I can charge it off someone else battery and it will start and drive, but by the next morning it's dead again. Truck charges fine while truck runs so I don't think it's the alternator. 1999 4.2L V6 ....
View 3 RepliesMy 98' Taurus will not hold a charge. I have replace the battery 3, The alternator was replaced 4 times, and the 175 amp mega fuse was replaced once.I am at wits end cause I don't have a clue what is causing the the battery to discharge over night in the winter and with in 3 days in the sommer. I have rewired the main fuse box under the hood cause the relay to the starter melted the box, I replaced cables to the battery, the alternator, the starter, and the ground to the battery, and the main fuse box under the hood. I have tested the battery to see if it will hold a charge on its own. This test took 3 weeks before it drained. I know it is not the battery. What is going on with this car, Did I miss something?
View 1 RepliesThere a couple of things wrong with this particular vehicle. first, that battery will not hold its charge; it also has a high pitched noise when started and only when accelerating. Where to start?
View 9 RepliesMy battery on my Celica wouldn't hold a charge, as if my alternator was faulty but i took it to Azone and it was fine. Replaced battery around a month ago so i doubt that's the problem..checked fuses and "charging" fuse in fuse box next to battery was not getting current to i ran direct current to from battery it and it seem to have fixed the problem for about a DAY, then fuse blew..replaced it but it still seems to have the same problem ): btw the battery and brake lights stay on..
View 1 RepliesMy sister owns a 2004 Kia Amanti. The battery will not hold a charge. The battery has been replaced several times. the alternator and regular and anything else that could drain the battery has been checked. All ground posts have been cleaned. At first the battery would go dead every 3 to 5 days but now you have to start the car every day or it will die. They say there is a 7ohm drain on the battery that can't be located. The latest suggestion is to replace the wiring in the driver's side door. What would be causing this?
View 4 RepliesHad a little fender bender. Right after that i noticed the battery red light was on. When I got it home I took the solenoid off the firewall (all the battery wires meet here). When you put 12 volts to the small terminal, the solenoid pulls in and the two big terminals are connected together. That works. When installed on the truck and startup, I have no 12v voltage at the small terminal. Don't have a diagram, but service manual says something about fuse #14 under the dash feeding the "battery cutout".. Checked that fuse and its o.k. .... where does the 12 v signal to the solenoid come from ? I assume somehow it triggers after the alternator starts charging ?
View 12 RepliesAbout 4 months I accidentally reversed the polarity when jumping my car and fried my 12V battery and blew the fusible link. I replaced it with an Optima yellow top but due to other issues I haven't driven the car since about that time.
Last week I got most of the other issues resolved and tried starting the car, nothing. It was reading less than a volt on the voltmeter. I used my portable jump starter and got the car started. I only drove it to the gas station (1 mile round trip) to fill my tires and back. I went to start it the next day and nothing again. I thought maybe I didn't charge the battery enough since I hadn't been driving it.
I charged it overnight using a wall charger and again the next day it wouldn't start. Yesterday I jumped it again and drove it about 20 minutes, about half at low speeds (<30 MPH) and half at higher speeds. I got home put the car in park, but still on, and checked the voltage again, about 13.8 V. Turned the car off and checked again and I could see the voltage dropping like a rock. Within about 30 seconds it was down to 6V and within another 30 seconds it was so low that I didn't have any interior lights or dash lights.
It seems to me like the battery is bad. However after I "fried" the original battery I had similar issues. In fact the reason I had to jump it in the first place is because the battery died a few times in the same day. Could something be killing the battery?
I've noticed that after sitting over night my battery for the hybrid system is not charged enough to operate the car in EV or for the first mile or two it does not seem to use as much electric power to supplement the car. After a couple miles it is charged or near charged and I see more use.
View 5 RepliesI am pretty sure that my Denso alternator is shot. My 2010 Corolla S will not start, battery won't hold a charge either. I pop started my vehicle around 10:30am today and drove 30 minute north on the 101. My car appeared to have no issue maintaining power. I rode my bicycle around for about an hour and then tried to start my car. Nothing. Tried to pop start the vehicle twice...still nothing.
The battery has about 40k on it. Car has 121k. So I am guessing it is my alternator.
Like I said the current alternator is made by Denso. I would like to buy a higher quality alternator with maybe a little more cranking amps.
I also am planning on purchasing a Optima battery, should I stick with a yellow top or a redtop. I have some aftermarket audio, only amp is in the Pioneer head-unit (avh p440bt), which is connected to aftermarket 6x9s and components (JL Audio c2-690tx and JL Audio C5-650).
I have a quick question, I just replaced the head gaskets on my 4.6 with 301,000 miles on it and now my battery only charges when you punch it and when you lift off the gas pedal, in town it does fine, but on drives 25 miles on the highway the battery guage goes to the line on the bottom. What could be causing that?
View 2 RepliesI have a 99 Ford F-150 Lariat 5.4L 4x4. I was driving my son to work and the truck died. My son-in-law gave me a jump and as soon as he removed the jumper cables my truck died. We took the alternator to Auto Zone and had it tested, twice they tested it and it passed. We took the battery to them for a battery test and it was dead. Got a new battery and put it in the truck and the truck starts. The voltage on the battery was 12.4 off and when we turned the truck on the voltage went to 12 so we replaced the voltage regulator on the alternator and now I get 13 volts on battery while it is off and on the voltage goes a little above 15 and the charge light will not go off. What to look for to try and fix this problem. What can cause the light to stay on? I can push down on the belt a little but my son-in-law says the belt is ok, it does have a few cracks in it.
