Well I was trying out my four wheel drive today and it worked fine until I went to turn off switch, it would not cut off it is a 98 F150 switch is located on dash. It is stuck in four wheel high!
View 3 RepliesCan't drive the truck. Went through the how to fix 4x4 and no go. How to kick it out of four wheel dive?
View 6 RepliesI have a 98 F250LD, its a Lariat, so everything electric/auto. Shift on the Fly 4x4, 5.4, 188K, Factory rear air suspension. Typical Minnesota rust. Anyway, I just noticed in the last 75 miles or so, a drive-line vibration. There is nothing until 39 MPH. Then from 39-41 MPH there is a decent vibration. Stops until 50, then from 50 MPH up it is a steady vibration. I have already changed the u-joints in the rear shaft. I have pulled/wiggled on everything else I can think of with no luck of finding of anything loose.
One thing I did notice, is that the front axle is locked in all the time. How long it has been like this: years for all I know... I can flip the switch from 2wd to 4H and 4L. It all seems to work fine, I hear clicking, the 4x4 engages, the proper lights come on/off. The front axle will pull when supposed to. The transfer case seems to be working fine, but the front axle won't disengage. I am hoping this can be fixed cheaply/easily (DIYer), and also hoping this explains my low fuel mileage.
Front axle? Where to look or what to try and fix for the vibration?
I have just put in another transmission and the truck will not shift out of first gear, it will go in reverse and first and reverse. The guy who had it before me had the same problem when he put in a transmission with only about 40-60,000 miles he assumed it was a bad transmission. And that's how I ended up with the truck. We have so far installed yet another transmission and it is doing the same not shifting out of first that it did for him. There is no cel or blinking overdrive lights, checked fluid levels, checked selinoids, gonna purchase a used computer for diagnostics, I am stumped with limited knowledge. The dealership said the transmission should be the e40d I'm reading it should have the 4r100 is that correct? The truck is the 5.4L v8 with 74,000 original miles. Truck sounds amazing. I really want to fix it.
View 2 RepliesI have a 1998 f150 4x4, the truck has not been driven in a few years and it’s been outside in my driveway up on jack stands. I just rebuilt the front end and did a four wheel break job, after getting the truck off the jack stands, I can't get it to move in drive or reverse. I also noticed that when you go from reverse to park the gears grind and I can't even get it to shift into 4H. I checked the tranny fluid and it is fine, also the tranny was just rebuilt a few years before I stopped driving the truck.
View 6 RepliesI have a 1998 F-150 XLT, 2WD, 4.2L, V6, just over 103,000 miles. My transmission shifts fine into reverse but when I put it into drive it is very slow to engage, sometimes it doesn't. I have to put it in drive, hold down the brakes, give it some gas and then it will engage and lurch forward. I have check the fluid level and quality. Both are fine. This just started to happen two days ago with no fore warning. No previous problems with transmission.
View 4 Replies98 F150 4.6L 4WD...
Attempted to replace fuel filter tonight. The connector on the fuel tank side of the filter came off just like it is supposed to. The engine side, however, will not come lose at all. I can wiggle to back and forth, but I can't seem to get the tool to compress the springs.
The engine side connector seems to be smaller than the tank side. I've done this once before on a '98 Ranger, but didn't notice a difference in connectors.
I have a 98 F150 4x4. I had some trans trouble so I pulled it out and had it rebuilt. Now when it shifts into drive the rpms speed up right before it shifts. What is causing the trans to do this? It doesn't do it all the time, only if I take off faster the usual which is most of the time.
View 1 RepliesMy t case will engage in 4 high and 4 low. so i know the switch and motor works because it go all the way to 4 low and i can feel the lower gears. BUT the front drive shaft is not turning because i know that the front diff is engaging just fine cus one I just fixed it and because when i put it in 4x4 the front drive shaft is locked in but when i take it out the drive shaft moves freely when i turn it by hand. But when I test it in gravel or mud the front wheels still ain't turning. So its gota be the t case. But what are the part that may be broken in the t case and if I can fix it wile its still on the truck.
View 4 RepliesMy truck is starting to shift strange. As it warms up and I'm in drive, it will shift between drive and 2nd by itself. When I pull up to a stop lite, it's like it's stuck in drive and doesn't downshift. Ultimately it dies. I've checked my fluid and its fine. Any ideas? Oh and my engine light is on. Can a parts store find the code for the issue I'm having?
