Ford F-150 - 1997-2003 :: 2000 - A/C Pump Stopped Working After 15 Minutes?
Jul 29, 2014
Ok this is actually on my girls car, a 2000 Altima. But i know all newer AC systems work the same. Cus its the same set up as my 98 f150. But the AC will work great for the first 15 mins or so then i notice the pump stops working(not cycling on/off) So i turn it off for 5 mins and then it starts working again and i hear the pump engaging, but it will only work for like 5 mins now. Could it be a bad pressure cycling switch or clogged condenser and gettn the AC too hot and it shuts down.
View 3 Replies
Advertisement
2000 F-150 Triton V-8, Super Cab, 2WD, ~170,000 miles, 4-wheel ABS (one speed sensor on each front wheel and one on the rear differential). The ABS light comes on a few minutes after driving. It seems to take a little bit longer for the light to come on when the weather is colder.
I used a Cen-Tech 60794 OBD II/CAN with ABS scan tool with key on, engine off, and the below sequence. No codes were detected. I then left the scanner connected but powered off and drove around until the ABS light came on. Pulled into a parking lot with engine running, powered up the scan tool and went through the following menu choices:
Diagnostics
ABS
Area - USA vehicles
Model - Ford
Although the tool's instruction manual has several more items that may or may not be required (VIN digits, model year, etc), the next thing I saw is a message indicating the scanner is linking with the vehicle computer. During that time the ABS light went out. Next on the scan tool display my choice was to read codes or erase codes. I selected "Read codes" and the display said there are no codes in the module.
View 3 Replies
I have a 2003 F150. My horn and cruise both stopped working. All fuses are OK. Cruise controls are on steering wheel (as is horn). Why both would stop working???
View 2 Replies
Last week my door locks just stopped working so I checked all the fuses and relays which all were good but still no power took door panels off and checked with tester and no power to switches or actuators, Checked wiring in between door and cab and no broken or bare wires. This truck does have remotes and they don't work either, what's going on ?
View 2 Replies
New to this site, my problem is on my 2003 4.6L fuel pump not working.My problem is that I am not getting voltage to contacts on pcm and fuel pump relays.
Getting volts to #30 fuse 30amps ok, voltage to pcm diode ok. Voltage on #30 on both relays(pcm & fuel) but I am loosing voltage across coils contacts #85 & #86, these makes hot #30 & #87 to make pump work. Inertia sw ok, Don't know if PCM is bad, ck fuse #2 ok 5 amps.
View 14 Replies
today all of the sudden my ford f150 5.4 liters speedometer started to not work and the airbag light came on while it was having trouble shifting! the windshield wipers don't work as well! checked all fuses! after messing around with smacking things under the hood it started to shift right but has a glitch in the electrical and it sounds like it's trying to start( this is while it's running) it's all glitchy...
View 4 Replies
I just noticed that the odometer and trip meter have stopped working. What is involved in the repair?
View 6 Replies
2003 F150 4wd with auto climate control. My blower for heat and AC completely stopped working a few weeks ago. I have checked all fuses, i replaced the relay under the dash, i replaced the blower motor control module. I supplied power to the blower motor itself and it ran fine with no noises. I ran the self test on the controller in the dash under the radio and it passed. I am not sure what else to try.
View 7 Replies
My 03 5.4 the obd2 port isnt working i have tried 4 bluetooth adapters and a snap on scanner and nothing will connect to the ecm. im having problems and trying to read codes my check engine light isnt on but that don't mean anything. my truck is running really rich and blows a little bit black smoke when i rev it up after its been idling a few min and getting horrible gas mileage again. yesterday i went to start it and i had to crank on it 4 time before it finally started and then when i reved it up it almost died on the way back down but it caught itself. then today i go out and it starts right up and runs fine but its still running rich but i still cant get an obd2 adapter to connect to the ecm. I checked the fuse and its not blown my cigarette plug and the power port both work. i really dont know where to start in trying to figure out this problem. Right now iI don't really want to take it to a shop right now.
