Ford F-150 - 1997-2003 :: 2000 - Coolant Started Leaking?
Aug 28, 2017
My 2000 F150 started leaking from a small pin hole in the coolant bypass pipe that is located on the top / front of the intake manifold, it is the pipe that flows toward the heater core. I decided to remove it without pulling the intake "being lazy". I almost had it and it snapped, while trying to retrieve the piece that was still in the hole It broke and part fell into the intake, I assume into the head in one of the coolant ports. I have removed the intake and still cant seem to see it or retrieve it. I have tried a shop vac, and a magnet wand, still nothing. While pulling a vacuum I noticed that I had flow / suctions from all my cooling ports on both heads, the line from the heater core, and even my top radiator hose.
So I guess my question is, If I cant get this out and it fell into one of the water jackets in my block will it hurt anything??? I know rust and other things end up in there anyway. I still haven't given up on removing, I am really in need of answers,, in case I cant remove it. I do know the flow of coolant is up through the pipe I was trying to replace, and either through the heater core (hose), thermostat, or maybe the bypass back to pump.
View 2 Replies
Advertisement
I have a 2001 F150 5.4 triton. It recently started leaking coolant so i stopped driving it until i could get it to the shop. The day i took it to the shop, i stopped 3 times and checked the coolant level and i kept it full while driving it to the shop. The mechanic that was fixing it kept putting it off and had an excuse every day why the truck wasn't ready yet. It stayed in the shop almost a month for him to put a new intake on the truck. The truck ran fine on the way to the shop. I finally got tired of excuses and delays so i went to the shop and asked him if it was ready. He told me now the motor is rurnt and water is getting in the oil.
I checked the oil before and after i got there and the oil had no water in it. He cranked it up and the motor had a loud rattle in it. He wants to rebuild it. I want everybody's honest opinion about this deal. Do yall think the motor just burnt up or do y'all think he could of screwed the engine up on purpose to make more money because i always pay on time? Like i said, the truck had 200,000 miles on the motor but i never once had a lick of engine probs. I just think he could have accidentally or purposefully messed the engine up.
View 3 Replies
I have an 01 SuperCrew with the 4.6L and it's idling really rough. Last summer, the idle started to flux pretty bad with the a/c on and eventually, it started to spray coolant mix through the vents and I lost heating about the same time. So, local dealership changed out the heater core and that is working again.
Well...I still have the idle flux, it fluxes from between 400-1000rpm at idle with the a/c on, it's a constant flux....up/down/up/down/up/down. A/C off and the idle is rock-solid steady. Dealership has changed 4 ignition coils over the last couple of years along with an EGR or PCV (whatever it's called) valve as well, none of which was for the idle problem, but somewhat associated. Where I should be looking?
View 2 Replies
So over the weekend my 2000 jetta VR6 started leaking coolant and getting way to hot. So i parked it at work and eventually got it towed to a friends shop. I haven't looked at the car since then so bear with me on the descriptions I'm giving as they are just what he told me over the phone. I'm going to try and get to the shop in the morning to check it out some more. He says I have a leak in 2 hoses that look like they are just rotted out.
First hose he says "Comes from the back of the head and is about a half inch wide. it goes into a Y and then the top half goes into a smaller hose." The 2nd hose he says "on the top of the coolant bottle there is a line that goes across the back of the firewall then comes into a rubber hose and from that hose their is a T going into other places."
Obviously that's not a lot to go on. and when I'm looking at replacement hoses at shops online I'm not seeing ones that match these descriptions really. I've been looking for a diagram or some kind of illustration of these hoses so that i can send it to him and he can figure out which ones they are but I have not been able to find one.
View 9 Replies
2000 Subaru Outback. The head gaskets have begun to leak slightly (oil and coolant), even though I brought it in for the recall at 80K and the dealer put in the additive. I recently (111,000 miles) put in another bottle of the additive coolant conditioner and the leak seems to have at least slowed to a trickle. Is it really essential to have the head gaskets replaced? Or could I just keep an eye on the oil and coolant levels and put a bit of kitty litter in my garage? Some of the information I googled indicates that the recall of this car is for an OUT leak and not an INNER leak--which would be worse. Is it true that an OUT leak is not as worrisome?
View 5 Replies
I have a 2003 F150 4.6l triton v8.... I started over heating yesterday. Got home, let it cool down and found Oil in Coolant. No coolant in oil or transmission fluid. What could be wrong?
View 2 Replies
I have a 2003 F150 4.6 Triton V8.... My truck started over heating again after replacing the Thermostat and Water Pump later this summer.... Well I checked Coolant and I have Oil in the Coolant. I see Nothing wrong with the Tranny Fluid and see nothing wrong with the Oil.... What could be the problem??????
View 4 Replies
I have a small leak (seems to only be leaking while driving and shortly after I stop the truck). I dont know what the part its leaking from is called but its right behind the oil pan (looks similar to the pan but a little larger) It has a small 1/8-1/4 inch hole/nozzle in it that looks like its meant to be there.
