does not change when I moving the temp lever on the dash. Is it likely just the heater control valve or is there something else possible wrong? I'm not finding anything online about how these systems work and my shop manual doesn't give me much info.
View 15 Replies
2007 GS 350 109,500 miles. My heater was blowing cold at idle and warm when driving so I took it to dealer. To my surprise, dealer says its a blown head gasket. No other symptoms. No white smoke, no smells, no warning lights on dash, and running fine. Just had VVT gear recall done last week.
Fortunately I have Lexus extended warranty good thru 125k miles and Feb 2014. I do my own maintenance (plugs, oil changes etc). Have records for all. But have not done coolant change (due at 100k).
View 10 Replies
I have a 1997 ford f 150 lariat with the 4.6 v8 and my engine had a piston slap so I replaced the engine with a used one and I put a new water pump on the engine. My problem is the heater does not get hot and it only gets warm when I get on the freeway and the rpms stay steady for a bit. but when i idle it just blows cool air. the heat door works cause I can turn it to cold air when I'm on the freeway and i just replaced the thermostat so I don't believe its that. It weird because the heater worked fine before I changed out the engine so i cant figure it out. the only thing i can think of is the water pump is bad out of the box. Could it be the belt or does spacing on the water pump have something to do with it. nothing is leaking.
View 7 Replies
Just bought a 04' F250, new head studs and gaskets. Put a tranny temp sensor in and replaced bad thermostat. My coolant res is full and temp is bout 185 (it's 10* outside). My heater is blowing out cold air, I'm assuming there's air in the system.
View 2 Replies
My '06 GS450h has developed a fault where the heater blows cold at idle and low revs but blows warm when driving or revving the engine at a standstill. The coolant hasn't dropped at all and the car never goes above halfway on the temp gauge. Its starting to get frustrating now the cold weather has set in and temps dropping! Long journeys are ok as at high speeds it stays warm but short journeys are uncomfortable!
I just had a feel of the rad hoses and hoses that go into the matrix (engine side of bulk head) and matrix hoses feel warm (both of them), the top hose to the rad is warm but not hot and bottom hose is cold suggesting the stat hasn't opened yet. Its cold outside so getting the car up to temp is quite difficult without a long drive (rush hour at the mo).
Still I just had the car parked on the drive and cranked the heater up to max and held the accelerator for a while and super warm air blows out. The engine cuts back out as "normal operating temp" has been reached for battery mode and then the heater goes cool again! Still the bottom radiator hose is cool and top hose not massively warm. It has never overheated thus far and I drive 150miles a day back and forth to Reading from Cheltenham 4 nights a week.
Only thing I can think of is a sticky thermostat or water pump not operating sufficiently enough to circulate the water? Its getting colder and short trips where it used to blow warm air nice and quickly (within 3-5miles) are becoming unpleasant!
View 6 Replies
Sunday I bought a 2001 f250/5.4 to replace my 91 f250. I didnt drive it yesterday, but this morning on my drive to work the heater was very weak, it seemed to blow warm for the most part, but was barely pushing air even on high. I flipped it over to A/C to see if it blew any harder and it did. Does the blower motor need replace? if so why does the AC blow harder than the heater?
View 14 Replies
2001 F250 5.4. The heater will blow warm air at idle and on the second highest setting, once you start moving or turn the fan up to full blast it instantly cools off. The coolant level is fine. The engine runs at a normal temp.The blend door does work. I just replaced the thermostat, and both hoses for the heater core are hot.
View 4 Replies