View 4 Replies
I have a 2002 f150 supercrew, 4wd. The power door locks stopped working the other day and I am trying to fix it. So far I have checked the fuse in the power distribution box, good. I have checked the wires from the doors to the cab along the door sills to the rear doors , all good. I did find a couple of iffy grounds on the left kick panel and cleaned and repaired them. I am having a heck of a time finding the group of relays that control the lock and unlock functions. Remember , I have no power lock function at all. I would swear its not getting power to the relays but until I find them , I just don't know. Where they are supposed to be?
View 5 Replies
My driver's door power window motor stopped working. Replaced motor (Dorman). New motor was shaky and wouldn't stop when going down. Replaced motor again (Dorman), same thing. Regulator became damaged, replaced (Dorman), smoother, still won't stop with auto button, or holding down button. At some point glass came out of regulator and track. Replaced glass. Window goes up and down smoothly, but just doesn't stop when going down and tries to keep going. I don't see a limit switch or circuit for it. I see there is a relay and a fuse for the auto down. What tells the motor to stop driving current?
View 2 Replies
I am working on my son's 1997 F-150, 2 wheel drive, 4/6L truck. He was driving it when the gauges and the tach stopped working. I replaced the cluster and it still blows the fuses. The five amp fuse that is specifically for the cluster doesn't blow. It is a twenty five amp fuse that also power the overdrive circuit, etc.
After replacing the gauge cluster I installed a new fuse and the overdrive button on the shifter started smoking. Where I could get a wiring diagram of this circuit so I can see how it is wired.
View 2 Replies
My blinkers started off blinking a few times then stopped working, now they don't work at all. The fuse says it goes to the brake lamps, hazards and turn signals. The hazards work as well as the brake lamps. I found the relay/flasher box and it appears the relay and flasher is the same for both the turn signals and the hazards. I checked for the wire/connector problem in the column and all looks good there. When I activate the turn signal lever I feel one click in the relay/flasher which leads me to believe the turn signal switch is working. I went ahead and replaced the relay with no results. Is the flasher internals the same for both the hazards and the turn signals or is there two independent sections inside for each?
View 4 Replies
How to diagnose my gas gauge not working? How to find out if it's the sending unit, pump, or gauge?
View 3 Replies
Sons 03 accent tachometer stopped working. It now reads zero..... All other gauges fine as well as lights. Question is , is there a sensor that controls it that may be bad??
View 3 Replies
On my way home the speedometer stopped working and the air bag light came on. The odometer is still tracking distance and one other odd thing, the radio volume goes out as soon as the clutch is released. Tried a scanner and there are no codes.
View 5 Replies
I did the diagnosis,on my non working cruise control on my 2000 f250. The cruise light came on when, I, depressed the off switch and turned key on. I depressed on switch,cruise light came on.
I then depressed the resume, coast, and set switch, as described in the diagnostic procedure,suggested,and no light came on. Do the switches for the cruise control are bad.
I have checked the fuses at the power distribution box under the hood and checked the fuses under dash,all are fine. I just replaced the switch at master cylinder, as it was leaking and it had the recall switch replacement, too.
View 8 Replies
2004 Excursion 4x4 6.0. I just had the fuel injectors & wiring harness replaced and it runs great, but after 30 minutes of driving the complete dash lights/gauges stopped working. I found that the #45 10amp fuse had blown so replaced it and after 20 minutes the same thing happened. While it was working all of the lights & gauges seemed to be working okay. This doesn't effect anything else, still starts & runs okay, turn signals work, head lights work, but the head light auto on/off doesn't.
View 4 Replies
2016 F250 with less than a 1K miles and the power steering all but stopped working at low RPMs. Once it got going it would start working again.
View 1 Replies
I have a 2006 Solara and overnight the windshield washer pump stopped working. I thought the problem was no washer fluid, filled it, and nothing. I checked the hose near the hood and nothing came out. The motor isn't humming like it is trying to pump, so I checked the fuse (I think I checked the right one, not sure, it was a 15a) and it appeared to be good. I checked the wires going to the pump with a multimeter and didn't get power, so is there any other "secret" fuse I am missing. I know on an older car I had, the fuses were sometimes mixed with other items and not labeled.
View 11 Replies
I have a 2000 ex with the 05 front end. My headlight on the right side stopped working I have the high just no low. I replaced it and still no go. I suck at wiring so what to look for..
View 3 Replies