So my question is..
Is there supposed to be a rubber stopper in there?
Is this common?
Whats the part called?
This seems to be the only place its leaking from.
View 2 Replies
Where exactly is the coolant temp sensor located on a 2000 F-150 4.6 V-8.
View 5 Replies
I have a leak on the right side of the cross over pipe. I removed one long bolt from the right side and two long bolts from the left side that go through the thermostat housing, and three bolts from the back of the alternator, but the pipe doesn't seem to want to move. I don't want to break anything.
View 2 Replies
I have a 2000 f150 4x2 5.4 168k... Check engine came on,started shaking, weather was really cold. RPM would be a little high then low then back up. Especially when I turned on heater. Felt like truck would die but never does nor does it have issue starting.
So far, I have replaced two oxygen sensors inside engine,all coils, spark plugs, fuel filter, had injectors cleaned, intake cleaned. Truck runs better but, light came on a day later again. I can feel the tiniest of shaking going on and, cold mornings still make RPMS a little unstable. I was driving truck on highway at about 60 mph when a slight tug was felt and Truck check engine came on. I feel truck heavy, once it warms up completely, a little lighter.
Codes came up at auto zone as P1151
But I'm running out of options and frankly, money to fix this truck.
Checked the MAF and looked okay.
I'm with minimal skills.
View 13 Replies
I have a 2000 f150 with 5.4 Triton with 165k miles. I did invest in a code reader. It started missing and code P0302 came up along with P0171. Put new coil on #2 and truck ran fine for a few days. Then it started to run rough again. Shaking, Idle rough, no power and CEL came on again. This time code P0171. I changed out fuel filter to no avail. My next step was to start looking for vacuum leaks. As I'm searching, All I am finding is trucks with this problem also get P0174 code. My question is since I am only getting lean on one bank does that pretty much eliminate things like MAF or the famous elbow vacuum leak and make something that only affects one bank like an O2 sensor on CAT more likely?
View 2 Replies
I have a 1999 Ford Expedition. A couple of days ago The engine started losing coolant as soon as the engine cooled. I replaced the coolant only to lose it again when the engine cooled. I was told that it is more likely the intake manifold gaskets leaking. It seems they are right. What is the cost to repair if I take it to a mechanic?
View 1 Replies
I have an old 83 datsun pickup. It is my first car and I love it and it has more character than most people that I know. one day it just started leaking antifreeze. I looked under the hood and could see a steady leak way down on the bottom driver's side of my engine. What's the problem and how can I fix it? No matter what, getting rid of this car is not an option.
View 11 Replies
Recently I started leaking coolant on the driver side area to the right of the engine:
I am assuming I need to replace some part/tubing that has a leak in it, but I am not sure what any of these things are called. How to identify what leaking part here is?
View 1 Replies
Coworker's 2000 Focus's heater core started leaking on his 50m commute this morning. He is ready to donate the car at this point. Any stop leak product (i.e. Bars) that would stop the leak without clogging the cooling system.
View 5 Replies
Mine has a 4.0 V6, the freeze plugs are leaking coolant, the guy at the shop said it will require pulling the engine to replace them. Is there an easy ( less expensive ) fix ? I was told I could use block sealer, is that an option? She has appox.160,000 miles...
View 2 Replies
I just purchased an 97 E350 (15 Passenger) and I notice that the two rear heater lines (along the driver side) are rotted and is showing sign of minor leakage. Can I simply replace them with rubber heater hoses or do I need to get the factory heater lines?
View 6 Replies
Today while I was working I walked back to my truck after finishing the job and saw a red fluid leaking from behind the front bumper, I crawled underneath and saw that it was leaking from somewhere between the plastic cover for the fan and the radiator but I couldn't find exactly where it was coming from, I drove 30 miles before I got to the job site with my ac on, and my ac was making a noise that seemed like a whirling noise but I kinda brushed it off as the condenser going bad or whatever. After I found my truck leaking I decided to drive 20 miles to the next job site but this time I left the ac off and nothing happened the temperature gauge didn't even go up, I checked underneath when I finished driving and there was no more coolant leaking from the radiator. I drove it an additional 50 miles before I got home and still no leaks. Could the bad ac system cause coolant to leak? I have a 2000 excursion 5.4L V8
View 14 Replies
My car is BMW2000 323i. My coolant is leaking, I need to refill it every month. The dealer told me I need to change the radiator and some related components in the coolant system. But the labor fee is too high.
I was told to use a coolant seal to fix the problem like K-Seal. After a long time searching on the Internet, I got confused. Someone says it works, but other people say it never works. What should I do?
View 15 Replies
I just bought a 2000 F250 SD 6.8 v10 and its mixing coolant in the block and leaking oil. I'm debating on just dropping a newer v10 in it but im just not 100% sure that this engine is shot. It runs great when there's oil in it and I can't even tell there's any problems going on for well over a couple hours after i fill it up with oil.
View 8 Replies