View 11 RepliesI've had the alternator and starter tested twice,new battery. Its a 97infiniti qx4 and it won't hold a charge. The weird thing is, I have to wait day or two after I charge the new battery (which I replaced twice thinking it was the battery),then it will run for almost a day and then it just dies. And if someone tries to give me a jump, it will not charge and fire over. I have to get it towed back home and wait a day or two. (the wrecking companies are getting to know me very well). I've checked under the vehicle for any wires that are not suppose to be touching each other. Its my only car that I have at this time
View 5 RepliesI have a 1997 Volvo 850 where the battery slowly loses its charge. We don't drive it much so every two weeks it has to be trickly charged.
I have determined that there is a drain of 150 mA. When removing fuse 15, it drops to a drain of 50-60 mA. When removing fuse 6 (central locking)(in conjunction with 15) it drops to a drain of 10 mA. I can live with a drain of 10 mA
I don't mind removing fuse 15 as it is not critical. However, with the fuse removed, it makes a beeping noise - like the indicator when a door is open. IS THERE A SIMPLE WAY TO STOP THE BEEPING?
I understand that there is an electrical issue but not sure I want to spend a lot of money to fix it. I am not very mechanically inclined and I have a feeling it could cost a lot to fix this.
I have an 03 F150 that I put a 4bt 3.9 cummins diesel in a couple years back. I'm just now working on ac issues. I have custom lines built and have a new drier in it. I am uncertain of the location of the expansion valve. I have not found a diagram of where that would be. It is a supercrew so it has the large condenser and I don't remember seeing the expansion valve/filter in that line when it was apart.
So I pulled full vacuum on the system and let it set for over an hour and it held the full vacuum. I plugged the Freon to it and it pulled just a small amount into the system. with the vehicle off it registered about 90lbs on both high and low with just the one can attached. I closed high side and jumped the ac pressure switch and it dropped to about 30 lbs on low side, but would move back up to 90lbs when I turned compressor off. It would not pull anymore out of the can. Do I have a plugged filter somewhere?
2000 F150 5.4... I was cleaning the battery posts tonight. I was leaning against the bumper when I touched the positive cable and got voltage into my knee. I have had weird electrical problems occasionally.
View 5 Replies1999 F150
automatic, v8 4wd 430K miles Low Battery light is on.
Other than the usual things to check: battery cable connections, corrosion at contact points, checking with a voltmeter, having battery tested, having alternator tested for volts and amps... are there other known issues with this year model/setup?
Also, once the battery is changed, is there a way for the codes to be cleared out or reset without having to hook it up to a computer?
My neighbor's kids truck battery drains from full charge to "no start" in 1-2 days. 1999 Ford F-150 w/ 4.6L engine. He has already.....
1) Replaced the Battery.
2) Replaced the GEM module.
3) Replaced the Turn Signal Relay.
He did all this before I looked at it....
I checked the following....
1) Truck off, doors closed, hood open... Amp meter shows 3.6 amp draw. When 1st hooked up, shows 4.2 amps... after a while drops to 3.6.
2) To isolate the draw, we pulled fuses while checking current draw at battery.
a) Under Dash fuse Panel. (Yes, with door closed) We remove fuse #15 "stop lamp switch, speed control, brake shift interlock, ABS, PCM,GEM, RABS test connector". (Really... couldn't be more stuff?)
b)Under the hood is another fuse box (drivers side). We remove Fuse #103. "Junction Block Battery Feed".
3) Found that if we remove the #15 fuse under the dash with the door opens, all interior lights flash on/off at about 1 second intervals... weird.
4) Again, another weird one... with the fuse #15 removed and door closed, the "ABS" indicator and some other indicators and dash lights are staying partially lit... not fully lit.
5) The only "aftermarket" stuff i can see is a dealer installed trailer brake system. Wiring looks professional and disconnecting it does not remove the amperage drain.
I'm hoping that one of you wizards will give me the "slam dunk"... if this happens, it must be that. Can I be so lucky? And, yes. I have my own '06 F-150 that i absolutely love. 6-cyl., manual trans, stripped down without even power door locks... my kinda technology.
So i have had a problem with my battery lately and i have done all the steps to try to fix it. First we took out the alternator and battery and had them tested at orielys and the alternator tested positive and the battery tested positive so we had them charge it then put them back in. They told us it is probably a parasitic drain which means something is draining the battery so we detached all my aftermarket stuff like my air compressor train horn and led lights on my grille guard and it ran fine for 2 days without dying. Well this morning i went to start it and it was dead again....
View 9 RepliesI am having a really curious issue with the charging system on my 1999 Golf VR6. The battery will not charge and the alternator seems to be nonfunctional. While running the voltage at the battery starts normal but drops until the engine dies within 20 minutes. Over the last two days I have replaced the alternator, battery, and the battery grounding cable with no change in behavior. The exciter wire on the alternator is showing 9 volts when the vehicle is running and 0 when it is off. There is 1.6 ohms of resistance between the B+ terminal on the battery and the respective terminal on the alternator. There is 0.3 ohms of resistance between the B- battery terminal and the case of the alternator. My task for tomorrow is to trace the exciter wire back to the cluster and try to troubleshoot it there.
View 9 RepliesWould it be a good idea to change the injector hold down bolts when I do the injector o-rings? They have never been out at 333,000 miles.
Plan on doing glow plugs, injector wiring, valve cover gasket's, intercooler pipes and the dreaded oil cooler.
I am having trouble with my 1999 F350 Ford Powerstroke, Looses power but the motor never quits and also starts up fine, will set and run and warm up on the coldest morningIdles fine, It will hold back sometimes and not increase speed. I can take it out today and it may be fine and tomorrow can't run 2 miles. I was thinking CPS but after reading information I am not sure. What may be causing this issue. I just put a High Pressure oil pump on it could this have anything to do with it. Was not having a problem before the pump was changed. The pickup has 190,000 on it actual miles.
View 7 Replies