View 1 RepliesI was driving my 1998 Ford F150 the other day and pulled into a driveway. At that time, the transmission quit pulling like I put it in neutral. It shifts from park and goes into reverse but not drive. It has the 4.6L and is 2 wheel drive.
View 4 Replieshaving problem w/ 98 f-150. first truck stuck in park. figured out how to get around that (turn key 1 position, shift to neutral, start vehicle, then engage transmission). but no brake lights! I have turn signals, driving lights, hazards, etc in rear. I disconnected harness from brake light switch. there are 2 leads, 1 hot, 1 not. i jumped them and no brake lights. i tested the switch and it functions properly (it's reconnected now). i changed my bulbs in tail lights. I unplugged the solenoid (which is impossibly located behind/beside steering column). this allowed me to shift like an old truck (without having to brake first), but doesn't solve my lack of brake lights (i've reattached the solenoid harness to remind me of my problems).
i am putting my money on a broken wire somewhere between the brake light switch (b/c that was good) and the solenoid (i am not hearing that faint click when i step on brake). but a broken wire should work by accident some of the time (unless cut cleanly and completely). there is a green wire with red stripe leaving the brake light switch and 3 wires at the solenoid harness (1 green and maybe a smaller gauge than those at the switch and 2 others which i don't recall their colors). Ford service manager doesn't think it's the solenoid but wasn't otherwise useful except to say, "hey, why don't you bring it in to me." What to look for before i plunk down for someone to perform what I already have before completing the job!
can i splice a wire from something (? brake light switch?) to something (?wire in solenoid harness?) or does that "electronic signal" get processed somewhere else first?
I have a 1997 f150 4x4. When I put to 4 wheel drive on all I hear is grinding, but I'm pretty sure it works...
View 4 RepliesLooking for the vacuum diagrams for the four wheel drive, where I can find them?
View 10 RepliesI have a 2000 ford f-150 4 wheel drive that will not disengage, I am down here in south fla where and don't put it in 4 wheel drive much, but yesterday I put in 4 wheel drive and I heard the click click and it engaged I put it in drive and drove it about 5-10 miles parked it and turned the switch to 2 wheel high and got out , got back in the truck turn her back on and the 4 by 4 lamp came one went off then came back on and stayed on and it still in 4 wheel drive and wont disengage.
View 4 RepliesI have a 2000 F-150 4x4 and the four wheel drive isn't working properly. It does work,but to get it to engage I had to drive in reverse for a couple feet then it locked it and everything was fine,pretty sure that isn't normal. What could be wrong with it? As soon as I turn the lights up on the dash,but the front tires don't spin.
View 1 RepliesI have a 1998 F-150 and when shifting into 4 wheel drive (manual floor mount shifter) the drive shaft from the transfer case turns but the wheels do not engage.
Looking for a diagram of how the axle works?
My selector switch does not light up when engaging four wheel drive on my 98 f150,could this be my GEM module gone bad ?
View 6 RepliesMy 4 wheel drive is not engaging on a 2001 F150. The indicator lites on the dash illuminate to suggest that the truck is in 4 wheel drive but sigh...it stays in 2 wheel drive. No gross sounds and the indicator lights are not flashing. Could this be a fuse or a relay issue of some sort. What else should I try?
View 3 RepliesLooking for diagrams for where the fuel filter is, the coils are in the engine compartment, and a steering wheel diagram because mine wobbles. I did attempt to look for one in a hayes when I was at Pep Boys a bit ago and didn't see one. 1998 F150 4.6L v8 w/auto trans 4wd 3dr...
View 6 RepliesI've managed to remove 95% of my driver's side drive shaft but can't for the life of me remove the spline from the transmission. I cut the boot so all there is is the cup with the spline plugged into the gear box. I've pried and pried with a screwdriver and drove a chisel with a hammer in between the cup (not sure the proper term for it) and it wouldn't budge. I'm going to try and track down a puller that will work on this car but that might take days or weeks. I have to work tomorrow night so my question: Will it do any harm to the transmission or be unsafe to drive with only one drive shaft?
View 19 Replies